• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.13 no.10
• /
• pp.2227-2234
• /
• 2009

DVB-SSP is a new broadcasting system for hybrid satellite communications, which supports mobile handheld systems and fixed terrestrial systems. An upper layer, including erasure Reed-Solomon error correction combined with cyclic redundancy check. However, a critical factor must be considered in upper layer decoding. If there is only one bit error in an IP packet, the entire IP packet is considered as unreliable bytes, even if it contains correct bytes. If, for example, there is one real byte error, in an IP packet of 512 bytes, 511 correct bytes are erased from the frame. Therefore, this paper proposed upper layer decoding methods; LLR-based decoding. By means of simulation we show that the performance of the proposed decoding algorithm is superior to that of the conventional one.

• Journal of Power Electronics
• /
• v.3 no.4
• /
• pp.230-238
• /
• 2003

Electric vehicles (EV) demands for greater acceleration, performance and vehicle range in pure electric vehicles plus mandated requirements to further reduce emissions in hybrid electric vehicles (HEV) increase the appeal for combined on-board energy storage systems and generators. And the power electronics plays an important role in providing an interface between fuel cells (FC) and loads. This paper deals with a multiple input DC-DC power converter devoted to combine the power flowing of multi-source on energy systems. The multi-source is composed of (i) FC system as a prime power demands, (ii) super capacitor banks as energy storage devices for high and intense power demands, (iii) superconducting magnetic energy storage system (SMES), (iv) multiple input DC-DC power converter and (v) a three phase inverter-fed permanent magnet synchronous motor as a drive. In this system, It is used super capacitor banks and superconducting magnetic energy replaces from the battery system. The modeling and transient performance simulation is effective for reducing transient influence caused by sudden charge of effective load. The main purpose of power electronic converters is to convert the DC power output from the fuel cell and other to a suitable AC voltage, which can be connected to electric loads directly (PMSM). The fuel cell and other output is connected to the DC-DC converter, which regulates the DC link voltage.

• Journal of Wetlands Research
• /
• v.4 no.2
• /
• pp.23-41
• /
• 2002

In this paper, changes of the coliform bacteria were investigated when aquatic plant pond was used for separating algal particles from waste stabilization ponds(WSPs). Three different types of integrated natural systems were operated. It was found that there were no significant interferences for the disinfection efficiency of two integrated systems (WSPs coupled with water hyacinth ponds) used for treating domestic sewage and upgrading the secondary effluent as well. However, when constructed wetland (CW) was combined with the shallow algal ponds and used for the secondary effluent, it seriously interfered with the disinfection efficiency due to the regrowth and/or after-growth of the coliform bacteria, which can readily metabolize the amino acids and sugars leached from plants. In order to find out the primary disinfection parameters, several sets of the batch test were run. It was found that sunlight is the most predominant factor for the coliform decay. During the night, algal toxicity partly supports the decay but during the day, deteriorates it by attenuating the sunlight. The pH in the range of 4 to 10 did not affect the decay in the dark.

• Journal of Physiology & Pathology in Korean Medicine
• /
• v.19 no.2
• /
• pp.323-328
• /
• 2005

Oriental medicine specifies points which have proven to be valuable in the treatment of certain diseases or conditions of pain-the so-called master points and alarm points of the acupuncture system. The idea of applying colorpuncture via the master points already suggested itself on the basis of the very old correlations between organs and organ systems and colors which we find in a number of different therapeutic systems and trations. Each of the twelve organs of the acupuncture system has an alarm point which is usually not situated on the related meridian but on another channel. These alarm points are always to be found in the vicinity of the organs they are associated with. The combined use of master points and alarm points is a simple and excellent way of using colorpuncture. Via their inherent vibrational frequencies, the healings rays of colored light radiation are capable of releasing potent resonance forces within the organism, thus contributing to the alleviation and healing of acute and chronic diseases.

• Korean Journal of Geomatics
• /
• v.2 no.1
• /
• pp.65-73
• /
• 2002

GPS in the United States and GLONASS of the old Soviet Union are used currently as satellite navigation systems. Plans are being made to use the Galileo satellite system in Europe, and these plans focus on a combined application of the satellite navigation systems. In this study, we examined the possibility of effective application of a combination of GPS/GLONASS in urban areas, where 3-dimensional positioning is impossible with GPS alone. We analyzed the 3-D coordinate deviation of a GLONASS satellite by integration interval and compared it with GLONASS satellite coordinates in precise ephmerides by transforming it into WGS84. We also programmed GPS/GLONASS, analyzed 3-D positioning accuracy by static surveying and kinematic surveying with Ashtech Z18 receivers and Legacy receivers, and then compared the results to those of GPS surveying. As a result, we are able to decide the integration interval for producing GLONASS satellite coordinates in navigation and geographical information and construct a GPS/GLONASS data processing system by developing a DGPS/DGLONASS positioning program. If more than four GLONASS satellites are observed, the accuracy of GPS/GLONASS is better than that of GPS positioning. As a result of kinematic surveying in a congested urban area with skyscrapers, we discovered that the GPS/LONASS combination is very effective.

• Transactions of the Society of Information Storage Systems
• /
• v.2 no.1
• /
• pp.13-20
• /
• 2006

In this paper, we propose novel optics design for media inside near-field recording(NFR) using hemispherical solid immersion lens(HMS). To obtain strong advantage of data protection and high data capacity simultaneously, HMS based near field optics using aplanatic position of super hemisphere is designed. In this design, to improve small optical tolerance of this aplanatic position, additional aspheric lens surface is added on top of the HMS and it is combined with zoom optics which composed of two single lenses having low numerical aperture(NA). Also, to compensate chromatic aberration which happens seriously in optics using blue laser diode, diffractive optical element is used. Using zoom optics, additional aspheric lens surface, and diffractive optical element together, wavefront aberration and chromatic aberration are effectively reduced in broad range of cover layer thickness and wavelength variation. In addition, in this paper, effect of gap induced aberration is investigated by analyzing different behavior of each TM and TE wave for designed media inside dual-layer NFR optics.

• Journal of the Korean Institute of Intelligent Systems
• /
• v.17 no.5
• /
• pp.707-711
• /
• 2007

Microarray gene expression data is believed to show the functions of living organism through the gene expression values. We have studied a method to get the informative genes from the microarray gene expression data. There are several ways for this. In recent researches to get more sophisticated and detailed results, it has used the intelligence information theory like fuzzy theory. Some methods are to add fudge factors to the significance test for more refined results. In this paper, we suggest a method to get informative genes from microarray gene expression data. We combined the difference of means between two groups and the fuzzy membership degree which reflects the variance of the gene expression data. We have called our significance test the Fuzzy Information method for Gene Expression data(FIGER). The FIGER calculates FIGER variation ratio and FIGER membership degree to show how strongly each object belongs to the each group and then it results in the significance degree of each gene. The FIGER is focused on the variation and distribution of the data set to adjust the significance level. Out simulation shows that the FIGER-test is an effective and useful significance test.

• Journal of the Korean Institute of Intelligent Systems
• /
• v.18 no.3
• /
• pp.387-391
• /
• 2008

For the detection of moving objects, background subtraction methods are widely used. In case the background has variation, we need to update the background in real-time for the reliable detection of foreground objects. Gaussian mixture model (GMM) combined with probabilistic learning is one of the most popular methods for the real-time update of the background. However, it does not work well in the complex and dynamic backgrounds with high traffic regions. In this paper, we propose a new method for modelling and updating more reliably the complex and dynamic backgrounds based on the probabilistic learning and the layered processing.

• Journal of Drive and Control
• /
• v.11 no.3
• /
• pp.7-13
• /
• 2014

Everyday about 90% of cargos are delivered by ships, and thousands of vessels enter and depart the international container harbors such as Shanghai, Singapore, Hong Kong, Busan, Rotterdam, etc. Maneuvering at harbor is known as the most sophisticated and difficult procedure, because the effectiveness of actuators during low speed berthing is reduced. In this paper, a new berthing method is discussed. Tugboats are combined with damper systems to ensure safe berthing. A mathematical model describing the interaction between unactuated ship, tugboats and damper systems is presented. An optimal controller is designed to maneuver the ship without oscillation and overshoot. MCL (Marine Cybernetics Lab) model ship is used to evaluate the efficiency of the proposed approach through MatLab simulation.

• Wind and Structures
• /
• v.11 no.1
• /
• pp.19-33
• /
• 2008

This research investigates the adaptive input estimation method applied to the multilayer shearing stress structure. This method is to estimate the values of wind load inputs by analyzing the active reaction of the system. The Kalman filter without the input term and the adaptive weighted recursive least square estimator are two main portions of this method. The innovation vector can be produced by the Kalman filter, and be applied to the adaptive weighted recursive least square estimator to estimate the wind load input over time. This combined method can effectively estimate the wind loads to the structure system to enhance the reliability of the system active performance analysis. The forms of the simulated inputs (loads) in this paper include the periodic sinusoidal wave, the decaying exponent, the random combination of the sinusoidal wave and the decaying exponent, etc. The active reaction computed plus the simulation error is regard as the simulated measurement and is applied to the input estimation algorithm to implement the numerical simulation of the inverse input estimation process. The availability and the precision of the input estimation method proposed in this research can be verified by comparing the actual value and the one obtained by numerical simulation.