• Proceedings of the Korean Magnestics Society Conference
• /
• 2013.05a
• /
• pp.15-16
• /
• 2013

Magnetization behavior of ultra thin $Fe_xCo_{1-x}$ alloy (where x varies from 0 to 100) has been investigated as functions of composition on Cr (100) substrate by using in situ surface magneto optical Kerr effect (SMOKE). It's always show in plane uniaxial magnetic anisotropy at room temperature (RT) & Low temperature (LT). It is observed that composition dependent coercive force maximum at about 30 at % Co and 70 at % Co atomic ratio and minimum near equiatomic site. The relative magnetic moments as composition variation also show magnetization collapse near equiatomic site. The magnetization behaviors of Fe-Co alloy on Cr (100) due to composition varies are supported the order-disordering as well as structural stability bcc (ferromagnetic)/fcc (anti-ferromagnetic) phase stability magnetism.

• Journal of the Korean Electrochemical Society
• /
• v.9 no.2
• /
• pp.77-83
• /
• 2006

Anodic overpotential has been investigated with gas composition changes in a $100cm^2$ class molten carbonate fuel cell. The overpotential was measured with steady state polarization, reactant gas addition (RA), inert gas step addition (ISA), and electrochemical impedance spectroscopy (EIS) methods at different anodic inlet gas compositions, i.e., $H_2:CO_2:H_2O=0.69:0.17:0.14\;atm\;and\;H_2:CO_2:H_2O=0.33:0.33:0.33\;atm$, at a fixed $H_2$ flow rate. The results demonstrate that the anodic overpotential decreases with increasing $CO_2\;and\;H_2O$ flow rates, indicating the anode reaction is a gas-phase mass-transfer control process of the reactant species, $H_2,\;CO_2,\;and\;H_2O$. It was also found that the mass-transfer resistance due to the $H_2$ species slightly increases at higher $CO_2\;and\;H_2O$ flow rates. EIS showed reduction of the lower frequency semi-circle with increasing $H_2O\;and\;CO_2$ flow rate without affecting the high frequency semi-circle.

• Proceedings of the IEEK Conference
• /
• 2000.11a
• /
• pp.401-404
• /
• 2000

We designed and fabricated partially shorted MSA with a slot for 850 MHz on Copper-clad Laminate substrate, where the width of the radiation patch is identical with that of the ground plane and one side of the radiation patch is partially shorted to the ground plane. The radiation patterns of ZX, XY and ZY planes were measured. As a result, a better co and cross polarization lot ZX plane was obtained, compared to the partially shorted MSA without a slot.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1996.11a
• /
• pp.346-348
• /
• 1996

The MCFC has conspicuous features and high potential in being used as an energy converter of various fuels to electricity and heat. However, the MCFC which use strongly corrosive molten carbonate at 650[$^{\circ}C$] have many problem. Systematic investigation on corrosion behavior of Fe/20Cr/Ti alloys has been done in (62+38)㏖ % (Li+K)CO$_3$ melt at 923K by using steady state polarization and electrochemical impedance spectroscopy method.

• Journal of the Korean Magnetics Society
• /
• v.15 no.1
• /
• pp.1-6
• /
• 2005

In this study we investigate the electronic structure and magnetism of transition metal (TM = Ti, Cr, Mn, Fe, Co, Ni, Ru, Pd, Ag ) deped ZnO($TM_{0.25}Zn_{0.75}O$), which are expected to have Curie temperature. Full-potential Linearized Augmented Plane Wave(FLAPW) metod is adopted with exchange-correlation potential expressed as general gradient approximation(GGA). The calculated magnetic moments of ($TM_{0.25}Zn_{0.75}O$) are 0.83, 3.03, 4.03, 3.48, 2.47, 1.56, 0.43, 0.75, 0.01 ${\mu}_B$ for TM = Ti, Cr, Mn, Fe, Co, Ni, Ru, Pd, Ag, respectively. The nearest neighbor O atom to the transition metal is calculated to have a significant magnetic moment of about 0.1${\mu}_B$, ?? 새 strong hybridization between O-p and TM-d bands. As the results, the systems may have larger magnetic moments in total, compared to the corresponding isolated atoms. The 3d TM doped systems exhibit the half-metallic character except Co, wheres the 4d TM doped systems behave like normal metals and low spin polarization at the Fermi levels.

• Journal of the Microelectronics and Packaging Society
• /
• v.28 no.3
• /
• pp.25-32
• /
• 2021

In this paper, the Magneto-Electric(ME) dipole array antenna with dual-polarization in the X-Band is proposed and it is implemented and measured. The proposed array antenna is composed of 32 single ME dipole antenna and a Teflon PCB. 1 × 1 ME dipole antenna is implemented dual-polarization by radiating vertical polarization and horizontal polarization from two pairs of radiators. 2-port feeding structures are realized by lamination process using LTCC. And, each port independently feeds the radiator through a Γ-shaped feeding strip with isolation between ports. The Teflon PCB used in the antenna array has a 4-layer structure, and 2-port is fed through the top and bottom layers. The λ_g/4 transformer is applied to the transmission line of the Teflon PCB for impedance matching of the arrayed antenna and the Teflon PCB, and the optimal parameters are obtained through simulation. The measured maximum antenna gains of port 1 was 18.2 dBi, Cross-pol was 1.0 dBi. And the measured maximum antenna gains of port 1 was 18.1 dBi, Cross-pol was 3.2 dBi.

• Proceedings of the KIEE Conference
• /
• 2004.07c
• /
• pp.2052-2054
• /
• 2004

The TX/RX broadband L-type circular polarization antenna using LTCC at K/Ka band has been presented. This antenna has been analyzed in compensation for LTCC with relative permittivity 5.2 and could have been integrated with RF component. As the measured 10dB impedance circular polarization bandwidth of the proposed antenna is 7%(20.8GHz${\sim}$22.2GHz) at the K band and 2.3%(30.9GHz to 31.6GHz) at the Ka band. Also the gain of the antenna is -0.7${\sim}$3.05dBi at the K band and -2.8${\sim}$1dBi at the Ka band. The purpose of the research is to design an efficient antenna structure for satellite communication at K/Ka band. the antenna should be used for both TX and RX frequency bands. The antenna will be mounted on LTCC(Low Temperature Co-fired Ceramic) so that it can be integrated with other RF circuits. This research is important because of the following reasons. 1) The frequency ranges of satellite communication tends to move up to higher frequency such as Ka band or milimeter wave band. 2) Design of antenna for smaller size, lighter weight and less loss is preferred by most RF engineers. 3) Antennas on LTCC enables to integrate the antenna with other RF circuits, and thus, one can reduce the size and loss of the RF system.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.23 no.3
• /
• pp.292-299
• /
• 2012

This paper proposes the design of circularly polarized multi band antenna for a non-linear junction detector (NLJD) system. In order to design for broad bandwidth, the CPW (Co-Planar Waveguide) feeding method is considered in this design. In order to realize the circular polarization, the axial ratio was controlled by inserting a $45^{\circ}$ inclined slot on radiating element and by cutting an edge of the radiating patch. Measurement results of return loss, bandwidth, axial ratio, polarization pattern and gain are agreed well with their simulation results in interested frequency band at 2.4~ 2.44 GHz, 4.84~4.92 GHz, and 7.28~7.32 GHz.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.38 no.4
• /
• pp.27-37
• /
• 2001

The design, fabrication, and an experimental implementation of the strip patch antenna coupled with a H-shaped aperture arc presented in this paper. The proposed antenna has the wide bandwidth, high gain, and low cross-polarization levels. We measured the VSWR, smith chart impedance characteristic, co/cross polarization pattern, gain, and so on. The measured bandwidth of this antenna is 47.1 %. To reduce the back lobe and increase the gain, when the reflector is used, cross polarization level is below -18.2dB at E-plane and below 25.7 dB at H -plane. The maximum gain at 2.05 GHz is also 10.4 dBi and the 3 dB gain bandwidth with center frequency at 2.17 GHz is 24 %, which is the wide bandwidth. This antenna can find applications in mobile communication, wireless LAN, RF communication system, and so on.

• Journal of Physiology & Pathology in Korean Medicine
• /
• v.36 no.1
• /
• pp.1-6
• /
• 2022

The tuber of Pinellia ternata (Thunb.) Brei (TPT) used in traditional Oriental medicine for the treatment of cough, sputum, vomiting, and insomnia, possesses antioxidant, antibacterial, and anti-inflammatory effects. Although recent studies have reported the anticancer effects of TPT in several cancer cells, it is still unclear whether TPT regulates tumor-associated macrophage (TAM) characterized by the immunosuppressive M2 macrophage phenotype. Our results showed that the ethanol extract of TPT (ETPT) suppressed the migration of RAW264.7 mouse macrophage cells and THP-1 human monocytes differentiated into macrophages towards the conditioned media (CM) collected from lung cancer cells, suggesting that ETPT would attenuate the recruitment of macrophages into tumors. In addition, ETPT suppressed the interleukin (IL)-4 or IL-6-induced M2 macrophage polarization in RAW264.7 cells. ETPT treatment not only downregulated the mRNA expression of M2 macrophage markers including arginase-1, mannose receptor C type 1 (MRC-1), and IL-10, but also inhibited the phosphorylation of signal transducer and activator of transcription 3 (STAT3) and STAT6, general regulators of M2 macrophage polarization. Finally, the transwell assay results showed that the CM from M2-polarized RAW264.7 cells increased the migration of mouse lewis lung carcinoma (LLC) cells, while those from RAW264.7 cells co-treated with ETPT and IL-6 significantly reduced the migration of LLC cells. Taken together, our observations clearly demonstrate that ETPT suppressed the cancer cell migration by regulating macrophage recruitment and M2 macrophage polarization.