• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.37 no.8
• /
• pp.1-10
• /
• 2000

Performance analyses of hybrid DS-SFH spread-spectrum systems using coherent MSK and QPSK modulation techniques are considered over Rayleigh fading channel in the presence of multi-tone jamming. The BER equations for MSK and QPSK systems with non-diversity reception in the receiver are derived as the concept of average signal-to-noise power ratio E$\_$b//N$\_$0/ and jamming-to-signal power ratio JSR, and the performances is evaluated for various system parameters. The evaluation of performance is done between fading and nonfading system, and between MSK and QPSK system. Results show that the performances of two systems are similar in low JSR. However, MSK system outperforms QPSK system as JSR increases. Overall performances of two systems are a little improved as the DS spreading gain increases for the total spread-spectrum bandwidth fixed. The performance difference between fading system and nonfading system is similar in low E$\_$b//N$\_$0/, however, it becomes very largewith increase of E$\_$b//N$\_$0/..

• Journal of the Institute of Electronics Engineers of Korea SP
• /
• v.44 no.5
• /
• pp.45-53
• /
• 2007

To recover transmitted signal perfectly at DTV receiver, we have to acquire carrier frequency synchronization to compensate pilot signal which located in wrong position and rotated phase. Also, we need a symbol timing synchronization to compensate sampling timing error. Conventionally, to synchronize symbol timing, we use Gardner's scheme which used in multi-level signal. Gardner's scheme is well known for its sampling the timing error signal from every symbol and it makes easy to detect and keep timing sync in multi-path channel. In this paper, to discuss the problem when the received power level is out of range and we cannot get synchronization information. With this problem, we use 2 step procedures. First, we put a received signal power compensation block before Garder's timing error detector. Second, adaptive loop filter to get a fast synchronization information and averaging loop filter's output value to reduce the amount of jitter after synchronization in PLL(Phased Locked Loop) circuit which is used to get a carrier frequency synchronization and symbol timing synchronization. Using the averaging value, we can estimate offset. Based on offset changing ratio, we can adapt adaptive loop filter to carrier frequency and symbol timing synchronization circuit.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.45 no.4
• /
• pp.31-37
• /
• 2008

Conventional cooperative communications can attain gain of spatial diversity and path loss reduction because destination node independently received same signal from source node and relay node located between source node and destination node. However, these techniques bring about decreased spectral efficiency with relay node and increased complexity of receiver by using maximal ratio combining (MRC). This paper has proposed cooperative ARQ protocol that can improve the above problems and can get the better performance. This method can increase the spectral efficiency than conventional cooperative communication because if the received signal from source node is satisfied by the destination preferentially, the destination transmits ACK message to both relay node and source node and then recovers the received signal. In addition, if ARQ message indicates NACK relay node operates selective retransmission and we can increase reliability of system compared with that of general ARQ protocol in which source node retransmits data. In the proposed protocol, the selective retransmission and ARQ message are to be determined by comparing log-likelihood ratio (LLR) computation of received signal from source node with predetermined threshold values. Therefore, this protocol don't waste redundant bandwidth with CRC code and can reduce complexity of receiver without MRC. We verified spectral efficiency and BER performance for the proposed protocol through Monte-Carlo simulation over Rayleigh fading plus AWGN.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.26 no.4
• /
• pp.381-388
• /
• 2015

In this paper, a wireless video streaming system is designed and implemented for TV white space applications. It consists of a RF transceiver module, a digital modem, a camera, and a LCD screen. A VGA resolution video is captured by a camera, modulated by modem, and transmitted by RF transceiver module, and finally displayed at a destination 2.6-inch LCD screen. The RF transceiver is based on direct-conversion architecture. Image leakage is improved by low pass filtering LO, which successfully covers the TVWS. Also, DC offset problem is solved by current steering techniques which control common mode level at DAC output node. The output power of the transmitter and the minimum sensitivity of the receiver is +10 dBm and -82 dBm, respectively. The channel bandwidth is tunable among 6, 7 and 8 MHz according to regulations and standards. Digital modem is realized in Kintex-7 FPGA. Data rate is 9 Mbps based on QPSK and 512ch OFDM. A VGA video is successfully streamed through the air by using the developed TV white-space RF communication module.

• Korean Journal of Optics and Photonics
• /
• v.18 no.3
• /
• pp.185-189
• /
• 2007

A novel technology for CWDM (Coarse Wavelength Division Multiplexer) utilizing a PLC (Planar Lightwave Circuit)-AWG (Arrayed Waveguide Grating) fabrication process is proposed. BPM (Beam Propagation Method) Simulation results on the employed parabolic-horn-type input slab waveguide of AWG and the performance of the 20 nm-channel spacing CWDM with flattened passband are presented. Waveguides of $0.75{\triangle}%$ have been used in this experiment and the insertion loss at the peak wavelength is 3.5 dB for a Gaussian spectrum and is 4.8 dB for a flat-top spectrum. The bandwidth at 3 dB is better than 10 nm and 13 nm for Gaussian and flat-top spectra, respectively.

• Journal of KIISE:Databases
• /
• v.30 no.5
• /
• pp.476-493
• /
• 2003

Data broadcast is an effective data transmission method from a data base server to numerous mobile clients due to the restrictions on mobile environment such as low wireless communication bandwidth and energy shortage of mobile devices. There are various broadcast methods based on clients' data access frequencies or semantic relationship of data. The broadcast schedule based only on the access frequencies does not consider semantic relations of data, so that when a client needs to access a series of semantically related data, the client has to listen to the wireless channel for a long time. On the other hand, the broadcast schedule based only on semantic relationship of data makes data access time longer when clients highly request specific data which are not semantically related but frequently accessed. In this paper, we present an efficient data broadcast method based on not only data access frequencies but also semantic relationship to improve mobile clients' query response time. The new hybrid broadcast method we propose creates a data broadcast schedule according to the data access frequencies and then the schedule is adjusted to reflect semantic relationship of data. We show our method is efficient by experimental performance analysis.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.26 no.11B
• /
• pp.1501-1509
• /
• 2001

Recently, the use of wireless communication systems has been rapidly increasing, which results in a difficult problem in efficient control of limited frequency resources. As a way of solving this problem, the ultra wideband time hopping impulse radio system attracts much attention. The impulse radio system communicates pulse position modulated data using Gaussian monocycle pulses of very short duration less than 1 nsec. Thus the transmitted signal has very low power spectral density and ultra wide bandwidth from near D.C. to a few GHz. It is blown that it hardly interferes with the existing communication systems because of its very low power spectral density. The purpose of this paper is to characterize multipath propagation of the impulse radio signal and to evaluate the performance of the correlator-based receiver for the multipath environments. In this paper, we consider the deterministic two-path model and the statistical indoor multipath model of Saleh and Valenzuela. For the two-path model the output of the correlator with the ideal reference waveform varies according to the relative difference between the indirect path delay and the time interval of PPM, and to the indirect path gains. In addition, the characteristics of bit error rates is measured for the two models through computer simulation. The simulation results indicate that the performance of the impulse radio system depends both on the relative difference between the indirect path delay and the time interval of PPM, and on the indirect path gains. Furthermore, it is observed that the reference signal designed for the AWGN channel can not be applied to the multipath channels.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.37C no.12
• /
• pp.1185-1194
• /
• 2012

This paper proposes a new terrestrial 3DTV broadcasting standard specification based on synchronization with non-real-time contents in order to overcome quality limitations of the current 3DTV services that are arisen from the limited bandwidth of the legacy broadcasting channel. In the services using the proposed specification, one view sequence of a stereoscopic video content is delivered as a non-real-time content in idle time, and the other view sequence is transmitted in real time broadcasting signal, thereafter two sequences are synchronized in a receiver for display. Thus, it is possible to provide higher-quality stereoscopic video content services than the current 3DTV services. In order to realize these services, a new mechanism is required which enables synchronization between the data that are from different transmission media and time. Therefore, this paper suggests a solution by multiplexing the synchronization signals of non-real-time contents into broadcasting signals with real-time streams together. This solution can provide a accurate synchronization mechanism by minimum updates of legacy broadcasting systems while maintaining compatibility with legacy services.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.19 no.1
• /
• pp.149-155
• /
• 2015

This paper proposes 5-MS/s 10-bit digital-to-analog converter(DAC) with the improved linearity. The proposed DAC consists of a 10-bit R-2R-based DAC, an output buffer using a differential voltage amplifier with rail-to-rail input range, and a band-gap reference circuit for the bias voltage. The linearity of the 10-bit R-2R DAC is improved as the resistor of 2R is implemented by including the turn-on resistance of an inverter for a switch. The output voltage range of the DAC is determined to be $2/3{\times}VDD$ from an rail-to-rail output voltage range of the R-2R DAC using a differential voltage amplifier in the output buffer. The proposed DAC is implemented using a 1-poly 8-metal 130nm CMOS process with 1.2-V supply. The measured dynamic performance of the implemented DAC are the ENOB of 9.4 bit, SNDR of 58 dB, and SFDR of 63 dBc. The measured DNL and INL are less than +/-0.35 LSB. The area and power consumption of DAC are $642.9{\times}366.6{\mu}m^2$ and 2.95 mW, respectively.

• Journal of Korea Multimedia Society
• /
• v.14 no.5
• /
• pp.658-668
• /
• 2011

Over the past decade, the improvement of communications technologies and the rapid spread of www (World Wide Web) have brought on the exponential growth of users using Internet and real time multimedia multicast services like video conferencing, tele-immersive virtual reality, and Internet games. The dense-wavelength division multiplexing (DWDM) networks have been widely accepted as a promising approach to meet the ever-increasing bandwidth demands of Internet users, especially in next generation Internet backbone networks for nation-wide or global coverage. A major challenge in the next generation Internet backbone networks based on DWDM technologies is the resolution of the multicasting RWA (Routing and Wavelength Assignment) problem; given a set of wavelengths in the DWDM network, we set up light-paths by routing and assigning a wavelength for each connection so that the multicast connections are set-upped as many as possible. Finding such optimal multicast connections has been proven to be Non-deterministic Polynomial-time-complete. In this paper, we suggest a new heuristic multicast routing and wavelength assignment method for multicast sessions called DVS-PMIPMR (Differentiated Virtual Source-based Priority Minimum Interference Path Multicast Routing algorithm). We measured the performance of the proposed algorithm in terms of number of wavelength and wavelength channel. The simulation results demonstrate that DVS-PMIPMR algorithm is superior to previous multicast routing algorithms.