• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.25 no.10A
• /
• pp.1473-1479
• /
• 2000

This paper presents the performance evaluation of an adaptive QAM scheme under flat and frequency selective fading channels for indoor wireless communication systems. The QAM modulation is combined with differential encoding and the demodulation process is carried out noncoherently. The adaptation is performed by varying the modulation level of QAM, depending upon received signal strength. The adaptation mechanism allows a 2- or 3-bit increase or decrease at a time, if the channel condition is considered to be significantly good or bad. Simulation results show that the average number of bits per symbol (ABPS) for each symbol block transmitted over a flat fading channel is higher than 5.0 and the BER performance is better than 10^-4 for a SNR value higher than 30 dB. For frequency selective fading channels, an oversampling technique in the receiver was employed. The BER performance obtained for frequency selective fading channels is better than 10^-4 with a SNR value of 40 dB and ABPS is found to be approximately 5.5. Therefore, this scheme is very useful in that it provides both very high bandwidth efficiency and acceptable performance with moderate SNR values over flat and frequency selective fading channels. In addition, this scheme provides reduced receiver complexity by way of noncoherent detection.

• Proceedings of the Korea Committee for Ocean Resources and Engineering Conference
• /
• 2003.05a
• /
• pp.341-344
• /
• 2003

There communicates using tire supersonic waves in tire underwater, that is different from tire ground that use tire propagation. Because using Law frequency to come under tire waves, bandwidth that is able to communicate is very smaller that tire mobile communication of tire ground. Also, The channel environment changes rapidly in tire shallow underwater than tire ground. Due to such a reason, data transmission technic that is able to tire maximum application to restricted bandwidth and tire signal processing technics that is able to conquer tire rapid changes of tire channel environment are being used. Algorithm is used at tire application of these technic has a lot of tire calculating quantity. So this research reveals small bulk and equal performance using one DSP chip and then implements QPSK transmitter, that uses SHARC DSP of Analog Device company, for tire underwater supersonic waves communication rapidly decrease tire calculating quantity.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.13 no.5
• /
• pp.239-247
• /
• 2013

In network based on multi-interface, there are needed channel assignment strategy that reduce interference and improve bandwidth efficiency by assigning each interface to available channels in order to utilize effectively multiple wireless interfaces on each node. MCS protocol had been proposed, which improve capacity and throughput of network by using hybrid assignment. MCS uses as the criterion to assign channel the number of node that use the same channel in contention area. but there have an problem that this information exactly does not reflect actually offered channel load. in this paper, we proposes CAMCS protocol to assign channel by that the channel busy degree to indicate the occupancy rate of channel by nodes as well as the number of nodes that use the same channel in inference area is used as criterion for estimation channel load, and conform performance improvement effect by simulation.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.36 no.5B
• /
• pp.573-581
• /
• 2011

The underwater channel is known to offer poor communications channel. The channel medium is highly absorptive and the transmission bandwidth is limited. In addition, the channel is highly frequency selective; the degree of selectiveness depends on a detailed geometry of the channel. Furthermore, the response changes over time as the channel conditions affecting the response such as water temperature, sea surface wind and salinity are time-varying. The transceiver design to deal with the frequency and time selective channel, therefore, becomes very challenging. It has been known that deep fading at certain specific sub-carriers are detrimental to OFDM systems. To mitigate this negative effect, the proposed coded OFDM system employs an LDPC code based modulation. In this paper, we aim 1) to provide a detailed underwater channel model; 2) to design a robust LDPC coded OFDM system; 3) to test the proposed system under a variety of channel conditions enabled by the channel model.

• The Journal of Korea Robotics Society
• /
• v.12 no.3
• /
• pp.350-355
• /
• 2017

UWB (Ultra Wide Band) refers to a system with a bandwidth of over 500 MHz or a bandwidth of 20% of the center frequency. It is robust against channel fading and has a wide signal bandwidth. Using the IR-UWB based ranging system, it is possible to obtain decimeter-level ranging accuracy. Furthermore, IR-UWB system enables acquisition over glass or cement with high resolution. In recent years, IR-UWB-based ranging chipsets have become cheap and popular, and it has become possible to implement positioning systems of several tens of centimeters. The system can be configured as one-way ranging (OWR) positioning system for fast ranging and TWR (two-way ranging) positioning system for cheap and robust ranging. On the other hand, the ranging based positioning system has a limitation on the number of terminals for localization because it takes time to perform a communication procedure to perform ranging. To overcome this problem, code multiplexing and channel multiplexing are performed. However, errors occur in measurement due to interference between channels and code, multipath, and so on. The measurement filtering is used to reduce the measurement error, but more fundamentally, techniques for removing these measurements should be studied. First, the TWR based positioning was analyzed from a stochastic point of view and the effects of outlier measurements were summarized. The positioning algorithm for analytically identifying and removing single outlier is summarized and extended to three dimensions. Through the simulation, we have verified the algorithm to detect and remove single outliers.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.16 no.3
• /
• pp.2141-2145
• /
• 2015

A new broadcasting signal transmission, which can save its channel bandwidth using compressive sensing(CS), is proposed in this paper. A new compression technique, which uses two dimensional discrete wavelet transform technique, is proposed to get high sparsity of multimedia image. A L1 minimization technique based on orthogonal matching pursuit is also introduced in order to reconstruct the compressed multimedia image. The CS enables us to save the channel bandwidth of wired and wireless broadcasting signal because various transmitted data are compressed using it. A $256{\times}256$ gray-scale image with compression rato of 20 %, which is sampled by 10 Gs/s, was transmitted to an optical receiver through 20-km optical transmission and then was reconstructed successfully using L1 minimization (bit error rate of $10^{-12}$ at the received optical power of -12.2 dB).

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.29 no.10B
• /
• pp.831-840
• /
• 2004

Providing quality of service (QoS) guarantees over wireless link requires thorough understanding and quantification of the interactions among the traffic source, the wireless channel, and the underlying error control mechanisms. In this paper, we account for such interactions in a network-layer model that we use to investigate the delay performance of a wireless channel. We consider a single ON/OFF traffic stream transported over a wireless link. The capacity of this link fluctuates according to a fluid version of Gilbert-Elliot's model. We derive the packet delay distribution via two different approaches: uniformization and Laplace transform. Numerical aspects of both approaches are compared. The delay distribution is further used to quantify the wireless effective bandwidth under a given delay guarantee. Numerical results and simulations are used to verify the adequacy of our analysis and to study the impact of error control and bandwidth allocation on the packet delay performance. Wireless networks, QoS, delay distribution, fluid analysis.

• The Proceeding of the Korean Institute of Electromagnetic Engineering and Science
• /
• v.17 no.2 s.58
• /
• pp.38-49
• /
• 2006

In order to increase the spectrum efficiency, recently, there is the number of studies for CR technology. For instance, IEEE 802.22 WRAN(Wireless Regional Area Network) WG considered the CR technology as a solution of WRAN system to serve the high speed internet service(1.5 Mbps down stream and 384 kbps up stream) in 100 km overall coverage and 54 MHz-746 MHz band. Basically, in MAC point of view, the WRAN system have been standardizing based on the IEEE 802.16 MAC layer features such as Data transmission method, QoS provision and Bandwidth request schemes. Additionally, the WRAN system further include CR nature functions such as incumbent user protection, self coexistence which would be importantly considered. Also, the inherent WRAN functions are added such as channel bonding and fractional bandwidth usage. This paper mainly explained frame structure, IU protection, self coexistence which are key functions of WRAN system. Finally, in this paper, we expressed a prospect of IEEE 802.22 WRAN standardization.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1998.06a
• /
• pp.101-104
• /
• 1998

We report some methods for measuring a LiNbO$_3$ optical phase modulator bandwidth. Since Mach-Zehnder waveguide type, one of methods for modulation bandwidth measurement, is comparatively simple and useful, it was adapted in this work. In order to confirm this method, the waveguide of single and Mach-Zehnder type were fabricated on the same wafer. The Mach-Zehnder interferometric waveguide and the single channel waveguide were used for the measurement of the phase modulator's driving voltage and bandwidth for device fabrications, respectively. Ti-860$\AA$ in-diffusion was achieved in a wet-bubbling oxygen environment at 105$0^{\circ}C$/8hours. LINbO$_3$ internal chips were pigtailed to PMF(polarization maintaining fiber)/SMF(single mode fiber) using an epoxy curing technique. Examined were optical properties such as an insertion loss, propagation loss and mode size, and the loss mechanism of optical coupling between an optical fiber and a waveguide was considered.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.18 no.1 s.116
• /
• pp.53-61
• /
• 2007

This paper researches on the scheme superimposing the rotation phases over the pilot and data symbols in order to reduce the peak-to-average power ratio(PAPR) of the orthogonal frequency division multiplexing(OFDM) communication. The bandwidth and power efficiency are the main consideration. The phases of rotation vector are added to those of both pilot symbols and data symbols interlaying between any two pilot symbols in an OFDM block. Owing to this scheme the transmitter reduces the PAPR using the partial transmit sequences(PTS) and the receiver restores the data symbol utilizing the channel estimation of pilot symbols. Therefore, the bandwidth efficiency is accomplished by not using the further subcarriers for the reduction of PAPR and the enormous increase of bit error rate according to the receiving error of the side information, i.e. the phases of rotation vector, is prevented. In other words, both bandwidth-and power-efficiency and quality of communication performance can be improved.