• Journal of Climate Change Research
• /
• v.6 no.1
• /
• pp.33-40
• /
• 2015

Forests are to be recognized as an important carbon sink under the UNFCCC that consist of above- and below-biomass, dead organic matter (DOM) such as dead wood and litter, and soil organic matter (SOM). In order to asses for DOM and SOM, however, it is relevant to land-use change matrices over last 20 years for each land-use category. In this study, a land-use change matrix was produced and its uncertainty was assessed using a point sampling technique with permanent sample plots in national forest inventory at Chungbuk province. With point sampling estimated areas at 2012 year for each land-use category were significantly similar to the true areas by given six land-use categories. Relative standard error in terms of uncertainty of land-use change among land-use categories ranged in 4.3~44.4%, excluding the other land. Forest and cropland covered relatively large areas showed lower uncertainty compared to the other land-use categories. This result showed that selected permanent samples in the NFI are able to support for producing land-use change matrix at a national or province level. If the $6^{th}$ NFI data are fully collected, the uncertainty of estimated area should be improved.

• Proceedings of the Korean Statistical Society Conference
• /
• 2005.05a
• /
• pp.191-196
• /
• 2005

Knowing the time of the process change could lead to quicker identification of the responsible special cause and less process down time, and it could help to reduce the probability of incorrectly identifying the special cause. In this paper, we propose a MLE of the process change point when control charts with the fixed sampling rate (FSR) scheme or the variable sampling rate (VSR) scheme monitor a process to detect changes in the process mean and/or variance of a normal quality variable.

• Journal of Korea Water Resources Association
• /
• v.47 no.8
• /
• pp.671-684
• /
• 2014

Change point analysis is a efficient tool to understand the fundamental information in hydro-meteorological data such as rainfall, discharge, temperature etc. Especially, this fundamental information to change points to future rainfall data identified by reasonable detection skills can affect the prediction of flood and drought occurrence because well detected change points provide a key to resolve the non-stationary or inhomogeneous problem by climate change. Therefore, in this study, the comparative study to assess the performance of the 3 change point detection skills, cumulative sum (CUSUM) method, Bayesian change point (BCP) method, and segmentation by dynamic programming (DP) was performed. After assessment of the performance of the proposed detection skills using the 3 types of the synthetic series, the 2 reasonable detection skills were applied to the observed and future rainfall data at the 5 rainfall gauges in South Korea. Finally, it was suggested that BCP (with 0.9 posterior probability) could be best detection skill and DP could be reasonably recommended through the comparative study. Also it was suggested that BCP (with 0.9 posterior probability) and DP detection skills to find some change points could be reasonable at the North-eastern part in South Korea. In future, the results in this study can be efficiently used to resolve the non-stationary problems in hydrological modeling considering inhomogeneity or nonstationarity.

• Journal of Korean Clinical Nursing Research
• /
• v.19 no.2
• /
• pp.245-254
• /
• 2013

Purpose: This study was done to examine predictive validity of Critical Care Non-verbal Pain Scale (CNPS) and develop criteria for pain assessment using CNPS with critically ill patients who have communication problems. Methods: Data were collected from intensive care units at three major general hospitals in Seoul and Kyunggi province. During each observation, a nurse assessed pain severity using CNPS ratings (range 0-9) at four treatment stages: at rest, during central catheter dressing change (nonpainful procedure), position change and suctioning (routine painful procedures). Patients also assessed their pain using a self-report 4-point VRS-4. Results: There were significant differences between the four treatment stages except between "at rest" and "nonpainful procedure". Strong correlations were found between CNPS and VRS-4 for "at rest" (r=.552, p<.001), central catheter dressing change (r=.505, p<.001), position change (r=.709, p<.001), and suctioning (r=.662, p<.001). ROC curve analysis of CNPS based on 3 point on VRS-4 showed the cutoff point was 3 for CNPS, the starting point for pain management with 73% sensitivity, 92.2% specificity, 73% positive predictive value, and 92.8% negative predictive value. Conclusion: Results indicate that CNPS is a valid tool for measuring pain in critically ill patients with communication problems and 3 point should be the standardized pain treatment point.

• Proceedings of the KIEE Conference
• /
• 2006.04a
• /
• pp.15-17
• /
• 2006

This paper presents a new global intensity compensation method for extracting moving object in a visual surveillance system by compensating time variant intensity changes of background region. The method that compensates a little changes of intensity due to time variant illumination change and automatic gain control of camera is called global intensity compensation. The proposed method expresses global intensity change with a mapping table to describe complex form of intensity change while the previous method models this global intensity change with a simple function as a straight line. The proposed method builds the mapping table by calculating the cross histogram between two images and then by selecting an initial point for generating the mapping table by using Hough transform applied to the cross histogram image. Then starting from the initial point, the mapping table is generated according to the proposed algorithm based on the assumption that reflects the characteristic of global intensity change. Experimental results show that the proposed method makes the compensation error much smaller than the previous GIC method

• The Transactions of the Korean Institute of Power Electronics
• /
• v.17 no.3
• /
• pp.205-212
• /
• 2012

This paper proposes the fuzzy logic based variable step-size MPPT (Maximum Power Point Tracking) method for the stability at the steady state and the improvement of the transient response in the wind power system. If the change value of duty ratio is set on stability of the steady state, MPPT control traces to maximum power point slowly. And if the change value is set on improvement of the transient response, the system output oscillates at the maximum power point. By adjusting the step size with fuzzy logic, it can be improved the MPPT response speed and stability at steady state when MPPT control is performed to track the maximum power point. The effectiveness of the proposed method has been verified by simulations and experimental results.

• Proceedings of the IEEK Conference
• /
• 2003.07e
• /
• pp.2032-2035
• /
• 2003

This paper focused on the possibility of face recognition using Flexible let Point Setting method in Gabor Filter Based Face Recognition. Gabor Filter is very sensible to the Texture variation. Therefore, any little change in the face expression or rotation of posture make recognition rate down significantly. A suggested solution for this problem is the Flexible Jet Point Setting. A significant effect of this method is that the number of Jet Point has been reduced from over 150 to under 30 even though the change of recognition rate between two methods is neglectable, Furthermore a set of feature values which results from a set of Gabor filtering became insensible to face variation such as expression, rotation, and light effect. Retinex Algorithm which has been developed by NASA are used as pre-processing.

• Journal of Forest and Environmental Science
• /
• v.33 no.4
• /
• pp.295-304
• /
• 2017

This study compared and analyzed the construction of a land use change matrix for the Intergovernmental Panel on Climate Change's (IPCC) land use, land use change, and forestry area (LULUCF). We used National Forest Inventory (NFI) permanent sample plots (with a sample intensity of 4 km) and permanent sample plots with 500 m sampling intensity. The land use change matrix was formed using the point sampling method, Level-2 Land Cover Maps, and forest aerial photographs (3rd and 4th series). The land use change matrix using the land cover map indicated that the annual change in area was the highest for forests and cropland; the cropland area decreased over time. We evaluated the uncertainty of the land use change matrix. Our results indicated that the forest land use, which had the most sampling, had the lowest uncertainty, while the grassland and wetlands had the highest uncertainty and the least sampling. The uncertainty was higher for the 4 km sampling intensity than for the 500 m sampling intensity, which indicates the importance of selecting the appropriate sample size when constructing a national land use change matrix.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.14 no.3
• /
• pp.9-23
• /
• 2015

A lane change maneuver which has a high driver cognitive workload and skills sometimes leads to severe traffic accidents. In this study, the Advanced Lane Change Assist System (ALCAS) was developed to assist with the automatic lane changes in merging sections which is mainly based on an automatic control algorithm for detecting an available gap, determining the Optimal Lane Change Start Point (OLCSP) in various traffic conditions, and positioning the merging vehicle at the OLCSP safely by longitudinal automatic controlling. The analysis of lane change behavior and modeling of fundamental lane change feature were performed for determining the default parameters and the boundary conditions of the algorithm. The algorithm was composed of six steps with closed-loop. In order to confirm the algorithm performance, numerical scenario tests were performed in various surrounding vehicles conditions. Moreover, feasibility of the developed system was verified in microscopic traffic simulation(VISSIM 5.3 version). The results showed that merging vehicles using the system had a tendency to find the OLCSP readily and precisely, so improved merging performance was observed when the system was applied. The system is also effective even during increases in vehicle volume of the mainline.

• Proceedings of the Korean Operations and Management Science Society Conference
• /
• 2006.05a
• /
• pp.1214-1220
• /
• 2006

In this article, it will be shown that a nonparametric and data-adaptive approach to the variance change point (VCP) detection problem is possible by formulating it as a pattern classification problem. Technical aspects of the VCP detector are discussed, which include its training strategy and selection of proper classification tool.