• Korean Chemical Engineering Research
• /
• v.60 no.1
• /
• pp.159-168
• /
• 2022

Catalytic activity in ammonia decomposition reaction was studied on Mo-Al nitride obtained through temperature programmed nitridation of calcined Mo-Al mixed oxide prepared by varying the MoO₃ quantity in the range of 10-50 wt%. N₂ sorption analysis, X-ray diffraction analysis (XRD), X-ray photoelectron spectroscopy (XPS) and H₂-temperature programmed reduction (H₂-TPR), and transmission electron microscopy (TEM) to investigate the physicochemical properties of the prepared catalyst were performed. After calcination at 600 ℃, the XRD of Mo-Al oxide showed γ-Al₂O₃ and Al₂(MoO₄)₃ phases, and the nitride after nitridation showed an amorphous form. The specific surface area after nitridation by topotactic transformation of MoO₃ to nitride was increased due to the formation of Mo nitride, and the Mo nitride was observed to be supported on γ-Al₂O₃. As for the catalytic activity in the ammonia decomposition reaction, 40 wt% MoO₃ showed the best activity, and as the nitridation time increases, the activity increased, and thus the activation energy decreased.

• Applied Biological Chemistry
• /
• v.2
• /
• pp.45-52
• /
• 1961

The decomposition of malathion in dust for mulations prepared from four Korean tales as carriers during storage period has been studied. Amberlite CG-120, a cation exchange resin . which has higher cation exchange capacity than tales, was also used as a carrier in hope of finding out the effect of nagative charge upon the decomposition of malathion. Besides the original talc powders obtained directly from the mines, the hydrogen ion saturated forms were also used as carriers for comparisonal study. The saturated ions for the resin were hydrogen, sodium and magnesium. As the physical properties of the tales, colloid content, water adsorption capacity, PH, specific surface, phosphate fixing capacity and exchangeable canons were determined, and these properties were correlated with the amount of the decomposition. Following results were obtained from the experiment. 1. The malathion in the talc in dust was found to decompose around 10-15% ofthe total withina month. About 50% of the decom position that took place after a month was found to occur within a week. 2. The resin which has higher cation exchange capacity than the tales was highly effective in the decomposition of malathion compared with the tales. 3. In every case the saturation of the exchange complexes with hydrogen ion greatly accelerated the decomposition of malathion. 4. The most highly correlated physical properties with the decomposition were colloid content and specific surface of the tales. 5. The water adsorption and phosphate fixing capacities of the tales were found not to correlate with the amount of malathion decomposed. From the experimental results it was concluded that the active negative spots on the colloidal tales or the resin attract the electropositive phosphorus atom in a malathion molecule thereby inducing the decomposition easier. The presence of hydrogen ion nearby might cause a catalytic effect in the decomposition of malathion.

• Transactions of the Korean hydrogen and new energy society
• /
• v.23 no.1
• /
• pp.1-7
• /
• 2012

This study was performed to develop a low Pt content catalyst as a catalyst for HI decomposition in S-I process. Bimetallic catalysts added various amounts of Pt on a silica supported Ni catalyst were prepared by impregnation method. HI decomposition was carried out using a fixed bed reactor. As a result, Ni-Pt bimetallic catalyst showed enhanced catalytic activity compared with each monometallic catalyst. Deactivation of Ni-Pt catalyst was not observed while deactivation of Ni monometallic catalyst was rapidly occurred in HI decomposition. The HI conversion of Ni-Pt bimetallic catalyst was increased similar to Pt catalyst with increase of the reaction temperature over a temperature range 573K to 773K. From the TG analysis, it was shown that $NiI_2$ remained on the Ni(5.0)-Pt(0.5)/$SiO_2$ catalyst after the HI decomposition reaction was decomposed below 700K. It seems that small amount of Pt in bimetallic catalyst increase the decomposition of $NiI_2$ generated after the decomposition of HI. Consequently, it was considered that the activity of Ni-Pt bimetallic catalyst was kept during the HI decomposition reaction.

• Journal of Korean Society of Environmental Engineers
• /
• v.22 no.11
• /
• pp.2077-2083
• /
• 2000

For the application of wet air oxidation(WAO) process reactive dyes, remazol blacks has been selected as the subject for this study. The rate of decomposition relating to the reaction temperature and catalyst has been summarized during the catalytic wet air oxidation reaction. When 1.5 gram per liter of platinum is added titanium-dioxide and the partial pressure is adjusted to 6 atmosphere at the reaction temperature exceeding $200^{\circ}C$, more than 95% of the remazol blacks dyes were decomposed. When the reaction temperature was raised to $200^{\circ}C$, $220^{\circ}C$ and $250^{\circ}C$, respectively, for 240 minutes after adding the catalyst, the remaining rate of ultraviolet absorbance had dropped significantly to 18%, 12%, and 4%. At the reaction temperature of $250^{\circ}C$, color removal efficiency was approximately 95% or more after 120 minutes from the beginning of the reaction.

• Journal of Korean Society for Atmospheric Environment
• /
• v.33 no.6
• /
• pp.605-615
• /
• 2017

Efficient simultaneous reduction conditions for $NO_x$ and $NH_3$-slip was investigated in SCR (Selective Catalytic Reduction) process with load variation by applying dual catalysts (SCR catalyst, $NH_3$ decomposition catalyst) system. $N_2O$ formation characteristics were analyzed to look into possible undesirable reaction pathways. In the experiments of catalyst characteristics, various operational variables were tested for the combined catalytic system, such as $NH_3/NO_x$ ratio, temperature, oxygen concentration and $H_2O$. The reaction characteristics of $NO_x$, $NH_3$ and $N_2O$ were analyzed and optimal conditions could be evaluated for the combustion facility with varied load. In terms of $NO_x/NH_3$ simultaneous reduction and $N_2O$ formation suppression, optimal condition was considered NSR 1.2 and temperature $300^{\circ}C$. At this operational condition, $NO_x$ conversion was 98%, $NH_3$ reduction efficiency was 95%, generated $N_2O$ concentration 9.5 ppm with inlet $NO_x$ concentration of 100 ppm. In $NH_3-SCR$ process with $NH_3$ decomposition catalyst, $NO_x$ and $NH_3$ can be considered to be reduced simultaneously at limited conditions. The results of this study may be utilized as basic data at facilities requiring simultaneous $NO_x$ and $NH_3$ reduction for facilities with load variation.

• Journal of Powder Materials
• /
• v.8 no.3
• /
• pp.163-167
• /
• 2001

A bulk porous $CaZrO_3/MgO$ composite with plantinum nano-dispersion was synthesized in air atmosphere through the combination of several in situ reactions, including the pyrolysis of $PtO_2$. A mixture of $CaMg(CO_3)_2$(dolomite), $ZrO_2$, $PtO_2$ and LiF (0.5 wt%, as an additive) was cold isostatically pressed at 200 MPa and sintered at $1100^{\circ}C$ for 2 h. The porous $CaZrO_3/MgO/Pt$ composite ($CaZrO_3/MgO$ : Pt=99 : 1 in volume) had a uniformly open-porous structure (porosity: 56%) with three-dimensional (3-D) network and a narrow pore-size distribution, similarly to the porous $CaZrO_3/MgO$ composites reported before. Catalytic Properties (viz., NO direct decomposition and NO reduction by $C_2H_4$) of the $CaZrO_3/MgO/Pt$ composite were investigated up to $900^{\circ}C$. In the absence of oxygen, the NO conversion rate reached ~52% for the direct decomposition and ~100% for the reduction by $C_2H_4$, respectively. The results suggest the possibility of the porous composite as a multifunctional filter, i.e., simultaneous hot gas-filtering and $de-NO_x$ in one component.

• Korean Chemical Engineering Research
• /
• v.45 no.3
• /
• pp.215-218
• /
• 2007

The aim of this study is to test the feasibility of Pt/Al-MCM-41 for the dioxin decomposition reaction. For model reaction, 1,2-dichlorobenzene was decomposed instead of dioxin. $Pt/{\gamma}-Al_2O_3$ was compared with Pt/Al-MCM-41. Al-MCM-41 catlaysts were prepared by post grafting method and the Pt/Al-MCM-41 catalysts with Si/Al = 15, 30 showed higher catalytic activity than $Pt/{\gamma}-Al_2O_3$. Their higher catalytic activities were related with acid amounts. Especially Al-MCM-41 with ion exchanged with $H^+$ enhanced catalytic activity.

• Carbon letters
• /
• v.13 no.2
• /
• pp.99-108
• /
• 2012

The sol-gel technique has been studied to fabricate a homogeneous Fe-Mo/MgO catalyst. Ambient effects (air, Ar, and $H_2$) on thermal decomposition of the citrate precursor have been systematically investigated to fabricate an Fe-Mo/MgO catalyst. Severe agglomeration of metal catalyst was observed under thermal decomposition of citrate precursor in air atmosphere. Ar/$H_2$ atmosphere effectively restricted agglomeration of bimetallic catalyst and formation of highly-dispersed Fe-Mo/MgO catalyst with high specific surface-area due to the formation of Fe-Mo nanoclusters within MgO support. High-quality thin-multiwalled carbon nanotubes (t-MWCNTs) with uniform diameters were achieved on a large scale by catalytic decomposition of methane over Fe-Mo/MgO catalyst prepared under Ar-atmosphere. The produced t-MWCNTs had outer diameters in the range of 4-8 nm (average diameter ~6.6 nm) and wall numbers in the range of 4-7 graphenes. The as-synthesized t-MWCNTs showed product yields over 450% relative to the utilized Fe-Mo/MgO catalyst, and indicated a purity of about 85%.

• Proceedings of the Korean Society of Propulsion Engineers Conference
• /
• 2010.05a
• /
• pp.373-376
• /
• 2010

The characteristics of thermal-resistance catalyst for $N_2O$ propellant decomposition were studied in the present study. Si was added to the $Al_2O_3$ support to stabilize its surface area at high temperature (> $1000^{\circ}C$). Ru was used as a catalyst for $N_2O$ decomposition. The prepared catalysts were characterized using SEM, EDS and XRD analysis, and $N_2O$ conversion was measured as reaction temperatures. The Ru/$Al_2O_3$-Si catalyst showed better performance than Ru/$Al_2O_3$ catalyst.

• Transactions of the Korean hydrogen and new energy society
• /
• v.30 no.1
• /
• pp.1-7
• /
• 2019

The preparation and catalytic activities of various transition metal carbide crystallites (VC, MoC, WC) were examined in this study. In particular, the effect of different kinds of transition metal crystallites were scrutinized on the ammonia decomposition reaction. The experimental results showed that BET surface areas ranged from $8.3m^2/g$ to $36.3m^2/g$ and oxygen uptake values varied from $9.1{\mu}mol/g$ to $25.4{\mu}mol/g$. Amongst prepared transition metal carbide crystallites, tungsten compounds (WC) were observed to be most active for ammonia decomposition reaction. The main reason for these results were considered to be related to the extent of electronegativity between these materials. Most of transition metal carbide crystallites were exceeded by Pt/C crystallite. However, the steady state reactivities for some of transition metal carbide crystallites (WC) were comparable to or even higher than that determined for the Pt/C crystallite.