• Analytical Science and Technology
• /
• v.35 no.6
• /
• pp.249-255
• /
• 2022

In this study, a new method for the analysis of high-purity nitrogen was developed. A gas chromatography-flame ionization detector (GC-FID) was used for purity analysis. Certified reference materials (CRMs) at a level of 3 µmol/mol of carbon monoxide (CO), carbon dioxide (CO₂), and methane (CH₄), which may exist in high-purity nitrogen, were prepared using the gravimetric method, and these CRMs were used for purity analysis. In this new method, ultra-high-purity and high-purity nitrogen were used as carrier gases. The impurities in high-purity nitrogen were quantitatively analyzed by comparing the differences in the area values of the GC chromatograms of the prepared CRMs. We purchased liquid nitrogen and three bottles of nitrogen gas, which were produced by three different manufacturers, using high-purity nitrogen. Furthermore, to validate the developed purity analysis method, the fraction of impurities in high-purity nitrogen was compared with the results of the typical purity analysis method. The comparison results were consistent within the expanded uncertainties (k = 2).

• Journal of the Korean Solar Energy Society
• /
• v.30 no.3
• /
• pp.33-38
• /
• 2010

The evaporative desalination system using solar thermal energy would be the efficient and attractive method to get fresh water from brine due to low carbon dioxide generation. In this research the solar desalination system as a heating source of refrigerant R123 in the evaporator was considered. The circulation of refrigerant in the evaporator can reduce the energy consumption of the system, because of using the latent heat of the refrigerant 123 instead of the sensible heat of present hot water. The system was comprised of the single-stage fresh water production unit on the capacity of 1ton/day with shell and tube type evaporator, heaters instead of solar collector to supply the proper heat to refrigerant, and refrigerant and brine circulation systems. Various operating flowrate and temperature ranges were varied in the experiments to get the optimum design data. The results showed that the optimum flow rate of brine feed rate to evaporator was 1.2Liter/min, and the yield of fresh water was increased as higher temperature of feed brine. It was confirmed that the circulation flowrate of heating source of refrigerant was decrease of one fifth of the present warm water system, and very efficient system for solar desalination.

• Structural Engineering and Mechanics
• /
• v.50 no.3
• /
• pp.257-273
• /
• 2014

This paper introduces a novel optimization technique based on gravitational search algorithm (GSA) for numerical optimization and multi-objective optimization of foundation. In the proposed method, a chaotic time varying system is applied into the position updating equation to increase the global exploration ability and accurate local exploitation of the original algorithm. The new algorithm called global-local GSA (GLGSA) is applied for optimization of some well-known mathematical benchmark functions as well as two design examples of spread foundation. In the foundation optimization, two objective functions include total cost and $CO_2$ emissions of the foundation subjected to geotechnical and structural requirements are considered. From environmental point of view, minimization of embedded $CO_2$ emissions that quantifies the total amount of carbon dioxide emissions resulting from the use of materials seems necessary to include in the design criteria. The experimental results demonstrate that, the proposed GLGSA remarkably improves the accuracy, stability and efficiency of the original algorithm.

• Journal of the East Asian Society of Dietary Life
• /
• v.13 no.6
• /
• pp.593-600
• /
• 2003

This study was carried out in order to investigate the possibility of frozen rice batter for the manufacturing of Jeung-pyun. Despite of its unique taste and texture, Jeung-pyun is not consumed much because it needs long time to make. The physicochemical, sensory, rheological and surface characteristics of Jeung-pyun were analyzed to develop the easy manufacture method. The storage condition of rice batter was used at -2$0^{\circ}C$ up to 4 weeks. Statistical data analysis was completed using a SAS program. The results are summarized as follow: The pH brix% and sugar content of all samples which added low-temperature tolerance raw yeast or regular raw yeast decreased during the fermentation. Kind of yeast did not influence on the moisture content of the Jeung-pyun batter. Specific volume and carbon dioxide evolution of Jeung-pyun batter were highest when the rice batter was frozen for 1 week regardless of the kind of yeast. Overall quality of frozen batter of Jeung-pyim at -2$0^{\circ}C$ for 4 weeks had the highest score among different samples. As the test results of mechanical characteristics, cohesiveness, gumminess, brittleness, hardness and springiness did not show any significant differences statistically. The result clearly suggests that freezing the rice batter is a possibile way to manufacture Jeung-pyun.

• Proceedings of the Korean Institute of Building Construction Conference
• /
• 2015.11a
• /
• pp.13-14
• /
• 2015

Carbonation is the results of the interaction of carbon dioxide gas in the atmosphere with the alkaline hydroxides in the concrete. in other words, of the hydrates in the cement pastes, the one which reacts with readily is Ca(OH)₂, the product of the reaction being CaCO₃ and which decreases the alkalinity of concrete. Consequently, RC structure is deteriorated due to steel corrosion in concrete. As the importance of maintenance of reinforced concrete structure recently has emerged, the attention of durability of structure has been increasing. There are many studies about durability decline especially due to the carbonation. In order to study carbonation progress after surface repair of carbonated concrete, each carbonation penetration velocity from different repair materials of concrete structure is compared through the experiment of carbonation accelerating CO₂ concentration to 100%. As carbonation infiltration progress is predicted through this study, the counterplan of service life evaluation will be prepared on selection of repair materials of concrete structure.

• Advances in concrete construction
• /
• v.9 no.3
• /
• pp.279-287
• /
• 2020

This paper focuses on the engineering properties of Bentonite-Cement-Sodium silicate (BCS) grout, which was prepared by partially replacing the ordinary Portland cement in Cement-Sodium silicate grout with lithium bentonite (Li-bent) and sodium bentonite (Na-bent), respectively. The effect of different Water-to-Solid ratio (W/S) and various replacement percentages of bentonite on the apparent viscosity, bleeding, setting time, and early compressive strength of BCS grout were investigated. The XRD method was used to detect its hydration products. The results showed that both bentonites played a positive role in the stability of BCS grout, increased its apparent viscosity. Na-bent prolonged the setting time of BCS, while 5% of Li-bent shortened the setting time of BCS. The XRD analysis indicated that the hydration products between the mixture containing Na-bent and Li-bent did not differ much. Using bentonite as supplementary cementitious material (SCM) to replace partial cement is a promising way to cut down on carbon dioxide emissions and to produce low-cost, eco-friendly, non-toxic, and water-resistant grout. In addition, Li-bent was superior to Na-bent in improving the strength and the thickening of BCS grouts.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2016.02a
• /
• pp.156.1-156.1
• /
• 2016

Nickel sulfide (NiS) is one of the most promising candidates as an electrode material for supercapacitors due to its good capacitive properties, high electrical conductivity and low cost. In addition to the development of the new electrode materials, nanostructuring the electrode surface is one of the main issues in enhancing the capacitive performance of the supercapacitors because the increased surface area can improve the charge transfer and energy storage processes occurring at the electrode surface. However, most nanofabrication techniques require complicated and delicate nanoprocesses, and hence are not suitable for practical use. In this work, we developed a simple method to fabricate nanostructured NiS electrodes by depositing NiS onto $TiO_2$ nanoparticles. First, $TiO_2$ nanoparticles were spin-coated on a fluorine-doped tin oxide (FTO) substrate, and then NiS layers were deposited onto the $TiO_2$ nanoparticles by consecutive dip-coatings in the solutions containing nickel and sulfur precursors. This nanostructured NiS electrode showed significantly improved capacitive properties compared to the electrode of NiS films deposited without $TiO_2$ nanoparticles. The asymmetric full-cell supercapacitor with this nanostructured NiS electrode and activated carbon electrode was also fabricated and investigated.

• Journal of Korean Society for Atmospheric Environment
• /
• v.21 no.5
• /
• pp.507-513
• /
• 2005

Increasing amounts of anthropogenic $CO_2$ emitted to the atmosphere are believed to be a significant factor in global climate change. Hence, the method of chemical absorption has been suggested to separate and recover acid gases such as $CO_2$. In this study, the characteristics of absorption and regeneration of $CO_2$ for the absorbent which adding HMDA (hexamethylenediamine) into AMP (2-amino-2-methyl-1-propanol), hindered amine, was investigated in lab-scale absorption/regeneration reactor. As a result of this study, the removal efficiency of $CO_2$ increased when adding $5.9\%,\;11.7\%\;and\;23.4\%$ HMDA into $30\%$ AMP respectively. Also, the removal efficiency of $CO_2$ increased $6.5\%,\;8.4\%,\;10.3\%$ respectively as compared to AMP alone when the gas flow rate was 7.5 SL/min. In addition, all absorbents used in the study revealed the high stripping efficiency, which was almost $99\%$, at the temperature of $110^{\circ}C$. Thus, the regeneration tower should be operated at $110^{\circ}C$. At this time, the concentration of exhausted $CO_2$ was higher than $99\%$.

• 한국신재생에너지학회:학술대회논문집
• /
• 2008.05a
• /
• pp.568-571
• /
• 2008

A novel self-humidifying composite membrane for the proton exchange membrane fuel cell (PEMFC) at low humidity condition was developed. The Pt/$TiO_2$ catalyst particles were synthesized via supercritical impregnation methods. Pt precursor was dissolved in supercritical carbon dioxide and impregnated onto $TiO_2$ particles. Pt precursors were platinum(II) acetylacetonate, Dimethyl(1,5-cyclooctadiene) platinum(II) and we controlled the ratio of Pt to $TiO_2$. The impregnated Pt precursor was converted to $TiO_2$ supported Pt nanoparticle under various reducing conditions. Pt/$TiO_2$ catalyst particles were dispersed uniformly into the Nafion solution, and then Pt/$TiO_2$/Nafion composite membrane was prepared using solution-cast method. The self-humidifying composite membrane could minimize membrane conductivity loss under dry conditions due to the presence of catalyst and hydrophilic Pt/$TiO_2$ particles. To optimize the performance of MEA, amount of ionomer loading was controlled. And mixed catalysts were used. The cell performance of MEA was obviously improved under dry conditions at $65^{\circ}C$.

• Journal of the Korean Society of Food Culture
• /
• v.8 no.4
• /
• pp.331-335
• /
• 1993

This study was performed to improved the quality of dried persimmon. For this, the investigation of quality factor and processing experiments were performed. The moisture contents of dried persimmons were 30 to 36% and it was the most important component of the quality. Tannin contents were 0 to 20% and non-treated persimmon had higher tannin contents than treatment of carbon dioxide and alcohol. Total sugar contents were 55 to 60% and it was composed in glucose and fructose. Processing of dried persimmon by artificial-drying seemed to be useful when it needed to shorten the drying time or it continued rainy day during sun-drying. From the result of quality evaluation, sliced dried persimmon was better than whole dried persimmon in quality, so the sliced dried persimmon was expected that it has a little marketability.