• Proceedings of the KIPE Conference
• /
• 2020.08a
• /
• pp.154-156
• /
• 2020

전기제품의 대기전력을 0.005W 미만으로 구현 할 수 있는 새로운 스위칭 제어 방법을 본 논문에서 제시하며 최소한의 소비전력을 구현하면서 제품의 기능을 유지 할 수 있는 방안에 대한 결과를 설명한다. 또한 실제 상용화되는 모니터에서의 동작원리를 설명하고 구현된 동작 특성을 바탕으로 제안한 회로의 동작원리 및 대기전력 수준을 검증한다.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.10 no.1
• /
• pp.99-108
• /
• 1999

In this paper, we propose $\pi$/4 QPSK scheme with block modulation algorithm, which can reduce preamble in order to transmit ATM cell efficiently in the uplink channel of LMDS, and also designed a new carrier recovery circuit which can improve carrier synchronization performance of block demodulation algorithm. The $\pi$/4 QPSK scheme employing the proposed block modulation algorithm achieved efficient frame transmission by making use of a few preamble when carrier synchronization, symbol timing synchronization and slot timing synchronization were performed by burst data of ATM cell in LMDS environment. For performance evaluation of the proposed method, a simulation analyzing the variation of carrier synchronization, symbol timing synchronization and slot timing synchronization using LMDS environment and burst mode condition was executed. In the simulation, the proposed method showed a good performance even though the reduced preamble as a few aspossible when carrier synchronization, symbol timing synchronization and slot timing synchronization is performed.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.18 no.10
• /
• pp.1181-1188
• /
• 2007

This paper presents the measured signal performances in the urban environment for the DVB-H parameters such as code rate, burst size, FFT mode and modulation technique to analyze the DVB-H signal performance avaible for the embodiment of single frequency network to improve the frequency efficiency. Measurements were performed for the case for applying and non-applying MPE-FEC technique simultaneously. Results show that the most outstanding performance are found in the case of QPSK modulation, 1/2 code rate, 2 k FFT mode and 512 burst size. In addition, the signal performance by the SFN with 1/8 guard interval becomes superiour in comparision with the measured data from each site and the data from SFN with 1/32 guard interval. The analysis of the results can be instructive for the improvement of the signal performance and broadcasting quality for the terrestrial digital mobile broadcasting service.

• Journal of Advanced Navigation Technology
• /
• v.9 no.2
• /
• pp.156-163
• /
• 2005

In this paper, we analyzed the performance of VDL mode 3 system model whose specification is defined by ICAO(International Civil Aviation Organization). For performance evaluation, we obtained BER(Bit Error Rate), transmission delay time, burst retransmission rate and throughput. From the analysis result, we could explicitly define relationships among BER, transmission delay time, throughput and burst restransmission rate. In addition, it became known that V/D retransmission rate and throughput are closely related in down link channel.

• ETRI Journal
• /
• v.35 no.2
• /
• pp.245-252
• /
• 2013

In this work, we study the physical layer solutions for 10-gigabit-capable passive optical networks (PONs), particularly for an optical link terminal (OLT) including a 10-Gbit/s electroabsorption modulated laser (EML) and a 2.5-Gbit/s burst mode receiver (BM-Rx) in a novel bidirectional optical subassembly (BOSA). As unique features, a bidirectional mini-flat package and a 9-pin TO package are developed for a 10-gigabit-capable PON OLT BOSA composed of a 1,577-nm EML and a 1,270-nm avalanche photodiode BM-Rx, including a single-chip burst mode integrated circuit that is integrated with a transimpedance and limiting amplifier. In the developed prototype, the 10-Gbit/s transmitter and 2.5-Gbit/s receiver characteristics are evaluated and compared with the physical media dependent (PMD) specifications in ITU-T G.987.2 for XG-PON1. By conducting the 10-Gbit/s downstream and 2.5-Gbit/s upstream transmission experiments, we verify that the developed 10-gigabitcapable PON PMD prototype can operate for extended network coverage of up to a 40-km fiber reach.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.29 no.4A
• /
• pp.390-398
• /
• 2004

This paper describes a study on the automatic generation system of the interface for communication among AMBA bus and IPs with different protocols. Employing an extended STG, the proposed system generates the interface modules required for the communication among IPs with different protocols. For an example system, the interface module for communication between AMBA AHB bus and a video decoder has been generated and verified in its functionality. The area and latency have been compared with the manually designed interface. For burst-mode communication, the generated interface module shows the comparable performance with the manually designed module. For single-mode communication, the generated interface module shows a slightly worse performance than the manually designed module. However, the increased area is negligible considering the size of the IP.

• ETRI Journal
• /
• v.34 no.3
• /
• pp.352-360
• /
• 2012

This paper proposes a low-cost, low-power, and high-capacity optical-electrical-optical-type reach extender that can provide 3R frame regeneration and remote management to increase the reach and split ratio with no change to a legacy time division multiple access passive optical network. To provide remote management, the extender gathers information regarding optical transceivers and link status per port and then transmits to a service provider using a simple network management protocol agent. The extender can also apply to an Ethernet passive optical network (E-PON) or a gigabit-capable PON (G-PON) by remote control. In a G-PON, in particular, it can provide burst mode signal retiming and burst-to-continuous mode conversion at the upstream path through a G-PON transmission convergence frame adaptor. Our proposed reach extender is based on the quad-port architecture for cost-effective design and can accommodate both the physical reach of 60 km and the 512 split ratios in a G-PON and the physical reach of 80 km and the 256 split ratios in an E-PON.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.27 no.10C
• /
• pp.945-950
• /
• 2002

In this paper the performance evaluations on Asynchronous Transfer Mode(ATM) access node are performed in the ATM access network which consists of access node and channel. The performance factors of access node are Cell Loss Ratio(CLR), buffer capacity and delay time. Both the ATM cell-scale queueing model and burst-scale queueing model are considered as the traffic model of access node for various traffic types such as Constant Bit Rate(CBR), Variable Bit Rate(VBR) and random traffic in the ATM access networks. Based on these situations, the relation of CLR, buffer capacity and delay time is analyzed in the ATM access node.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.28 no.3
• /
• pp.195-207
• /
• 2017

Recently, the SAR-GMTI mode is becoming increasingly essential in airborne radar systems. While SAR requires wideband waveforms for high resolution imaging, GMTI requires narrowband waveforms for doppler processing, which makes general LFM waveforms difficult to use for SAR-GMTI. This paper analyses the FJB(Frequency Jump Burst) waveform, which is studied for the SAR-GMTI waveform, and presents the method for the pulse compression and SAR image formation using FJB waveforms. Simulation results show that there is little difference in performances between the FJB waveform and the LFM waveform.

• International Journal of Contents
• /
• v.11 no.1
• /
• pp.7-14
• /
• 2015

In this paper, we derive the outage probability for M-ary phase shifting keying (MPSK) and M-ary quadrature amplitude modulation (MQAM) burst transmission (BT) of adaptive decode-and-forward (ADF) cooperative relay systems over quasi-static Rayleigh fading channels. Within a burst, there are pilot symbols and data symbols. Pilot symbols are used for channel estimation schemes and each relay node's transmission mode selection schemes. At first, we focus on ADF relay systems in which the probability density function (PDF) is derived on the basis of error events at relay nodes corresponding to channel estimation errors. Next, the average outage probability is derived as an approximate expression for an arbitrary link signal-to-noise ratio (SNR) for different modulation orders. Its accuracy is demonstrated by comparison with simulation results. Further, it is confirmed that BT-ADF relay systems with pilot symbol based channel estimation schemes enables to select correctly decoded relay nodes without additional signaling between relay nodes and the destination node, and it is verified that the ideal performance is achieved with small SNR loss.