• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• v.9 no.2
• /
• pp.899-902
• /
• 2005

Pipeline hazard due to branch instructions is the major factor of the degradation on the performance of microprocessors. Branch target buffer predicts whether a branch will be taken or not and supplies the address of the next instruction on the basis of that prediction. If the branch target buffer predicts correctly, the instruction flow will not be stalled. This leads to the better performance of microprocessor. In this paper, the architecture of a tag memory that branch target buffer and TLB can share is presented. Because the two tag memories used for branch target buffer and TLB each is replaced by single shared tag memory, we can expect the smaller ship size and the faster prediction. This hared tag architecture is more advantageous for the microprocessors that uses more bits of address and exploits much more instruction level parallelism.

• Journal of Nuclear Fuel Cycle and Waste Technology(JNFCWT)
• /
• v.21 no.2
• /
• pp.225-234
• /
• 2023

In the design of HLW repositories, it is important to confirm the performance and safety of buffer materials at high temperatures. Most existing models for predicting hydraulic conductivity of bentonite buffer materials have been derived using the results of tests conducted below 100℃. However, they cannot be applied to temperatures above 100℃. This study suggests a prediction model for the hydraulic conductivity of bentonite buffer materials, valid at temperatures between 100℃ and 125℃, based on different test results and values reported in literature. Among several factors, dry density and temperature were the most relevant to hydraulic conductivity and were used as important independent variables for the prediction model. The effect of temperature, which positively correlates with hydraulic conductivity, was greater than that of dry density, which negatively correlates with hydraulic conductivity. Finally, to enhance the prediction accuracy, a new parameter reflecting the effect of dry density and temperature was proposed and included in the final prediction model. Compared to the existing model, the predicted result of the final suggested model was closer to the measured values.

• Journal of Korean Society of Forest Science
• /
• v.79 no.4
• /
• pp.376-387
• /
• 1990

A research effort has been made to determine soil buffer capacity in forest soils nearby urban and industrialized regions. Buffer capacities of soils from four regions were measured by different pH levels of artificial acid precipitation. The following conclusions have been drawn in response to the overall research objectives. Soil Suffer capacity was the highest in Kangwondo followed by Uisan, Yeochon and Seoul when simulated acid precipitation were treated at the level of pH 3.0-5.7. With the acid precipitation treatment below pH 2.0 level, however, the capacity dropped seriously with no significant differences between the regions. In Kangwondo region soils weathered from granite and limestone showed significant differences in the buffer capacities. Soil collected in Seoul and Ulsean revealed that the capacities tended to increase with the distance from the pollution sources when treated at pH 3.0, 4.5 and 5.7 level of acid precipitation. The major mechanism of soil buffer observed during simulated acid precipitation experiment was canon exchange for Kangwondo forest soils. In Seoul region canon exchange also played an important role in soil buffering under artificial acid precipitation between 3.0 and 5.7 pH levels, yet under pH 2.0 level aluminum and silicate hydrolysis. In Ulsan canon exchange was a msjor determinant for the buffer capacity above pH 4.5 level, between pH 3.0-4.5 aluminum hydrolysis and below pH 3.0 aluminum and silicate hydrolysis. In Yeochon silicate hydrolysis led buffer capacity above pH 4.5 and below pH 4.5 aluminum hydrolysis.

• Tunnel and Underground Space
• /
• v.20 no.4
• /
• pp.284-291
• /
• 2010

In the present design concept of a high-level waste repository, the bentonite and bentonite-sand mixture are considered as the buffer and backfill material. For the Kyungju bentonite which is a candidate material, the thermal conductivities of compacted bentonite and bentonite-sand mixture were measured. A correlation has been proposed to predict the thermal conductivity of the Kyungju bentonite and the bentonite-sand mixture as a function of the dry density, the water content and the sand fraction. The proposed correlation can predict the thermal conductivity with a difference less than 10% under the experimental conditions.

• The KIPS Transactions:PartC
• /
• v.17C no.3
• /
• pp.299-306
• /
• 2010

IPTV and VoIP services are considered as killer applications over Mobile WiMAX network, which provideshigh mobility and data rate. Among those which affect the quality of voice in those services, the jitter buffer or playout buffer can compensate the poor voice quality caused by the packet drop due to frequent route change or differences among routes between service endpoints. In this paper, we analyze the correlation between the sleep interval length and jitter buffer size in order to guarantee a predefined level of voice quality. For this purpose, we present an end-to-end delay model considering additional delay incurred by the WiMAX PSC-II sleep mode and a VoIP service quality requirement based on the delay constraints. Through extensive simulation experiments, we also show that the increase of jitter buffer size may degrade the voice quality since it can introduce additional packet drop in the jitter buffer under WiMAX power saving mode.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.53 no.1
• /
• pp.36-42
• /
• 2016

In multi-level-cell based storage devices, TLC NAND has been employed solid state drive due to cost effectiveness. Since TLC has slow performance and low endurance compared with MLC, TLC based storage has adopted SLC buffer scheme to improve performance. To improve SLC buffer scheme, this paper proposes page overwriting method in SLC block. This method provides data updates without erase operation within a limited number. When SLC buffer area is filled up, FTL should execute copying valid pages and erasing it. The proposed method reduces erase counts by 50% or more compared with previous SLC buffer scheme. Simulation results show that the proposed SLC buffer overwrite method achieves 2 times write performance improvement.

• Journal of Nuclear Fuel Cycle and Waste Technology(JNFCWT)
• /
• v.17 no.1
• /
• pp.29-36
• /
• 2019

High-level radioactive waste (HLW) such as spent fuel is inevitably produced when nuclear power plants are operated. A geological repository has been considered as one of the most adequate options for the disposal of HLW, and it will be constructed in host rock at a depth of 500~1,000 meters below ground level with the concept of an engineered barrier system (EBS) and a natural barrier system. The compacted bentonite buffer is one of the most important components of the EBS. As the compacted bentonite buffer is located between disposal canisters with spent fuel and the host rock, it can restrain the release of radionuclides and protect canisters from the inflow of groundwater. Because of inflow of groundwater into the compacted bentonite buffer, it is essential to investigate soil-water characteristic curves (SWCC) of the compacted bentonite buffer in order to evaluate the entire safety performance of the EBS. Therefore, this paper conducted laboratory experiments to analyze the SWCC for a Korean Ca-type compacted bentonite buffer considering dry density, confined or unconfined condition, and drying or wetting path. There was no significant difference of SWCC considering dry density under unconfined condition. Furthermore, it was found that there was higher water suction in unconfined condition that in confined condition, and higher water suction during drying path than during wetting path.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2004.08a
• /
• pp.999-1002
• /
• 2004

We propose and simulate a new integrated DAC analog buffer composed of only p-type poly-Si TFTs in AMLCD and AMOLED. Proposed circuit employs a voltage level shifter which $V_{OUT}$ has a linear functional relation to $V_{IN}$. The proposed scheme enables to allow a constant $V_{GS}$ of buffer transistor so that the charging speed of pixel data address is improved.

• Journal of Korean Institute of Industrial Engineers
• /
• v.24 no.1
• /
• pp.105-113
• /
• 1998

This paper deals with a production line which consists of two production stages that are separated by a finite storage buffer. The inventory level in the storage buffer controls the production rate of the preceding stage. That is, the production rate becomes high (low) when the buffer inventory is low (high). We analyze the system characteristics utilizing the Markov process theory and then find an optimal control policy which maximizes a given system profit function. Also, a sensitivity analysis is made to examine the effects of various system parameters on the system performances.

• The Journal of Information Systems
• /
• v.6 no.1
• /
• pp.159-180
• /
• 1997

Database sharing system(DBSS) refers to a system for high performance transaction processing. In DBSS, the processing nodes are locally coupled via a high speed network and share a common database at the disk level. Each node has a local memory, a separate copy of operating system, and a DBMS. To reduce the number of disk accesses, the node caches database pages in its local memory buffer. However, since multiple nodes may be simultaneously cached a page, cache consistency must be ensured so that every node can always access the latest version of pages. In this paper, we propose efficient buffer invalidation schemes in DBSS, where the database is logically partitioned using primary copy authority to reduce locking overhead. The proposed schemes can improve performance by reducing the disk access overhead and the message overhead due to maintaining cache consistency. Furthermore, they can show good performance when database workloads are varied dynamically.