• New & Renewable Energy
• /
• v.19 no.4
• /
• pp.35-45
• /
• 2023

Global efforts are focused on achieving carbon neutrality due to the increases in the levels of greenhouse gases. Moreover, the greenhouse gases generated from the disposal of municipal solid waste (MSW) are the primary sources of emissions in South Korea. In this study, we conducted the biological conversion of syngas (CO, H₂, and CO₂) generated from MSW gasification. The MSW-derived syngas was used as a feed source for cultivating Eubacterium limosum KIST612, and pressurization was employed to enhance gas solubility in culture broth. However, the pH of the medium decreased owing to the pressurization because of the CO₂ in the syngas and the cultivation-associated organic acid production. The replacement of conventional HEPES buffer with a phosphate buffer led to an approximately 2.5-fold increase in acetic acid concentration. Furthermore, compared with the control group, the pressurized reactor exhibited a maximum 8.28-fold increase in the CO consumption rate and a 3.8-fold increase in the H2 consumption rate.

• Journal of Marine Bioscience and Biotechnology
• /
• v.16 no.1
• /
• pp.36-44
• /
• 2024

This study attempted to improve the growth of the freshwater microalgae, Parachlorella kessleri, through the sequential optimization of culture conditions. This attempt aimed to enhance the microalgae's ability to fixate atmospheric CO₂. Culture temperature and light intensity appropriate for microalgal growth were scanned using a high-throughput photobioreactor system. The supplied air flow rate varied from 0.05 to 0.3 vvm, and its effect on the growth rate of P. kessleri was determined. Next, sodium phosphate buffer was added to the culture medium (BG11) to enhance CO₂ fixation by increasing the availability of CO₂(HCO₃^-) in the culture medium. The results indicated that optimal culture temperature and light intensity were 20℃-25℃ and 300 μE/m²/s, respectively. Growth rates of P. kessleri under various air flow rates highly depended on the increase of the culture's flow rate and pH which determines CO₂ availability. Adding sodium phosphate buffer to BG11 to maintain a constant neutral pH (7.0) improved microalgal growth compared to control conditions (BG11 without sodium phosphate). These results indicate that the CO₂ fixation rate in the air could be enhanced via the sequential optimization of microalgal culture conditions.

• Journal of Korean Society of Environmental Engineers
• /
• v.28 no.4
• /
• pp.362-367
• /
• 2006

Waste activated sludge(WAS) collected from domestic wastewater treatment plant is biomass that contains large quantities of organic matter. However, relevant literature show that the bio-hydrogen yield using WAS was too low. In this study, the effect of pretreatment of WAS on hydrogen yield was investigated. Pretreatment includes acid and alkali treatments, grinding, heating, ozone and ultrasound methods. After pretreatment organic matters of WAS were solubilized and soluble chemical oxygen demand(SCOD) was increased by 14.6 times. Batch experiments were conducted to investigate the effects of pre-treatment methods and buffer solution, hydrogen partial pressure, and sodium ion on hydrogen production from WAS by using heated anaerobic mixed cultures. Experimental results showed that addition of buffer solution, efficient pre-treatment method with alkali solution, and gas sparging condition markedly increased the hydrogen yield to 0.52 mmol $H_2/g$-DS.

• Journal of Yeungnam Medical Science
• /
• v.1 no.1
• /
• pp.101-106
• /
• 1984

Before beginning the extracorporeal circulation, perfusionists should supply oxygen into the oxygenator and establish blood flow through the blood line of the heart-lung machine. But these manipulation can induce severe hypocarbic state of priming solutions due to wash out of $CO_2$ gas in the solution. This study was carried out to examine the relationship of blood gas changes between hypocarbic priming solutions and body circulation in 15 patients undergoing open heart surgery with extracorporeal circulation. $PaCO_2$, pH, buffer base and $PaO_2$ were measured from priming solutions before and 15 minutes after the extracorporeal circulation. The results were as follows; 1) Before the extracorporeal circulation, mean $PaCO_2$ level was $12.1{\pm}7.8mmHg$ in the priming solution. However, 15 minutes after extracorporeal circulation, the $PaCO_2$ level was maintained at $35.7{\pm}5.7mmHg$. 2) pH in the priming solution was variable from 6.93 to 7.99 (mean $7.45{\pm}0.29$), but after 15 minutes it was ranged from 7.28 to 7.42 (mean $7.35{\pm}0.05$). 3) Mean buffer base level in the priming solution was $7.9{\pm}3.5mmol/l$, but after 15 minutes, it was $19.6{\pm}1.2mmol/l$. 4) Mean $PaO_2$ level in the priming solution was $667.1{\pm}45.6mmHg$, but after 15 minutes, it was $280.7{\pm}131.7mmHg$.

• Journal of the Korean Society for Nondestructive Testing
• /
• v.26 no.2
• /
• pp.69-76
• /
• 2006

TRISO(tri-isotropic)-coated fuel particle technology is utilized owing to its higher stability at a high temperature and Its efficient retention capability for fission products In the HTGR(high temperature gas-reeled reactor). The typical spherical TRISO fuel panicle with a diameter of about 1mm is composed of a nuclear fuel kernel and outer coating layers. The outer coating layers consist of a buffer PyC(pyrolytic carbon) layer, Inner PyC(1-PyC) layer, SiC layer, and outer PyC(O-PyC) layer Most of the Inspection Items for the TRTSO-coated fuel particle depend on destructive methods. The coating thickness of the TRISO fuel particle can be nondestructively measured by the X-ray radiography without generating radioactive wastel. In this study, the coaling thickness for the simulated TRISO-coated fuel particle with $ZrO_2$ kernel Instead of $%UO_2$ kernel was measured by using micro-focus X-ray radiography with micro-focus X-ray generator and flat panel detector The radiographic image was also enhanced by image processing technique to acquire clear boundary lines between coating layers. The coaling thickness wat effectively measured by applying the micro-focus X-ray radiography The inspection process for the TRISO-coated fuel particles will be improved by the developed micro-focus X-ray radiography and digital image processing technology.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2013.02a
• /
• pp.183-184
• /
• 2013

Two main MBE growth techniques have been used: plasma-assisted MBE (PA-MBE), which utilizes a rf plasma to supply active nitrogen, and ammonia MBE, in which nitrogen is supplied by pyrolysis of NH3 on the sample surface during growth. PA-MBE is typically performed under metal-rich growth conditions, which results in the formation of gallium droplets on the sample surface and a narrow range of conditions for optimal growth. In contrast, high-quality GaN films can be grown by ammonia MBE under an excess nitrogen flux, which in principle should result in improved device uniformity due to the elimination of droplets and wider range of stable growth conditions. A drawback of ammonia MBE, on the other hand, is a serious memory effect of NH3 condensed on the cryo-panels and the vicinity of heaters, which ruins the control of critical growth stages, i.e. the native oxide desorption and the surface reconstruction, and the accurate control of V/III ratio, especially in the initial stage of seed layer growth. In this paper, we demonstrate that the reliable and reproducible growth of GaN on Si (110) substrates is successfully achieved by combining two MBE growth technologies using rf plasma and ammonia and setting a proper growth protocol. Samples were grown in a MBE system equipped with both a nitrogen rf plasma source (SVT) and an ammonia source. The ammonia gas purity was ＞99.9999% and further purified by using a getter filter. The custom-made injector designed to focus the ammonia flux onto the substrate was used for the gas delivery, while aluminum and gallium were provided via conventional effusion cells. The growth sequence to minimize the residual ammonia and subsequent memory effects is the following: (1) Native oxides are desorbed at $750^{\circ}C$ (Fig. (a) for [$1^-10$] and [001] azimuth) (2) 40 nm thick AlN is first grown using nitrogen rf plasma source at $900^{\circ}C$ nder the optimized condition to maintain the layer by layer growth of AlN buffer layer and slightly Al-rich condition. (Fig. (b)) (3) After switching to ammonia source, GaN growth is initiated with different V/III ratio and temperature conditions. A streaky RHEED pattern with an appearance of a weak ($2{\times}2$) reconstruction characteristic of Ga-polarity is observed all along the growth of subsequent GaN layer under optimized conditions. (Fig. (c)) The structural properties as well as dislocation densities as a function of growth conditions have been investigated using symmetrical and asymmetrical x-ray rocking curves. The electrical characteristics as a function of buffer and GaN layer growth conditions as well as the growth sequence will be also discussed. Figure: (a) RHEED pattern after oxide desorption (b) after 40 nm thick AlN growth using nitrogen rf plasma source and (c) after 600 nm thick GaN growth using ammonia source for (upper) [110] and (lower) [001] azimuth.

• Journal of agriculture & life science
• /
• v.51 no.4
• /
• pp.97-109
• /
• 2017

This study was conducted to investigate the effects of anti-inflammatory plant extracts on the in vitro rumen fermentation characteristics and methane emission. Anti-inflammatory plant extracts from Morus bombycis Koidz, Mallotus japonicus L., Morus alba L., Paulownia coreana Uyeki, Isodon japonicus Hara and Ginkgo biloba L. were used in the study. The ruminal fluid(5 mL), McDougall buffer(10 mL), timothy as a substrate(0.3 g) and each anti-inflammatory plant extract(5% of substrate) were dispensed anaerobically into 50mL serum bottle. The mixtures were incubated for 3, 9, 12, 24, 48 and 72h at $39^{\circ}C$ without shaking. Supplementation of the anti-inflammatory plant extracts did not effects characteristics(pH, digestibility of dry matter, glucose concentration, ammonia concentration, protein concentration, VFA) on rumen fermentation. Total gas was showed a different pattern depending on treatments. Carbon dioxide was significantly(p<0.05) higher in Morus alba and Isodon japonicus than in control at 48h. Methane was significantly(p<0.05) lower in treatment than in control at initial fermentation. However the more incubation time was increased, the more methane emission was higher in treatment than in control. The concentrations of polyphenol and flavonoid were higher in Ginkgo biloba. In conclusion, supplementation of the anti-inflammatory plant extracts did not effect on rumen fermentation and methane emission was decreased in initial fermentation.

• Journal of Food Hygiene and Safety
• /
• v.8 no.1
• /
• pp.9-15
• /
• 1993

In an attempt to quantitate and qualitate residual antibiotics and antibacterial agents in meat simultaneously, we studied a gas chromatography-mass spectrometry(GC/M8) analysis. For a simultaneous analysis of penicillin G, chloramphenicol and thiamphenicol in meat, a simple and rapid clean-up procedure including extraction with 0.01 M EDTA-2Na Mcilvaine buffer (pH 4.0), defatting with n-hexane, and elution with 0.01M-methanolic oxalic acid from Bond Elute $C_{18}$ cartridge, and quantitation by selected ion monitoring (SIM) mode after derivatization was performed. The recoveries (%) of penicillin G, chloramphenicol and thiamphenicol (CV, %) at 1 ppm fortification level were 63.5 (7.6), 76.3 (8.1) and 84.7 (2.0), and the detection limits of those were 0.6, 0.085 and $0.084\;\mu\textrm{g}$ beef, respectively. This method using 81M mode allows excellent detection and quantitation of residual antibiotics and antibacterial agents in meat. Moreover, confirmation by a full scan electron impact mass spectrum is possible if residual level in the sample in above 1 ppm.

• Korean Journal of Soil Science and Fertilizer
• /
• v.46 no.4
• /
• pp.288-295
• /
• 2013

Nitrogen dioxide ($NO_2$) gas damage on vegetable crops commonly occurs in plastic film houses where relatively large amounts of $NO_3{^-}$ are applied in acid soils. In acid soils, $HNO_2$ can be formed from the $NO_2{^-}$ accumulated during denitrification, and $NO_2$ can be evolved from the chemical self-decomposition of $HNO_2$. In this study, $NO_2$ gas production and its detrimental effects on plants were investigated in soils of various conditions to elucidate the mechanisms involved in the gas production. A silty loam soil was amended with $NO_3{^-}$ (500 mg N $kg^{-1}$) and glucose, and pH and moisture of the soil were adjusted respectively to 5.0 and 34.6% water holding capacity (WHC) with 0.01 M phosphate buffer. The soil was placed in a 0.5-L glass jar with strawberry leaf or $NO_2$ gas absorption badge in air space of the jar, and the jar was incubated at $30^{\circ}C$. After 4-5 days of incubation, dark burning was observed along the outside edge of strawberry leaf and $NO_2$ production was confirmed in the air space of jar. However, when the soil was sterilized, $NO_2$ emission was minimal and any visible damage was not found in strawberry leaf. In the soil where water or $NO_3{^-}$ content was reduced to 17.3% WHC or 250 mg N $kg^{-1}$, $NO_2$ production was greatly reduced and toxicity symptom was not found in strawberry leaf. Also in the soil where glucose was not amended, $NO_2$ production was significantly reduced. In soil with pH of 6.5, $NO_2$ was evolved to the level causing damage to strawberry leaf when the soil conditions were favorable for denitrification. However, compared to the soil of pH 5.0, the $NO_2$ production and its damage to plants were much less serious in pH 6.5. Therefore, the production of $NO_2$ damaging plants might be occurred in acid soils when the conditions are favorable for denitrification.

• Journal of the Korean Chemical Society
• /
• v.34 no.5
• /
• pp.424-429
• /
• 1990

A bio-sensor for the determination of glucose has been constructed by immobilizing the Citrobacter freundii or its organelle on carbon dioxide gas-sensor. The bacterial sensor was better than organelle in response, but the latter showed a shorter response time. The bacterial sensor gave linearity between 7.0 ${\times}\;10^{-4}$ and 1.0 ${\times}\;10^{-2}$ M glucose with a slope of 42.2 mV/decade in pH 7.0, 0.2 M tris-HCl buffer at 30$^{\circ}C$. The selectivity of this sensor was very high for glucose. Employing for the determination of glucose in serum, the sensor showed a good agreement with a routine analyzer.