• Proceedings of the Optical Society of Korea Conference
• /
• 2004.07a
• /
• pp.190-191
• /
• 2004

• Proceedings of the Optical Society of Korea Conference
• /
• 2001.08a
• /
• pp.274-275
• /
• 2001

• Proceedings of the Optical Society of Korea Conference
• /
• 2004.02a
• /
• pp.282-283
• /
• 2004

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.9 no.4
• /
• pp.1081-1085
• /
• 2008

To measure the curvature, in this paper, we investigate an optical curvature sensor based on the fiber Bragg gratings. We observed the variation of the Bragg resonant wavelength shift to measure the curvature change. From the experimental results, we knew that the Brags resonant wavelength shift was lineally increased with the increase of the curvature from $0\;m^{-1}$ to $10\;m^{-1}$. It's slope is about $8.8\;pm/m^{-1}$. On the other hand, the spectral reflection decreased with the increase of the curvature.

• Proceedings of the KIEE Conference
• /
• 2002.07c
• /
• pp.1936-1938
• /
• 2002

A tunable fiber laser and the Quadrature Sampling technique are used to construct highly sensitive fiber-optic distributive Bragg grating strain sensor system. By using a wavelength-modulated fiber laser, the variations of strain-dependent Bragg wavelengths are transformed into the variations of time-domain reflection profiles. The locations of profile peaks that correspond to the applied strains are demodulated using a precise wavelength encoder that uses a fiber-optic Mach-Zehnder interferometer and Quadrature Sampling technique. With the extremely high sensitive optical encoder, we could obtain not only high sensitivity, but also very linear responses that was impossible with the conventional techniques. This paper is attempted to report the theoretical and experimental results.

• Journal of the Korean Institute of Telematics and Electronics A
• /
• v.33A no.10
• /
• pp.90-97
• /
• 1996

A numerical method for scattering of electromagnetic waves from a periodic strip grating over a grounded dielectric slab is considered for TE and TM polarization cases from the viewpoints of both reflection grating problem and leaky wave antenna problem. The analysis is based on a mode expansion method, floquet's theorem, and the method of moments. Numerical results involving some combinations of geometric parameters are presented in terms of complex propagation constant (kd-$\beta$d diagram), radiation pattern, and relative scattered powers of spectral modes. In particular, the relationship between complex propagatio constnat form the viewpoint of leaky wqve antenna problem and Off-bragg and bragg blazing phenomena from the viewpoint of reflecton graing problem is investigated.

• Journal of the Korean Society of Safety
• /
• v.16 no.2
• /
• pp.121-129
• /
• 2001

This paper demonstrates the development of optical temperature sensor based on the etched planar waveguide Bragg grating. Topics include design and fabrication of the etched planar waveguide Bragg grating, investigation of the grating reflection characteristics, and temperature measurement capabilities. The typical bandwidth and reflectivity of the surface etched grating has been ~0.2nm and ~7%, respectively, at a wavelength of ～1552nm. The temperature-induced wavelength change of the optical sensor is found to be slightly non-linear over ～20$0^{\circ}C$ temperature range. Theoretical models for the grating response of the sensor based on waveguide and plate deformation theories agree with experiments to within acceptable tolerance.

• Korean Journal of Optics and Photonics
• /
• v.27 no.6
• /
• pp.203-211
• /
• 2016

We have studied the hybrid method for reconstructing apodized chirped fiber Bragg gratings, using both an analytic estimation of grating parameters and an optimization algorithm. The Hilbert transform of the reflection spectrum was utilized to estimate grating parameters, and then the layer-peeling algorithm was used to obtain refined parameter values by the differential-evolution optimization process. Calculations for a fiber Bragg grating with wavelength chirp rate 2 nm/cm were obtained with an accuracy of $6{\times}10^{-5}nm/cm$ for the chirp rate and $3{\times}10^{-9}nm/cm$ for the index modulation, with much improved calculation speed and high reliability.

• Journal of applied mathematics & informatics
• /
• v.27 no.5_6
• /
• pp.1017-1031
• /
• 2009

The problem of interaction of surface water waves by small undulation at the bottom of a laterally unbounded sea is treated on the basis of linear water wave theory for both normal and oblique incidences. Perturbation analysis is employed to obtain the first order corrections to the reflection and transmission coefficients in terms of integrals involving the shape function c(x) representing the bottom undulation. Fourier transform method and residue theorem are applied to obtain these coefficients. As an example, a patch of sinusoidal ripples is considered in both the cases as the shape function. The principal conclusion is that the reflection coefficient is oscillatory in the ratio of twice the surface wave number to the wave number of the ripples. In particular, there is a Bragg resonance between the surface waves and the ripples, which is associated with high reflection of incident wave energy. The theoretical observations are validated computationally.

• Korean Journal of Optics and Photonics
• /
• v.7 no.4
• /
• pp.370-374
• /
• 1996

A Superstructure Grating(SSG) Distributed-Bragg-Reflector(DBR) laser has a broad tuning range with a good mode suppression ratio. However, gaps of channel are observed in the wavelength-tuning characteristics of an SSGDBR laser which employs linearly-chirped DBR mirrors. We found by numerical simulation that the gaps may be attributed to the nonuniform reflection-peak heights of a linearly-chirped DBR mirrors. We propose a nonlinearly chirped grating DBR mirror structure that makes reflection-peak heights almost uniform. Therefore a nonlinearly chirped grating structure can be employed in an extended tuning range semiconductor laser to achieve gap-free tuning and low threshold current operation simultaneously.