• Journal of The Korean Dental Society of Anesthesiology
• /
• v.11 no.1
• /
• pp.16-21
• /
• 2011

Background: Since introduced by Gow-Gates GA in 1973, Gow-Gates mandibular nerve block (GMNB) has played an important role in the area of dental local anesthesia. However, compared to the conventional inferior alveolar nerve block (IANB), this technique seems to fail to attract the attentions of general practitioners in South Korea. The aim of this study was to prove the clinical real value, mainly the anesthetic efficacy, of GMNB in minor oral surgery. Methods: The study group comprised 40 patients (15 males and 25 females) who were randomly allocated to receive GMNB or IANB for extraction of third molars. Both techniques utilized two 1.8 ml dental cartridges of 2% lidocaine including 1:100,000 epinephrine for each patient. Pulpal and gingival tissue anesthesia of mandibular premolars and molars were recorded at 0, 15 and 40 minutes after administration of local anesthetics using both an electric pulp tester and a sharp dental explorer. Results: The success rates of pulpal and gingival tissue anesthesia in the IANB group were not significantly different from the GMNB group in overall efficacy. Patient's and operator's satisfaction ratings were also not significantly different between two groups. Interestingly, the injection pain of GMNB group was significantly lower than that of IANB group. Conclusion: This study demonstrated that the anesthetic efficacy of pulpal and gingival tissue of GMNB was not inferior to that of IANB. The GMNB could be a good alternative of the IANB in most of minor oral surgical procedures.

• Journal of Korea Society of Industrial Information Systems
• /
• v.19 no.4
• /
• pp.1-8
• /
• 2014

In order to cope with shadow areas and to extend cell coverage, relay-assisted wireless communication systems have been widely studied. In this paper, we propose a space-frequency(SF) block coded orthogonal frequency division multiple access(OFDMA) transmission system in a relaying multi-path shadow area. The receiving performance of mobile station in a shadow area can be improved by applying SF block code to the recovered signals of multiple relays before re-transmitting them. The simulation result shows that the proposed SF block coded OFDMA transmission system considerably outperforms the conventional single-path OFDMA transmission system.

• Journal of the Korean Wood Science and Technology
• /
• v.44 no.3
• /
• pp.315-322
• /
• 2016

Block-glued glulam is a structural material that can be used as a construction member of a large-section wooden building, which is produced by edgewise bonding of two or more glulam beam elements. The edgewise bonding performance of the block-glued glulam was examined through delamination test and block shear strength test. According to the test results, the block-glued glulam that was manufactured with 1.5 MPa of compressive pressure after applying $500g/m^2$ of Resorcinol adhesive showed the best edgewise bonding performance. The block-glued glulam produced in a good edgewise bonding condition was compared with a control glulam with the same section modulus for bending strength performance. The modulus of elasticity (MOE) in bending was similar to that of the control glulam. The modulus of rupture (MOR) of the block-glued glulam was higher by 27% than that of the control glulam. No interfacial failure or cohesive failure were observed in the edgewise bonding layer.

• Korean Journal of Materials Research
• /
• v.29 no.12
• /
• pp.804-811
• /
• 2019

As the importance of three-dimensiona (3D) nano patterns and structures has recently emerged, interest in the study of 3D structures of block copolymers has increased. However, most existing studies on block copolymer 3D patterns on substrates are limited to simple 3D structures such as a multi-layered forms. In this study, we propose an experimental method for realizing free-standing 3D block copolymer patterns on substrates using an e-beam lithographic template and film transfer method. The block copolymer 3D structure formed in wide hole templates are similar to simple multi-layered structures; however, as the width of the hole template become narrower, more complex block copolymer 3D structures are formed in which the upper and lower layer structures are interconnected. Furthermore, we introduce a method to fabricate novel block copolymer structures in which the 2D planar structures are connected to 3D complex structures. Proposed 3D block copolymer fabrication method provides a framework for generation of unconventional 3D structures of block copolymer, which can be useful for next generation 3D devices.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.26 no.6
• /
• pp.472-477
• /
• 2013

This paper carried out the comparative analysis on ground impedance of a carbon block and a copper rod. Two types of grounding electrode were compared ; a carbon block (L : 1 m, ${\Phi}$ : 245 mm) buried at a depth of 0.8 m and a three-linked copper rod (L : 1 m, ${\Phi}$ : 10 mm) of equilateral triangles with 1 m spacing. Ground impedance depending on applied current source was evaluated by the application of a sine wave current with 60 Hz ~ 3.5 MHz, a fast-rise pulse with rising time of 200 ns, a standard lightning impulse of $8/20{\mu}s$ and a 600 Hz square wave. Ground impedance for both electrodes were almost the same value below 100 kHz, and increased rapidly afterwards. The maximum ground impedance appeared $400{\Omega}$ at around 1.5 MHz. Ground impedance of the carbon block was lower at the square wave and was higher at fast-rise pulse than that of the copper rod. Also, ground impedance as ages showed no difference for the last 8 months. From the results, it is likely that ground performance for both electrodes shows no difference against commercial frequency and lightning impulse current, while the copper rod shows better performance against a fast-rise pulse with rise-time of a few hundred ns.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.15 no.9
• /
• pp.5776-5782
• /
• 2014

Relay-assisted wireless communication systems have been studied widely to cope with shadow areas and extend the cell coverage. This paper proposes a space-frequency (SF) block coded single carrier-frequency division multiple access (SC-FDMA) transmission system in a relaying multi-path shadow area and present the performance comparison of SC-FDMA systems based on the signal-to-noise power ratio (SNR) between a relay and a destination station. The performance of relaying SC-FDMA systems can be improved by applying SF block code to the recovered signals of relays before re-transmitting them. The simulation result showed that the SNR performance of the proposed SF block coded relaying SC-FDMA system was approximately 5 dB better than the SNR performance of the single-path relaying SC-FDMA system at a symbol error rate (SER) of $10^{-2}$.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.7 no.5
• /
• pp.122-130
• /
• 2008

Improving the transmission rates of multi-media delivery, such as moving pictures and internet services, has become increasingly important in modern society. To satisfy such high data rate requirements, the MIMO technique, which has the capacity to transmit large amounts of data using limited frequency resources, was developed. The Space Division Multiplexing (SDM) system is one of the MIMO techniques to be able to improve the transmission capacity. However, it is unable to achieve diversity gain because of interference due to the use of multiple antennas. In this paper, an SDM system that utilizes a Multi-Block method as an advanced transmission technique in a wireless communication system to obtain diversity gain is proposed and discussed fur the performance of the proposed system.

• The Journal of the Acoustical Society of Korea
• /
• v.25 no.3
• /
• pp.113-120
• /
• 2006

This paper is concerned with a equalization technique for Orthogonal Frequency Division Multiplexing (OFDM) systems based on a block type pilot arrangement over slow fading channels. The bit rates obtained in underwater channels are relatively modest compared to some other communication channels such as cellular phones or indoor wireless systems. Consequently. the Doppler effect is the important parameter in tracking a channel. In case of a coherent demodulation scheme, the residual mean phase errors due to Doppler frequency may be fatal for the performance of the system. The equalizer could not solely handle mean Doppler shift. To account for the common Doppler effect a phase error tracking loop is used with the frequency equalizer. so that the rotation errors are avoided. Furthermore. simulations show that we can reduce the computational load of the tracking loop with negligible effect on performance.

• Journal of Embryo Transfer
• /
• v.33 no.3
• /
• pp.139-147
• /
• 2018

Somatic cell nuclear transfer (SCNT) is a useful biotechnological tool for animal cloning. Until now, SCNT has been inefficient, especially in dog. It is believed that an embryo developmental block in SCNT embryos is cause of low production efficiency. However, no studies have been performed on canines for embryo developmental block. In this study, we attempted to evaluate the beneficial role of EDTA in canine parthenogenic (PA) embryos development to overcome embryo developmental block. The PA embryos were divided into 0.01 mM EDTA treated and non-treated groups. Embryo developmental efficiency was measured by activating chemically parthenote. After EDTA induction, PA embryos were evaluated for embryonic development, Reactive Oxygen Species (ROS) activity, mitochondrial integrity, ATP production and genomic activation. The EDTA treated PA embryos showed significantly higher survival rate and improved cavity formation compared to non-treated. Furthermore, cytoplasmic ROS level was mitigated and mitochondrial membrane potential was found significantly higher in EDTA treated group followed by higher ATP production. Moreover, major embryonic genomic activation specific markers/factors were also elevated in EDTA treated group. Conclusively, we elucidated that EDTA showed substantially positive effect to overcome embryo developmental block in canine.

• Proceedings of the Korean Fiber Society Conference
• /
• 2003.10b
• /
• pp.179-180
• /
• 2003

ABA triblock copolymer made up of long middle block(B) and sho.1 terminal blocks(A) is being widely used as thermoplastic elastomers. Block copolymers with non-polar hydrophobic polystyrene and polar hydrophilic poly(ethylene glycol) blocks has been prepared and the physical properties of the solutions of PS-PEG-PS in polar (dimethyl formamide, DMF) and non-polar solvent (benzene) were investigateded[-3]. (omitted)