• Journal of Ocean Engineering and Technology
• /
• v.31 no.2
• /
• pp.177-182
• /
• 2017

This paper describes an unscented Kalman filter approach to estimate the bias in magnetic field measurements. A microelectromechanical systems attitude heading reference system (MEMS AHRS) was used to measure the magnetic field, together with the acceleration and angular rate. A magnetic field is usually used for yaw detection, while the acceleration serves to detect the roll and pitch. Magnetic field measurements are vulnerable to distortion due to hard-iron effect and soft-iron effect. The bias in the measurement accounts for the hard-iron effect, and this paper focuses on an approach to estimate this bias. The proposed method is compared with other methods through experiments that implement the navigation of an underwater robot using an AHRS and Doppler velocity log. The results verify that the compensation of the bias by the proposed method improves the navigation performance more than or comparable to the compensation by other methods.

• Journal of Korean Ophthalmic Optics Society
• /
• v.9 no.2
• /
• pp.291-299
• /
• 2004

DLC films were deposited using the ECR-PECVD method with the fixed deposition condition, such as ECR power, methane and hydrogen gas-flow rates and deposition time, for various substrate bias voltage. We have investigated the ion bombardment effect induced by the substrate bias voltage on films during the deposition of film. The characteristic of the films were analyzed using the FTIR, Raman, and UV/Vis spectroscopy analysis shows that the amount of dehydrogenation in films was increased with the increase of substrate bias voltage and films thickness was decreased. Raman scattering analysis shows that integrated intensity ratio(ID/IG) of the D and G peak was increased as the substrate bias voltage increased and films hardness was increased. Optical transmittances of DLC film were decreased with increasing deposition time and substrate bias voltage. From these results, it can be concluded that films deposited at this experimental have the enhanced characteristics of DLC because of the ion bombardment effect on films during the deposition of film.

• Journal of Magnetics
• /
• v.20 no.4
• /
• pp.347-352
• /
• 2015

The magnetoelectric (ME) characteristics for Terfenol-D/PZT laminate composite dependence on bias magnetic field is investigated. At low frequency, ME response is determined by the piezomagnetic coefficient $d_{33,m}$ and the elastic compliance $s_{33}^H$ of magnetostrictive material, $d_{33,m}$ and $s_{33}^H$ for Terfenol-D are inherently nonlinear and dependent on $H_{dc}$, leading to the influence of $H_{dc}$ on low-frequency ME voltage coefficient. At resonance, the mechanical quality factor $Q_m$ dependences on $H_{dc}$ results in the differences between the low-frequency and resonant ME voltage coefficient with $H_{dc}$. In terms of ${\Delta}E$ effect, the resonant frequency shift is derived with respect to the bias magnetic field. Considering the nonlinear effect of magnetostrictive material and $Q_m$ dependence on $H_{dc}$c, it predicts the low-frequency and resonant ME voltage coefficients as a function of the dc bias magnetic field. A good agreement between the theoretical results and experimental data is obtained and it is found that ME characteristics dependence on $H_{dc}$ are mainly influenced by the nonlinear effect of magnetostrictive material.

• Korea Trade Review
• /
• v.46 no.1
• /
• pp.23-38
• /
• 2021

This paper investigated the preference change of payment terms in international trade along with counteroffer or first offer conditions of the other parties. Studies on trade payment terms have mainly focused on payment term determination factors such as firm size, product price level, country credit rate, etc. We tried to find other factors affecting payment terms choice, during the negotiation process. We applied behavioral economics theories such as 'Status Quo Bias' and 'Anchoring effect' to build our research model. To prove the existence of the above effects, we proceeded with field experiments to the exporting companies in Alibaba.com. Both 'Status Quo Bias' and 'Anchoring effect' were found in the field experiment. Most of the exporting companies preferred traditional payment methods to new payment methods. And an initial request for a low advance payment ratio led to a lower advance payment ratio. Also, the experience of using new payment methods could diminish status quo bias. This paper applied behavioral economics theories and field experiment methodology to the payment term studies in international trades. These attempts could contribute to expanding the diversity of methodology and scope of international trade studies.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.61 no.10
• /
• pp.1483-1488
• /
• 2012

This paper analyzed the precision and accuracy of the altitude-aided GNSS using the altitude information from digital map. The precision of altitude-aided GNSS is analysed using the theoretically derived DOP. It is confirmed that the precision of altitude-aided GNSS is superior to the general 3D positioning method. It is also shown that the DOP of altitude-aided GNSS is independent of altitude bias error while the accuracy was influenced by the altitude bias error. Furthermore, it is shown that, since the altitude bias error influenced differently to each pseudorange measurement, the effect of the altitude bias error is more serious than clock bias error which does not influence position error at all. The results are evaluated by the simulation using the commercial RF simulator and GPS receiver. It confirmed that altitude-aided GNSS could improve not only precision but also accuracy if the altitude bias error are small. These results are expected to be easily applied for the performance improvement to the land and maritime applications.

• Journal of the Korean institute of surface engineering
• /
• v.54 no.3
• /
• pp.133-138
• /
• 2021

Ternary Ti-X-N coatings, where X = Al, Si, Cr, O, etc., have been widely used for machining tools and cutting tools such as inserts, end-mills, and etc. Ti-Al-N-O coatings were deposited onto silicon wafer and WC-Co substrates by a cathodic arc evaporation (CAE) technique at various negative substrate bias voltages. In this study, the influence of substrate bias voltages during deposition on the microstructure and mechanical properties of Ti-Al-N-O coatings were systematically investigated to optimize the CAE deposition condition. Based on results from various analyses, the Ti-Al-N-O coatings prepared at substrate bias voltage of -80 V in the process exhibited excellent mechanical properties with a higher compressive residual stress. The Ti-Al-N-O (-80 V) coating exhibited the highest hardness around 30 GPa and elastic modulus around 303 GPa. The improvement of mechanical properties with optimized bias voltage of -80 V can be explained with the diminution of macroparticles, film densification and residual stress induced by ion bombardment effect. However, the increasing bias voltage above -80 V caused reduction in film deposition rate in the Ti-Al-N-O coatings due to re-sputtering and ion bombardment phenomenon.

• Journal of Information Technology Services
• /
• v.21 no.4
• /
• pp.1-26
• /
• 2022

Recently, the number of cases of purchasing food online has been increased, especially in the open market. Therefore, we examined the characteristics of status quo bias and switching costs in the open market. Also, in this study, the causal relationship between the characteristics of status quo bias and switching costs, switching costs and switching intention in the open market was investigated. The analysis result consists of four parts as follows. First, in the open market, rational decision making, which belongs to the characteristics of status quo bias, was found to have a positive (+) effect on time switching cost among switching costs, but did not have a positive (+) effect on economic and psychological switching cost. Second, cognitive misperceptions was consistent with the assumption that it have a positive (+) effect on all of the economic, time, and psychological switching cost, which are switching costs in the open market. Third, psychological commitment was found to have a positive (+) effect on economic and time switching cost among switching costs, but did not have a positive (+) effect on psychological switching cost. Fourth, psychological switching cost, which belongs to switching costs in the open market, was found to have a negative (-) effect like the hypothesis set in switching intention. However, it was found that economic and time switching cost did not have a negative (-) effect on switching intention. This study subdivided the switching costs into three dimensions and compared the degree of influence on the switching intention, and the degree of influence was different for each dimension. Therefore, it was found that when switching from the existing open market to the new open market, it is not possible to simply judge that the switching costs directly has a negative (-) effect on the switching intention or does not.

• Journal of Biosystems Engineering
• /
• v.23 no.1
• /
• pp.1-12
• /
• 1998

This study was intended to investigate experimentally the effect of inflation pressure on tractive performance of bias-ply tires for agricultural tractors. Traction tests were conducted at the three velocities of 3, 4, and 5.5km/h under few different surface conditions using a 13.6-28 6PR bias-ply tire as driving wheel of the test tractor. When the inflation pressure was reduced from 250kPa to 40kPa by a decrement of either 30 or 50kPa depending upon the test surface conditions, some of the test results showed that the tractive coefficient and efficiency were increased maximally by 40% and 17％, respectively, at 20% slippage. However, it was failed to derive any consistent rules depicting the effect of inflation pressure of bias ply tires on the tractive performance of tractors.

• Journal of information and communication convergence engineering
• /
• v.8 no.1
• /
• pp.107-111
• /
• 2010

This paper has presented the dependence of the threshold voltage on back gate bias and drain voltage for FinFET. The FinFET has three gates such as the front gate, side and back gate. Threshold voltage is defined as the front gate bias when drain current is 1 micro ampere as the onset of the turn-on condition. In this paper threshold voltage is investigated into the analytical potential model derived from three dimensional Poisson's equation with the variation of the back gate bias and drain voltage. The threshold voltage of a transistor is one of the key parameters in the design of CMOS circuits. The threshold voltage, which described the degree of short channel effects, has been extensively investigated. As known from the down scaling rules, the threshold voltage has been presented in the case that drain voltage is the 1.0V above, which is set as the maximum supply voltage, and the drain induced barrier lowing(DIBL), drain bias dependent threshold voltage, is obtained using this model.

• Journal of the Korean institute of surface engineering
• /
• v.28 no.4
• /
• pp.225-235
• /
• 1995

To investigate the effects of pretreatment and substrate bias on the characteristics of the diamond thin films, the thin films were deposited on the p-type Si(100) wafer by MPECVD using mixtures of $H_2$, $CH_4$, and $O_2$ gases. Deposition was carried out at the substrate temperature of $900^{\circ}C$ and at the pressure of 40torr. The effect of the pretreatment on the film formation was the examined by using SiC and diamond powders as abrasive powders. Furthermore, the substrate bias effect on the formation of the diamond film was also examined. The highest nucleation density was observed for the pretreatment with 40~60$\mu\textrm{m}$ size of diamond powders and a negative bias potential(-50V). Many defects and(111) twins in the diamond films were observed.