• Nuclear Engineering and Technology
• /
• v.54 no.8
• /
• pp.3154-3165
• /
• 2022

During a loss-of-coolant accident (LOCA) in the pressurized water reactor (PWR), there is a possibility that high temperature and internal pressure of the fuel rods lead to ballooning of the cladding, which causes a partial blockage of flow area in a subchannel. Such flow blockage would influence the core coolant flow, thus affecting the core heat transfer during a reflooding phase and subsequent severe accident. However, most of the system analysis codes simulate the accident process based on the assumed channel blockage ratio, resulting in the fact that the simulation results are not consistent with the actual situation. This paper integrates the developed core Fuel Rod Thermal-Mechanical Behavior analysis (FRTMB) module into the self-developed severe accident analysis code ISAA. At the same time, the existing flow blockage model is improved to make it possible to simulate the change of flow distribution due to fuel rod deformation. Finally, the ISAA-FRTMB is used to simulate the QUENCH-LOCA-0 experiment to verify the correctness and effectiveness of the improved flow blockage model, and then the effect of clad ballooning on core heat transfer and subsequent parts of core degradation is analyzed.

• Nuclear Engineering and Technology
• /
• v.55 no.8
• /
• pp.2897-2904
• /
• 2023

The Standardized Plant Analysis Risk-Human Reliability Analysis (SPAR-H) method is a widely used method in human reliability analysis (HRA). Performance shaping factors (PSFs) refer to the factors that may influence human performance and are used to adjust nominal human error probabilities (HEPs) in SPAR-H. However, the PSFs are assumed to be independent, which is unrealistic and can lead to unreasonable estimation of HEPs. In this paper, a new method is proposed to handle the dependencies among PSFs in SPAR-H to obtain more reasonable results. Firstly, the dependencies among PSFs are analyzed by using decision-making trial and evaluation laboratory (DEMATEL) method. Then, PSFs are assigned different weights according to their dependent relationships. Finally, multipliers of PSFs are modified based on the relative weights of PSFs. A case study is illustrated that the proposed method is effective in handling the dependent PSFs in SPAR-H, where the duplicate calculations of the dependent part can be reduced. The proposed method can deal with a more general situation that PSFs are dependent, and can provide more reasonable results.

• International journal of advanced smart convergence
• /
• v.12 no.2
• /
• pp.182-186
• /
• 2023

In this study, we measured the power and temperature of the floating horizontal solar cell in a coastal lagoon and compared with those of ground solar cell and water platform solar cell. Because the bottom surface of the floating horizontal solar cell was contacting the water, cooling effect was expected stronger than other cells. As a result of the measurement, the power of floating horizontal cell was 11.7% higher than that of the ground cell and 15% higher than that of the water platform cell. During the measurement, it was observed that water waves were continuously flowed on the top surface of floating horizontal cell by the wind, and it could be assumed that the cooling effect occurred not only on the bottom surface of the cell but also on the top surface. In order to analyze the cooling effect and power increasing of the horizontal cell in the wave situation, we measured power and temperature of the cell while generating artificial waves in a laboratory equipped with Zenon lamp as a solar simulator. At the height of thewater surface, the power of the cell with waves was 3.7% higherthan without waves and temperature was 4.6℃ lower. At 1 cm and 2 cm below the watersurface, power of the cell with waves was decreased by 14% and 11% than without waves while temperature was same . At 3 cm below the water surface, there was no effect of waves.

• Korean Journal of Clinical Laboratory Science
• /
• v.49 no.2
• /
• pp.108-113
• /
• 2017

A sudden cardiac death (SCD) is defined as an unnatural sudden death caused by heart disease. To determine the cause of death, observation of the microscopic change in cardiac muscle tissue is suggested, rather than visual postmortem examination. However, this suggestion is time consuming to be applied in the field, is cost-ineffective, and is inconvenient. Therefore, the purpose of this study is to understand whether temporary inspection used to examine the cardiac marker (Myoglobin, CK-MB, cTn I) in postmortem blood via rapid cardiac triple test kit (which is used by clinics to diagnose patients with acute myocardial infarction) can effectively be utilized for the paragnosis of sudden, unnatural cardiac death. The results of postmortem examination and temporary investigation found that 23 groups (76.7%), among the 30 experimental groups, were assumed to be non-traumatic sudden cardiac deaths, which indicated a positive response (according to comparison with forensic autopsy); 4 groups, among the 10 control groups, were assumed to be cerebrovascular disease, which indicated a negative response; 1 group was assumed to be alcoholic and drug poisoning, indicating a positive response; and 1 group was assumed to be oxygen deficiency due to suffocation, indicating a positive response. Hence, it was found that the level of sensitivity and specificity of cardiac marker's temporary inspection showed significant result, 76.7% and 80% respectively. Given this, temporary inspection can be effectively used for the paragnosis of sudden cardiac death when the medical history, situation of the site, and postmortem interval are considered together. With the result of precedent research on time of first revelation and extinction in blood, and difference in concentration over time progress according to the characteristic of cardiac marker's (myoglobin, CK-MB, cTn I) individual material, further research on concentration of cardiac marker per each post time needs to be conducted in order to estimate time science death (which is required to identify the cause of death and investigation).

• Journal of Korean Society of Transportation
• /
• v.25 no.4
• /
• pp.57-66
• /
• 2007

According to the rapid economic growth and the escalation of recreational tourism activities due to the change of job and working patterns, currently various traffic problems often occur in tourist areas. As tourist traffic, contrary to general traffic, is not regional but rather from outside the area of interest, it is hard to grasp the traffic situation surrounding the tourist area. Furthermore, since the traffic is concentrated during a limited tourist season, it is difficult to examine and solve the problem. In this study, in order to test the feasibility of introducing a traffic transfer system to reduce congestion in tourist areas, the authors considered the differences in traffic congestion between typical and tourist seasons and designed a willingness to pay model. The willingness to pay amount for a shuttle bus fare is assumed as 1,430 Won and 1,650 Won is assumed for a transfer parking charge. These amounts were slightly above the current bus fare in the study area, but many people thought that the introduction of a traffic transfer system would help to relieve the traffic congestion approaching the tourist area and to develop tourism resources. As the willingness to pay appeared high from the persons used in this study, it was indirectly confirmed that the introduction of a traffic transfer system would be a step in the right direction.

• Journal of the Korean Geographical Society
• /
• v.44 no.4
• /
• pp.447-462
• /
• 2009

Kohyun River basin is located at southern parts of Taebaek Mountains and most of river basins consists of sedimentary rock. The aims of this study are to investigate the distribution characteristics and processes of fluvial terraces at Kohyun River, using scientific methods such as classification of fluvial landforms, analysis of geomorphological deposits, XRD and OSL age dating. In Kohyun River basin are three levels terraces from T1 to T3. Fluvial terraces are assumed to be erosional terraces according to deposited situation of alurium and existences of bedrock riverbed. From the result of OSL age dating, formation age of fluvial terrace 1(T1) is calculated about 37,000 yr.B.P.(MIS 3), and fluvial terrace 2(T2) is calculated about 113,000 yr.B.P.(MIS 5). Therefore, fluvial terraces at Kohyun River are assumed to be formed at warmer period in the glacial stages or cooler period in the interglacial stages. The incision rate of fluvial terrace 1 at Kohyun River is calculated to be 0.054m/ka, and the incision rate of fluvial terrace 2 is calculated to be 0.115m/ka. This results suggest to lower incision rate than other rivers in Korea because of low uplift rates and little discharge.

• The Journal of the Petrological Society of Korea
• /
• v.23 no.4
• /
• pp.351-366
• /
• 2014

We assumed the situation where an eruption column had been formed by the explosive Plinian eruption from Mt. Baekdu and that the collapse of eruption column had caused pyroclastic density currents to occur. Based on this assumption, we simulated by using a Titan2D model. To find out about the range of the impacts of pyroclastic density currents by volcanic eruption scenarios, we studied the distance for the range of the impacts by VEIs. To compare the results by each volcanic eruption scenario, we set the location of the vent on the 8-direction flank of the outer rim and on the center of the caldera, the internal friction angle of the pyroclastic density currents as $35^{\circ}$, the bed friction angle as $16^{\circ}$. We set the pile height of column collapse and the vent diameter with various VEIs. We properly assumed the height of the column collapse, the diameter of the vent, the initial rates of the column collapse and the simulation period, based on the VEIs, gravity and the volume of the collapsed volcanic ash. According to the comparative analysis of the simulation results based on the increase of the eruption, the higher VEI by the increase of eruption products, the farther the pyroclastic density currents disperse. To the northwest from the vent on the northeast slope of the outer rim of the caldera, the impact range was 3.3 km, 4.6 km, 13.2 km, 24.0 km, 50.2 km, 83.4 km or more from VEI=2 to VEI=7, respectively. Once the database has been fully constructed, it can be used as a very important material in terms of disaster prevention and emergency management, which aim to minimize human and material damages in the vicinity of Mt. Baekdu when its eruption causes the pyroclastic density currents to occur.

• Korean Journal of Organic Agriculture
• /
• v.26 no.1
• /
• pp.57-72
• /
• 2018

Organic agriculture seeks sustainable agriculture. Organic agriculture is based on circulating agriculture of a family farm unit. However, as of the end of 2016, only 33 out of the total organic farming farms were implementing Crop-Livestock cycling organic farming. The reason seems to be a matter of income after all. The optimal size combination refers to the scale by which family farms can maintain their quality of life while engaging in farming activities. In other words. it is a farm scale that maintains optimal income through stable labor costs. In the meantime, there has been no previous study on the optimal economical combination of Crop-Livestock cycling farming. Choi (2016) analyzed whether the economies of scope (EOS) were realized in the combined production by using the management data of the farmers who practiced Crop-Livestock cycling organic farming for four years. As a result, it has been revealed that the EOS measurement value is 0 or more so the economies of scope are being realized. Therefore, the purpose of this empirical analysis is to identify farm incomes under this circumstance. It is assumed that the optimum production is achieved by balancing the total income curve and the total cost curve in the optimal scale production range. The results of the analysis are as follows. First, the income after the conversion to Crop-Livestock cycling farming was 44,789,280 won, the sum of the seedling-livestock sector, which was 17,873,120 won higher when the non-Crop-Livestock cycling farming was assumed. The same is true for 2014 and 2015. The reason for this is that pig droppings were composted from organic seedlings, and the cost of selling pork was 150,000 won/per pig more expensive even though the manufacturing cost of organic feeds was higher than the purchasing cost. Secondly, this study simulated the result that the economic index varies when the farm size combination is changed by the farm size of 100% standard (S100) as of 2014. S130 is the increase in size from 100% of 2014, whereas S30 is the result of 3ha crop and 66 livestock (pigs). As a result of this simulation, Crop-Livestock cycling farming income decreased more than non-Crop-Livestock cycling farming as the farm size decreased, whereas the income decreased as the farm size increased. When the size was reduced below S50, the income tended to decrease. In this situation, EOS changed in the same direction. The results showed that when the farming size was reorganized and reduced to 50% compared to 2014, the income and income difference was the highest. At the same time, economies of scope (EOS) were the highest at 0.12985. In other words, it was found that the income of farm houses in a family farm unit sector was the best in the combination of 1.5ha crop agriculture and 110 livestock (pigs).

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.21 no.6
• /
• pp.154-160
• /
• 2020

This study analyzed the fire intensity according to the zones classification between traditional market stores using FDS software. Modeling was conducted for the Seomoon traditional market district 4 at Daegu, which places combustibles, such as textiles and clothing near the passageway. The first ignition point assumed a short circuit fire situation at the fourth store combustible. The analysis was conducted under similar conditions as the fire situation in 2016. When there was no section wall, the fire spread rapidly through radiation in all directions from the fire-origin point. After 600 seconds, the mall was burnt to the ground. When section walls were present, however, the fire could be restricted inside the compartment. The first intensity of the two analysis conditions was predicted from the total heat energy from 200 seconds (X₁) to 600 seconds (X₂), where the heat generation rate began to increase rapidly. As a result of installing section walls near the fire point, heat energy generation of approximately 11.12 MW (55.68 %) was delayed. Further analysis of smoke control, according to the section wall arrangement and re-installation facilities, will be needed to study the characteristics of fire in traditional markets comprehensively.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.17 no.12
• /
• pp.339-344
• /
• 2016

Since transmissions of large amounts of data are frequent, users require more bandwidth, and the need for communications networks having greater bandwidth is increasing. One communications network satisfying this need is an optical communications network. Therefore, studies to increase the transmission capacity of optical communications systems have been carried out. However, in a general optical communications system, a signal transmitted through optical fiber (a transmission medium) is detected through direct detection in the receiving system. This method has a disadvantage in that the entire bandwidth of the optical signal cannot be utilized. Also, when transmitting an optical signal, there is a problem where the signal-to-noise ratio is affected by neighboring channels. To overcome this situation, various studies are being conducted to minimize the influence of external interference and noise. This paper overcomes the situation by transmitting spectrum-sliced signals using the digital transmission system, FSK. Analyzing the characteristics of the signals detected in the receiver of the optical communications system, Gaussian distribution is used for the PDF of the spectrum-sliced signal, and the signal at the receiving end of the optical communications system is assumed to have a k-square distribution. The results of the analysis confirmed it is better to transmit the spectrally divided signal rather than transmit the laser source.