• Journal of Microbiology and Biotechnology
• /
• v.16 no.4
• /
• pp.576-583
• /
• 2006

The alkali-soluble glucan of the yeast cell wall contains $\beta-(1,3)-$ and (1,6)-D-linkages and is known to systemically enhance the immune system. In the previous study [6], in order to isolate cell wall mutants, a wild-type strain was mutagenized by exposure to ultraviolet light, and the mutants were then selected via treatment with laminarinase $(endo-\beta-(1,3)-D-glucanase)$. The mass of alkali- and water-soluble glucans produced by the mutant was measured to be 33.8 mg/g of the dry mass of the yeast cell. Our results showed that the mutants generated the amount of alkali-soluble glucan 10-fold higher than that generated by the wild-type. Structural analysis showed that the alkali-soluble glucan from the mutants was associated with a higher degree of $\beta-(1,6)-D-linkage$ than was observed in conjunction with the wild-type. Yeast cell wall $\beta-glucan$ was shown to interact with macrophages via receptors, thereby inducing the release of tumor necrosis factor alpha $(TNF-\alpha)$ and nitric oxide. Alkali-soluble $\beta-glucans$, both from water-soluble and water-insoluble glucan, exhibited a higher degree of macrophage activity with regard to both the secretion of tumor necrosis factor alpha $(TNF-\alpha)$ and nitric oxide and direct phagocytosis, than did the positive control ($1{\mu}g$ of lipopolysaccharide).

• Korean Journal of Materials Research
• /
• v.21 no.12
• /
• pp.679-684
• /
• 2011

One of the trace constituents included in cement clinker, chromium, has become prominent and highly noticed lately as a social issue both inside and outside of this country because it affects the human body negatively. The purpose of the present study was to investigate leaching properties of water-soluble hexavalent chromium by different manufacturing conditions of cement clinker. Raw materials were prepared to add different $SiO_2$, $Al_2O_3$ and $Fe_2O_3$ sources. After the raw materials, such as limestone, sand and clay, iron ore was pulverized and mixed, and the raw meal was burnt at $1450^{\circ}C$ in a furnace with an oxidizing atmosphere. Leaching of soluble hexavalent chromium showed a tendency to decrease with an increasing LSF and IM. However, leaching of soluble hexavalent chromium increased with an increasing S.M. Alkali contents of iron source minerals is closely related to the leaching properties of soluble hexavalent chromium. Green sludge has the highest content of alkali added; leaching of water-soluble hexavalent chromium was mostly high. In order to reduce the water-soluble hexavalent chromium in cement, reducing the alkali content in raw materials is important.

• Journal of Adhesion and Interface
• /
• v.14 no.2
• /
• pp.88-94
• /
• 2013

Because of recent requirement for environmentally-friendly adhesive, water and/or alkali soluble pressure sensitive adhesives are being developed and produced. Our research laboratory newly developed the test method for measuring the water and alkali solubility of the adhesives. Also, we made the test method published both in KS and ISO. In this research, the test of measuring the water and/or alkali solubility of the test adhesive samples as a function of time at various temperatures was carried out using the proposed test method. The results showed this proposed test method made stable output data for the change of solubility as a function of time in the proper range of temperature.

• Journal of the Korean Graphic Arts Communication Society
• /
• v.20 no.1
• /
• pp.16-27
• /
• 2002

Recently, the attraction for water-based ink is increasing, Because Solvent ink, based on organic solvent, cause bad effect on environment and rise the cost. Instead of organic solvent that cause environment pollution as well as cost-rise by rise of petroleum price, Binder based on alkali-soluble resin is popular and studied by many other country. However, in domestic, research and development for alkali-soluble resin is not like, because of lack of understanding environmental pollution and safety, therefor alkali-soluble resin development and research for the properties of the water-based ink used by alkali-soluble resin is not study very well. In this paper, we studied dispersion of carbon black in acrylic resin solution and the properties of water-based ink used by carbon black and acrylic binder.

• Cement
• /
• s.49
• /
• pp.38-41
• /
• 1972

• Journal of the Korean Wood Science and Technology
• /
• v.25 no.1
• /
• pp.23-27
• /
• 1997

Alkali-soluble extracts were prepared from barks of Japanese larch(Larix leptolepis). Siberian larch(Larix gmelineii) and Radiata pine(Pinus radiata) The effect of various factors, such as particle size, liquor ratio, extraction temperature, and reaction time, on the extracts yield was investigated. Particle sizes affected the alkali-soluble extracts; the finer the particle size, the higher extracts and extract efficiency. High temperature and high liquor ratio were more effective. In the range of 0.25% to 1% NaOH concentration, alkali extracts were increased with the increasing alkali concentration. However, extract yields were leveled off above 0.5% alkali concentration. Extractions with NaHCO3 were almost equivalent to those of NaOH extraction. 1% NaOH and 1% NaHCO3 resulted in the highest yields of alkaline extracts. Extracts from Japanese larch were lower than those from Siberian larch and Radiata pine barks. Siberian larch bark was the best raw material for tannin adhesives, because its extractive yield was higher than those of the other barks. Concerning pH of alkaline media during extraction, small increases of the extract yields were resulted at range of pH 7 to pH 9, while a large increases from pH 9.0 to pH 12. This phenomenon is attributed to higher alkalinity.

• Journal of the Korean Ceramic Society
• /
• v.22 no.3
• /
• pp.60-66
• /
• 1985

The formation mechanism of unstable alkali and its existing states in the clinker were studied. The relation of unstable alkali content vs. other water-soluble components porosity and the distributionof potassium were investigated. The results are as follows :1) Two states of unstable alkali seem to exist in clinker ie compounds of $K_2O-Al_2O_3$ system and free $K_2O$ 2) The content of water-soluble $Al_2O_3$ tends to increase with increase of unstable alkali content, 3) Most of alkalies in clinker are concentrated in liquid phase at high temperature. Therefore it is possible to make various $K_2O-Al_2O_3$ system compounds according to the content of $K_2O$ in the liquid phase of clinker. In this experiment we found out a $K_2O-Al_2O_3$ compound of high $Al_2O_3$ content (34%) and high $K_2O$ content (33%) in clinker with 1.09% unstable alkali. 4) The porosity of clinker tends to increase with increase of unstable alkali content. 5) The amount of trapped alkali vapor may increase in closed pore in the clinker with high alkali and low $SO_3$ condecent. Therefore free $K_2O$ is the condensed alkali on the wall of closed pore in the clinker.

• Korean Journal of Food Science and Technology
• /
• v.22 no.7
• /
• pp.738-742
• /
• 1990

Cell wall components were decreased during maturation and postharvest of persimmon fruits. Contents of pectin and alkali-soluble hemicellulose were increased during maturity, but those of acid-soluble hemicellulose were decreased. Contents of pectin and alkali-soluble hemicellulose were decrease in soft persimmon, whereas acid-soluble hemicellulose was increased remarkably. Cellulose contents were increased during maturation and this tend was notable in soft persimmon. Contents of cell wall polysaccharides per 100g-fresh weight were decreased. Contents of total pectin and insoluble pectin were increased during maturation but decreased in soft persimmon. Content of water-soluble pectin was increased during maturation and postharvest.

• Journal of the Korean Recycled Construction Resources Institute
• /
• v.5 no.1
• /
• pp.111-116
• /
• 2010

The treatment of heavy metal, in the waste ash from incinerator and mine solid waste, by using alkali-soluble acrylic copolymer emulsion, that is effective in the absorption of heavy metal has been studied. It seemed that alkali soluble acrylic copolymer emulsion was very effective in the absorption of Hg, Pb, Cd and Cu in this test. Also, eco-friendly thixotropic grout, using alkali soluble acrylic copolymer emulsion, that is effective in the absorption of heavy metal, for the recycling of waste ash from incinerator and mine solid waste has been tested. It was observed that waste ash could be used as a raw material of eco-friendly thixotropic grout mortar due to the effectiveness of alkali soluble acrylic copolymer emulsion in the fixation of heavy metals including $Cr^{6+}$ from waste ash in this test.

• Journal of the Korean Ceramic Society
• /
• v.22 no.2
• /
• pp.25-32
• /
• 1985

Effect of alkali $SO_3$ and $C_2S$ content and cooling condition of clinker on the formation of unstable alkali and cooling condition of clinker on the formation of unstable alkali was investigated. As a result alkali and $SO_3$ content of clinker were the main factors of unstable alkali formation and equation (7) in which the two factors were the variables showed a good agreement with the observed results. Water soluble alkali content of sulphate was decreased with increase of $C_2S$ content of clinker resulted by the increase of solid solution rate of alkali to clinker minerals. But change of unsatble alkali content accordint to the increase of $C_2S$ content was slight. A increasing tendency of ignition loss of clinker with increase of unstable alkali content was found.