• The Journal of the Acoustical Society of Korea
• /
• v.31 no.1
• /
• pp.1-10
• /
• 2012

The linear and decision-feedback equalization can mitigate time-varying intersymbol interference (ISI) caused by time-varying multipath propagation for underwater acoustic channels. The perfect elimination of interference components, however, is difficult using the linear equalization and the decision feedback equalizer has an error propagation problem. To overcome these shortcomings, this paper proposes an equalizer mode selection method using training sequences. The proposed method selects an equalization mode corresponding to the signal-to-noise ratio (SNR). If the SNR is low, the proposed system operates the linear equalizer for preventing the error propagation and if the SNR is high, the decision feedback equalizer for eliminating the residual ISI. Therefore, the proposed method can improve the error performance compared to the conventional equalizers. The computer simulation shows the proposed method improves the bit error performance using practical underwater channels responses acquired from the sea experiment.

• Smart Structures and Systems
• /
• v.15 no.3
• /
• pp.627-643
• /
• 2015

Negative stiffness, previously emulated by active or semi-active control for cable vibration mitigation, is realized passively using a self-contained highly compressed spring, the negative stiffness device (NSD).The NSD installed in parallel with a viscous damper (VD) in the vicinity of cable anchorage, enables increment of damper deformation during cable vibrations and hence increases the attainable cable damping. Considering the small cable displacement at the damper location, even with the weakening device, the force provided by the NSD-VD assembly is approximately linear. Complex frequency analysis has thus been conducted to evaluate the damping effect of the assembly on the cable; the displacement-dependent negative stiffness is further accounted by numerical analysis, validating the accuracy of the linear approximation for practical ranges of cable and NSD configurations. The NSD is confirmed to be a practical and cost-effective solution to improve the modal damping of a cable provided by an external damper, especially for super-long cables where the damper location is particularly limited. Moreover, mathematically, a linear negative stiffness and viscous damping assembly has proven capability to represent active or semi-active control for simplified cable vibration analysis as reported in the literature, while in these studies only the assembly located near cable anchorage has been addressed. It is of considerable interest to understand the general characteristics of a cable with the assembly relieving the location restriction, since it is quite practical to have an active controller installed at arbitrary location along the cable span such as by hanging an active tuned mass damper. In this paper the cable frequency variations and damping evolutions with respect to the arbitrary assembly location are then evaluated and compared to those of a taut cable with a viscous damper at arbitrary location, and novel frequency shifts are observed. The characterized complex frequencies presented in this paper can be used for preliminary damping effect evaluation of an adaptive passive or semi-active or active device for cable vibration control.

• Journal of the Institute of Electronics Engineers of Korea CI
• /
• v.47 no.5
• /
• pp.61-66
• /
• 2010

A stereo vision, which is based on two or more images taken from different view points, is able to build three dimensional maps of its environment having various applications including robots and home networks. SAD algorithm, which is based on area-based correlation, is widely used since its regular structure provide abundant parallelism. In this paper, we present heuristic designs of SAD algorithm to meet the demands on accuracy and resource usages in various applications. The disparity abridgement and the window abridgement algorithms can be used for vision systems in low cost and small size. The window shape algorithm can be applicable when object are in specific shapes. The adaptive window algorithm work well when accuracy is the primary concern.

• International Journal of Advanced Culture Technology
• /
• v.5 no.1
• /
• pp.90-97
• /
• 2017

Nowadays, the most of commercial buildings are build-out with complex architecture and decorated with more complicated interiors of buildings so establishing intelligible escape routes becomes an important case of fire or other emergency in a limited time. The commercial buildings are already equipped with multiple exit signs and these exit signs may create confusion and leads the people into different directions under emergency. This can jeopardize the emergency situation into a chaotic state, especially in a complex layout buildings. There are many research focused on implementing different approached to improve the exit sign system with better visual navigating effects, such as the use of laser beams, the combination of audio and video cues, etc. However the digital signage system based emergency exit sign management is one of the best solution to guide people under emergency situations to escape. This research paper, propose an intelligent evacuation route GUIDE that uses the combination centralized Wireless Sensor Networks (WSN) and digital signage for people safety and avoids dangers from emergency conditions. This proposed system applies WSN to detect the environment condition in the building and uses an evacuation algorithm to estimate the safe route to escape using the sensor information and then activates the signage system to display the safe evacuation route instruction GUIDE according to the location the signage system is installed. This paper presented the prototype of the proposed signage system and execution time to find the route with future research directions. The proposed system provides a natural intelligent evacuation route interface for self or remote operation in facility management to efficiently GUIDE people to the safe exit under emergency conditions.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.36 no.3A
• /
• pp.250-258
• /
• 2011

In this paper we propose a load balancing scheme for heterogeneous multiple AS's (Application Server) in IMS (IP Multimedia Subsystem) based network. In IMS network, to perform load balancing among multiple ASs with different registration pattern, different weight value should be set for each AS. In previous systems, there exists an inconvenience that the weight value should be set manually by the operator after monitoring the result. In this paper we propose a method to calculate optimal weight in automatic manner and to perform load balancing simultaneously. We also propose a simplified algorithm to reduce calculation in specific situation and present a way to apply our proposed scheme in adaptive manner according to the situation. Through simulation result, we verify that our proposing scheme outperforms previous schemes in load balancing and adjusts well to the change of the system in automatic manner with fast convergence.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.36 no.3A
• /
• pp.189-197
• /
• 2011

OFDM systems are much studied for the recent high speed wireless optical communication system. OFDM system has basically high PAPR and ICI easily generated because of non-linearity and RF impairments. In the wireless optical communication system, optical output power driven by current of LED is not linear so that transmission signals are distorted. Therefore, research about reception performance of this nonlinear optical output emitted by non-linear LED transfer function and OFDM signal has been conducted. Nonlinear effect of LED is different from nonlinear effect of OFDM system in the conventional radio communication system, which degrades the BER performance. In this paper, we apply non-linear transfer function of recently studied LED into OFDM system. So, for reducing the PAPR and suppressing the ICI in frequency domain of receiver, we suggest a new PAPR reduction technique to reduce non-linear distortion of LED and an adaptive ICI suppression algorithm so that BER performance may be improved. Also, the proposed method is verified through simulation results.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.34 no.5B
• /
• pp.489-497
• /
• 2009

In the 3GPP LTE and IEEE 802.16m standardizations for IMT-Advanced, the efficient transmission of multicast and broadcast data is one of the important issues to improve system performance. Especially, to guarantee each user's QoS in the multicast group, H-ARQ or adaptive modulation are considered to be adoption, however, reduction of feedback overhead is one of the most important issues. In this paper, performance of the previously proposed OOK (On-Off Keying) based common ACK/NACK feedback channel is analyzed through theoretical analysis and simulation. Based on the results, system parameter optimization methods for common feedback channel are proposed. In addition, through computer simulation, it is shown that the common feedback method according to the proposed feedback parameter optimization can feedback ACK/NACK information for multicast H-ARQ transmission, more reliably than the conventional user dedicated feedback method in 3GPP LTE systems, and can reduce the feedback overhead as well.

• Journal of Korea Game Society
• /
• v.7 no.2
• /
• pp.21-32
• /
• 2007

It is significant to simulate scattering of light within media for realistic image synthesis; however, this requires costly computation. This paper introduces a practical image-space approximation technique for interactive subsurface scattering. We use a general two-pass approach, which creates transmitted irradiance samples onto shadow maps and computes illumination using the shadow maps. We estimate single scattering efficiently using a method similar to common shadow mapping with adaptive deterministic sampling. A hierarchical technique is applied to evaluate multiple scattering, based on a diffusion theory. We further accelerate rendering speed by tabulating complex functions and utilizing level of detail. We demonstrate that our technique produces high-quality images of animated scenes with blurred shadow at hundreds frames per second on graphics hardware. It can be integrated into existing interactive systems easily.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.4 no.1
• /
• pp.191-200
• /
• 2000

The marine accident is being highlighted as a serious worldwide problem for the guard station of human safety and the protection of marine environment pollution. Especially, the GMDSS is operated as a international rule for the safety of a large scale ship, but the small size ship's management is required a adaptive national rule because of the complex condition of national circumstance. This study is motivated to develop a ship's position tracking system combined with GPS information for VTS and control the ship navigation, velocity and longitude etc.. In Part of Navigation Data Transmission is GPS data transmission whih ship's ID using microprocessor and TX speed translation for flexibility with 4800∼2400 [bps]. Results show that the our system for data transmission using microprocessor is useful tool in maritime transmission as SSB used the main TX method of small ship and has a cost competitive power. Therefore, we will expected cost and technical competitive power compared to AIS. But those systems are still remained the unsolved problem for protection from marine accident.. Finally, we examined the semi-actual receiving state on simulated sailing in the around sea of Mok-Po harbor.

• Journal of Broadcast Engineering
• /
• v.23 no.2
• /
• pp.206-217
• /
• 2018

We develop the signal processing method for adaptive implementing direction of signal and the frequency sensitivity of human visual system(HVS). Existing multiband energy scaling method makes ringing artifact because it does not consider signal direction. To solve this problem, we use block gradient for signal direction in addition to existing method. And we use the fact that frequency component of signal is more sensitive than value of signal over human eyes. we enhance the signal according to contrast sensitivity function(CSF) which is the model of frequency sensitivity of human eye. Compared that the existing analysis models only improve the efficiencies in the existing systems, the developed method can process the image signals to be more desirable and suitable to HVS.