• Journal of the Institute of Electronics and Information Engineers
• /
• v.51 no.12
• /
• pp.3-11
• /
• 2014

Multiple antennas can provide huge capacity gains when the transmitter knows the channel state information (CSI). Precoding is a technique that exploits CSI at the transmitter side. In this paper, an adaptive precoding scheme is proposed, called a hybrid multiple-input multiple-output (MIMO) precoding (HMP). HMP is a combination of linear and nonlinear precoding. The number of transmit antennas less than or equal to four is as same as the conventional antenna selection scheme. Therefore, the HMP scheme uses more than four transmit antennas. The good channel means that the channels must be selected to maximize the channel capacity among the given channels, and the rest channels are called bad channel. In HMP scheme, we use the nonlinear precoding in the good channels and the linear precoding in the bad channels. The well-known Tomlinson-Harashima precoding (THP) is considered as nonlinear precoding. The system throughput and MSE (minimum square error) are shown for the performance of HMP scheme compared to the conventional schemes which are BD (block diagonalization), antenna selection and THP.

• 전자공학회논문지 IE
• /
• v.43 no.2
• /
• pp.80-86
• /
• 2006

The wireless communication based on LDPC and adaptive spatial-subcarrier coded modulation using MQAM for orthogonal frequency division multiplexing (OFDM) wireless transmission by using instantaneous channel state information and employing multiple antennas at both the transmitter and the receiver. Adaptive coded modulation is a promising idea for bandwidth-efficient transmission on time-varying, narrowband wireless channels. On power limited Additive White Gaussian Noise (AWGN) channels, low density parity check (LDPC) codes are a class of error control codes which have demonstrated impressive error correcting qualities, under some conditions performing even better than turbo codes. The paper demonstrates OFDM with LDPC and adaptive modulation applied to Multiple-Input Multiple-Output (MIMO) system. An optimization algorithm to obtain a bit and power allocation for each subcarrier assuming instantaneous channel knowledge is used. The experimental results are shown the potential of our proposed system.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.31 no.9A
• /
• pp.844-855
• /
• 2006

The communication system using multiple antennas improves link reliability or system capacity using tx & rx diversity, spatial multiplexing, and beamforming technique with services and characteristics of channel environment. This system is sensitive to spatial channel environment. In case of diversity, the lower correlation among links as a LoS environment, the better performance is acquired. In practical channel environment, However, there is high correlation, and there is high performance difference between ideal case and practical case. On the contrary, in case of beamforming, the higher correlation among links, the better performance is acquired. If we use the spatial adaptive transmission technique with spatial channel characteristics, we can get the system that maintains minimum link reliability and guarantees the overall system performance. In this paper, we propose the adaptive transmission and reception technique which use diversity or beamforming technique with channel characteristics.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.15 no.6
• /
• pp.812-819
• /
• 2012

Interference and jamming are becoming increasing concern to a radar system nowdays. AESA(Active Electronically Steered Array) antennas and adaptive beamforming(ABF), in which antenna beam patterns can be modified to reject the interference, offer a potential solution to overcome the problems encountered. In this paper, we've developed a planar active phased array radar system, in which ABF, target detection and tracking algorithm operate in real-time. For the high output power and the low noise figure of the antenna, we've designed the S-band TRMs based on GaN HEMT. For real-time processing, we've used wavelenth division multiplexing technique on fiber optic communication which enables rapid data communication between the antenna and the signal processor. Also, we've implemented the HW and SW architecture of Real-time Signal Processor(RSP) for adaptive beamforming that uses SMI(Sample Matrix Inversion) technique based on MVDR(Minimum Variance Distortionless Response). The performance of this radar system has been verified by near-field and far-field tests.

• The Journal of Korea Institute of Information, Electronics, and Communication Technology
• /
• v.7 no.2
• /
• pp.111-116
• /
• 2014

In this paper, we estimates the direction of arrival of desired a target using linear array antenna in wireless communication. Direction of arrival estimation is to estimate for desired target position among incident signals on receiver array antennas. This paper improved estimation of direction of arrival for target using optimum weight, high resolution adaptive beamforming algorithm, and sparse matrix for driection of arrival estimation. Through simulation, we showed that we are performance the analysis to compare general algorithm with proposed algorithm. We show that propose algorithm more improve for direction of estimation than general beamforming algorithm.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.16 no.5
• /
• pp.613-621
• /
• 2013

This paper presents the direction finding proximity fuze sensor using the clutter rejection method and the adaptive target detection algorithm for anti-air missiles. To remove effects by clutter and detect a target accurately, the clutter rejection method of Legendre sequence with BPSK(Bi phase Shift Keying) modulation has been proposed and the Doppler signal which has cross correlation characteristics is obtained from reflected target signals. Considering the change of the Doppler signal, the adaptive target detection algorithm has been developed and the direction finding algorithm has been fulfilled by comparing received powers from adjacent three receiving antennas. The encounter simulation test apparatus was made to collect and analyze reflected signal and test results showed that the -10 dBsm target was detected over 10 meters and the target with mesh clutter was detected and direction was distinguished definitely.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2007.10a
• /
• pp.347-350
• /
• 2007

Adaptive arrays have been proposed as an effective means of mitigating Multiple Access Interference (MAI) and improving the performance of existing and future wireless communication systems. In this paper, we apply the analytical method proposed to analyse the theoretical Mean Bit Error Rate (BER) of an uncoded IS-95 based CDMA system with an array antenna at the BS in a Ricean fading environment. We present a modified expression for the Signal to Interference plus Noise (SINR) ratio as a function of the number of users, number of antennas and noise levels. We also verify the analytical results by means of simulations by considering different user and channel scenarios.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.18 no.7
• /
• pp.2027-2046
• /
• 2024

Reconfigurable Intelligent Surface (RIS) is an innovative technique to precisely control the phase of incident signals with the help of low-cost passive reflective elements. It shows excellent potential in the sixth generation of mobile communication systems, which not only extends wireless coverage but also boosts channel capacity. Considering that multipath propagation and a high number of antennas are involved in RIS in assisted mega multiple-input multiple-output (MIMO) systems, it suffers from severe channel fading and multipath effects, which in turn lead to signal instability and degradation of transmission performance. To overcome this obstacle, this essay suggests an improved gradient optimization algorithm to dynamically and optimally adjust the phase of the reflective elements to counteract channel fading and multipath effects as a strategy. In order to overcome the optimization problem of falling into local minima, this paper proposes an adaptive learning rate algorithm based on Adagrad improvement, which searches for the global optimal solution more efficiently and improves the robustness of the optimization algorithm. The suggested technique helps to enhance the estimate of channel efficiency of RIS-assisted large MIMO systems, according to simulation results.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.14 no.1
• /
• pp.81-88
• /
• 2003

For driver's convenience, the ACC(Adaptive Cruise Control) requires a system which determines the direction of vehicles and controls the vehicle to keep the distance among the automobiles constant. This paper describes the microstrip array antennas designed to operate at 24 GHz, and used as a direction indicator of moving vehicles. 8${\times}$2 transmit array antenna with wide beamwidth, 8${\times}$4 receive center array antenna, and two 8${\times}$8 receive array antennas with narrow beamwidth were designed and fabricated. Measurement results for the arrays showed that the azimuthal beamwidth is 50$^{\circ}$and the gain is 16.7 dBi for the transmit array antenna. For the receive array antenna, the center, the left, and the right array antenna have beamwidths of 20$^{\circ}$, 13$^{\circ}$, 13$^{\circ}$respectively, and have gains of more than 20 dBi. The left and right array antenna have the beam tilt angle of ${\pm}$18$^{\circ}$. The measured radiation patterns showed a good agreement with the simulated patterns, and the designed array antennas are suitable fur detecting 3 directions of the vehicle within the scan angle area.

• Journal of the Korean Institute of Telematics and Electronics S
• /
• v.35S no.10
• /
• pp.144-155
• /
• 1998

The array weights that will maximize the SNR for any type of noise environment are determined by the function of the antenna design configuration and the directions of receiving target and interference signals. The conventional SLCs(sidelobe cancellers) using the SNR maximization perform worst from the saturation of the receiving system of main channel when the main antenna has pattern with high gain at the arrival angle of strong interference. In this paper, the new SLC is accomplished by using two independent antenna architecture. Main antenna is implemented with adaptive nulling, which is used for rejecting high-power interference primarily. Auxiliary antenna is realized with adaptive array for receiving interference signal to be suppressed completely, which has a characteristics of sufficient gain for every direction. The new SLC is implemented with above both antennas. We show that the new SLC, which consists of the adaptive nulling main antenna and the adaptive array auxiliary antenna, is useful in reducing the effect of strong interference like jammer, because the adaptive nulling at main antenna prevents its receiver and signal processor for saturation by strong interference. The proposed SLC has improved SNR over the conventional SLCs. The improved SNR at sidelobe region is typically more than 7 dB for a given test signal. Moreover, it improves the SNR of about 20 dB under strong interference at mainlobe.