• 센서학회지
• /
• 제20권1호
• /
• pp.14-18
• /
• 2011

An analytical pinning-voltage model of a pinned photodiode has been proposed and derived. The pinning-voltage is calculated using doping profiles based on shallow- and exponential-junction approximations. Therefore, the derived pinning-voltage model is analytically expressed in terms of the process parameters of the implantation. Good agreement between the proposed model and simulated results has been obtained. Consequently, the proposed model can be used to predict the pinning-voltage and related performance of a pinned photodiode in a CMOS active pixel sensor.

• Carbon letters
• /
• 제1권1호
• /
• pp.27-30
• /
• 2000

Performance of direct methanol fuel cell using high porous active carbon as an uncatalysed diffusion layer in anode (composite electrode) has been evaluated. Effects of porous active carbon in anode were investigated by galvanostatic method and Fourier Transform Infrared spectroscopy. The single cell was operated with 2.5 M methanol at temperature of $80-120^{\circ}C$ and showed performance of $210-510\;mA/cm^2$ at 0.4V. By replacing conventional electrode with composite electrode, the increment of $290\;mA/cm^2$ in current density was obtained at $90^{\circ}C$and 0.4V. The potential decay of the single cell was about 14.5% for 20 days operation.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2004년도 추계학술대회 논문집
• /
• pp.59-63
• /
• 2004

In this paper, active forward converter with snubber circuit - composed of a tapped inductor, a snubber capacitor, two diodes - is proposed. By adding the snubber circuit, ZVS operation became possible even in a smaller magnetizing current conditions than the conventional converter. The operational principles and the equivalent mode analysis of the proposed converter is described and compared to conventional converter. We constructed the prototype active clamped forward converter with 300W output capacity and verified that efficiency of the proposed converter is higher than the conventional converter.

• 조명전기설비학회논문지
• /
• 제22권3호
• /
• pp.79-87
• /
• 2008

This paper presents a simple circuit topology of the auxiliary active quasi-resonant DC link snubber-assisted three phase voltage source soft-switching inverter for small scale PM motor drive applications. The pulse processing drive circuit interface and its soft-switching operation are discussed from an experimental point of view. Moreover, its conductive noise is measured and evaluated for electrical AC servo motor drive as compared with that of the conventional hard switching inverter.

• Journal of Communications and Networks
• /
• 제11권4호
• /
• pp.406-415
• /
• 2009

In this work, we consider performance modeling of a wireless sensor network with a time division multiple access (TDMA) media access protocol with slot reuse. It is assumed that all the nodes are peers of each other and they have two modes of operation, active and sleep modes. We model the sensor network as a Jackson network with unreliable nodes with on and off states. Active and sleep modes of sensor nodes are modeled with on and off states of unreliable nodes. We determine the joint distribution of the sensor node queue lengths in the network. From this result, we derive the probability distribution of the number of active nodes and blocking probability of node activation. Then, we present the mean packet delay, average sleep period of a node and the network throughput. We present numerical results as well as simulation results to verify the analysis. Finally, we discuss how the derived results may be used in the design of sensor networks.

• 전력전자학회논문지
• /
• 제10권2호
• /
• pp.169-176
• /
• 2005

본 논문에서는 능동 클램프 풀브릿지 Boost 컨버터에 관한 DC 모델링과 AC 모델링 과정에 대하여 기술한다. 동작 원리로부터 이 컨버터의 교류 부분을 등가의 직류 부분으로 바꾸고 반도체 스위치를 재배치하여 개념적인 등가 회로가 유도된다. 유도된 등가회로는 CCM(Continuous conduction mode) Boost 컨버터와 DCM(Discontinuous conduction mode) Buck 컨버터로 표현된다. 유도된 등가회로의 각 스위치 부분을 PWM 스위치 모델로 대체하여 DC 모델 및 AC 모델이 완성된다. 이론적인 DC 및 AC 모델링 결과는 실험이나 SIMPLIS 시뮬레이션을 통해 검증된다.

• Journal of Power Electronics
• /
• 제12권5호
• /
• pp.723-730
• /
• 2012

This paper presents a new ZVS single phase bridgeless (Power Factor Correction) PFC, using an active clamp to achieve zero-voltage-switching for all main switches and diodes. Since the presented PFC uses a bridgeless rectifier, most of the time, only two semiconductor components are in the main current path, instead of three in conventional single-switch configurations. This property significantly reduces the conduction losses,. Moreover, zero voltage switching removes switching loss of all main switches and diodes. Also, auxiliary switch turns on zero current condition. The presented converter needs just a simple non-isolated gate drive circuitry to drive all switches. The eight stages of each switching period and the design considerations and a control strategy are explained. Finally, the converter operation is verified by simulation and experimental results.

• 조명전기설비학회논문지
• /
• 제28권5호
• /
• pp.122-133
• /
• 2014

This paper deals with the rapid charger which is the mid-type between the slow and fast chargers in the aspect of charging time. In its functions, it can perform the Active Power Filter(APF) function without changing the topology besides the charging function. In addition, to perform the charging and APF function, this paper proposes the mode selection algorithm. The operation of the charger that has APF function and the mode selection algorithm are verified by the simulation and experiment.

• 한국정밀공학회지
• /
• 제21권5호
• /
• pp.83-83
• /
• 2004

The analysis of relative pose(position and rotation) between stereo cameras is very important to determine the solution that provides three-dimensional information for an arbitrary moving target with respect to robot-end. In the space of free camera-model, the rotational parameters act on non-linear factors acquiring a kinematical solution. In this paper the general solution of active stereo that gives a three-dimensional pose of moving object is presented. The focus is to achieve a derivation of linear equation between a robot′s end and active stereo cameras. The equation is consistently derived from the vector of quaternion space. The calibration of cameras is also derived in this space. Computer simulation and the results of error-sensitivity demonstrate the successful operation of the solution. The suggested solution can also be applied to the more complex real time tracking and quite general and are applicable in various stereo fields.

• 한국정밀공학회:학술대회논문집
• /
• 한국정밀공학회 2005년도 추계학술대회 논문집
• /
• pp.661-665
• /
• 2005

The muffler reducing the exhaust noise and vibration from the engine influence on the engine performance. Recently the semi-active muffler was developed and adopted to the actual use in consideration of the cost and technical side for noise and vibration. This study is about the recently developed semi-active muffler. This paper attempt to analyze the dynamic stress field on the gate plate by using the finite element methods. According to the analysis of the Exhaust Variable Valve, its spring has the most influence on its operation compare with effects of other components. The design parameters of the Exhaust Variable Valve such as the spring displacement, diameter, coil number, free angle and so forth were used.