• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.14 no.11
• /
• pp.6015-6022
• /
• 2013

It has been known that there are large amount of nitric acid and valuable metals, copper in the plating waste solution of automobile wheel. As nitric acid and valuable metals are high price and toxic, they should be recovered for economics and environment. Plating waste was extracted with TBP diluted with kerosene. The concentration of nitric acid in aqueous phase was analyzed by titration method by NaOH solution (0.1~1.0N) and the amount of metals by ICP-MS and ICP-AES. The concentration of copper in plating waste were 76,850 mg/L. The concentration of nitric acid in plating waste was 1.02 M. After three step extraction was performed with 50% TBP, each organic phase was stripped three times with distilled water to obtain 48.1% of nitric acid. Purity of final nitric acid was over 99.9% by ICP analysis. After recovery of nitric acid, copper was extracted with various solvent extractors like PC 88A, D2EPHA, LIX 84 and ISE 106. Among these extractors, 92% of copper was recovered by ISE 106 after 1st extraction and 30% $H_2SO_4$ stripping. Copper ion was reduced with $N_2H_4$ to make metal powders, respectively.

• Journal of the Korean Society of Environmental Restoration Technology
• /
• v.27 no.4
• /
• pp.29-43
• /
• 2024

The purpose of this study was to analyze the soil on two waste areas that lack plants to find out the limiting factors of plant introduction, and to find out the possibility of plant introduction through plant growth experiments by mixing the two waste soil. In the case of tungsten waste soil, insufficient organic matter, water content, effective phosphoric acid, and nitrogen content were the limiting factors for plant introduction, and in the case of coal waste soil, low pH of the soil acted as the limiting factors for natural introduction. Growth experiments showed that the number of leaves of Ipomoea nil grown in soil mixed with both waste soil was 2.7 times greater than that of Ipomoea nil grown in tungsten waste soil, and 2.29 times greater than that of Ipomoea nil grown in coal waste soil. The fresh weight comparison showed that Ipomoea nil grown in soil mixed with the two waste soil had a fresh weight of 2.64 times higher than that of tungsten waste soil and 2.45 times higher than that of coal waste soil. There was no significant difference in the fresh weight of Ipomoea nil grown in soil mixed with the two waste soil and in general soil. Therefore, when the two waste soil are mixed, it can be judged that the components unfavorable to growth complement each other, improving the soil and being effective in plant growth.

• Membrane Journal
• /
• v.7 no.4
• /
• pp.167-174
• /
• 1997

The concentration of silica is required to meet a certain level because silica affects fuel and materials integrity by forming a zeolite layer on fuel cladding surfaces. When the established Feed and Bleed method is employed, nuclear waste increase and the corresponding amount of boric acid is constantly consumed. This study concentrates on minimizing the amount of nuclear waste and consumption of boric acid. Using five different membranes, operating conditions such as temperatur, feed water flow rate, boric acid recovery and silica removal rate were examined. A silica-selective removal system was designed based on the above optimization procedures. Three-stage system was designed with two characteristically different membranes so that it could correspond with the different situation easily. Compared to the pevious results of the Feed and Bleed method, the current method showed that the amount of nuclear waste was reduced to 7%, and the consumption of boric acid to 15.7%.

• Proceedings of the Korean Society of Soil and Groundwater Environment Conference
• /
• 2002.04a
• /
• pp.209-212
• /
• 2002

Main radionuclides of the soil waste stored in Korea Atomic Energy Research Institute are Co-60 and Cs-137. Moisture content of soil is 12%, pH of soil is 5.8, and content of organic matter is 2.2 %. Radioactive concentrations of the soil particle size of which is less than 0.063mm and soil in the drum surface of which is more than radiation dose rate 0.05mR/hr are higher. Meanwhile, radioactive concentration of soil in the drum surface of which is less than radiation dose rate 0.02 mR/hr are mostly lower. On using the mixing solution of ammonium sulfate and citric acid, 62% Co was removed from soil and 41% Cs was removed. Also, on using the mixing solution of ammonium nitrate and citric acid, 61% Co was removed from soil and 39% Cs was removed, and on using the mixing solution of ammonium potassium oxalate, 36% Co was removed and only 3% Cs was removed. And on using only water, removal efficiency is less than 5%.

• Journal of the Korean GEO-environmental Society
• /
• v.5 no.4
• /
• pp.13-24
• /
• 2004

This study was carried out to plan the prevention of the generation and discharge of Acid Rock Drainage (ARD). The Acid Base Accounting(ABA) test was performed for geological materials such as pit wall, waste rock and stream sediments near the Imgi abandoned pyrophyllite mine in Busan, Korea. In addition, hydraulic characteristics were tested with the disk tension infiltrometer around the waste rock dump. Maximum Potential Acidity(MPA) of geological materials near the Imgi mine was 246.942kg $H_2SO_4/t$, and maximum Acid Neutralising Capacity(ANC) was 8.7kg $H_2SO_4/t$. These results indicate the pit wall and waste rock, except most of stream sediments are acid generating geological materials. These have salt and free hydrogen ion which resulted from oxidation of sulfides. Hence they could be convert rain water to acid rock drainage. Although the waste rock dump of the Imgi mine have very low infiltration rate, slopes of the waste rock dump have many "V" type erosion gullies and multi-layers. These gullies and multi-layers have coarse clastic particle layers which have very large hydraulic conductivity. Through this coarse clastic particle layer a large part of rain flow into ground. And also this layer could function as aeration path which induced oxidation of sulfide minerals and generation of ARD continuously.

• Journal of Korean Society of Water and Wastewater
• /
• v.31 no.4
• /
• pp.357-362
• /
• 2017

Acetate, propionate, butyrate are the major soluble volatile fatty acids metabolites of fermented food waste leachates. This work investigate the effects of volatile fatty acid on the growth rate and $NH_4-N$, $PO_4-P$ removal efficiency of mixotrophic microalgae Chlorella vulgaris to treat digested food waste leachates. The results showed that acetate, propionate and butyrate were efficiently utilized by Chlorella vulgaris and microalgae growth was higher than control condition. Similar trends were observed upon $NH_4-N$ and $PO_4-P$ consumption. Volatile fatty acids promoted Chlorella vulgaris growth, and nutrient removal efficiencies were highest when acetate was used, and butyrate and propionate showed second and third. From this work it could be said that using mixotrophic microalgae, in this work Chlorella vulgaris, fermented food waste leachates can be treated with high efficiencies.

• Journal of Korean Society on Water Environment
• /
• v.23 no.6
• /
• pp.961-965
• /
• 2007

In this study, degradation of carbohydrates and composition of fermentative products were investigated in semi-continuous acid fermenter varying hydraulic retention time (HRT). Rice soup was used as a sole substrate for the acid fermentation. Solubilization efficiency of the substrate was higher than 70% for all HRT, however the gas conversion was ignorable implying that most of organic contents in the influent remained in the form of volatile fatty acids (VFAs) and ethanol after acid fermentation. The VFAs were the predominant product and the VFAs conversion increased as the HRT decreased. The VFAs conversion reached the maximum value at 12 hr HRT accounting for 70% of the influent COD. Similar to VFAs, ethanol conversion was increased with the decrease of HRT and the maximum ethanol conversion efficiency was 8% at the HRT of 12 hr. Composition of VFAs was markedly dependent on HRT. As HRT increased, the composition of acetic acid was increased as a product of acetogenesis from butyrate, valerate and ethanol. This study demonstrated that HRT affected acid fermentation of a carbohydrate containing organic wastes producing VFAs and ethanol which could be effectively used to compensate the lack of carbon in wastewater for biological nutrient removal.

• Journal of the Korean Ceramic Society
• /
• v.55 no.5
• /
• pp.446-451
• /
• 2018

In this study, different formulations of magnesium oxide and various modifiers (phosphoric acid, ferrous sulfate, pure acrylic emulsion, silicone acrylic emulsion, glass fiber, and polypropylene fiber) were used to prepare magnesium oxychloride cement composites. The compressive strength of the magnesium oxychloride cement was tested, and the softening coefficients of the composites after soaking in water were also calculated. The results showed that a magnesium oxychloride cement sample could not be coagulated when the MgO activity was 24.3%, but the coagulation effect of the magnesium oxide cement sample was excellent when the MgO activity was 69.5%. While pure acrylic emulsion, silicon-acrylic emulsion, and glass fiber showed insignificant modification effects on the magnesium oxychloride cement, ferrous sulfate heptahydrate, phosphoric acid, and polypropylene fiber could effectively improve its water resistance and compressive strength. When the phosphoric acid, ferrous sulfate heptahydrate, and polypropylene fiber contents were 0.47%, 0.73%, and 0.25%, respectively, the softening coefficient of a composite soaked in water reached 0.93 after 7 days, and the compressive strength reached 64.3 MPa.

• Journal of the Korean Chemical Society
• /
• v.4 no.1
• /
• pp.38-43
• /
• 1957

Purified cellulosic materials suitable for the production of cellulose esters can be prepared from waste cotton (carding waste from textile mill). The most desirable conditions in purifying waste cotton were obtained. Waxy materials were removed by boiling in 2-3% soda ash solution for more than 30 minutes in open vessel at atmospheric pressure. As for bleaching, it is desirable to use the bleaching powder solution containing 1%, available chlorine for 60 minutes at 35 deg. C. Purified cellulosic material was acetylated to fibrous cellulose triacetate, which was fractionated in the solution of 70% monochloroacetic acid using water as a precipitant, and the degree of polymerizaion and molecular weight of each fraction were measured viscometrically, thereon, molecular weight distribution curve was drawn. Analyzing the shape of this curve, most of the polymers were concentrated on the part of higher degree of polymerization. Purified waste cotton was also analysed, the result was that this cellulosic material can be used as a raw material for cellulose esters and ethers.

• Journal of Environmental Science International
• /
• v.10 no.2
• /
• pp.153-158
• /
• 2001

The biosorption abilities of different parts of waste brown seaweeds and their derivatives to remove heavy metals (Cd, Zn, Pb, Cu, Fe, Ni, Mn) from waste were evaluated. The two parts of waste brown seaweeds (Undaria pinnatifida) were stems and sporophyls, and the brown seaweed derivatives were alginic fibers, active carbon added alginate(AC-alginate) and dealginate. The abilities of the sporophyls to adsorb the heavy metal ions were higher than those of stems, and those of alginates were slightly higher than those of dealginate in single ion solution. With decreasing the size of biosorbents, the velocity and the amount of adsorption increased. The abilities of alginate to remove the heavy metal ions increased in multi-ion solutions by adding active carbon to alginate. The selectivity of these biosorbents(alginate, AC-alginate) to lead ion was highest and to manganese ion was lowest.