• Applied Biological Chemistry
• /
• v.35 no.2
• /
• pp.69-75
• /
• 1992

Viscosity changes of acidified milk at the various pH $ranges(5.2{\sim}4.2)$was measured as a function of temperature. The rate and extent of acid-induced coagulation of milk protein were monitored by turbidity changes as a function of temperature, preheating and salt. Relative viscosities of acidified milk were also measured. The coagulation of casein occurred in a specific pH range and was accompanied by a sharp increase in viscosity at pH of $5.0{\sim}5.2$, depending on the heating temperatures. Onset pH of coagulation and maximum coagulation rate were enhanced by increasing temperatures and preheating process and reduced by addition of salt. Relative viscosity of acidified milk was reversed at the same conditions, reflecting the size of casein coagulum formed was related to the coagulation rate.

• Preventive Nutrition and Food Science
• /
• v.2 no.3
• /
• pp.259-262
• /
• 1997

The microstructures of soybean milk curds, prepared by different coagulation methods, were observed by the scaning electron microscope. Th curd coagulated by theaddition of bacerial soybean mil clotting enzyme showed little textural changes and gave smoother gel than those prepared either by lactic acid fermentation using Streptococcus thermophilus or by the addition of CaSO$_4$. The curds obtained by lactic acid fermentation and by the addition of inorganic salt exhibited three dimensional network structure which indicated harder gel than that prepared by soybean mil clotting enzyme.

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.36 no.2
• /
• pp.74-79
• /
• 2003

The functional properties such as a firming maintenance capacity for fermented vegetables, protein coagulation capacity antibacterial activity, calcium and peroxide absorption capacity of calcium powder of cuttle bone treated with acetic acid (ATC) were examined. In the Korean pickled cucumbers (20 days), the calcium content of ethanol insoluble solids was 5,264.9 mg/100 g and this value was higher than that of control (2,036.4 mg/100 g). Protein coagulation capacity of ATC was $0.9\%$ and its calcium absorption capacity was $49.3\%.$ The peroxide absorption capacity of ATC was shown $0-1.1\%$ range. Antibacterial activity was detected above $0.2\%.$ The ATC was effective in a firming maintenance of fermented vegetables (cucumber), coagulation capacities for soybean milk and antibacterial activity. The ATC was not effective in clarifying wastewater. Peroxide absorption capacity toward linoleic acid could not be checked by ATC, but its calcium absorption ratio was high compared to that of commercial calcium powder.

• Journal of Korean Society of Water and Wastewater
• /
• v.19 no.3
• /
• pp.357-362
• /
• 2005

Poly-${\gamma}$-glutamic acid (${\gamma}-PGA$), which is extracted from fermented soybeans, is a high molecular weight, adhesive, and negatively charged(anionic) polymer. Recently, ${\gamma}-PGA$ has gained attention due to its potential as polymer. The objectives of this study were to examine the applicability of ${\gamma}-PGA$ as a coagulant and/or a coagulant aid, to evaluate the efficiency of ${\gamma}-PGA$ for the removal of Organic and Ammonium substance in wastewater treatment. The effect of coagulation was evaluated for the removal of SS and organic matter using poly aluminum chloride(PACI) as well as newly developed ${\gamma}-PGA$. The maximum COD removal rate of 63% and the SS of 78% were occurred at the dosage of 50mg/L ${\gamma}-PGA$ only. The most effective removal for particulate and organic matter was occured when both PACI and ${\gamma}-PGA$ were applied at the rate of 20:1(10mg/L PACI and 0.5mg/L ${\gamma}-PGA$). When mixed with PACI, only small portion of ${\gamma}-PGA$ was enough to improve removal efficiencies of organic and particulate matter in wastewater. This result showed the positive potential of ${\gamma}-PGA$ as a new coagulant materials for wastewater treatment.

• Proceedings of the Korea Society for Simulation Conference
• /
• 1999.10a
• /
• pp.186-191
• /
• 1999

The coagulation process of PAN (poly(acrylonitrile)) wet-spinning was modeled and simulated based on the numerical analysis of the coagulation of a viscous polymer solution by diffusional interchange with a bath. Experiments were performed with gelled solutions of PAN in nitric acid to determine the diffusion rate of solvent and nonsolvent (water) during the coagulation. The experimental data were analyzed by using equations of diffusion coefficient which are the function of the solvent concentrations of the coagulation bath and the filament. The concentration profile of solvent in moving filament was predicted by solving the diffusion model equation numerically. A simplex method was used in the computation of the parameters of the diffusion equations to minimize the difference between the numerical results and experimental data.

• Journal of Korean Society of Water and Wastewater
• /
• v.12 no.2
• /
• pp.99-105
• /
• 1998

This research explored the feasibility of preparing and utilizing a preformed polymeric solution of Al(III) for coagulation in water treatment. Slow base(NaOH) injection into supersaturated aluminum chloride solutions did produce high yields of the type of Al polymers useful to water treatment applications. PACl's characteristic analysis showed that the quantity of polymeric Al produced at value of $r(OH_{added}/Al)=2.2$ was 83% of the total aluminum in solution, as showing maximum contents and precipitate was dramatically increased when r was increased above 2.35. And PACl was stable during sitoring period so aging effect was negligible. Results of the coagulation of Nakdong river waters with three PACls showed that the effectiveness of the three coagulants can be considered as r = 2.2 > r = 2.0 > r = 2.35 which are also the order of higher polymeric aluminum contents. Coagulation results for synthetic water exhibited optimum dose of 0.25mM Al, for three PACls, but above optimum dose, r = 2.0 and 2.2 PACl impaired the coagulation and sedimentation of turbidity and humic acid because of the restabilization of particulate. The effect of pH for on coagulation of Nak Dong River water showed that it had much effect turbidity and TOC removal, especially near pH 7. But pH effect was little for turbidity and TOC removal when r = 2.35 PACl was used for coagulation, that PACl had much more precipitates content.

• Journal of Korean Society of Environmental Engineers
• /
• v.22 no.11
• /
• pp.2059-2065
• /
• 2000

The purpose of this study is to improve coagulation efficiency by pre-treatment of high pH water using sulfuric acid. The common reason of pH increasing at down stream of Nakdong river is water blooming. The pH go above 9.0 during water blooming periods. The higher pH water demands more coagulant and pre-chlorine dosage than lower pH water for better coagulation condition. The DOC, THMFP, UV-254 after coagulation with the same coagulant dosage by pre-treatment from pH 9.2 down to 8.1 with sulfuric acid are 1.84mg/L, $51{\mu}g/L$ and $0.032cm^{-1}$, by pretreatment of chlorine are 2.09mg/L, $78{\mu}g/L$ and $0.030cm^{-1}$, by pre-treatment of sulfuric acid and chlorine are 2.14mg/L, $72{\mu}g/L$ and $0.031cm^{-1}$ respectively. Pretreatment with sulfuric acid can improve water quality and reduce coagulant demand.

• Journal of Korean Society of Water and Wastewater
• /
• v.21 no.1
• /
• pp.37-46
• /
• 2007

A feasibility test was conducted to evaluate the addition of turbidity substance in a coagulation process to remove natural organic matters (NOM), the precursor of disinfection by-products (DBPs). The experimental water sources were synthetic water containing 5 mg/L of humic acid and 50 mg/L of NaHCO3 and drinking water resource of Ulsan city (S Dam water, D Dam water and Nak-Dong raw water). The examined turbidity substances were kaolin, acid clay, and modified clay (0.38 meq $NH_4{^+}-N/g$ clay). In Jar tests at different concentrations of the turbidity substances (5, 10, 15, 20, 30 mg/L) using the synthetic water, the turbidity substances improved the removal of turbidity, UV-254 absorbance and dissolved organic carbon (DOC) by 23.8-38.1%, 17.0-24.5% and 2.5-44.5%, respectively. The modified clay showed higher removal efficiencies than other substances. In Jar tests using the drinking water, 10 and 20 mg/L of modified clay enhanced the removal efficiencies of turbidity, UV-254 absorbance, DOC, trihalomethane formation potential (THMFP), and haloacetic acid formation potential (HAAFP) by 3.0~4.3%, 19.1~29.0%, 12~34.9%, 4.9~36.7%, and 1.6~30.2%, respectively.

• Journal of Environmental Science International
• /
• v.20 no.6
• /
• pp.767-773
• /
• 2011

The objectives of this research are to investigate the proper coagulation conditions which are a type and doses of coagulants, mixing conditions (velocity gradients and mixing times), pH and so on through Jar-test, to evaluate the flux variations, permeate, backwashing according to characteristics of pretreatment of the wastewater by means of MF membranes for river maintenance water reuse. The effluent water from B-city K-sewage treatment plant are used for this research. Turbidity and suspended solids(SS) are 14.2 NTU and 10.4 mg/L respectively. This condition causes fouling for membrane process. The flux decline could be reduced when coagulation pretreatment was carried out. Optimal coagulations PAC which are commonly used in the sewage treatment plant was observed in this research. The results indicate that an optimal coagulation dose and pH are 80 ppm and pH of 7 respectively, but coagulation efficiency was lower at strong acid or strong base. Results showed that continuous and steady operations in membrane separation process by means of the effective removal of organic matter and turbidity with coagulation pretreatment of sewage secondary effluent were achieved.

• Membrane and Water Treatment
• /
• v.8 no.2
• /
• pp.185-199
• /
• 2017

Low-pressure membrane filtration is increasingly used for tertiary treatment of wastewater effluent organic matter (EfOM), mainly comprising organic base/neutral compounds. In-line coagulation with underdosing, charge neutralization, and sweep floc conditions prior to ultrafiltration (UF) was studied to determine removals of the EfOM components and consequent reduction of fouling using polyethersulfone membranes. Coagulation and UF substantially reduced fouling for all coagulation conditions while removing from 7 to 38% of EfOM organic acids. From 7 to 16% of EfOM organic base/neutrals were removed at neutral pH but there was no significant removal for slightly acid coagulation conditions even though fouling was substantially reduced. Sweep floc produced the lowest resistance to filtration but may be inappropriate for in-line use due to the large added volume of solids. Charge-neutralization resulted in poor recovery of the initial flux with hydraulic cleaning. Under-dosing paralleled sweep floc in reducing hydraulic resistance to filtration (for sub-critical flux) and the initial flux was also easily recovered with hydraulic cleaning. Hydrophobic and hydrophilic base/neutrals were identified on the fouled membranes but as previously reported the extent of fouling was not correlated with accumulation of organic base/neutrals.