• Journal of Institute of Convergence Technology
• /
• v.13 no.1
• /
• pp.13-17
• /
• 2023

Direct air capture (DAC) refers to the process of permanently removing CO₂ from the atmosphere by capturing CO₂ that has been emitted into the atmosphere from the past to the present directly from the atmosphere. DAC is a process that captures CO₂ that exists at 400 ppm in the atmosphere, so it has the problem of requiring a significant amount of air and high energy compared to CO₂ capture from a point source such as exhaust gas from a coal-fired power plant. In this study, we aim to introduce the performance, characteristics, and processes of absorbents that can be applied to DAC, focusing on the DAC process using absorbents developed to date, and present challenges that must be overcome in future DAC technology development.

• Mycobiology
• /
• v.42 no.1
• /
• pp.59-65
• /
• 2014

Entomopathogenic fungi are promising pest-control agents but their industrial applicability is limited by their thermosusceptibility. With an aim to increase the thermotolerance of Isaria fumosorosea SFP-198, moisture absorbents were added to dried conidial powder, and the relationship between its water potential and thermotolerance was investigated. Mycotized rice grains were dried at $10^{\circ}C$, $20^{\circ}C$, $30^{\circ}C$, and $40^{\circ}C$ and the drying effect of each temperature for 24, 48, 96, and 140 hr was determined. Drying for 48 hr at $10^{\circ}C$ and $20^{\circ}C$ reduced the moisture content to < 5% without any significant loss of conidial thermotolerance, but drying at $30^{\circ}C$ and $40^{\circ}C$ reduced both moisture content and conidial thermotolerance. To maintain thermotolerance during storage, moisture absorbents, such as calcium chloride, silica gel, magnesium sulfate, white carbon, and sodium sulfate were individually added to previously dried-conidial powder at 10% (w/w). These mixtures was then stored at room temperature for 30 days and subjected to $50^{\circ}C$ for 2 hr. The white carbon mixture had the highest conidial thermotolerance, followed by silica gel, magnesium sulfate, and then the other absorbents. A significant correlation between the water potential and conidial thermotolerance was observed in all conidia-absorbent mixtures tested in this study (r = -0.945). Conidial thermotolerance in wet conditions was evaluated by adding moisturized white carbon (0~20% $H_2O$) to conidia to mimic wet conditions. Notably, the conidia still maintained their thermotolerance under these conditions. Thus, it is evident that conidial thermotolerance can be maintained by drying mycotized rice grains at low temperatures and adding a moisture absorbent, such as white carbon.

• Asian Journal of Atmospheric Environment
• /
• v.10 no.2
• /
• pp.99-113
• /
• 2016

In order to improve the portability of basic absorbents monoethanolamine (MEA) and glycine (Gly), both were supported on microporous activated carbon (AC). Chemical modification by alkali-metal ion exchange (of Li, Na, K) was carried out on Gly-based absorbents. All supported absorbents were subjected to $CO_2$ absorption capacity (pure $CO_2$) and selectivity (indoor level) tests. Textural and chemical characterizations were carried out on test sorbents. All impregnation brought about significant reduction of specific surface area and microporosity of the adsorbent Depreciation in the textural properties was found to result to reduction in pure $CO_2$ sorption. Contrarily, low-level $CO_2$ removal capacity was enhanced as the absorbent dosage increases, resulting in supported 5 molar MEA in methanol solution. Adsorption capacities were improved from 0.016 and 0.8 in raw ACs to 1.065 mmol/g for MEA's. Surface chemistry via X-ray photoelectron spectroscopy (XPS) of the supported sorbents showed the presence of amine, pyrrole and quaternary-N. In reducing sequence of potency, pyridine, amine and pyrrolic-N were noticed to contribute significantly to $CO_2$ selective adsorption. Furthermore, the adsorption isotherm study confirms the presence of various SNGs heterogeneously distributed on AC. The adsorption mechanism of the present AC adsorbents favored Freundlich and Langmuir isotherm at lower and higher $CO_2$ concentrations respectively.

• Journal of Hydrogen and New Energy
• /
• v.27 no.1
• /
• pp.83-94
• /
• 2016

Performance of absorbent for post-combustion $CO_2$ capture was measured and discussed. Fully saturated fresh absorbent (P2-15F) and absorbents sampled from absorption and regeneration reactor of continuous $CO_2$ capture process, P2-15A, P2-15R, respectively, were used as representative absorbents. Small scale fluidized bed reactor (0.05 m I.D., 0.8 m high) which can measure exhaust gas concentration and weight change simultaneously was used to analyze regeneration characteristics for those absorbents. Exhausted moles of $CO_2$ and $H_2O$ were measured with increasing temperature. $H_2O/CO$ ratio and working capacity were determined and discussed to confirm reason of reactivity decay after continuous operation. Moreover, possibility of side reaction was checked based on the $H_2O/CO_2$ mole ratio. Finally, suitable regeneration temperature range was confirmed based on the trend of working capacity with temperature.

• Korean Chemical Engineering Research
• /
• v.50 no.6
• /
• pp.994-1001
• /
• 2012

The Effects of operating variables on reactivity of two $CO_2$ absorbents (PKM1-SU and P4-600) for SEWGS process were investigated in a pressurized fluidized bed reactor. For both $CO_2$ absorbents, $CO_2$ sorption capacity decreased as the number of absorption-regeneration cycles increased. PKM1-SU absorbent represented higher $CO_2$ sorption capacity than that of P4-600 absorbent. However, P4-600 absorbent represented better performance than PKM1-SU absorbent from the view points of regeneration temperature and regeneration rate. For PKM1-SU absorbent, $CO_2$ sorption capacity increased as the steam concentration increased. However, $CO_2$ sorption capacity increased initially as the steam concentration increased from 5% to 10%, but maintained thereafter for P4-600 absorbent. For both $CO_2$ absorbents, $CO_2$ sorption capacity increased as the final regeneration temperature increased. For PKM1-SU absorbent, $CO_2$ sorption capacity increased as the pressure increased and the increment tendency was drastic at higher pressure than 15 bar.

• Journal of Korean Society of Forest Science
• /
• v.95 no.6
• /
• pp.751-758
• /
• 2006

To investigate soil management practices for increasing tree growth in arid regions of China, Xinjiang poplar (Populus alba var. pyramidalis) seedlings were planted in a nursery and windbreak and were treated with fertilizers (nitrogen and phosphorus) and absorbents (artificial; K-SAM and natural: Yuho (Artemisia ordosica)) at Dengkou in Inner Mongolia. Seedling height, diameter at breast height (DBH), biomass, and nitrogen (N) and phosphorus (P) concentrations were measured 1.5 years after the treatments. Soil texture was sandy loam for nursery and clay loam for windbreak, soil pH was 8.78 for nursery and 8.51 for windbreak, and total soil N concentration was 0.06% for nursey and 0.08% for windbreak. [n general, seedling height and DBH increased in the N fertilizer treatment compared to control or other treatments both in nursery and windbreak. Also seedling growth increased after the treatments of artificial and natural absorbents in windbreak. Total above- and belowground biomass increased after the N + P treatment. Foliage N and P concentrations following N and/or P treatments were same in the nursey, however, they significantly increased in the windbreak indicating N deficiency. It appeared that N was a limiting factor for early growth of Xinjiang poplar seedlings and artificial and natural absorbents (K-SAM and Yuho) would be useful to increase seedling growth in the arid region.

• The Research Journal of the Costume Culture
• /
• v.20 no.4
• /
• pp.475-484
• /
• 2012

The purpose of this study is to help to prevent daily noises by measuring the noise absorption coefficient of the non-woven fabrics and wallpapers which are commonly used in lining and noise absorption coefficient of lining curtain. Seven types of fiber materials for the interior decoration, one non-woven fabric for the wallpaper linings, and two types of textiles for curtain linings are used as the experimental materials in this study. The noise absorption coefficient of the noise absorbents were measured by using impedance tube. And the thermal transmittance were measured by using thermal transmittance tester. The results of this study are as follows; Observing the noise absorption efficiency of each experimental materials, the combination of fiber materials and linings, the noise absorption efficiency of cotton, polyester and silk were similar and for the experimental materials of flax, rayon, acrylic and nylon were resulted the similar noise absorption efficiency. The result of combination of fiber material and black fabric was highest among the combined linings. For the combination of fiber material and non-woven fabric, double layers of non-woven fabric resulted slightly higher noise absorption coefficient result than single layer of non-woven fabric. The thermal transmittance and the sound absorbents of experimental materials were affected by the thickness, density and layer of air of the experimental materials.

• Proceedings of the SCSK Conference
• /
• 2003.09a
• /
• pp.417-430
• /
• 2003

A new method was developed to prepare microcapsules involving hydrophobic components. A totally new "silicone-resin-polypeptide" was used as the wall materials. The polypeptide was made by hydrolysis of collagen and silk protein and so on, and that was combined with silicone. This microcapsule was easily prepared from silicone-resin-polypeptide in water solution. The ratio of encapsulation in the microcapsule was not only high level as 90％, which had never been reached, but also the particle size could be controlled to obtain very small size (average particle size: 2${\mu}{\textrm}{m}$). Moreover, these microcapsules were resistant to high shearing forces and were stable over a long time period. This stable microcapsule was not crushed in pressure with finger spreading, so the core materials hardly touch the skin directly. Application in cosmetics by using microcapsule involving UV absorbents (2-ethylhexy1-4-methoxycinnamate (OMC) and 4-tert-butyl-4' -methoxydibenzoyl-methane (BMDBM)) was examined. It was possible to apply organic UV absorbents in water-rich formulations without any surfactant by using this microcapsule. This formulation demonstrated a good moisturizing and soft skin feel. Therefore, the microcapsule was applied to hair care products. As a result, the sunscreen hair lotion with microcapsule was able to prevent from damaging and decoloring of hair color by UV rays. As just, it was suggested that this microcapsules were be widely applied in cosmetics.cosmetics.

• Journal of KSNVE
• /
• v.10 no.5
• /
• pp.892-897
• /
• 2000

In this paper, experimental methods to find acoustic characteristics of acoustically treated air-conditioning duct system are proposed. Existing methods to analyze acoustic properties of duct with absorbent material have dilemma which has to assume the wave in duct to be a plane wave. Under this assumption. applicable frequency limitation makes accurate analysis of practical air-conditioning system impossible. In order to analyze the properties of in-lined treated absorbent with high degree of accuracy, in this experiments the range of exciting frequency of sound source is broadband, which means that source speaker excited higher mode of in-duct sound field. Also, to define the relations of air cavity to the acoustic characteristics, acoustic experiments on ducts with air cavity of different depth are operated. In conclusion, air-cavity makes the absorbing ability of duct improved in low frequency range. Due to the interactions between the air cavity depth and the depth of absorbents, according to depth of cavity, the magnitude of absorption coefficients vs frequencies in specific range is changed. In lower frequency range, the absorption of sound energy by air cavity is more dominant than by absorbent itself, in higher range, the inversion is true.

• Journal of the Korean Society of Safety
• /
• v.8 no.1
• /
• pp.29-34
• /
• 1993

Two major hazardous gases. SOx and NOx. are emissioned from fossile fuels. SOx has been removed when oil is refined but NOx hasn't. So NOx is very serious problem in air pollution now There are several technologies to remove NOx. e.g. cooling method. scrubbers method. combustion method, polymer membrane method and adsorbent methods. Polymer membrane and adsorbent methods have good economic merit in removal systems of low content hazard gases. Traditional absorbents are porous silicas, aluminas. active carbon and zeolites. But these absorbents act only physisorption which has less removal performance than chemisorption. In this study. polymeric absorbent which has chemisorption as well as physisorption was analyzed about chemical structure and experimented about optimum operation conditions. The results showed that the chemical structure of the polymeric absorbent was expected as polystyrene having -N-CH$_2$COOH absorbent was revealed about 310$m^2$/g. The molar ratio of absored NO to charged NO in absorption experiments was shown 60% of the polymeric absorbent and 45% of zeolite absorbent at 3$0^{\circ}C$.