• Journal of Electrical Engineering and information Science
• /
• 제1권2호
• /
• pp.52-57
• /
• 1996

Detection of arcing high impedance faults has been a perplexing in the power distribution protection. Transient analysis of distribution disturbances for fault discrimination from other normal events is important for a secure protection of the power system. A simple parameter of wave form distortion quantification is used to analyze the behaviors of arcing faults and normal distribution disturbances. Theoretical perspectives of the transients were studied and actual disturbances were examined. From this investigation, a discrimination guideline based on the revised crest factor is developed. The discrimination method has a high potential to enhance the reliability and security for the distribution system protection.

• 대한화학회지
• /
• 제21권5호
• /
• pp.320-329
• /
• 1977

p-Phenylenediamine dihydroperchlorate의 세포상수는 $a=4.79{\pm}0.02,\;b=9.03{\pm}0.02,\;c=7.12{\pm}0.03{\AA},\;{\alpha}=109.4{\pm}0.2,\;{\beta}=79.6{\pm}0.2,\;r=104.6{\pm}0.2^{\circ},\;Z=1$이며 공간군은 $P\={1}$이다. 구조는 Patterson 및 Fourier법으로 해석하였으며 block diagonal 최소자승법으로 정밀화하였따. 등경사 Weissenberg 사진들에서 얻은 387개의 관측된 반사에 대하여 R값은 0.13이었다. 이 물질의 결정구조에서 수소결합은 아미노기와 과염소산 이온 사이에서 이루어져 있으며 2가지 형이 있다. 첫째것은, 한개의 삼지형 N${\cdot}{\cdot}{\cdot}$O 수소결합이고, 둘째것은, 보통형의 2개의 N${\cdot}{\cdot}{\cdot}$O 수소 결합이다. 한개의 p-phenylenediamine 그룹은 실험오차 내에서 평면이며 12개의 과염소산이온에 결합되어 있다. 그중 10개의 과염소산이온은 수소결합으로 연결되어 있으며 2개는 van der Waals 힘들로 접촉되어 있다. 한개의 과염소산이온은 6개의 p-phenylenediamine과 4개의 과염소산이온에 의하여 둘러싸여 있따. 6개의 p-phenylenediamine 그룹 중 5개는 수소결합이 되어있고 나머지는 van der Waals 힘으로 접촉되어 있다.

• Journal of Magnetics
• /
• 제11권1호
• /
• pp.55-59
• /
• 2006

The effect of annealing temperature on the permeability and giant magneto-impedance (GMI) behaviors of $Fe_{68.5}Mn_{5}Si_{13.5}B_9Nb_3Cu_1$ amorphous alloy has been systematically investigated. The nanocrystalline $Fe_{68.5}Mn_{5}Si_{13.5}B_9Nb_3Cu_1$ alloys consisting of ultra-fine $(Fe,Mn)_3Si$ grains embedded in an amorphous matrix were obtained by annealing their precursor alloy at the temperature range from $500^{\circ}C\;to\;600^{\circ}C$ for 1 hour in vacuum. The permeability and GMI profiles were measured as a function of external magnetic field. It was found that the increase of both the permeability and the GMI effect with increasing annealing temperature up to $535^{\circ}C$ was observed and ascribed to the ultrasoft magnetic properties in the sample, whereas an opposite tendency was found when annealed at $600^{\circ}C$ which is due to the microstructural changes caused by high-temperature annealing. The study of temperature dependence on the permeability and GMI effect showed some insights into the nature of the magnetic exchange coupling between nanocrystallized grains through the amorphous boundaries in nanocrystalline magnetic materials.

• 한국결정성장학회지
• /
• 제25권6호
• /
• pp.239-244
• /
• 2015

에어로졸 증착법에 의해 실리콘 기판위에 $10{\sim}20{\mu}m$의 두께를 가진 PZT 후막을 제조한 후 $700^{\circ}C$에서 어닐링처리하였다. PZT 분말에 의해 제조된 막은 임피던스 분석기(impedance analyzer)와 쇼여-타워 서킷(Sawyer-Tower circuit)으로 분석하였다. PZT 분말은 통상적인 고상반응법 및 솔-젤 법으로 준비되었다. 고상반응법으로 만들어진 분말을 사용한 $10{\mu}m$ 두께 PZT 막의 잔류분극, 항전계 및 유전상수는 각각 $20{\mu}C/cm^2$, 30 kV/cm 그리고 1320이었다. 한편 솔-젤 법으로 제조된 분말을 사용한 경우의 유전상수는 635로 비교적 낮은 값을 나타낸다. 이는 어닐링시 생기는 발생하는 유기물에 의한 기공의 존재 때문이다.

• 한국자기학회:학술대회 개요집
• /
• 한국자기학회 2003년도 하계학술연구발표회 및 한.일 공동심포지엄
• /
• pp.60-61
• /
• 2003

Theoretical considerations on a giant magneto-impedance (GMI) effect in amorphous ribbons (i.e., thin films) have been made in terms of the expressions of effective permeability and impedance derived in the frame of classical electrodynamics and ferromagnetism. The dependence of GMI effect on the external do magnetic field (H$\_$ext/) and the frequency of alternating current are simulated and discussed in the knowledge of energy conversion consisting of the current energy loss, the ferromagnetic energy consumption, and the magnetic energy storage in the film. The obtained results are summarized as follow: (a) As frequency f< 20 ㎒, the real part of effective permeability (${\mu}$′) changes slightly. The peak of the ${\mu}$′curve always locates at H$\_$ext/=H$\_$ani/ - the anisotropy field. However, the peak value of ${\mu}$′ tends to increase with increasing frequency in the frequency range of 11-20 ㎒. (b) In the frequency range, f= 21-23 ㎒, a negative peak additionally appears. Meanwhile, both the positive and negative peak values rapidly increase with increasing frequency and their peak positions shift towards a high H$\_$ext/. (c) The positive peak value of ${\mu}$′ starts to decrease at f= 29 ㎒ and its negative peak does so at about 35 ㎒. Then, both peaks keep such a tendency and their peak positions move to high H$\_$ext/, as increasing frequency. (d) The dependence of the imaginary part of effective permeability (${\mu}$") on the external dc magnetic field and the frequency of the alternating field indicates that there is only one peak involved in ${\mu}$" for the whole frequency range. (e) The impedance vs. magnetic field curves at various frequencies show that there is a critical value of frequency around f= 18-19 ㎒ where the transition between two frequency regimes occurs; the one (low frequency) in which ${\mu}$′ predominantly contributes to the GMI effect and the other (high frequency) in which ${\mu}$" determines the GMI effect.

• 조명전기설비학회논문지
• /
• 제22권10호
• /
• pp.56-61
• /
• 2008

배전계통의 고조파 방해(Harmonics Disturbance)현상은 배전계통에서 전압강하와 함께 순시 전력품질을 저해하여 중성선 및 NGR(Neutral Ground Reactor) 과열, OCGR 오동작 등의 문제를 발생시킴으로써 전력회사와 고객 모두에게 막대한 경제적인 손실을 주고 있어 동 분야에 대한 적극적인 대책이 필요하다. 이에 대한 해결 방안으로 유럽에서는 IEC 61000-3-2 규격을 통해 상당 16[A] 이하 저압 전기기기의 고조파를 제한하고 있다. 본 규격은 저압 전기기기를 4개의 등급으로 구분하여 관리하고 있으며, 분석결과 클래스 A등급 해당 전기기기의 고조파 유출제한 기준은 저압계통의 기준임피던스와 허용 최대전압을 바탕으로 산정되었으며, 타 등급(B, C, D등급)의 유출제한 기준들도 클래스 A의 유출제한 기준을 바탕으로 산정되었다. 따라서 본 논문에서는 IEC 61000-3-2 규격 분석결과를 바탕으로 국내 기준임피던스에 기초하여 국내 저압 전기기기의 고조파 유출 제한 값을 산정하였다.

• 한국산업정보학회:학술대회논문집
• /
• 한국산업정보학회 2000년도 추계공동학술대회논문집
• /
• pp.711-727
• /
• 2000

본 논문에서는 레이다 및 EW수신시스템에서 사용하는 SDLA를 5-7㎓(C-Band)의 RF 주파수대에서 설계 구현하였다. 구현한 SDLA의 특성은 -80㏈m-0㏈m의 동작범위를 얻었고, $\pm$1.2㏈이하의 대수오차, 19.2㎷/㏈의 대수기울기, 출력전압 범위는 0-l.53V, 2.0:1 이하의 VSWR, 약2㏈의 잡음지수와 900$\Omega$의 비디오 임피던스를 얻었다.

• Advances in Energy Research
• /
• 제2권1호
• /
• pp.21-31
• /
• 2014

The use of a microporous membrane along with Au/C catalyst for direct glycerol alkaline fuel cell was investigated. In comparison with Nafion 112, the microporous Celgard 3401 membrane provides a better cell performance due to the lower ionic resistance as confirmed by impedance spectra. The single cell using Au/C as anode catalyst prepared by using PVA protection techniques provided a higher maximum power density than the single cell with commercial PtRu/C at $18.65mW\;cm^{-2}$ The short-term current decay studies show a better stability of Au/C single cell. The higher activity of Au/C over PtRu/C was owing to the lower activation loss of Awe. The magnitude of current decay indicates a low problem of glycerol crossover from anode to cathode side. The similar performance of single cell with and without humudification at cathode points out an adequate transport of water through the microporous membrane.

• 한국재료학회지
• /
• 제22권9호
• /
• pp.470-475
• /
• 2012

$La_{1-x}Sr_xMnO_3$(LSM,$0{\leq}x{\leq}0.5$) powders as the air electrode for solid oxide fuel cell were synthesized by a glycine-nitrate combustion process. The powders were then examined by X-ray diffraction(XRD) and scanning electron microscopy (SEM). The as-formed powders were composed of very fine ash particles linked together in chains. X-ray maps of the LSM powders milled for 1.5 h showed that the metallic elements are homogeneously distributed inside each grain and in the different grains. The powder XRD patterns of the LSM with x < 0.3 showed a rhombohedral phase; the phase changes to the cubic phase at higher compositions($x{\geq}0.3$) calcined in air at $1200^{\circ}C$ for 4 h. Also, the SEM micrographs showed that the average grain size decreases as Sr content increases. Composite air electrodes made of 50/50 vol% of the resulting LSM powders and yttria stabilized zirconia(YSZ) powders were prepared by colloidal deposition technique. The electrodes were studied by ac impedance spectroscopy in order to improve the performance of a solid oxide fuel cell(SOFC). Reproducible impedance spectra were confirmed using the improved cell, which consisted of LSM-YSZ/YSZ. The composite electrode of LSM and YSZ was found to yield a lower cathodic resistivity than that of the non-composite one. Also, the addition of YSZ to the $La_{1-x}Sr_xMnO_3$ ($0.1{\leq}x{\leq}0.2$) electrode led to a pronounced, large decrease in the cathodic resistivity of the LSM-YSZ composite electrodes.

• Journal of Electrical Engineering and information Science
• /
• 제2권5호
• /
• pp.40-44
• /
• 1997

This paper presents the results of studies made for measuring the relative complex permittivity of PCB sheet material in he frequency a range of 100MHz∼1GHz using vector network analyzer. A measurement cell was developed for this purpose using broad-band impedance method and the dielectric constant and loss tangent of two PCBV sheet materials, glass-epoxy and teflon, were measured. The effect of copper cladding was studied.