• Journal of Korean Neurosurgical Society
• /
• v.30 no.11
• /
• pp.1332-1335
• /
• 2001

Acase of malignant schwannoma in the cervico-thoracic region with lung metastasis is presented. The patient was 55-year-old man presented with right arm weakness. Magnetic resonance image demonstrated lobulated enhancing soft tissue masses in spinal canal, neural foramen and right paraspinal space at C7-T1 level compressing the dural sac and spinal cord. Subtotal removal was performed and histological diagnosis of malignant schwannoma was made. Reoperation due to recurrence was done but subsequent metastasis to lung was observed.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 1999.05a
• /
• pp.254-260
• /
• 1999

Meteor Burst Communication can provide effective and economical means of communication where long distance VHF NLOS data transmission is needed; often ranges more than 1000 km. It has been, however, so far considered unsuitable for short distance application because of phenomenal decrease in burst durations, which leads to decreation of total duty rate of the system. This paper extensively analyzes characteristics of shot distance MB(Meteor Burst) path and shows the low duty rate may be improved by increasing burst rate through adapting antenna beam width to cover entire hot-spot region in the space and, by compensating effective burst length through cutting down man-made noises introduced by antenna. Based on the analysis, we are developed a small-opening-cavity antenna, especially designed for short distance MB path. In operation, the antenna is to be buried under ground surface so as to improve directivity and reduces noise introduction. The antenna exhibits power gain of 3 dB with 90 degree beam width and thus enables to illuminate entire hot-spot regions with the elevation angle of 8-90 degree which is the case of transmission less than 100 km. Directivity horizontal to earth surface is suppressed to minimum which enables to cut man-made noises from near-by sources down to more than 3 dB from the level reported with conventional 4 element Yagi. A series of experiments performed on 100 km MB paths have conformed that, with the antenna installed at receiving site, the burst rate and duration time have been noticed to increase by 10 and 20 percent respectively from the values obtained by conventional 4-element Yagi antenna under same testing condition.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.9 no.6
• /
• pp.788-801
• /
• 1998

Meteor Burst Communication can provide effective and economical means of communication where long distance VHF NLOS data transmission is needed ; often ranges more than 1000 km. It has been, however, so far considered unsuitable for short distance application because of phenomenal decrease in burst durations, which leads to decreation of total duty rate of the system. This paper extensively analyzes characteristics of shot distance MB(Meteor Burst) path and shows the low duty rate may be improved by increasing burst rate through adapting antennal beam width to cover entire hot-spot region in the space and, by compensating effective burst length throughcutting down man-made noises introduced by antennal. Based on the analysis, we are developed a small-opening-cavity antennal, especially designed for short distance MB path. In operation, the antenna is to be buried under ground surface so as to improve directivity and reduces noise introduction. The antennal exhibits power gain of 3 dB with 90 degree beam width and thus enables to illuminate entire hot-spot regions with the elevation angle of 8-90 degree which is the case of transmission less than 100 km. Directivity horizontal to earth surface is suppressed to minimum which enables to cut man-made noises from near-by sources down to more than 3 dB from the level reported with conventional 4 element Yagi. A series of experiments performed on 100km MB paths have conformed that, with the antenna installed at receiving site, the burst rate and duration time have been noticed to increase by 10 and 20 percent respectively from the values obtained by conventional 4-element Yagi antennal under same testing condition.

• Journal of architectural history
• /
• v.18 no.3
• /
• pp.7-25
• /
• 2009

Hakbongjongtaek(The head house of Uisong Kim family, 鶴峯宗宅), firstly built in the early 17th century, was moved to its neighboring place in the late 18th century. The man who led the relocation(移建) of the house was the eldest grandson of the family, Jong-soo, Kim. He made and overall plan and also participated in building the house. There remain four Gados(family paintings, 가도(家圖)) related to the relocation plan. This paper aims to make an analysis of these Gados, and through analysis, to find what was the essential poing of the relocation plan and how the point was represented in the paintings. The result of analysis is as follows: 1. The main focus of relocation plan was the form of Anchae(the inner house). Anchae was designed as asymmetrical form, and restricted to four kan. Only Andaechung needed to be 6 kan size for religious ceremonies. 2. For the design of Sarangchae, the displacement of large Sarangbang and small Sarangbang was an important issue. There were two ways of layout: parallel type and facing type. The latter was chosen. 3. The representation and techniques of Gado is quite concrete, in spite of differences among them. The expression of doors, windows, attic and kitchen was based on the understanding of space. Also the spatial division, which was expressed line on the grid, was based on the scaled ruler. As we've seen before, painting the relocation plan was a kind of endeavors to make the housing type as a realization of Garye. Also, we can find out that role of the eldest grandson of the family was quite important to carry out the plan. As well as, it was meaningful to examine Sadaebu (the aristocrat of Chosun)'s perception of housing.

• Journal of the Korean Institute of Landscape Architecture International Edition
• /
• no.2
• /
• pp.185-191
• /
• 2004

This study dealt with the Kogi River, located in Kaizuka City, Osaka, which has experienced different improvements from the upper through the lower regions, aimed at revealing temporal relations between residents and the river, as well as probing future problems and directions regarding the river in the suburban area, by conducting a survey of local residents. The result showed that, in the upper region where nature remains in its natural state and the good water quality has been maintained, the relations between the residents and the river continued until around 1965; meanwhile in the middle region the relations have been disappearing since about 1955, and in the lower region where the stream has been repeatedly rehabilitated since 1955, there are fewer involvements of the people with the river. It also revealed that the weaker the relations between people and the river became, the larger the number of residents, even in the upper region, who became concerned over the deteriorating river environment after about 1975, and that in the middle and lower areas, about a decade earlier than in the upper area, the number of those who were aware of the environmental deterioration began to increase. Consequently, with an eye to resuming the relations between people and the river in an suburban area, their future challenges would be the space improvements depending on the environmental characteristics of the area; for example, the recovery of grassy banks for the purpose of protection in the lower region; the preservation and maintenance of many waterside woods as well as the creation of open spaces utilizing the river banks in the middle area; and throughout the whole region, the establishment of a system in which the relations between man and the river can be passed down to future generations, by utilizing the local human resources including those who know the former river landscapes or about the playing in and around the river.

• Tuberculosis and Respiratory Diseases
• /
• v.70 no.3
• /
• pp.261-265
• /
• 2011

Cholethorax is a bilious pleural effusion caused by a pleurobiliary fistula or leakage of bile into the pleural space. Most cases of cholethorax arise from a complication of abdominal trauma, hepatobiliary infection, or invasive procedures or surgery of hepatobiliary system. However, we experienced a case of a patient with cholethorax of unknown origin. There was no evidence of pleurobiliary fistula or leakage of bile from the hepatobiliary system although we examined the patient with various diagnostic tools including chest and abdominal computed tomography, endoscopic retrograde cholangiopancreatography, tubography, bronchofiberscopy, hepatobiliary scintigraphy and video-assisted thoracoscopic surgery. Herein we report a case of cholethorax for which the specific cause was not identified. The patient was improved by percutaneous drainage of pleural bile.

• Journal of the Korea Furniture Society
• /
• v.16 no.2 s.30
• /
• pp.59-65
• /
• 2005

As physical condition of students improves, there is a need to develop human body-friendly desk and chair for students. In this study, desks and chairs were manufactured with curved veneer lamination under high frequency heating and pressing, using ten wood species such as Japanese red pine, Korean pine, pitch pine, Japanese larch, yellow poplar, black locust, oak, radiata pine, beech, and birch. The performance of these products were evaluated. The results obtained were summarized as follows; With high frequency heating, the turned lamination of veneers with full size sheet ($3{\times}6\;feet$) prepared by rotary lathe peeling was successfully applied for making the members of desk top, leg frames of desk and chair. Bending strengths of desk tops were relatively greater for yellow poplar, black locust and red pine, which were similar to those of beech and birch. Bending strengths of desk legs were classified into greater species group (red pine, yellow poplar, larch) and lower species group (radiata pine, Korean pine, pitch pine). Compressive strengths of chair legs in parallel direction to the lamination were greater in black locust and larch. On the other hand, differences between outer and inner gap at the top and drawer bottom of desk top were rather larger for the laminations of birch and beech, and less for those of yellow poplar and pitch pine, showing greater stability of open drawer space. In results, yellow poplar, larch, pitch pine and red pine showed good appearance and strength properties at the curved veneer lamination. Accordingly, it was believed that these domestic woods were able to substitute for birch which was being imported for the use of veneer-laminates type furniture.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.8 no.5
• /
• pp.105-113
• /
• 2009

In this paper, a vehicle antenna for AM, FM, TDMB, GPS systems was designed and implemented. AM antenna loaded into small space of shark shape was designed by ferrite turn style antenna. For the FM and TDMB antenna, folded monopole antenna which helical is folded was applied. GPS antenna for achieving characteristics both bandwidth and gain improvement was designed microstrip patch that has air substrate and fractal structure. Receiving signal strengths by the measurement were presented for the AM, FM and TDMB antenna. AM signal strength was -65.7dBm, this strength is almost as same conventional pole antenna as -63.4dBm. It can be replaced conventional pole or glass antenna by the studied antenna. Signal strengths for FM and TDMB were -55.66 and -43.50dBm at center frequency, they are 5~10dB higher than conventional antenna. Measurements of bandwidth and gain for the GPS antenna showed 135 MHz under VSWR 2 : 1 and 4.31dBi, gains over GPS band were 3~5dB higher than ceramic patch antenna.

• The korean journal of orthodontics
• /
• v.43 no.1
• /
• pp.42-52
• /
• 2013

The aim of this paper was to propose a new method of bimaxillary orthognathic surgery planning and model surgery based on the concept of 6 degrees of freedom (DOF). A 22-year-old man with Class III malocclusion was referred to our clinic with complaints of facial deformity and chewing difficulty. To correct a prognathic mandible, facial asymmetry, flat occlusal plane angle, labioversion of the maxillary central incisors, and concavity of the facial profile, bimaxillary orthognathic surgery was planned. After preoperative orthodontic treatment, surgical planning based on the concept of 6 DOF was performed on a surgical treatment objective drawing, and a Jeon's model surgery chart (JMSC) was prepared. Model surgery was performed with Jeon's orthognathic surgery simulator (JOSS) using the JMSC, and an interim wafer was fabricated. Le Fort I osteotomy, bilateral sagittal split ramus osteotomy, and malar augmentation were performed. The patient received lateral cephalometric and posteroanterior cephalometric analysis in postretention for 1 year. The follow-up results were determined to be satisfactory, and skeletal relapse did not occur after 1.5 years of surgery. When maxillary and mandibular models are considered as rigid bodies, and their state of motion is described in a quantitative manner based on 6 DOF, sharing of exact information on locational movement in 3-dimensional space is possible. The use of JMSC and JOSS will actualize accurate communication and performance of model surgery among clinicians based on objective measurements.

• Journal of Trauma and Injury
• /
• v.27 no.3
• /
• pp.84-88
• /
• 2014

The severity of blunt hepatic injury correlates with internal organ damage. We experienced a patient, who had an extensive crushed liver injury. The patient was a 28-year-old man, who was involved in a traffic accident in which a wheel ran over his right upper abdomen. A grade V severe hepatic laceration was diagnosed with computed tomography. His vital signs were stable, so we could wait for times with conservative management. Bile leakage led to biloma and bile spillage into the peritoneal space. Selective percutaneous drainage was needed to control the several biloma. After four months of conservative management, could the patient was discharged in good condition.