• 제목/요약/키워드: ZnS nanowires

검색결과 31건 처리시간 0.031초

녹색기술을 이용하여 제작된 ZnO 나노선 (Fabrication of ZnO Nanowires by Green Technology)

  • 이근형
    • 대한금속재료학회지
    • /
    • 제50권3호
    • /
    • pp.233-236
    • /
    • 2012
  • ZnO nanowires were fabricated through thermal evaporation of Zn or ZnS powder using solar energy. The Zn or ZnS powder was heated and evaporated by sunlight. The sunlight was concentrated on the Zn or ZnS powder by a converging lens and then the Zn or ZnS powder was evaporated and oxidized in air. After oxidation, ZnO nanowires were fabricated in the focal point. Strong ultraviolet emission, which corresponds to the near band-edge emission, was observed from the ZnO nanowires synthesized using Zn powder as a source material. Meanwhile, green emission, related to intrinsic defects such as oxygen vacancies, prevailed for the ZnO nanowires fabricated using ZnS powder. No catalysts were used in the fabrication of the ZnO nanowires, which suggested the ZnO nanowires were grown by a vapor-solid mechanism.

상온에서 UV 활성화된 ZnS 나노와이어의 NO2 가스 검출 특성 (NO2 gas sensing properties of UV activated ZnS nanowires at room temperature)

  • 강우승
    • 한국표면공학회지
    • /
    • 제47권6호
    • /
    • pp.297-302
    • /
    • 2014
  • ZnS nanowires were synthesized in order to investigate $NO_2$ gas sensing properties. They were grown on the sapphire substrate using ZnS powders. SEM (scanning electron microscopy) showed the diameter and length of the ZnS nanowires were approximately in the range of 50 - 100 nm and a few $10s\;{\mu}m$, respectively. They were also found to be composed of Wurtzite- structured single crystals from TEM (transmission electron microscopy) analysis. $NO_2$ gas sensing performance of the ZnS nanowire was measured with electrical resistance changes caused by $NO_2$ gas with a concentration of 1-5ppm. The sensor was UV treated with an intensity of $1.2mW/cm^2$ to facilitate charge carrier transfer. The responses of the ZnS nanowires to the $NO_2$ gas at room temperature, treated with UV of two different wavelengths of 365 nm and 254 nm, are measured to be 124.53 - 206.87 % and 233.97 - 554.83%, respectively. In the current work, the effect of UV treatment on the gas sensing performance of the ZnS nanowires was studied. And the underlying mechanism for the electrical resistance changes of the ZnS nanowires by $NO_2$ gas was also discussed.

산소 분위기에서 열처리시 ZnS 나노선의 발광 강도 변화 (Enhancement of Photoluminescence Intensity of ZnS Nanowires by Annealing in O2)

  • 권진업;이종우
    • 한국표면공학회지
    • /
    • 제45권5호
    • /
    • pp.193-197
    • /
    • 2012
  • The influence of annealing process in an $O_2$ atmosphere on the photoluminescence (PL) spectra properties of ZnS nanowires has been investigated. ZnS nanowires with the diameters approximately 100 nm and the lengths a few tens micrometers were synthesized by evaporating ZnS powders on Si substrates while using an Au thin film as a catalyst. ZnS nanowires had an NBE emission band at 430 nm in the violet region. The emission intensity was improved drastically by a process in which ZnS nanowires were heat-treated at $500^{\circ}C$ in an $O_2$ atmosphere for 45 minutes.

Fabrication, Structure and Gas Sensing Properties of Pt-functionalized ZnS Nanowires

  • Kim, Soohyun;Park, Sunghoon;Jung, Jihwan;Lee, Chongmu
    • 한국진공학회:학술대회논문집
    • /
    • 한국진공학회 2014년도 제46회 동계 정기학술대회 초록집
    • /
    • pp.315.2-315.2
    • /
    • 2014
  • Pt-functionalized ZnS nanowires were synthesized on Au-deposited c-plane sapphire substrates by thermal evaporation of ZnS powders followed by wet Pt coating and annealing. The $NO_2$ gas sensing properties of multiple-networked Pt-functionalized ZnS nanowire sensors were examined. Scanning electron microscopy showed the nanowires with diameters of 20-80 nm. Transmission electron microscopy and X-ray diffraction showed that the nanowires were wurtzite-structured ZnS single crystals. The Pt-functionalized ZnS nanowire sensors showed enhanced sensing performance to $NO_2$ gas at $150^{\circ}C$ compared to pristine ZnS nanowire sensors. Pristine and Pt-functionalized ZnS nanowire sensors showed responses of 140-211% and 207-488%, respectively, to 1-5 ppm $NO_2$, which are better than or comparable to those of many oxide semiconductor sensors. In addition, the underlying mechanism of the enhancement of the sensing properties of ZnS nanowires by Pt functionalization is discussed.

  • PDF

Morphological evolution of ZnO nanowires using varioussubstrates

  • Kar, J.P.;DAS, S.N.;Choi, J.H.;Myoung, J.M.
    • 한국재료학회:학술대회논문집
    • /
    • 한국재료학회 2009년도 추계학술발표대회
    • /
    • pp.27.1-27.1
    • /
    • 2009
  • In recent years, ZnO nanostructures have drawn considerable attentions for the development of futuristic electronic devices due to their superior structural and optical properties. As the growth of ZnO nanowires by MOCVD is a bottom-up technique, the nature of substrates has a vital role for the dimension and alignment of the nanowires. However, in the pursuit of next generation ZnO based nanodevices, it would be highly preferred if well-ordered ZnO nanowires could be obtained on various substrates like sapphire, silicon, glass etc. Vertically aligned nanowires were grown on A and C-plane sapphire substrates, where as nanopencils were obtained on R-plane sapphire substrates. In addition, C-axis oriented vertical nanowires were also found using an interfacial layer(aluminum nitride film) on silicon substrates. On the other hand, long nanowires were found on Ga-doped ZnO film on glass substrates. Structural and optical properties of the ZnO nanowires on various substrates were also investigated.

  • PDF

산화아연 나노선과 나노튜브의 구조 및 탄성계수에 관한 원자단위 연구 (Atomistic simulation of structural and elastic modulus of ZnO nanowires and nanotubes)

  • 문원하;최창환;황호정
    • 한국전기전자재료학회:학술대회논문집
    • /
    • 한국전기전자재료학회 2008년도 하계학술대회 논문집 Vol.9
    • /
    • pp.429-429
    • /
    • 2008
  • The structural stability and the elastic modulus of hexagonal ZnO nanowires and nanotubes are investigated using atomistic simulations based on the shell model. The ZnO nanowire with (10-10) facets is energetically more stable than that with (11-20). Our calculations indicate that the structural change of ZnO nanowires with (10-10) facets is sensitive to the diameter. With decreasing the diameter of ZnO nanowires, the unit-cell length is increased while the bond-length is reduced due to the change of surface atoms. Unlike the conventional layered nanotubes, the energetic stability of single crystalline ZnO nanotubes is related to the wall thickness. The potential energy of ZnO nanotubes with fixed outer and inner diameters decreases with increasing wall thickness while the nanotubes with same wall thickness are independent of the outer and inner diameters. The transformation of single crystalline ZnO nanotubes with double layer from wurtzite phase to graphitic suggests the possibility of wall-typed ZnO nanotubes. The size-dependent Young's modulus for ZnO nanowires and nanotubes is also calculated. The diameter and the wall thickness play a significant role in the Young's modulus of single crystalline ZnO nanowires and nanotubes, respectively.

  • PDF

Fabrication and characterization of ternary compound ZnCdS nanowires

  • Lee, Dong-Jin;Son, Moon-A;Kang, Tae-Won
    • 한국진공학회:학술대회논문집
    • /
    • 한국진공학회 2009년도 제38회 동계학술대회 초록집
    • /
    • pp.57-57
    • /
    • 2010
  • Self assembled $Zn_{x-1}Cd_xS$ nanowires, synthesized on a Indium tin oxide coated glass substrate with low composition of Cd as x=0.09, were fabricated non-precursor via a co-evaporation method using of solid sources of CdS and ZnS. We studies that ZnCdS nanowires are dislocation-free and the single crystalline hexagonal wurtzite structure showed by transmission electron microscopy and selected area electron diffraction pattern. Cathode luminescence spectra showed an near band edge peak at 383nm originated from nanowires at 80K and 300K. Core level spectra of the Cd 3d, Zn 2p and S 2p in the ZnCdS nanorods were obtained by x-ray photoelectron spectroscopy. Prepared ZnCdS nanorods showed different shape with increase of substrate temperature at the growth.

  • PDF

액상에서 성장한 ZnO 나노와이어의 전계방출 특성연구 (Field emission characteristics of ZnO nanowires grown at liquid phase)

  • 노임준;김성현;조진우;박구범;김용혁;이덕출;신백균
    • 대한전기학회:학술대회논문집
    • /
    • 대한전기학회 2009년도 제40회 하계학술대회
    • /
    • pp.1347_1348
    • /
    • 2009
  • We fabricated FEDs based on ZnO nanowires. ZnO nanowires were synthesized on Au thin films by hydrothermal method on hot plate. After 2 hours, we obtained nanowires of chin form. The high-purity nanowires showed sharp tips geometry with a wurtzite structure. The field emission properties of the ZnO nanowires were investigated in high vacuum chamber. The turn-on field for the ZnO nanowires was found to be about 4.1 V/${\mu}m$ at a current density of $0.1{\mu}A/cm^2$.

  • PDF

산소 분위기 열처리에 따른 ZnO 나노선의 상온 영역에서의 수소가스 검출 특성 향상 (Enhanced Hydrogen Gas Sensing Properties of ZnO Nanowires Gas Sensor by Heat Treatment under Oxygen Atmosphere)

  • 강우승
    • 한국표면공학회지
    • /
    • 제50권2호
    • /
    • pp.125-130
    • /
    • 2017
  • ZnO nanowires were synthesized and annealed at various temperatures of $500-800^{\circ}C$ in oxygen atmosphere to investigate hydrogen gas sensing properties. The diameter and length of the synthesized ZnO nanowires were approximately 50-100 nm and a few $10s\;{\mu}m$, respectively. $H_2$ gas sensing performance of the ZnO nanowires sensor was measured with electrical resistance changes caused by $H_2$ gas with a concentration of 0.1-2.0%. The response of ZnO nanowires at room temperature to 2.0% $H_2$ gas is found to be two times enhanced by annealing process in $O_2$ atmosphere at $800^{\circ}C$. In the current study, the effect of heat treatment in $O_2$ atmosphere on the gas sensing performance of ZnO nanowires was studied. And the underlying mechanism for the sensing improvement of the ZnO nanowires was also discussed.

황화납/산화아연 나노선을 이용한 양자점 감응형 태양전지 (Quantum Dot Sensitized Solar Cell Using PbS/ZnO Nanowires)

  • 김우석;용기중
    • 청정기술
    • /
    • 제16권4호
    • /
    • pp.292-296
    • /
    • 2010
  • 황화납(PbS)을 감응물질로 하는 양자점 감응형 태양전지를 제작하고 효율을 측정해 보았다. 기판에 산화아연(ZnO) 나노선을 기른 후 SILAR(Successive ionic layer adsorption and reaction)법으로 PbS 양자점을 합성하고 이를 주사전자현미경(SEM), X-선 회절(XRD)을 통해 확인하였다. SILAR를 통해서 형성된 나노이종구조는 PbS 나노입자들이 ZnO 나노선 위에 균일하게 성장한 것을 확인할 수 있었다. 본 실험에서 PbS을 이용한 양자점 감응형 태양전지의 최고 효율은 one sun에서 0.075%로 나타났으며, 이는 기존의 다른 감응 물질에 비해 비교적 낮은 효율을 나타내었다. 이러한 요인으로는 i) ZnO와 PbS의 밴드갭 배열이 Type-I 형을 이룰 수 있는 가능성, ii) 다양한 크기의 밴드갭을 가지는 PbS에 의한 전자이동 방해 효과, iii) 전해질에 의한 PbS의 안정성 저하 등의 이유를 생각해 볼 수 있으며, 이를 해결하기 위해서는 PbS의 크기분포 조절과 새로운 전해질에 대한 연구가 향후 필요할 것으로 생각된다.