• 한국전기전자재료학회논문지
• /
• 제22권4호
• /
• pp.318-322
• /
• 2009

In this paper, to establish growth technology of ZnO:Al thin films at low temperature applied to photoelectronic devices, ZnO:Al were prepared by RF magnetron sputtering on glass substrate at room temperature using different RF power with subsequent annealing process at different temperature in $H_2$ ambient. The resistivity of hydrogen-annealed ZnO:Al thin film at temperature of $300^{\circ}C$ was reduced to $8.32{\times}10^{-4}{\Omega}cm$ from $9.44{\times}10^{-4}{\Omega}cm$ which was optimal value for as-grown films. X-ray photoelectron spectroscopy(XPS) revealed that improved electrical properties are ascribed to desorption of the negatively charged oxygen species from the grain boundary surfaces by the hydrogen annealing process.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2008년도 추계학술대회 논문집 Vol.21
• /
• pp.229-230
• /
• 2008

We have studied the structural and optical properties of ZnO thin film deposited on glass by RF magnetron sputtering as functions of working pressures. The grain sizes were decreased as the working pressures were increased. The average optical transmissions over all exceeded 80% for ZnO films deposited in 20, 25 and 300m torr working pressures. And the transmission spectra patterns were almost same. While the transmission spectra pattern of ZnO film deposited in 35nm torr was different with other spectra patterns obtained in 20, 25 and 30nm torr working pressures.

• 한국진공학회:학술대회논문집
• /
• 한국진공학회 2014년도 제46회 동계 정기학술대회 초록집
• /
• pp.322.2-322.2
• /
• 2014

Lighting emitting diodes of n-ZnO/MQW/p-GaN structure are fabricated and investigated. To realize this LED structure, n-ZnO/MQW/p-GaN are grown by MOCVD. At several bias voltages, blue-green light is emitted from the ZnO mesa edge. However, the emission is restricted near the mesa edge. It is seen that the hole current does not spread well. It is because conductivity of p-GaN is extremely small. The break down voltage of the device is small compared to conventional InGaN/GaN LEDs. It is seen that ZnO columnar grain boundaries act as leakage current paths and non-radiative recombination center.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2005년도 추계학술대회 논문집 Vol.18
• /
• pp.183-184
• /
• 2005

In this study, our varistors based on M.Matsuoke's composition were fabricated with ZnO nano-powder whose sizes were 50nm and 100nm. Electrical properties of ZnO nano-powder varistors were obtained by capacitance-voltage and frequency-real impedance. nano-powder varistors are indicated the change of the interface defects density $N_t$ at the grain boundaries and the donor concentration $N_d$ in the ZnO grains. Frequency analysis was accomplished to understand the equivalent circuit.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2000년도 추계학술대회 논문집
• /
• pp.324-327
• /
• 2000

ZnO(Zinc Oxide) thin films were deposited on glass substrate by Facing Targets Sputtering. Facing Targets Sputtering system can deposit thin films in plasma-free situation and change the sputtering conditions in wide range. The characteristics of ZnO thin films deposited at variation of sputtering conditions films thickness, power and substrate temperature were evaluated by XRD(x-ray diffractometer), ${\alpha}$-step (Tencor). The excellently c-axis oriented ZnO thin films were obtained at sputter pressure ImTorr, power 150W, substrate temperature 200$^{\circ}C$. In these conditions, the rocking curve of ZnO thin films deposited on glass was 3.3$^{\circ}$.

• 한국안광학회지
• /
• 제10권3호
• /
• pp.193-203
• /
• 2005

Zn-나프텐산염을 출발 원료로 사용하고 스핀코팅 - 열분해법을 이용하여 실리카 유리 위에 c축으로 배향된 나노 결정질 ZnO 박막을 제조하였다. X-선 회절 분석을 행한 결과, 모든 시편에서 ZnO (002) 피크만이 관찰되었으며, 박막의 열처리 온도가 증가함에 따라 (002) 피크 강도가 증가하였다. 박막의 표면 미세 구조는 매우 균질하였으며, 입자들 간의 응집은 관찰되지 않았다. 박막의 topology를 주사형 탐침 현미경으로 분석한 결과에 따르면, 실리카 기판 자체의 불균질한 표면 특성과 ZnO 입자의 c축 배향 특성에 의한 것으로 보이는 3차원적인 입자성장이 모든 열처리 온도 영역에 대해 박막의 표면에서 관찰되었다. 고배향된 박막들 중에서 $800^{\circ}C$로 열처리한 박막의 표면이 가장 균질한 특성을 나타내었다. 박막의 가시영역에서의 투과율은 $1000^{\circ}C$로 열처리한 박막을 제외하고 모든 박막에 있어서 80% 이상의 투과율을 나타냈으며, 380~400nm 영역에서 날카로운 absorption edge가 나타났다. 흡수피크를 이용하여 계산된 오든 박막의 에너지 밴드 캡은 ZnO 단결정 및 다른 연구자들에 의해 보고된 박막과 같은 영역에 존재하였다. 본 연구에서 제조된 ZnO 박막들 중에 치밀한 입자 성장과 균질한 표면 특성을 보이는 $600^{\circ}C{\sim}800^{\circ}C$로 열처리된 박막은 UV차단성 투명전도막 및 렌즈 등의 광학소자에 실질적인 응용이 기대 된다.

• 한국재료학회지
• /
• 제22권12호
• /
• pp.675-681
• /
• 2012

We aimed to examine the co-doping effects of 1/6 mol% $Mn_3O_4$ and 1/4 mol% $Cr_2O_3$ (Mn:Cr = 1:1) on the reaction, microstructure, and electrical properties, such as the bulk defects and grain boundary properties, of ZnO-$Bi_2O_3-Sb_2O_3$ (ZBS; Sb/Bi = 0.5, 1.0, and 2.0) varistors. The sintering and electrical properties of Mn,Cr-doped ZBS, ZBS(MnCr) varistors were controlled using the Sb/Bi ratio. Pyrochlore ($Zn_2Bi_3Sb_3O_{14}$), ${\alpha}$-spinel ($Zn_7Sb_2O_{12}$), and ${\delta}-Bi_2O_3$ (also ${\beta}-Bi_2O_3$ at Sb/Bi ${\leq}$ 1.0) were detected for all of the systems. Mn and Cr are involved in the development of each phase. Pyrochlore was decomposed and promoted densification at lower temperature on heating in Sb/Bi = 1.0 system by Mn rather than Cr doping. A more homogeneous microstructure was obtained in all systems affected by ${\alpha}$-spinel. In ZBS(MnCr), the varistor characteristics were improved dramatically (non-linear coefficient, ${\alpha}$ = 40~78), and seemed to form ${V_o}^{\cdot}$(0.33 eV) as a dominant defect. From impedance and modulus spectroscopy, the grain boundaries can be seen to have divided into two types, i.e. one is tentatively assigned to ZnO/$Bi_2O_3$ (Mn,Cr)/ZnO (0.64~1.1 eV) and the other is assigned to the ZnO/ZnO (1.0~1.3 eV) homojunction.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1994년도 하계학술대회 논문집 C
• /
• pp.1257-1261
• /
• 1994

Phsysical and dielectric properties of $(1-x)CaTiO_3-xLa(Zn_{1/2}Ti_{1/2})O_3$ ceramics were investigated at the temperature range of $25^{\circ}C$ to $80^{\circ}C$ at the frequency of 6 GHz. As increasing addition of the amount of $La(Zn_{1/2}Ti_{1/2})O_3$ to x = 5 mol,Q value was increased due to grain growth and increase of density. For more addition, Q value decreased due to electrical defect. Temperature coefficient of resonant frequency could be controlled by the amount of $La(Zn_{1/2}Ti_{1/2})O_3$, which could be explained by volume mixing rule.

• E2M - 전기 전자와 첨단 소재
• /
• 제10권2호
• /
• pp.126-133
• /
• 1997

In order to apply for the gas sensing layer and the piezoelectric thin film devices, we studied the effects of magnetron sputtering conditions and annealing temperature on the electrical and structual characteristics of the ZnO thin film. The optimal deposition conditions, in order to obtain a c axis of the ZnO (002) phase thin film which is perpendicular to SiO$_{2}$/Si substrate, were like these ; substrate temperature 150.deg. C, chamber pressure 2 mtorr, R.F. power 300 watts, gas flow ratio 0.4[O$_{2}$(Ar + $O_{2}$)]. When the ZnO thin film was annealed in 600.deg. C, $O_{2}$ gas ambient for 1 hr, the resistivity was 2.6 x 10$^{2}$.ohm.cm and the grain size of ZnO thin film was less than 1 .mu.m. So the ZnO thin film acquired from above conditions can apply for the gas sensing layer which require a c axis perpendicular to the substrate surface.

• 한국진공학회:학술대회논문집
• /
• 한국진공학회 2011년도 제40회 동계학술대회 초록집
• /
• pp.83-83
• /
• 2011

본 연구에서는 p-type Si (100) 위에 분자선 에피택시 성장방법으로 ZnO 완충층이 삽입된 ZnO 박막을 성장시켰다. ZnO 완충층은 Zn 셀 셔터의 열림/닫힘을 반복하는 성장 멈춤법으로 성장되었다. Zn 셀 셔터의 열림 시간은 4분, 2분, 1분이며 닫힘 시간은 2분으로 동일하게 유지하였다. 이러한 과정은 각각 5, 10, 20회로 반복되었으며 ZnO 완충층을 성장한 후 ZnO 박막은 기존의 분자선 에피택시 방법으로 성장되었다. ZnO 박막의 구조적, 광학적 특성은 field-emission scanning electron microscopy (FE-SEM), atomic force microscopy (AFM), X-ray diffraction (XRD), photoluminescence (PL)로 조사하였다. SEM 측정결과 성장 멈춤 횟수가 증가함에 따라 ZnO 박막의 표면은 섬(island) 구조에서 미로(maze) 구조로 변화하였고, XRD 측정결과 full-width at half-maximum (FWHM) 이 감소하고 결정립 크기(grain size)가 증가하였다. 그리고 PL 측정결과 성장 멈춤 횟수가 증가함에 따라 near-band-edge emission (NBE) 피크의 세기가 증가하였고 deep-level emission (DLE) 피크의 위치는 오렌지 발광에서 녹색 발광으로 청색편이(blue-shift)하였다.