• Korean Journal of Remote Sensing
• /
• 제26권6호
• /
• pp.653-664
• /
• 2010

The land surface reflectance is a key parameter influencing the climate near the surface. Therefore, it must be determined with sufficient accuracy for climate change research. In particular, the characteristics of the bidirectional reflectance distribution function (BRDF) when using earth observation system (EOS) are important for normalizing the reflected solar radiation from the earth's surface. Also, wide swath satellites like SPOT/VGT (VEGETATION) permit sufficient angular sampling, but high resolution satellites are impossible to obtain sufficient angular sampling over a pixel during short period because of their narrow swath scanning. This gives a difficulty to BRDF model based reflectance normalization of high resolution satellites. The principal objective of the study is to add BRDF modeling of high resolution satellites and to supply insufficient angular sampling through identifying BRDF components from SPOT/VGT. This study is performed as the preliminary data for apply to high-resolution satellite. The study provides surface parameters by eliminating BRD effect when calculated biophysical index of plant by BRDF model. We use semi-empirical BRDF model to identify the BRD components. This study uses SPOT/VGT satellite data acquired in the S1 (daily) data. Modeled reflectance values show a good agreement with measured reflectance values from SPOT satellite. This study analyzes BRD effect components by using the NDVI(Normalized Difference Vegetation Index) and the angle components such as solar zenith angle, satellite zenith angle and relative azimuth angle. Geometric scattering kernel mainly depends on the azimuth angle variation and volumetric scattering kernel is less dependent on the azimuth angle variation. Also, forest from land cover shows the wider distribution of value than cropland, overall tendency is similar. Forest shows relatively larger value of geometric term ($K_1{\cdot}f_1$) than cropland, When performed comparison between cropland and forest. Angle and NDVI value are closely related.

• Korean Journal of Remote Sensing
• /
• 제38권6_1호
• /
• pp.1081-1089
• /
• 2022

This study aims to investigate and monitor the ground subsidence in Ulsan city, South Korea using time-series Small Baseline Subset (SBAS)-InSAR analysis. We used 79 Sentinel-1 SAR scenes and 385 interferograms to estimate the ground displacements at Ulsan city from May 2015 and December 2021. Two subsiding regions Buk-gu and Nam-gu Samsan-dong were found with the subsidence rate of 3.44 cm/year and 1.68 cm/year. In addition, we evaluated the possibility of removing the effect of atmospheric (tropospheric delay) phase in unwrapped phase using the Zenith Total Delay (ZTD) maps from Generic Atmospheric Correction Online Service (GACOS).We found that the difference between the SBAS-InSAR ground displacements before and after GACOS ZTD correction is less than 1 mm/year in this study.

• Journal of the Korean Geotechnical Society
• /
• 제38권11호
• /
• pp.137-147
• /
• 2022

Various geophysical exploration methods are used to determine the exact location of underground utilities, and many studies have been performed to improve the accuracy. This study analyzed the feasibility of exploring underground utilities through a new exploration method using cosmic ray muon. A prototype of a portable muon detector was manufactured by combining a scintillator and a silicon photomultiplier. Further, a calibration operation was performed on the muon count rate. The ground thickness of the ground model was measured using the muon detector prototype, where the value could be estimated with an error of about 3%, close to the actual. In addition, the theoretical basis for tomography analysis technology was analyzed to utilize the muon detector for exploring underground utilities, and a zenith angle correction method was presented. This study revealed that the technology of exploration using muon can analyze density with high resolution and will be used for exploring underground utilities.

• Journal of Dental Rehabilitation and Applied Science
• /
• 제36권4호
• /
• pp.254-261
• /
• 2020

Purpose: The purpose of this study was to assess the marginal and internal fit of interim crowns fabricated by two different manufacturing method (subtractive manufacturing technology and additive manufacturing technology). Materials and Methods: Forty study models were fabricated with plasters by making an impression of a master model of the maxillary right first molar for ceramic crown. On each study model, interim crowns (n = 40) were fabricated using three types of 3D printers (Meg-printer 2; Megagen, Zenith U; Dentis, and Zenith D; Dentis) and one type milling machine (imes-icore 450i; imes-icore GmbH). The internal of the interim crowns were filled with silicon and fitted to the study model. Internal scan data was obtained using an intraoral scanner. The fit of interim crowns were evaluated in the margin, absolute margin, axial, cusp, and occlusal area by using the superimposition of 3D scan data (Geomagic control X; 3D Systems). The Kruskal-wallis test, Mann-Whitney U test and Bonferroni correction method were used to compare the results among groups (α = 0.05). Results: There was no significant difference in the absolute marginal discrepancy of the temporary crown manufactured by three 3D printers and one milling machine (P = 0.812). There was a significant difference between the milling machine and the 3D printer in the axial and occlusal area (P < 0.001). The temporary crown with the milling machine showed smaller axial gap and higher occlusal gap than 3D printer. Conclusion: Since the marginal fit of the temporary crown produced by three types of 3D printers were all with in clinically acceptable range (< 120 ㎛), it can be sufficiently used for the fabrication of the temporary crown.

• Proceedings of the Korean Society of Surveying, Geodesy, Photogrammetry, and Cartography Conference
• /
• 한국측량학회 2007년도 춘계학술발표회 논문집
• /
• pp.27-30
• /
• 2007

The objective of this study is to improve an accuracy of PWV estimates using GPS in Korea. We determined a weighted mean temperature equation by a linear regression method based on 6 radiosonde meteorological observations, for a total 17,129 profiles, from 2003 to 2005. Weighted mean temperature, Tm, is a key parameter in the retrieval of atmospheric PWV from ground-based GPS measurements of zenith path delay. The accuracy of the GPS-derived PWV is proportional to the accuracy of Tm. And we applied the reduction of air Pressure to GPS station altitude. The reduction value of air pressure from mean sea level to GPS stations altitude is adopted a reverse sea level correction.

• Journal of Positioning, Navigation, and Timing
• /
• 제4권2호
• /
• pp.87-95
• /
• 2015

In this study, the temporal and spatial variation in precipitable water vapor (PWV) was analyzed for typhoon Ewiniar which had made landfall in the Korean peninsula in 2006. To make a contour map of PWV, zenith total delay (ZTD) was calculated using about 60 GPS permanent stations in Korea, and the pressure and temperature data of nearby AWS stations were interpolated and applied to the equation for calculating the PWV. While Typhoon Ewiniar was migrating north from the southern coast to the eastern coast of Korea, the PWV migrated showing a spatial distribution similar to that of rainfall. Also, the fluctuating pattern of the normalized PWV was analyzed, and the moving speed of the PWV was estimated using the delay time of the increase/decrease pattern in the eight-test stations. The result indicated that the moving speed of the PWV was about 35 km/h, which was similar to the average moving speed of the typhoon (38.9 km/h).

• Journal of The Korean Astronomical Society
• /
• 제38권2호
• /
• pp.311-314
• /
• 2005

We report the current status of Japanese lunar exploration SELENE (SELenological and ENgineering Explorer). As of the end of 2004, scientific instruments onboard the Main Orbiter are under final checkout before they are provided to the proto-flight-model (PFM) integration test. Also, we present the future perspectives of the lunar based instruments and facilities. 'In-situ Lunar Orientation Mea-surement (ILOM)' experiment measures the lunar rotation with high accuracy by tracking stars on the Moon with a small photo-zenith-tube type optical telescope. A basic idea of a radio telescope array of very low frequency range on the lunar far-side is also mentioned.

• Asian Journal of Turfgrass Science
• /
• 제15권1호
• /
• pp.9-14
• /
• 2001

Callus formation and plant regeneration from the seeds of zoysiagrass cv. Zenith was tested on MS basal medium supplemented with various concentrations of 2,4-dichlorophenoxyacetic acid(2,4-D) and of several cytokinins. A concentration of 1mg/L 2,4-D on medium stimulated callus formation. In the presence of 5mg/L 2,4-D, addition of 1mg/L kinetin significantly enhanced callus formation and plant regeneration over 2,4-D alone. To transfer foreign DNA into turfgrass, parameters for the bombardment of embryogenic callus with the particle bombardment were partially optimized using transient expression assay of a $chimeric \beta$-glucuronidase(GUS) gene driven by the CaMV 35S promoter. GUS gene was strongly expressed at helium pressure 1,100 psi and 6~9cm target distance.

• Proceedings of the KSRS Conference
• /
• 대한원격탐사학회 1999년도 Proceedings of International Symposium on Remote Sensing
• /
• pp.13-18
• /
• 1999

Land cover map of 30 arc-second grid by NOAA AVHRR data for the whole Asia was produced by the authors as the project of the Asian Association on Remote Sensing(AARS). Land cover change monitoring of continental scale by satellite data needs preprocessing to remove undesirable factors due to noises, atmosphere, or the effect by solar zenith angle. The paper describes the method to remove these factors. The most important thing for better mapping/monitoring in the future is the accumulation of ground truth data by many land cover related researchers. The project of the development of Global Land Cover Ground Truth Database(GLCGT-DB) is proposed.

• Korean Journal of Microbiology
• /
• 제6권1호
• /
• pp.1-5
• /
• 1968

This experiment was undertaken the purpose of investigating the difference of the content of free amino acids in the diseased and healthy leaves of the resistance and susceptible rice varieties, to blast by means of paper chromatography. The results obtained are summarized as follows. (1) In the healthy and diseased leaves, the former was founded nine to tell sorts of free amino acids and later was observed eleven. In the both of leaves, alanine and valine were contained in larger amount, and aspartic acid, glycine and arginine were found relatively less in general. (2) In the diseased leaves, the amino acids were increased in quantity, especially glutamine and aspartic acid were remarkable, and cystine were found only in the diseased ones. (3) It seems to that the health leaves in all varieties were observed the amino acid contents, in notably increase and decrease, but in the diseased ones were not changed in amount. Tatacho, susceptible variety was more contained the amount of glutamine and aspartic acid than Zenith, resistance one.