• Journal of the Korean Magnetics Society
• /
• v.8 no.6
• /
• pp.350-356
• /
• 1998

$Y_{3-x}La_xFe_5O_{12}$ (x=0.0, 0.25, 0.5, 0.75, 1.0) powders and thin films were fabricated by a sol-gel method and their magnetic properties and crystal structure were investigated by using X-ray diffraction (XRD), atomic force microscopy (AFM), scanning electron microscopy (SEM), vibrating sample magnetometer (VSM), and Mossbauer spectroscopy. XRD and Mossbauer spectroscopy measurements show that garnet powders annealed at 900 $^{\circ}C$ for 8 hours were single-phased and that thin films fired at 800 $^{\circ}C$ for 2 hours were crystallized without any preferred direction. X-ray diffraction patterns of $Y_{3-x}La_xFe_5O_{12}$ powders annealed at 1000 $^{\circ}C$ had only peaks of the garnet structure in case of x$\leq$0.75 but those of $Y_2LaFe_5O_{12}$ powders consisted of peaks from garnets and $LaFeO_3$. Mossbauer sepectra of garnet powders grown by the sol-gel method had a similar shape of those of powders grown by a conventional ceramic method. Grain sizes of garnet powders were 200~300 nm and the averaged surface roughness was 3.17 nm. Results of VSM measurements show the powders and thin films had soft magnetic properties and that the garnet powders had the largest saturation magnetization, 30 emu/g, and the lowest coercivity, 52 Oe.

• Polymer(Korea)
• /
• v.25 no.6
• /
• pp.818-825
• /
• 2001

Polycarbonate(PC)/montmorillonite (MMT) nanocomposites were prepared by solution and melt mixing methods. A d-spacing of the nanocomposites was measured by an X-ray diffractometer. Neat montmorillonite (MMT-Na) and MMTs modified by dodecyl ammonium (MMT-DA) or dimethyl hydrogenated tallow 2-ethylhexyl ammonium (MMT-25A) were used. The d-spacing value of PC/MMT-25A and PC/MMT-DA was higher than that of PC/MMT-Na. The d-spacing increased from around 12 to $37AA$ depending on the mixing method. PC was more readily introduced to the gallery of MMT as the molecular weight of PC reduced and the mixing time increased. PC/MMT-25A showed higher thermal stability by thermogravimetric analysis (TGA) than PC/MMT-DA and PC/MMT-Na.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.20 no.4
• /
• pp.390-395
• /
• 2009

Design and optimization of a broadband meander-line twist reflector was performed for X-band application. Based on the equivalent transmission line model, the polarization twist performance was evaluated. Genetic analysis, particles swarm, and hybrid swarm optimizations were employed to obtain the optimized geometrical parameters. The optimized design exhibits low cross-polarization level below - 25 dB between 8.45 and 11.38 GHz. The polarization twist loss was below 0.2 dB. Comparison between computed and simulated results was also discussed.

• Journal of Astronomy and Space Sciences
• /
• v.25 no.4
• /
• pp.375-382
• /
• 2008

On August 31, 2001, ${\sim}$ 1705 - 1718 UT, Cluster was located near the midnight magnetotail, GSE (x, y, z) ${\sim}$ (-19, - 2,2) RE, and observed fast earthward flow bursts in the vicinity of the neutral sheet. They occurred while the tail magnetic field suddenly increased. Using simultaneous measurements in the solar wind, at geosynchronous orbit, and on the ground, it is confirmed that tail magnetic field enhancement is due to an increased solar wind pressure. In the neutral sheet region, strongly enhanced earthward flow bursts perpendicular to the local magnetic field $(V_{{\perp}x})$ were observed. Auroral brightenings localized in the pre-midnight sector (${\sim}$ 2200 - 2400 MLT) occurred during the interval of the $V_{{\perp}x}$ enhancements. The $V_{{\perp}x}$ bursts started ${\sim}$ 2 minutes before the onset of auroral brightenings. Our observations suggest that the earthward flow bursts are associated with tail reconnection directly driven by a solar wind pressure impulse and that $V_{{\perp}x}$ caused localized auroral brightenings.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.9 no.12
• /
• pp.1331-1336
• /
• 2014

In this study, we have implemented a PAM(Power Amplifier Module) with 25W output power using by cooperate divider/Combiner circuit in X-band to minimize combine loss on a Al2O3 substrate. The PAM(Power Amplifier Module) is consisted of MMIC and 10way traveling wave divider/Combiner with proposed structure what have showed that 45.2dBm output power, 16dB gain, PAE 26 % and 17dBc@44dBm IMD3 characteristics. This combine/divider structure can be used when multistage passive divider and combiner needs. especially, power amplifier with very compact size.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2002.11a
• /
• pp.346-349
• /
• 2002

Ferroelectric $Bi_{4-x}Nd_{x}Ti_{3}O_{12}(BNdT)$ thin films with the composition(x=0.75) were prepared on $Pt/Ti/SiO_{2}/Si(100)$ substrate by metal-organic deposition. The films were annealed by various temperatures from 550 to $650^{\circ}C$ and then the electrical and structural characteristics of BNdT films were investigated for the application of FRAM. Electrical properties such as dielectirc constant, 2Pr and capacitance were quite dependent on the thermal heat treatment. The measured 2Pr value on the BNdT capacitor annealed at $650^{\circ}C$ was $56{\mu}C/cm^{2}$ at an applied voltage of 5V. In fatigue characteristics value remained costant up to $8{\times}10^{10}$ read/write switching cycles at a frequency of 1Mhz regardless of annealing temperatures.

• Bulletin of the Society of Naval Architects of Korea
• /
• v.7 no.1
• /
• pp.37-44
• /
• 1970

The plate under shear loading umformly distributed on the end portions of its side boundary was considered. Infinite hyperbolic serieses and Fourier serieses were combined as a stress function and from which exact solutions for the 15 cases for the parameters of b/L=0.25, 0.5, 1.0 and l/L=0.2, 0.4, 0.6, 0.8, 1.0 are obtained. In each cases the first 5 terms of the infinite series at the 36 points as shown in Fig. 3. The results are presented in Fig. 4-1, 4-2, and 4-3. The conclusions are as follows: 1) The stresses ${\sigma}_x$ increase very slightly as $\chi$ increases in the range of 0<x<L-l 2) When the parameters satisfy the conditions b/L<0.25 and l/L<0.2, the stresses in the region of 0<x<L-l can be obtained by replacing the uniform shear loading by the equivalent uniform shear loading by the equivalent uniform tensile force and pure bending moment at x=l. 3) The stress ${\sigma}_y$ is negligible throughout the region. 4) When the parameter b/L varies, the stresses ${\sigma}_x$ and u vary as L/b, while strain $\upsilon$ varies as $(L/b)^2$.

• Bulletin of the Korean Chemical Society
• /
• v.25 no.6
• /
• pp.859-864
• /
• 2004

The solid solutions of the $Sr_{1-x}Ba_xFeO_{3-y)$ system (x = 0.0, 0.1, 0.2 and 0.3) having a perovskite structure were prepared in air at 1423 K and then heat-treated in air (A), $O_2(O)\;and\;N_2(N)$ to examine possibility of controlling the nonstoichiometry and applicability as an additive for electrical conducting inorganic adhesives (ECIA). In the samples heated in $N_2$ stream, there existed almost no $Fe^{4+}$ ions, and at constant temperature their electrical conductivities were considerably lower than those of the samples heat-treated in air or $O_2.\; Sr_{0.8}Ba_{0.2}Fe^{3+}_{0.49}Fe^{4+}_{0.51}O_{2.76}$ (SB2-A) whose $Fe^{3+}/Fe^{4+}$ ratio was nearly 1 (0.96) and whose conductivity values (1.04 $ohm^{-1}cm^{-1}$ at 283 K and 1.88 $ohm^{-1}cm^{-1}$ at 673 K) were higher than any other samples, was found to be the best additive for ECIA.

• Journal of fish pathology
• /
• v.25 no.3
• /
• pp.243-247
• /
• 2012

Histopathological observations on a epidermal papilloma of wild red halibut (Hippogossoides dubius) caught at the area around Echung Island and Gogunsan Islands were done. The papilloma formed on the dorsal fin was the same color with the body on the ocular side but black on the non-ocular side. Under light microscopy, the tumor on the skin was very similar to epithelial papilloma supported by connective tissue. X-cell-like cells in the tumors were large and eosinophilic with a centrally-located, large nucleus. But the characteristic large nucleolus in the nucleus of the x-like cells was indistinct clear in this specimen because about 6-9 hours have passed after catching the fish and autolysis have occurred.

• Journal of the Korean Applied Science and Technology
• /
• v.25 no.2
• /
• pp.130-136
• /
• 2008

$xTiO_2$-$ySiO_2$ system photocatalysts were developed by sol-gel method based on the change of production parameters, and their structure of crystallization and the specific surface area were measured. Considering the efficiency of the ethanol and phenol degradation using the catalyst, the conclusions were obtained as follows: By means of X-ray analysis of $xTiO_2$-$ySiO_2$ powder that is obtained from Titanium and Silicon alkoxide by sol-gel process, it is shown that crystal structure of anatase type is a dominating structure and, on the other hand, the structure of rutile also partly exists. The increase of $SiO_2$ contents causes the decrease of the degree of crystallization of the gel, whereas the specific surface area preferentially increases. It is shown that more than 90% of ethanol and phenol are degraded when reaction time is about three and an hours, and the maximum degradation rate of ethanol and phenol is shown in $60TiO_2$-$40SiO_2$ catalyst.