• 제목/요약/키워드: X type

검색결과 4,650건 처리시간 0.029초

온수로 및 온수지에서의 수온상승효과에 관한 조사연구 (An Observational Study on the Temperature Rising Effects in Water Warming canal and Water Warming Pond)

  • 홍종백;홍성범
    • 한국농공학회지
    • /
    • 제32권3호
    • /
    • pp.31-38
    • /
    • 1990
  • The power water flowed out from the multipurpose darn influences the ecosystem approximately because of the low water temperature. An appropriate counter measure to the rising water temperature is needed for growing crops especially when the temperature is below 18˚C in the source of the irrigation water This observational study is practiced in Yong-Doo water warming canal and pond in the down stream of Choong-Ju multipurpose dam and is practiced for analyse and compare the rising effects in actural water temperature by actual measurement with the rising effects of planned water temperatuer by the basic theoritical method and for the help to present the direction in plan establishment through investigate the results afterwards. The results are as follows. 1.The degree of the rise of the water temperature can be decided by $\theta$x=$\theta$o +K L--v.h (T-$\theta$˚)Then, K values of a factor representing the characteristics of the water warming canal were 0.00002043 for the type I. and 0.0000173 for the type II. respectively. 2.A variation of water temperature which produced by the difference effective temperature and water temperature in the water warming canal was $\theta$x1 = 16.5 + 15.9(1-e -0.00018x), $\theta$x2 =18.8 + 8.4( 1-e -0.000298x)for the type I. and $\theta$x, = 19.6 + 12.8 ( 1-e -0.00041x) for the type II. 3.It was shown that the effects of the rise of water temperature for the type I. water warming canal were greater than that of type II. as a resultes of broadening the surface of the canal compared with the depth of water, coloring the surface of water canal and installing the resistance block. 4.In case of the type I. water warming canal, the equation between the air temperature and the degree of the rise of water temprature could be made ;Y= 0.4134X + 7.728 In addition, in case of the type II. water warming canal, the correlation was very low. 5.A monthly variation of the water temperature in the water warming canal was the highest in August during the irrigation period and the water temperature rose with the air temperature until August. However, it was blunted after then. 6.A rising degree of water temperature of the practical value in the water warming pond was higher than that of the theoritical equation by 69% for the type I. and 57% for the type II. Accordingly, it was possible to acquire the result near the practical value.$\theta$w-$\theta$o=[1-exp{ -h(1+2$\psi$) . X($\theta$w-$\theta$0)XC Here, C values are 1.69 for the type I. and 1.57 for the type II. 7.It was shown that the effect of the rise of water temperature was favorable when the thermal absorption was to be good by coloring the surface of the water warming pond and removing the bottom osmosis. 8.By enlarging the surface of water in comparison with the depth, and by having dead area of water in the water warming pond, this structure in the water warming pond is helpful for the rise of water temperature.

  • PDF

EXOSAT X-RAY LIGHT CURVES OF SS ARI

  • Kim, Yong-Gi
    • Journal of Astronomy and Space Sciences
    • /
    • 제15권1호
    • /
    • pp.65-68
    • /
    • 1998
  • We construct the X-ray light curves of the W UMa type contact binary SS Arietis(HD12929) from the EXOSAT data in HEASARC data archive. The phase dependent X-ray light curves obtained by using the ephimeris of Kaluzny & Pojmanski of SS Ari is modulated on the orbital phase as in the case of other W UMa type binaries. Although a detailed analysis of these data is impossible because of the very low X-ray light curves in the context of the radiation in the corona region of W UMa type stars.

  • PDF

치과용 X-선 관구의 조정시간 (Settling time of dental x-ray tube head after positioning)

  • 윤숙자;강병철;왕세명;고창성
    • Imaging Science in Dentistry
    • /
    • 제32권3호
    • /
    • pp.159-165
    • /
    • 2002
  • Purpose: The aim of this study was to introduce a method of obtaining the oscillation graphs of the dental x-ray tube heads relative to time using an accelerometer. Materials and Methods: An Accelerometer, Piezotron type 8704B25 (Kistler Instrument Co., Amherst, NY, USA) was utilized to measure the horizontal oscillation of the x-ray tube head immediately after positioning the tube head for an intraoral radiograph. The signal from the sensor was transferred to a dynamic signal analyzer, which displayed the magnitude of the acceleration on the Y-axis and time lapse on the X -axis. The horizontal oscillation of the tube head was measured relative to time, and the settling time was also determined on the basis of the acceleration graphs for 6 wall type, 5 floor-fixed type, and 4 mobile type dental x-ray machines. Results : The oscillation graphs showed that tube head movement decreased rapidly over time. The settling time varied with x-ray machine types. Wall-type x-ray machines had a settling time of up to 6 seconds, 5 seconds for fixed floor-types, and 1 I seconds for the mobile-types. Conclusion: Using an accelerometer, we obtained the oscillation graphs of the dental x-ray tube head relative to time. The oscillation graph with time can guide the operator to decide upon the optimum exposure moment after x-ray tube head positioning for better radiographic resolution.

  • PDF

CGL의 재료에 따른 청색 형광 Tandem OLED의 발광 특성 (Emission Characteristics of Blue Fluorescence Tandem OLED with Materials of CGL)

  • 곽태호;주성후
    • 한국표면공학회지
    • /
    • 제47권4호
    • /
    • pp.210-214
    • /
    • 2014
  • We investigated emission characteristics of tandem organic light emitting devices (OLEDs) with p-type materials as charge generation layer. The tandem OLEDs were fabricated by using $MoO_x$, $WO_x$, C60 and HATCN as p-type material or not using p-type material for charge generation. When HATCN was used as p-type material, it showed high current density at low applied voltage, but increase of efficiency was small because of charge unbalance in emitting layer. In case of tandem OLED not using p-type material, applied voltage increased remarkably because of difficulty of hole injection. In case of $MoO_x$, $WO_x$ or C60 as p-type material, current emission efficiency increased greatly. In particular, current emission efficiency of tandem OLED using $MoO_x$ as p-type material increased up to 3 times than current emission efficiency of single OLED. The Commission Internationale de l'Eclairage (CIE) 1931 color coordinates were changed by overlapping of 504 nm emission wavelength. As a result, emission efficiency of tandem OLED improved compared with single OLED, but driving voltage also increased by increase of organic layer thickness.

GaxIn1-xSbyAs1-y의 전자적 구조: UTB 방법에 의한 밴드정렬상태 (Electronic Structure of GaxIn1-xSbyAs1-y: Band Alignments Based on UTB Calculations)

  • 심규리
    • 한국진공학회지
    • /
    • 제20권6호
    • /
    • pp.461-467
    • /
    • 2011
  • 사원화합물 반도체 $Ga_xIn_{1-x}Sb_yAs_{1-y}$을 구성하는 네 가지 이원화합물 반도체 GaAs, GaSb, InAs, InSb의 최고 가전자띠 준위와 최저 전도띠 준위를 밀접결합방법에 근거한 해석적 근사법으로 계산하였다. 이들을 이종 접합시켰을 때 경계면에서의 밴드정렬상태를 구한 결과, GaAs/InAs와 GaAs/InSb, GaSb/InSb는 제 I형, GaAs/GaSb는 제 II형, GaSb/InAs, InSb/InAs는 제III형의 밴드 정렬 형태를 갖는다는 것을 알 수 있었다. 또한 범용적 밀접결합을 이용하여 사원화합물 반도체 $Ga_xIn_{1-x}Sb_yAs_{1-y}$의 성분비 x와 y에 따른 최고 가전자 띠와 최저 전도 띠 준위변화를 구하였다. $Ga_xIn_{1-x}Sb_yAs_{1-y}$을 GaSb와 InAs 격자 정합시켜 경계면에서의 밴드정렬상태를 구해 본 결과 성분비에 따라 제 II형과 제 III형 사이의 밴드정렬형태의 전이가 일어남을 알 수 있었다. $Ga_xIn_{1-x}Sb_yAs_{1-y}$를 GaSb에 격자 정합 시켰을 때 $x{\geq}0.15$에서 제 III형 밴드정렬이었던 것이 $x{\geq}0.81$에서는 제 II형의 밴드정렬 상태로 전이되며, 이와 반대로 $Ga_xIn_{1-x}Sb_yAs_{1-y}$를 InAs에 격자정합 시켰을 때 $x{\geq}0.15$에서 제 II형 밴드 정렬이 $x{\geq}0.81$에서 제 III형 밴드정렬로 전이됨을 알 수 있었다.

HYPERIDENTITIES IN (xy)x ≈x(yy) GRAPH ALGEBRAS OF TYPE (2,0)

  • Khampakdee, Jeeranunt;Poomsa-Ard, Tiang
    • 대한수학회보
    • /
    • 제44권4호
    • /
    • pp.651-661
    • /
    • 2007
  • Graph algebras establish a connection between directed graphs without multiple edges and special universal algebras of type (2,0). We say that a graph G satisfies an identity $s{\approx}t$ if the corresponding graph algebra $\underline{A(G)}$ satisfies $s{\approx}t$. A graph G=(V,E) is called an $(xy)x{\approx}x(yy)$ graph if the graph algebra $\underline{A(G)}$ satisfies the equation $(xy)x{\approx}x(yy)$. An identity $s{\approx}t$ of terms s and t of any type ${\tau}$ is called a hyperidentity of an algebra $\underline{A}$ if whenever the operation symbols occurring in s and t are replaced by any term operations of $\underline{A}$ of the appropriate arity, the resulting identities hold in $\underline{A}$. In this paper we characterize $(xy)x{\approx}x(yy)$ graph algebras, identities and hyperidentities in $(xy)x{\approx}x(yy)$ graph algebras.

(ZnSe/FeSe) 초격자에 있어서 $Zn_{1-x}Fe_xSe$ 상호확산층의 미세구조 (Microstructure of Intermixed $Zn_{1-x}Fe_xSe$ Alloys in (ZnSe/FeSe) Superlattices)

  • 박경순
    • Applied Microscopy
    • /
    • 제27권3호
    • /
    • pp.235-241
    • /
    • 1997
  • (001) GaAs 기판 위에 성장된 (ZnSe/FeSe) 초격자의 구성층 사이에 상호확산으로 형성된 $Zn_{1-x}Fe_xSe$ 의 미세구조가 고분해능 투과전자현미경과 컴퓨터 이미지 시뮬레이션에 의해 연구되었다. 컴퓨터 이미지 시뮬레이션은 multislice 방법으로 여러 시편 두께와 초점 거리에서 실시되었다. 컴퓨터 시뮬레이션에 의해 얻은 이미지는 실험에 의해 얻은 이미지와 비교되었다. 또한, CuAu-I 형태 규칙화가 $Zn_{1-x}Fe_xSe$ 상호화산층에서 일어났다. 이 CuAu-I 형태 규칙격자는 <100>과 <110> 방향에 따라서 ZnSe와 FeSe 층이 교대로 구성되어 있다.

  • PDF

ON THE STABILITY OF THE GENERALIZED G-TYPE FUNCTIONAL EQUATIONS

  • KIM, GWANG-HUI
    • 대한수학회논문집
    • /
    • 제20권1호
    • /
    • pp.93-106
    • /
    • 2005
  • In this paper, we obtain the generalization of the Hyers-Ulam-Rassias stability in the sense of Gavruta and Ger of the generalized G-type functional equations of the form $f({{\varphi}(x)) = {\Gamma}(x)f(x)$. As a consequence in the cases ${\varphi}(x) := x+p:= x+1$, we obtain the stability theorem of G-functional equation : the reciprocal functional equation of the double gamma function.