• The Transactions of the Korea Information Processing Society
• /
• v.7 no.8S
• /
• pp.2608-2619
• /
• 2000

This paper proposes the Handover Scheme for the mobile and describes the result of the performance analysis. In the conventional scheme of handover request, the withdrawal of terminal may occur because handover request is performed based on fixed signal level without considering network load and terminal mobility. The proposed scheme offers the minimization of withdrawal and handover blocking probability by means of the handover request of terminal based on the network load and terminal mobility. Conventional handover scheme has the sequential procedure that network performs resource check and path rerouting on the handover by MT(Mobile Terminal). Proposed handover scheme pre-processes the resource check before the handover request by predicting the handover request timo so that handover latency can be reduced. Moreover, path optimization is executed after the completion of handover in order to reduce handover latency. The rdduction of handover latency prevents the dropping of service by minimizing backward handover blocking. In summary, we propose the prediction of handover request time and decision method based on terminal, validating the performance of proposed scheme considering various cases of simulation.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.30 no.11B
• /
• pp.792-803
• /
• 2005

Ultra wide band (UWB) technology will be applied in the high rare wireless personal area networks (WPANs) for its high rate, low power, and innate immunity to multipath fading. In this paper, a power aware multi-hop packet relay MAC protocol in UWB based WPANs is proposed and a power aware path status factor (PAPSF), which is derived from SINR and power resource condition of each device, is used to select a suitable relay node. Compared with relaying by piconet coordinator (PNC), which is easily chosen by other ad hoc routing protocol, the new scheme can achieve hi임or throughput, decrease the time required for transmitting high power signal and we can easily distribute the battery power consumption from PNC to other devices in the piconet to prevent the PNC device using up its battery too fast and finally avoid PNC handover too frequently.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.34 no.8A
• /
• pp.633-639
• /
• 2009

For operation of IEEE 802.22 WRAN system, spectrum sensing is a essential function. However, due to strict sensing requirement of WRAN system, spectrum sensing process of CR nodes require long quiet period. In addition, CR nodes sometimes fail to detect licensed users due to shadowing effect of wireless communication environment. To overcome this problem, CR nodes collaborate with each other for increasing the sensing reliability or mitigating the sensitivity requirement. A general approach for decision fusion, the "k out of N" rule is often taken as the decision fusion rule for its simplicity. However, since k out of N rules can not achieve better performance than the highest SNR node when SNR is largely different among CR nodes, the local SNR of each node should be considered to achieve better performance. In this paper, we propose two novel data fusion methods by utilizing confidence vector which represents the confidence level of individual sensing result. The simulation results show that the proposed schemes improve the signal detection performance than the conventional data fusion algorithms.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.32 no.11A
• /
• pp.1173-1181
• /
• 2007

A number of routing algorithms have been studied for wireless mobile ad-hoc network. Among them, the AODV routing algorithm with on-demand method periodically transmits hello message and monitors link state during data transmission in order to maintain routing paths. When a path is disconnected, a node that senses it transmits a RERR packet to the transmitting node or transmits a RREQ locally so that the path could be repaired. With that, the control packet such as a RREQ is broadcast, which causes the consumption of bandwidth and incurs data latency. This paper proposes a LRRLBP algorithm that locally repairs a path by predicting link state before disconnecting the path based on the AODV routing protocol for solving such problems. Intensive simulations with the results using NS-2 simulator are shown for verifying the proposed protocol.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.47 no.5
• /
• pp.16-23
• /
• 2010

This paper presents 6bit 250MS/s flash A/D converter which can be applied to wireless communication system. To solve the problem of large power consumption in flash A/D converter, control algorithm by input signal level is used in comparator stage. Also, input voltage range detector circuit is used in reference resistor array to minimize the dynamic power consumption in the comparator. Compared with the conventional A/D converter, the proposed A/D converter shows 4.3% increase of power consumption in analog and a seventh power consumption in digital, which leads to a half of power consumption in total. The A/D converter is implemented in a $0.18{\mu}m$ CMOS 1-poly 6-metal technology. The measured results show 106mW power dissipation with 1.8V supply voltage. It shows 4.1bit ENOB at sampling frequency 250MHz and 30.27MHz input frequency.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.51 no.6
• /
• pp.124-131
• /
• 2014

This paper describes a design of an adaptive baseband modem based on TDMA(time division multiple access) with a relay protocol function for wireless personal area networks. The designed baseband modem is controlled by a master synchronization signal and can be configured a relay network up to 14 hops. For efficient data relay communications, the internal buffer design is optimized by implementing a priority memory bus controller to a single port memory. And the priority memory bus controller is also designed to minimize the number of synthesized logic gates. To implement the synchronization function of the narrowband TDMA relay communication, the number of gates has been reduced by dividing the frame synchronization circuits and the network slot synchronization circuits. By using these methods, the number of gates are used about 37%(34,000 gates) on Xilinx FPGA XC6SLX9 which has 90,000 gates. For the 1024-bit frame size with a 32-bit synchronization word, the communication reception rate is 96.4%. The measured maximum transmission delay of the designed baseband modem is 230.4 msec for the 14-hop relay communication.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.50 no.3
• /
• pp.9-15
• /
• 2013

Recent works on ad hoc network study have shown that achievable throughput can be made to scale linearly with the number of receive antennas even if the transmitter has only a single antenna. In this paper, we propose a non-parametric linear minimum mean square error (MMSE) receiver for achieving further gain in performance when the channel state information at receiver (CSIR) of interferers is imperfect. The key feature to make our approach effective is to exploit the autocorrelation of the received signal. In fact, by incorporating the desired channel information on top of the observations including interference and noise only, the proposed method achieves large fraction of the optimal MMSE transmission capacity without transmission rate loss. From the SINR analysis as well as transmission capacity simulations in realistic ad hoc network system, we show that the proposed non-parametric linear MMSE receiver brings substantial performance gain over existing multiple receive antenna algorithms.

• The Journal of the Convergence on Culture Technology
• /
• v.2 no.4
• /
• pp.77-82
• /
• 2016

IoT technology was selected as one of IT 10 strategic technologies by gartner from 2013 to 2015, and implements advanced smart society while enabling interaction between people and things. Because IoT devices are connected to the Internet, they are involved in issues including exposure of private lives, for example, hacking to result in wireless signal interference, data theft, data modification and forgery and service denial, and critical security issues including threat to national confidential information and facilities. This study aims to suggest a method for examining threats to security through IP exposure of IoT devices and examining related problems to minimize threats to security through IP exposure including exposure of private lives or damages to the national infrastructure system.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.11 no.2
• /
• pp.159-164
• /
• 2016

A wireless communication system is required to be implemented with the low power circuits because it uses a battery having a limited energy. Therefore, the current mode circuit has been studied because it consumes constant power regardless of the frequency change. However, the clock-feedthrough problem is happened by leak of stored energy in memory operation. In this paper, we suggest the current memory circuit to minimize the clock-feedthrough problem and introduce a technique for ultra low power operation by inducing dynamic voltage scaling. The current memory circuit was designed with BSIM3 model of $0.35{\mu}m$ process and was operated in the near-threshold region. From the simulation result, the clock-feedthrough could be minimized when designing the memory MOS Width of $2{\mu}m$, the switch MOS Width of $0.3{\mu}m$ and dummy MOS Width of $13{\mu}m$ in 1MHz switching operation. The power consumption was calculated with $3.7{\mu}W$ at the supply voltage of 1.2 V, near-threshold voltage.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.14 no.8
• /
• pp.3366-3383
• /
• 2020

The Poisson point process (PPP) is widely used in wireless network modeling and performance analysis because it can provide tractable results for heterogeneous cellular networks (HetNets) analysis. However, it cannot accurately reflect the spatial distribution characteristics of the actual base stations (BSs). Considering the fact that the distribution of macro base stations (MBSs) is exclusive, the deployment of MBSs is modeled by the Matérn hard-core point process (MHCPP), and the deployment of pico base stations (PBSs) is modeled by PPP. This paper studies the performance of multiantenna HetNets and improves the energy efficiency (EE) of HetNets by optimizing the transmit power of PBSs. We use a simple approximate method to study the signal-to-interference ratio (SIR) distribution in two-tier MHCPP-PPP HetNets and derive the coverage probability, average data rate and EE of HetNets. Then, an optimization algorithm is proposed to improve the EE of HetNets. Finally, three transmission technologies are simulated and analyzed. The results show that multiantenna transmission has better system performance than single antenna transmission and that selecting the appropriate transmit power for a PBS can effectively improve the EE of the system. In addition, two-tier MHCPP-PPP HetNets have higher EE than two-tier PPP-PPP HetNets.