• Journal of the Institute of Electronics and Information Engineers
• /
• v.53 no.1
• /
• pp.145-152
• /
• 2016

The usage of LED(Light Emitting Diode) has been rapidly increased and energy efficient management of LED light system is regarded as an important technology to enhance the energy efficiency. In this paper, we design and implementation of LED lighting controller which can control the LED lighting by using the wire and wireless communication technology based on the LAN(Local Area Network) and PAN(Personal Area Network). The implemented system can reduce the cost of LED lighting installing and avoids complicated wiring problem. And it is possible to minimize power consumption through automatic or manual LED control that they wished. In experimental results, the implemented LED lighting controller was satisfactory for all of the desired functions.

• Proceedings of the KIEE Conference
• /
• 2003.11b
• /
• pp.143-146
• /
• 2003

In mobile Internet banking service through wireless local area network, security is a most important factor to consider. We describe the development of mobile banking service using Personal Digatal Assistant (PDA). In order to increase the strength of encryption, we adopted hybrid approach where both of the public key algorithm and the secret key algorithm are used during the transaction among PDA, banking server and authentication server.

• 한국정보통신설비학회:학술대회논문집
• /
• 2007.08a
• /
• pp.279-282
• /
• 2007

Typically a wireless sensor network consists of a number of nodes that sense surrounding environment and collaboratively work to process and route the sensing data to a sink or gateway node. We propose an architecture with support of multiple routers in IPv6-based Low-power Wireless Personal Area Network (6LoWPAN). Our architecture provides traffic load balancing and increases network lifetime as well as self-healing mechanism so that in case of a router failure the network still can remain operational. Each router sends its own Router Advertisement message to nodes and all the nodes receiving the messages can select which router is the best router with the minimum hop-count and link information. We have implemented the architecture and assert our architecture helps in traffic load balancing and reducing data transmission delay for 6LoWPAN.

• Journal of Korea Multimedia Society
• /
• v.19 no.10
• /
• pp.1808-1815
• /
• 2016

TPSN(Timing-sync Protocol for Sensor Networks), the representative of time synchronization protocol, has been already developed to provide time synchronization among nodes in wireless sensor networks. Even though the TPSN's method has been referenced by so many other time synchronization schemes for resource-constrained networks like wireless sensor networks or low power personal area networks, it has some inefficiency in terms of power consumption and network-wide synchronization time (or called convergence time). The main reason is that each node in TPSN needs waiting delay to solve the collision problem due to simultaneous transmission among competing nodes, which causes more power consumption and longer network convergence time for a network-wide synchronization. In this paper an improved scheme is proposed by changing message exchange method among nodes. The proposed scheme not only shortens network-wide synchronization time, but also reduce collision traffic which lead to needless power consumption. The proposed scheme's performance has been evaluated and compared with an original scheme by simulation. The results are shown to be better than the original algorithm used in TPSN.

• The Journal of Society for e-Business Studies
• /
• v.13 no.2
• /
• pp.195-212
• /
• 2008

The demand of wireless communication system is increasing due to the development of computers and other digital media appliances. In particular, new wireless communication technology is necessary for implementation of home network since a lot of data transmission is occurred. Recently, two wireless communication technologies, Ultra Wide Band(UWB) and 60GHz band wireless communication technology, have being developed for high-speed data transmission and Wireless Personal Area Network(WPAN). In this paper, we study the present development condition of these two technologies and a role of them in home network. We also suggest the method to implement the home network using all wireless communication technologies. At the end, we outlook the market of WPAN and High Definition Multimedia Interface(HDMI).

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.27 no.1
• /
• pp.88-91
• /
• 2016

In this paper, we have proposed the frequency interference analysis system using both LabVIEW and Universal Software Radio Peripheral(USRP) for performance degradation analysis of Multi Input Multi Output-Orthogonal Frequency Division Multiplexing(MIMO-OFDM) Wireless Local Area Network(WLAN) due to Wireless Local Area Network(WPAN) interferer. The proposed system consists of three part, i.e., victim, channel, and interferer. Both victim and interferer are implemented by LaBVIEW and a USRP board. Then interfering signal and additive white Gaussian noise are combined with the wanted signals of a victim. Measured Bit Error Rate(BER) at the victim receiver is compared with theoretical BER according to various signal to interference plus noise power ratio (SINR) values. Measured and theoretical BER curves show good agreement.

• The KIPS Transactions:PartA
• /
• v.14A no.5
• /
• pp.287-294
• /
• 2007

Most of existing integrated remote controllers can control only a group of home appliances made by the same manufacturer. And they cannot monitor the status of home appliances since they are based on analog RF(Radio Frequency) signal and operate in a uni-directional manner In this paper, we propose a software framework for a hi-directional universal remote controller(URC) which monitors the status of home appliances in Wireless Personal Area Network(WPAN). The URC can handle the control and status messages which consist of a command with related arguments. When a user wants to control any home appliance, the URC can be dynamically configured to its dedicated remote controller by generating a GUI according to its profile. Any other devices which have a capacity for understanding the profile from the controlled devices can play the same role of the URC.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.38C no.11
• /
• pp.1078-1083
• /
• 2013

At the ubiquitous age, applications of Wireless Personal Area Network (WPAN) technology using LEDs are in progress. However, visible light communication using LED have weakness, which deteriorates performance of communication. To reduce information losses, which is caused by optical noise, such as incandescent lamps, fluorescent lamps, sunbeam etc., proposed channel coding scheme, double binary turbo codes. In this paper, encoding scheme of the proposed system is described and simulation results are analyzed. We had expected improved performance by using double binary turbo codes. Finally, performances of the proposed system came up to our expectations.

• Journal of Digital Contents Society
• /
• v.5 no.4
• /
• pp.306-310
• /
• 2004

In this paper, we proposed a capacity enhancement method using TCM-128QAM modulation and bandwidth extension of 25MHz in HDR-WPAN (high data rate wireless personal area network) system. In case using TCM-128 QAM modulation scheme, we can obtain maximum 66Mbps transmission rate in bandwidth of 15MHz. If extend bandwidth by 25MHz and roll-off coefficient ${\alpha}=0.35$, we can obtain maximum 110Mbps transmission rate. These results are confirmed through PSD(power spectrum density) analysis and BER (bit error rate) performance.

• Proceedings of the Korean Information Science Society Conference
• /
• 2010.06d
• /
• pp.185-189
• /
• 2010

IEEE 802.15.4는 저전력 무선 개인 네트워크(LR-WPAN, Low Rate-Wireless Personal Area Network)를 위한 표준으로 무선 센서 네트워크 기술에서 광범위하게 사용되고 있다. 그러나 IEEE 802.15.4는 멀티홉 네트워크나 여러 개의 PAN(Personal Area Network)으로 구성된 네트워크에 대해서는 상세하게 기술하고 있지 않다. 본 논문에서는 IEEE 802.15.4를 기반으로 하는 ZigBee RF4CE 네트워크에서 사용하는 multiple star 토폴로지를 주목하였다. multiple star 토폴로지처럼 여러 개의 PAN 간에 통신이 이루어질 경우, 이를 에너지 효율적으로 수행할 수 있도록 하는 비컨 간격(Beacon Interval)과 슈퍼프레임 시간(Superframe Duration)을 분석한다. 이를 위해 QualNet 시뮬레이터를 이용하여 multiple star 토폴로지 네트워크를 형성하고, 비컨 간격과 슈퍼프레임 시간을 결정하는 요소에 대해 분석하였다.