• Journal of the Korean Society of Hazard Mitigation
• /
• 제6권3호
• /
• pp.69-76
• /
• 2006

An hydraulic and hydrologic analysis procedure was proposed to reduce the inundation damage of highway in urban stream, that could contribute the EAP and Traffic control planning of Dongbu highway in the Jungrang stream basin which is one of the representative urban area in Korea. We performed the HEC-HMS runoff analysis, and the UNET unsteady flow modeling to decide the inundation reaches and their characteristics. The high inundation risk areas were of Emoon railway bridge and the Wollueng bridge, which are inundated in the case of 10 year and 20 year frequency flood respectively. We also analyze the inundation characteristics under the various conditions of the accumulation rainfall and the duration. Flood elevation at the Wolgye-1 bridge exceed over Risk Flood Water Level(EL.17.84 m) when the accumulation rainfall is over 250 mm and shorter duration than 7 hr. When neglecting backwater effect from the Han river, inundation risk are highly at the reach C2(Wolgye-1 br. ${\sim}$Jungrang br., left bank), C1(Wolgye-1 br. ${\sim}$Jungrang br., right bank), D(Jungrang br. ${\sim}$Gunja br.) in order, but when consider the effect, the inundation risk are higher than the others at the reach D2(Jungrang br. ${\sim}$Gunja br., left bank) and E(Gunja br. ${\sim}$Yongbi br.), which are located downstream near confluence.

• Geophysics and Geophysical Exploration
• /
• 제9권4호
• /
• pp.261-270
• /
• 2006

Two-dimensional (2-D) inversion of magnetotelluric (MT) data for two survey lines having south-north direction from Jeju Island has been carried out. Broad band MT sounding curves with good quality could be gathered by performing audio-frequency magnetotelluric (AMT) survey during the MT survey and by operating the remote reference in Kyushu Island, Japan. Comparison of the 2-D inversion model using MT band only and that using both AMT and MT bands for the field data as well as for the data from numerical 2-D modeling said that high frequency information from AMT survey can be useful for interpreting not only the shallow part but also the deep structures, especially when the formation is resistive. The 2-D inversion models of field data show a thick layer having around 10 ohm-m in the depth of a few hundred meters throughout the survey area, which can be considered as the unconsolidated sedimentary layer. And they also show a conductive anomaly at the central part of each survey lines. It can be either the effect of the surrounding sea water, or the structures due to ancient volcanic events. But unfortunately by now, we do not have any further information about the anomaly.

• Geophysics and Geophysical Exploration
• /
• 제9권4호
• /
• pp.304-315
• /
• 2006

We have examined the applicability of f-k analysis to the GPR direct wave measurement for water content to characterize vadose zone condition. When the vadose zone consists of a dry surface layer over wet substratum, we obtained f-k spectra where most of the energy is bounded by the air and dry soil velocities. In this case, dry soil velocity was successfully estimated by using high frequency data. On the other hands, when wet soil overlies dry substratum, the f-k spectra show a contrasting response where most of the energy travels with the velocity bounded by dry and wet soil velocities. In this case, the radar waves are trapped and guided within wet soil layer, exhibiting velocity dispersion. By adopting modal propagation theory, we could formulae a simple inversion code to find two layer's dielectric constants as well as layer thickness. By inverting the velocity dispersion curve obtained from f-k spectra of synthetic modeling data, we could obtain good estimates of dielectric constants of each layer as well as first layer thickness. Moreover, we could obtain more accurate results by including the higher mode data. We expect this method will be useful to get the quantitative property of real subsurface when the field condition is similar.

• Journal of the Korean Geographical Society
• /
• 제39권6호
• /
• pp.873-887
• /
• 2004

We examined research trends in geomorphology and hydrogeography in America based on papers presented at the annual meetings of the Association of American Geographers(AAG) and papers published in two AAG journals between 2002 and 2004. Among the 437 papers in geomorphology, $40\%$ of the papers concerned fluvial geomorphology, followed by environmental geomorphology and glacial and periglacial geomorphology concern. Among the 452 papers in hydrogeography, about $20\%$ of the papers focused on water, law and institutional aspects, followed by hydrogeomorphology and hydrologic modeling. Twenty one papers examining geomorphology and hydeogeography were published in two AAG journals, and fluvial geomorpholoy was the dominant theme. GIS was used for $29\%$ papers in geomorphology and $35\%$ of papers in hydrogeography($35\%$), suggesting that other methods, including geostatistics, field survey, and qualitative methods, are employed as well. This methodological diversification seems to be associated with solving such complex environmental problems as integrated watershed management and implies that geomorphologists and hydrogeographers are expanding their traditional territories and are making close connections with human-environment geographers and human geographers. Geomorphologists and hydrogeographers are likely to continue examining the causes of and solving environmental problems that humans are currently facing and might face in the future.

• Korean Chemical Engineering Research
• /
• 제46권5호
• /
• pp.922-930
• /
• 2008

The selective non-catalytic reduction(SNCR) performance is sensitive to the process parameters such as flow velocity, reaction temperature and mixing of reagent(ammonia or urea) with the flue gases. Therefore, the knowledge of the velocity field, temperature field and species concentration distribution is crucial for the design and operation of an effective SNCR injection system. In this work, a full-scale two-dimensional computational fluid dynamics(CFD)-based reacting model involving a droplet model is built and validated with the data obtained from a pilot-scale urea-based SNCR reactor installed with a 150 kW LPG burner. The kinetic mechanism with seven reactions for nitrogen oxides($NO_x$) reduction by urea-water solution is used to predict $NO_x$ reduction and ammonia slip. Using the turbulent reacting flow CFD model involving the discrete droplet phase, the CFD simulation results show maximum 20% difference from the experimental data for NO reduction. For $NH_3$ slip, the simulation results have a similar tendency with the experimental data with regard to the temperature and the normalized stoichiometric ratio(NSR).

• Journal of the Microelectronics and Packaging Society
• /
• 제16권1호
• /
• pp.13-19
• /
• 2009

A 440MHz wireless and passive surface acoustic wave (SAW) based chemical sensor was developed on a $41^{\circ}YX\;LiNbO_3$ piezoelectric substrate for simultaneous measurement of $CO_2$ gas and relative humidity (RH) using a reflective delay line pattern as the sensor element. The reflective delay line is composed of an interdigital transducer (IDT) and several shorted grating reflectors. A Teflon AF 2400 and a hydrophilic $SiO_2$ layer were used as $CO_2$ and water vapor sensitive films. The coupling of mode (COM) modeling was conducted to determine optimal device parameters prior to fabrication. According to simulation results, the device was fabricated and then wirelessly measured using the network analyzer. The measured reflective coefficient $S_{11}$ in the time domain showed high signal/noise (S/N) ratio, small signal attenuation, and few spurious peaks. In the $CO_2$ and humidity testing, high sensitivity ($2^{\circ}/ppm$ for $CO_2$ detection and $7.45^{\circ}/%$RH for humidity sensing), good linearity and repeatability were observed in the $CO_2$ concentration ranges of $75{\sim}375ppm$ and humidity levels of $20{\sim}80%$RH. Temperature and humidity compensations were also investigated during the sensitivity evaluation process.

• Journal of The Korean Society of Agricultural Engineers
• /
• 제62권6호
• /
• pp.85-95
• /
• 2020

According to the standard guidelines of design flood (MLTM, 2012; MOE, 2019), the design flood is calculated based on past precipitation. However, due to climate change, the frequency of extreme rainfall events is increasing. Therefore, it is necessary to analyze future floods' volume by using climate change scenarios. Meanwhile, the standard guideline was revised by MOE (Ministry of Environment) recently. MOE proposed modified Huff distribution and new CN (Curve Number) value of forest and paddy. The objective of this study was to analyze the change of flood volume by applying the modified Huff and newly proposed CN to the probabilistic precipitation based on SSP and RCP scenarios. The probabilistic rainfall under climate change was calculated through RCP 4.5/8.5 scenarios and SSP 245/585 scenarios. HEC-HMS (Hydrologic Engineering Center - Hydrologic Modeling System) was simulated for evaluating the flood volume. When RCP 4.5/8.5 scenario was changed to SSP 245/585 scenario, the average flood volume increased by 627 ㎥/s (15%) and 523 ㎥/s (13%), respectively. By the modified Huff distribution, the flood volume increased by 139 ㎥/s (3.76%) on a 200-yr frequency and 171 ㎥/s (4.05%) on a 500-yr frequency. The newly proposed CN made the future flood value increase by 9.5 ㎥/s (0.30%) on a 200-yr frequency and 8.5 ㎥/s (0.25%) on a 500-yr frequency. The selection of climate change scenario was the biggest factor that made the flood volume to transform. Also, the impact of change in Huff was larger than that of CN about 13-16 times.

• Journal of the Mineralogical Society of Korea
• /
• 제23권1호
• /
• pp.63-71
• /
• 2010

The artificial rains having different pH and weathering simulation test were performed for Gyeongju Namsan granite and dacitic tuff to predict the role of acid rain in the deterioration of stone monuments located in Gyeongju area. The pH 4.0 rain reacted with the fresh granite showed near neutral pH at the early stage due to the hydrolysis of minerals in the rock surface. But the pH changed back to the initial pH in the later stage. On the other hand, the pH 5.6 rain showed the neutral pH for a longer time than the experiment with pH 4.0 rain, reflecting slower reaction of minerals due to the weaker acidity. When the pH 5.6 rain reacted with the weathered granite, the water showed neutral pH longer than the case of the fresh granite. The similar tendencies were observed in the experiment of dacitic tuff, except that the pH 4.0 rain reacted with dacitic tuff took a longer time to go back to the initial pH as compared with the case of granite. These results may due to the differences in mineral composition and texture of two rocks. Dacitic tuff contains more fine-grained or glassy groundmass than granite and is more reactive with weaker acid rain. It was predicted that the weight loss and strength decrease rate of dacitic tuff would be approximatetly twice relative to those of granite in the same experimental environment.

• Journal of Climate Change Research
• /
• 제9권1호
• /
• pp.13-29
• /
• 2018

This study presented evaluation procedure for selecting appropriate GCMs and downscaling method by focusing on the climate extreme indices suitable for climate change adaptation. The procedure includes six stages of processes as follows: 1) exclusion of unsuitable GCM through raw GCM analysis before bias correction; 2) calculation of the climate extreme indices and selection of downscaling method by evaluating reproducibility for the past and distortion rate for the future period; 3) selection of downscaling method based on evaluation of reproducibility of spatial correlation among weather stations; and 4) MME calculation using weight factors and evaluation of uncertainty range depending on number of GCMs. The presented procedure was applied to 60 weather stations where there are observed data for the past 30 year period on Korea Peninsula. First, 22 GCMs were selected through the evaluation of the spatio-temporal reproducibility of 29 GCMs. Between Simple Quantile Mapping (SQM) and Spatial Disaggregation Quantile Delta Mapping (SDQDM) methods, SQM was selected based on the reproducibility of 27 climate extreme indices for the past and reproducibility evaluation of spatial correlation in precipitation and temperature. Total precipitation (prcptot) and annual 1-day maximum precipitation (rx1day), which is respectively related to water supply and floods, were selected and MME-based future projections were estimated for near-future (2010-2039), the mid-future (2040-2069), and the far-future (2070-2099) based on the weight factors by GCM. The prcptot and rx1day increased as time goes farther from the near-future to the far-future and RCP 8.5 showed a higher rate of increase in both indices compared to RCP 4.5 scenario. It was also found that use of 20 GCM out of 22 explains 80% of the overall variation in all combinations of RCP scenarios and future periods. The result of this study is an example of an application in Korea Peninsula and APCC Integrated Modeling Solution (AIMS) can be utilized in various areas and fields if users want to apply the proposed procedure directly to a target area.

• Journal of the Korean Society of Marine Environment & Safety
• /
• 제24권4호
• /
• pp.459-466
• /
• 2018

Hazardous and Noxious Substances (HNS) are defined as substances that are likely to create a significant impact on human health and marine ecosystem when they are released into the marine environment. Recently, as the volume of HNS transported by ships increases, the rate of leakage accidents also increases. Therefore, research should be conducted to control and monitor sunken materials from the viewpoint of technology development for hazardous material leakage accident response. In this paper, acoustic detection experiments were carried out using HNS substitute materials in order to confirm the possibility of acoustic detection of sunken HNS on the sediment. The castor oil, which has a similar acoustic impedance with chloroform, is used as a substitute. 200 kHz high frequency signals were used to discriminate the reflected signals and measure reflection loss from the interface between water and castor oil. The reflection loss measured is in good agreement with the modeling results, showing a possibility of acoustic detection for sunken HNS.