• Proceedings of the Korea Committee for Ocean Resources and Engineering Conference
• /
• 2006.11a
• /
• pp.373-376
• /
• 2006

In general, a method for generating irregular wave by combination of component waves obtained from linear wave theory is widely used. In these method, however, mean water surface elevation is rising from time to time because of nonlinear effect of wave. In this study, for the rising problem of mean water surface elevation and stabilization of calculation from time to time, mass transport velocity for horizontal velocity at wave source position is considered. The rising problem of mean water surface elevation is checked by comparing calculated wave profile from numerical technique proposed in this study with target wave profile at wave source position in numerical wave tank by using CADMAS-SURF code. And, by generating irregular wave, the validity of wave overtopping rate estimated from this numerical analysis is discussed by comparing computed results with measured results in hydraulic model experiments for vertical seawall located on a sloping sea bottom. As a results, the computations are validated against the previously experimental results by hydraulic model test and numerical results of this study and a good agreement is observed. Therefore, numerical technique of this study is a powerful tool for estimating wave overtopping rate over the crest of coastal structure.

• Journal of Korean Society on Water Environment
• /
• v.21 no.6
• /
• pp.549-563
• /
• 2005

The study was carried out to develop and standardize the analytical method of 1,4-dioxane in water. The National Institute of Environmental Research in Korea has monitored for 1,4-dioxane in water since 1998 and it has been detected in environmental water occasionally. But the environmental pollution and analytical method in water is not well known over the world. The trace analytical method at low-${\mu}/L$ level is prerequisite in order to evaluate the residue of 1,4-dioxane in water. Evaluation of the method was demonstrated by comparing and analyzing with liquid-liquid extraction, solid-phase extraction and purge & trap technique. As a result of experiment by standard solutions and raw samples, the precision and accuracy for three methods were obtained within error rate of about 10%. Therefore, three methods were standardized as official monitoring method in Korea. Also, a convenient and simple liquid-liquid extraction method for the analysis of 1,4-dioxane in water was developed by combined with gas chromatography/mass spectrometry and applied to the water samples in Korea

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.38 no.6
• /
• pp.483-491
• /
• 2014

In this study, a thermodynamic analysis was carried out for a combined power generation system using a low-temperature heat source in the form of sensitive energy and liquefied natural gas cold energy. An ammonia-water mixture, which is a zeotropic mixture, was used as the working fluid, and systems with and without a regenerator were comparatively analyzed. The effects of the mass fraction of ammonia and the condensation temperature of the working fluid on the system variables, including the net work production, exergy destruction, and thermal and exergy efficiencies, are analyzed and discussed. The results show that the performance characteristics of the system varied sensitively with the ammonia concentration or condensation temperature of the working fluid. The system without regeneration was found to be better in relation to the net work per unit mass of the source fluid, whereas the system with regeneration was better in relation to the thermal or exergy efficiency.

• Special Issue of the Society of Naval Architects of Korea
• /
• 2013.12a
• /
• pp.85-89
• /
• 2013

In the engine room and the aft body, there are so many fluid tanks such as fresh water tank and oil tank. The vibration analysis for the fluid tank structures has to consider the added mass effect due to the fluid. However, it is known that the result of the fluid tank has the difference according to the boundary condition of the fluid field such as infinite fluid and finite fluid. In this paper, a numerical case study is carried out for the research about the vibration characteristics of the fluid tank with various fluid field. In addition, an experimental study is carried out to verify the validity of the vibration analysis for the fluid tank structure.

• Bulletin of the Korean Chemical Society
• /
• v.23 no.3
• /
• pp.432-436
• /
• 2002

Benomyl, one of the known endocrine disrupting chemicals, was analyzed to understand the fate in the nature. Water, sediment and biota samples are acidified to hydrolyze benomyl into carbendazim then followed by extraction and concentration. The concentrations of carbendazim in the samples were determined by liquid chromatography/time-of-flight mass spectrometer. Analysis data showed that certain amount of carbendazim was accumulated in sediment. On the contrary, no sign of accumulation in biota was observed probably due to the increased degradation rate in vivo. It is, however, that no one can claim carbendazim is not harmful to biota, since carbendazim may give a negative effect against organisms at the point of intaking.

• International Journal of Air-Conditioning and Refrigeration
• /
• v.14 no.4
• /
• pp.125-130
• /
• 2006

This study has been performed to investigate the thermal performance of variable conductance heat pipe (VCHP) with screen meshed wick. The active length of condenser section in a VCHP is varied by non-condensible gas, which controls the operating temperature, and the heat capacity of VCHP is controlled by the operating temperature. In this study, numerical analysis of the VCHP based on the diffusion model of non-condensible gas is done for the thermal control performance of VCHP. Water is used as a working fluid and nitrogen as a control non-condensible gas in the copper tube. As a result, the thermal conductance of VCHP has been compared with that of constant conductance heat pipe (CCHP) corresponding to the variation of operating temperature.

• Journal of Ocean Engineering and Technology
• /
• v.30 no.4
• /
• pp.320-326
• /
• 2016

Rip current forecasts, based on intensity, are marked in four levels—notice, watch, warning, and danger. However, numerical results are represented by current vectors, whose magnitudes are then converted into predictive levels. In the present study, the rose diagram is adapted as a determinative forecasting index and examined for the case of an ideal rip channel consisting of surface, bottom, and averaged currents. Further, it is employed in the sensitivity analysis of wave-induced currents generated by wave conditions at the Haeundae Beach. The simulation of surface onshore and bottom undertow currents is accomplished by including a mass flux term in the wave-averaged continuity equation.

• Journal of Gastric Cancer
• /
• v.17 no.4
• /
• pp.342-353
• /
• 2017

Purpose: This study evaluated the changes in nutritional status based on quality of life (QoL) item-level analysis to determine whether individual QoL responses might facilitate personal clinical impact. Materials and Methods: This study retrospectively evaluated QoL data obtained by the European Organisation for Research and Treatment of Cancer (EORTC) Quality of Life Questionnaire-Core 30 (QLQ-C30) and Quality of Life Questionnaire-Stomach (QLQ-STO22) as well as metabolic-nutritional data obtained by bioelectrical impedance analysis and blood tests. Patients were assessed preoperatively and at the 5-year follow-up. QoL was analyzed at the level of the constituent items. The patients were categorized into vulnerable and non-vulnerable QoL groups for each scale based on their responses to the QoL items and changes in the metabolic-nutritional indices were compared. Results: Multiple shortcomings in the metabolic-nutritional indices were observed in the vulnerable groups for nausea/vomiting (waist-hip ratio, degree of obesity), dyspnea (hemoglobin, iron), constipation (body fat mass, percent body fat), dysphagia (body fat mass, percent body fat), reflux (body weight, hemoglobin), dry mouth (percent body fat, waist-hip ratio), and taste (body weight, total body water, soft lean mass, body fat mass). The shortcomings in a single index were observed in the vulnerable groups for emotional functioning and pain (EORTC QLQ-C30) and for eating restrictions (EORTC QLQ-STO22). Conclusions: Long-term postoperative QoL deterioration in emotional functioning, nausea/vomiting, pain, dyspnea, constipation, dysphagia, reflux, eating restrictions, dry mouth, and taste were associated with nutritional shortcomings. QoL item-level analysis, instead of scale-level analysis, may help to facilitate personalized treatment for individual QoL respondents.

• Tunnel and Underground Space
• /
• v.20 no.4
• /
• pp.233-240
• /
• 2010

Double Plug is constructed for preventing mixing of two different oils between two compartments in the underground oil storage cavern. And the gas and oil tightness of double plug is tested from the measurement of water leakage from double plug after the completion of double plug water filling. If water leakage is underestimated, it can increase construction cost and if water leakage is overestimated, it can increase operating cost. Therefore, optimum water leakage should be estimated to cut down the cost. In this study, hydraulic stability analysis was conducted to consider permeable properties of rock mass around double plugs and a water leak rate from double plug was estimated from the hydraulic stability analysis and case study. Finally, the reliability of estimation of water leak rate was proven by comparing estimated water leak rate with measured data.

• The KSFM Journal of Fluid Machinery
• /
• v.2 no.2 s.3
• /
• pp.39-45
• /
• 1999

Pumped-storage power plants pumps the water from the lower reservoir to the upper reservoir using the extra electric power at night and generates electric power in the daytime. Currently it tends to be a high-head large-capacity machine. In this paper, we developed the computer programs for vibration analysis of the pump/turbine and generator/motor rotor system considering electromagnetic force, hydrodynamic unbalance force, dynamic characteristics of guide bearings and add mass of water. This program was verified by applying it to the real model and calculating the critical speed, natural mode and unbalance response.