• 한국지반환경공학회 논문집
• /
• 제8권1호
• /
• pp.49-55
• /
• 2007

폐타이어의 트레드를 지반보강재로서 활용하기 위해서는 타이어 외면 및 내면과 흙간의 내부마찰각 그리고 폐타이어 연결부의 강도특성을 알아야 한다. 본 연구에서는 폐타이어 트레드와 모래 및 풍화토간의 접촉면마찰각을 알기 위해 흙의 다짐정도를 달리하여 대형직접전단시험을 수행하였다. 직접전단시험 결과 모래-타이어 외면간의 마찰각비(${\delta}/{\phi}$)는 1.06배 이상, 모래-트레드 내면간의 ${\delta}/{\phi}$는 0.93배 이상, 풍화토의 마찰각비(${\delta}/{\phi}$)는 트레드 외면과 내면에 대하여 각각 0.98, 0.92로 나타났다. 또한 UTM을 이용하여 폐타이어 연결부의 재료에 따른 인장강도시험을 수행하였다. 시험 결과 고장력 볼트를 사용한 인장시험에서 볼트의 개수 및 와셔의 크기가 증가할수록 연결부에서의 인장강도는 증가하였으며 폴리프로필렌 로프 연결의 경우가 볼트연결의 경우보다 작은 강도를 나타내었다.

• Computers and Concrete
• /
• 제27권5호
• /
• pp.417-435
• /
• 2021

The optimal distribution of steel fibers over different layers of concrete can be considered as an appropriate method in improving the structural performance and reducing the cost of fiber-reinforced concrete members. In addition, the use of waste tire rubber in concrete mixes, as one of the practical ways to address environmental problems, is highly significant. Thus, this study aimed to evaluate the flexural behavior of functionally graded steel fiber-reinforced concrete containing recycled tire crumb rubber, as a volume replacement of sand, after exposure to elevated temperatures. Little information is available in the literature regarding this subject. To achieve this goal, a set of 54 one-, two-, and three-layer concrete beam specimens with different fiber volume fractions (0, 0.25, 0.5, 1, and 1.25%), but the same overall fiber content, and different volume percentages of the waste tire rubber (0, 5, and 10%) were exposed to different temperatures (23, 300, and 600℃). Afterward, the parameters affecting the post-heating flexural performance of concrete, including flexural strength and stiffness, toughness, fracture energy, and load-deflection diagrams, along with the compressive strength and weight loss of concrete specimens, were evaluated. The results indicated that the flexural strength and stiffness of the three-layer concrete beams respectively increased by 10 and 7%, compared to the one-layer beam specimens with the same fiber content. However, the flexural performance of the two-layer beams was reduced relative to those with one layer and equal fiber content. Besides, the flexural strength, toughness, fracture energy, and stiffness were reduced by approximately 10% when a 10% of natural sand was replaced with tire rubber in the three-layer specimens compared to the corresponding beams without crumb rubber. Although the flexural properties of concrete specimens increased with increasing the temperature up to 300℃, these properties degraded significantly with elevating the temperature up to 600℃, leading to a sharp increase in the deflection at peak load.

• 환경위생공학
• /
• 제15권4호
• /
• pp.98-104
• /
• 2000

Commercial rubber(IR, NR, BR), SBR, and tire were degraded by thermal degradation process. The oil yield of rubbers and tire ranges about 37~86%, it was increased with increase of operation temperature in pyrolysis. And the yield of pyrolytic oil was increased with increase of heating rate. The maximum oil yields of IR, NR, BR, SBR, and tire were 80, 73, 83, 86 and 55% each at $700^{\circ}C$ with a heating rate of $20^{\circ}C$/min, respectively. The pyrolytic oil components were consisted of about 50 aromatic compounds. The calorific value of purolytic oil of commercial rubber, SBR, and tire was measured by calorimeter, it was 39~40 kJ/g. The BET surface area of pyroblack was $47~63m^2/g$. The optimum condition of pyrolysis was operating temperature of $700^{\circ}C$ with heating rate of $20^{\circ}C$. Therefore, the pyrolytic oil and pyroblack are possible to alternative fuel and carbon black.

• 콘크리트학회논문집
• /
• 제19권5호
• /
• pp.623-630
• /
• 2007

주로 교량 슈 (shoe)나 기계 기초 등과 하부 콘크리트 구조체간의 공극을 충전시켜 상부 구조물과 하부 구조물을 일체화하는데 사용되는 그라우트재는 구조물의 특성상 주로 큰 하중을 받는 부위에 시공되기 때문에 높은 압축강도를 갖는 제품 위주로 개발 사용되어 왔다. 그러나 고강성 위주로 제품이 개발되어 한계응력 이상에서는 구조체가 갑자기 파괴되는 취성체라는 구조적 문제점을 안고 있고, 연속 및 반복하중 등의 응력에 의한 누적 피로에 의해 균열 등의 성능 저하 현상이 발생할 수 있다 또한, 초기 고강도를 유지하기 위해 발열 특성이 높은 속경성 재료를 과다하게 사용함으로써 대형 부재인 경우 수화열 등에 의한 균열발생 우려의 문제 등도 안고 있다. 본 연구는 이와 같은 문제들을 개선하기 위해, 탄성재료인 분말 폐타이어 및 분말 수지를 이용하여 기존의 고유동, 무수축, 고강도 특성 이외에 고인성과 고내구성을 부여하여 보다 안정적으로 시공될 수 있으며, 모체와의 일체성을 향상시키기 위한 그라우트재의 분체 조성물을 개발하였다 또한, 부수적으로 분말 폐타이어 및 플라이애쉬와 같은 산업폐기물을 재활용할 수 있도록 하여 환경친화적인 건설 재료를 제공하는 데에도 기여하였다. 이를 위해 총 7가지 배합 조건별 실험이 진행되었고, 이를 통해 최적 배합 조건을 선정하였다.

• Elastomers and Composites
• /
• 제46권4호
• /
• pp.318-323
• /
• 2011

폐타이어고무분말을 재활용하기 위하여 방수시트용 고무분말 복합체를 제조하였으며, 수지 종류와 가교제의 함량이 복합체의 기계적 특성에 미치는 영향을 고찰하였다. EPDM이 부가됨에 따라 고무분말 PE 복합체의 신장율이 3배 이상 증가하는 현상을 나타내었다. 고무분말 충전 복합체에 가교제의 농도가 증가함에 따라 복합체의 강도가 증가하였으며, 특히 재생 폴리프로필렌을 사용한 경우 3배 이상 인장강도가 현저하게 높게 나타났다. 따라서 폴리프로필렌 블렌드물로 고무분말 복합체를 제조하는 경우 신재 폴리프로필렌을 사용하는 것 보다 재생 폴리프로필렌을 사용하는 것이 기계적 특성면에서 효과적인 것으로 나타났다.

• Geomechanics and Engineering
• /
• 제37권5호
• /
• pp.443-452
• /
• 2024

The use of sand-tire chip mixtures in construction industry is a sustainable and environmentally friendly approach that addresses both waste tire disposal and soil improvement needs. However, the addition of tire chip particles to natural soils decreases maximum shear modulus (G_max), but increases compressibility, which can be potential drawbacks. This study examines the effect of overconsolidation stress history on the maximum shear modulus (G_max) of rigid-soft mixtures with varying size ratios (SR) and tire chip contents (TC) by measuring the wave velocity through a 1-D compression test during loading and unloading. The results demonstrate that the G_max of tested mixtures in the normally consolidated state increased with increasing SR and decreasing TC. However, the tested mixtures with a smaller SR exhibited a greater increase in G_max during unloading because of the active pore-filling behavior of the smaller rubber particles and the consequent increased connectivity between sand particles. The SR-dependent impact of the overconsolidation stress history on G_max was verified using the ratio between the swelling and compression indices. Most importantly, this study reveals that the excessive settlement and lower G_max of rigid-soft mixtures can be overcome by introducing an overconsolidated state in sand-tire chip mixtures with low TC.

• 한국환경과학회지
• /
• 제10권4호
• /
• pp.311-314
• /
• 2001

The asphalt mixture with CRM(Crumb Rubber Modifier) is known to show a better performance in resisting thermal cracking, fatigue cracking and rutting compared with the conventional mixture. The laboratory tests on the physical characteristics of indirect tensile strength, density, flow and Marshall value of the CRM asphalt were conducted. The test results show that CRM asphalt has better physical characteristics than that of conventional asphalts. And the analysis on the noise reduction effect, penetration capacity from the field test on the national road in Haksan of Chungbuk, and recycling of tire waste were conducted. From this study, the results show that 1% CRM asphalt has higher the noise reduction effect and penetration capacity that those of conventional asphalts. And, optimal contents of crumb rubber modifier in the asphalt binder is one percent. In this case, crumb rubber modifier were used 10 kg to make the asphalt binder of one cubic meter. So it was named as Eco-asphalt.

• 한국철도학회:학술대회논문집
• /
• 한국철도학회 2011년도 정기총회 및 추계학술대회 논문집
• /
• pp.1129-1135
• /
• 2011

Recently, In Korea region becoming subtropical climate, freezing index values have been increasing in winter. The climate condition in Korean became polarized. Since freezing index is increased recently, track heaving from frost is often occurred, which is ignored in past couple of years. Methods to prevent frost-heaving are circumfusion of calcium chloride and replacement of gravel ballast in usual. The effects of those methods are minimal, incontinuous, and not eco-friendly. Therefore, maintenances are performed repeatedly every year. This study discussed utilizing the waste-tire-chips and insulators in the small structures(bridge and box etc) for prevention of frost-heaving. In order to prove effect of waste-tire-chips, laboratory and field tests were conducted with CBR and measurement of frost-heaving amount to prove and verify effect of insulators.

• 한국신재생에너지학회:학술대회논문집
• /
• 한국신재생에너지학회 2008년도 추계학술대회 논문집
• /
• pp.157-160
• /
• 2008

본 연구에서는 디스크 이동식 폐타이어 열분해 실증 설비(10톤/일)를 설계, 제작 그리고 시운전을 통하여 열분해 설비의 안정적인 연속 운전이 가능함을 확인하였다. 시운전 결과 반응기 내부 온도는 $500{\sim}600^{\circ}C$, 내부 압력은 $-80{\sim}-100mmHg$, 체류시간은 $60{\sim}90min$ 범위에서 안정적인 열분해가 일어났다. 또한 이번 과제 수행을 통해NC 가스의 연소기를 개발 적용하여 NC 가스의 열분해 열원으로 사용 가능성을 확인하였으며, NC 가스 연소 시 대기 측정을 통하여 규제치도 만족함을 확인할 수 있었다. 지금까지 나온 결과는 장기 연속 운전과 scale-up을 위한 기초 자료가 될 것이다.

• 산업기술연구
• /
• 제25권A호
• /
• pp.133-139
• /
• 2005

In this study, as MBBR(Moving Bed Biofilm Reactor) process using waste tire media is suggested for retrofitting with advanced wastewater treatment and the removal property of organic matter and nutrient and the capacity of media are evaluated through long-term operation with pilot plant following seasons, the application capacity of retrofitting with MBBR process to a existing wastewater treatment is studied. As a result of the long-term operation of the process, it is proved that there is no loss and abrasion of media, and also that it is possible to secure the sufficient attached bio-mass. The values of organic matter and nutrient in effluent are suitable for the strict discharged water quality standards in every season including winter.