• Journal of Food Hygiene and Safety
• /
• v.13 no.3
• /
• pp.238-242
• /
• 1998

Chicken carcass microflora were evaluated for aerobic microorganisms after defeathering, evisceration, washing, chilling, and sanitizing during a commercial chicken processing and storage at wholesale and retailsale levels. Sampling was at between December 1997, and March, 1998. Tap water washing and sanitizing with 25 ppm chlorine for 10 sec significantly (P<0.05) reduced aerobic plate counts (APC) and gram-negative bacterial counts (GNC) on chicken carcasses from a commercial chicken-processing plant. After 4 days at $2{\pm}2^{\circ}C$, APC and GNC on chicken carcasses in retailsale store rapidly increased compared to those in wholesale store (P<0.05). Chicken wings from retailsale store significantly (P<0.05) decreased generation time (GT) compared to other chicken carcasses.

• Carbon letters
• /
• v.3 no.4
• /
• pp.198-204
• /
• 2002

In this paper, impregnated activated carbon fiber (IACF) was manufactured to pitch-based activated carbon fibers (ACF) with potassium hydroxide (KOH) by using wet impregnation method to raise nitrogen oxides ($NO_x$) adsorptivity. The properties of IACF were observed using EPMA, TGA and DSC and $NO_x$ adsorptivity was observed at high and low temperature. Before and after adsorption was analyzed using ToF-SIMS for examine surface characterization of adsorbed $NO_x$. The results showed that the better adsorptivity appeared for increasing KOH ratio. So, $NO_x$ adsorptivity showed result that is proportional between KOH and the adsorbed amount. On the other hand, adsorbent that manufactured without washing was better $NO_x$ adsorptivity than adsorbent that manufactured with washing. The behavior of adsorption show that crossing time of NO and $NO_2$ delayed for a rising adsorptivity. And NO ratio increased but $NO_2$ ratio decreased according as KOH ratio increases. $NO_x$ was confirmed through surface analysis that remain in $NO_2^-$ and $NO_3^-$ form on IACF surface.

• Toxicological Research
• /
• v.19 no.1
• /
• pp.39-44
• /
• 2003

Two local irritation and skin sensitization studies of nonspecific immunostimulator, $BARODON^{\circledR}$ were carried out with New Zealand White rabbits and Hartley guinea pigs. In skin irritation test of male New Zealand White rabbits, body weights were not significantly changed and there were no responses after treatment for 24 or 72 hours and the Primary irritation index (P.1.1.) was '0'. And, in the eye irritation test, there were chemosis in some of rabbits. One of 3 rabbits in washing group was detected chemosis after 24 and 72 h following treatment and 2 of 6 rabbits in non-washing group were detected chemosis after 24h and 7 days following treatment. Therefore, total score is '4' after 24 h and '2' after 72 h following treatment by conforming article "some blood vessel are clearly hyperemic" . However evaluation value is non-irritant because M.O.I. (Mean ocular irritation index) score is below during the all experimental period and no significance through individuals and exposure time. In skin sensitization, the score of skin reaction was graded 1 with 0% sensitization rate. Taken together, these results indicate that $BARODON^{\circledR}$ may be non-irritant material. material.

• Journal of Environmental Health Sciences
• /
• v.22 no.3
• /
• pp.103-115
• /
• 1996

The purpose of this study was to establish acceptable criteria for the design of simple water treatment plant in rural areas. To develop efficient simple water treatment methods for rural areas, water quality in the study areas was investigated and rapid and slow filtrations in pilot-scale were tested under various conditions. The main results of this study are as follows. It was found that the water qualities of the study areas exceed the drinking water standards, which implies that some treatments are required in rural areas. Treatment efficiencies of both rapid sand and dual-media (sand and anthracite) filtration without pre-treatment such as flocculation and sedimentation are very low, which were turned out to be unadequate for the rural areas. Treatment efficiencies of both vertical and horizontal slow filtration without chlorination are very high for consumed $KMnO_4, NH_3-N, NO_3-N$, turbidity, and very low for coliform and bacteria. Treatment efficiencies of both vertical and horizontal slow filtration with chlorination are very high over the most pollutants. A slow filtration with chlorination is efficient for the rural areas. An adequate depth of sand layer is over 60 cm. A horizontal filtration is more economical than a vertical filtration. A horizontal filtration can be operated for a relatively long periods of time without sand washing or replacement because clogging is removed by simple back-washing.

• Journal of Korean Society on Water Environment
• /
• v.30 no.5
• /
• pp.532-538
• /
• 2014

A cylinder-shaped filter was developed to manage the runoff from construction sites. Compressed air was used for back-washing and pore sizes of filter were $23{\mu}m$ and $46{\mu}m$. The turbid water was prepared using sediments in construction sites. The grain size analysis showed that grains smaller than $38{\mu}m$ and larger than $335{\mu}m$ in size constituted 34.4 % and 37.6 %, respectively. Removal efficiency of the filter on turbidity, SS, COD, TN and TP showed 25~37%, 20~40%, 50~55%, 23~27% and 14~20%, respectively, whereas their removal efficiecy by using coagulant PAC showed 77~84%, 70~83%, 53~60%, 27~36%, and 59~75%, respectively. The filtration time was determined to be around 10 to 20 minutes. Back-washing for 10 seconds by pressurized air resulted in a satisfactory regeneration efficiency. According to the aforementioned test results, the cylinder-shaped filter is effective in reducing turbidity and would be suitable for practical application in construction sites and farms.

• Textile Coloration and Finishing
• /
• v.16 no.1
• /
• pp.34-39
• /
• 2004

Dyeing properties of Glycyrrhizae Radix was investigated with silk fabrics. Dyeing water is a type of chalcone, it showed yellow in IR spectrum. K/S value showed high in following conditions; Glycyrrhizae Radix $200g/1\ell4 water, $80^{\circ}$ of dyeing temperature, 90 minute of dyeing time. Glycyrrhizae Radix dyeing water has higher K/S value in alkalinity(pH9) than in neutrality(pH7) or acidity(pH3) conditions. K/S value showed highest in pH5 premordant method of alkalinity dyeing water condition. The color of silk fabric dyed with Glycyrrhizae Radix is yellow. The change of color did not show by mordant treatment. K/S value showed higher in mordant treatment than nonmordant. Light fastness showed over 3 degree in nonmordant, premordant, simmordant(Al,Cu,Fe) and postmordant(Cu). Water fastness showed over 3 degree in dyeing water(pH3, pH5, pH7). Dry cleaning fastness showed over 3 degree in all dyeing methods. Washing fastness is showed in 2-3 degree; Al in nonmordant, premordant, simmordant and Cu in simmordant are 2-3 degree. Perspiration fastness is nearly 3-4 degree in premordant and simmordant. Perspiration fastness shows high in premordant, simmordant than postmordant. The fastness of light, water, dry cleaning, washing, perspiration shows better nonmordant, premordant, simmordant than postmordant method.

• Textile Coloration and Finishing
• /
• v.27 no.4
• /
• pp.318-326
• /
• 2015

A pre-treatment process is essential for getting high quality of digital textile printing(DTP). In this study, we have studied three kinds of carrageenan polymer(k-, ${\lambda}$-, i-Carrageenan) as a pre-treatment thickening agent for the first time. Alginate polymer was also examined and its results were compared with that of the three kinds of carrageenan polymer. To confirm the performance of each thickening agent, we examined for a sharpness, color strength and fastness(washing, rub, light). The result showed that ${\lambda}$-Carrageenan has superior property in sharpness with low viscosity and i-Carrageenan was excellent in the color strength among the pre-treatment agents. Washing fastness to color change and staining for the all samples were 4 or 4-5 grade. Both dry and wet rubbing fastness of the samples were 4-5 grade. However, ${\lambda}$-Carrageenan coated sample has the lowest grade in light fastness. As a result, we found the possibility of carrageenan polymer as pre-treatment agent.

• Journal of the Korean Applied Science and Technology
• /
• v.27 no.3
• /
• pp.378-384
• /
• 2010

Regenerated cellulose was prepared from Buckeye wood pulp V60 via dissolution in N-methylmorpholin N-oxide (NMMO) solvent system. The effect of antioxidants such as, n-propylgallate (PG), tris(nonylphenyl) phosphite (TRIS), ethylenediamine tetraacetic acid disodium salt (EDTA), and magnesium sulfate on the properties of regenerated cellulose was studied using X-ray diffraction, copper index calculation, and viscometry. Only addition of more than 0.01% of PG into NMMO solvent was effective to avoid the reduction of the degree of polymerization(DP) of regenerated cellulose during dissolution at $110^{\circ}C$. However, the early stage(within 0.5h of dissolution process) degradation of cellulose was not prevented eventhough up to 0.5% PG was appled to hot NMMO system. In addition, to recover the expensive NMMO after cellulose regenerating process, the washing filtrate was studied using simple techniques, such as refractive index, pH, and conductivity measurements. Through conductivity measurement result, 4-time of washing was enough to remove the NMMO completely from regenerated cellulose.

• Journal of Fashion Business
• /
• v.23 no.3
• /
• pp.23-34
• /
• 2019

The aim of this study is to explore the possibility utilizing Rhododedron brachycarpum as a new natural dye resource. It was dyed in silk fabric according to different dyeing conditions such as dye concentration, dye bath temperature, dyeing time and dye bath pH. The effect of the mordanting conditions were estimated as dyeability and color changes. Additionally, the colorfastness, antibacterial property, ultraviolet protection properties of the dyed and mordanted silk fabrics were examined. The water-soluble dye of Rhododedron brachycarpum extracted with distilled water was expressed as Yellow Red color. The dye-abilities of silk generally increased depending on the increasing values of dye concentration, dye bath temperature and dyeing duration. The highest K/S values were obtained at a dye concentration of 100% (v/v), a dye bath temperature of $90^{\circ}C$, a dyeing duration 120 minutes and a dyeing of pH 2. The light fastness of dyed and Cu mordanted silk fabrics were found to be 4 grade while Al, Fe mordanted silk fabrics were found to be 2~3 grade. The dry cleaning and rubbing fastness were excellent or good. The fade of washing fastness was not good, however, the stain of washing fastness was excellent. The dyed and Al, Cu mordanted silk fabrics indicated 99.9% reduction rate. The dyed and the mordanted fabrics showed very good ultraviolet protection factors.

• Journal of Korean Society of Industrial and Systems Engineering
• /
• v.27 no.1
• /
• pp.32-37
• /
• 2004

A new display device is required, which has concepts of flatness and slimness. FED can be one of the solutions. When we use flat panel, we can save the raw material and reduce the production time by eliminating the printing process, drying process, and washing process. In this case, good panel flatness and consistency with panel flatness and black matrix is the precondition. Therefor, we analyzed process capability of panel flatness and regression between panel flatness and BM position by experiments.