• Journal of the Society of Cosmetic Scientists of Korea
• /
• v.36 no.1
• /
• pp.41-45
• /
• 2010

Emulsion body cleansing systems containing high levels of occlusives have recently been developed such as using insoluble crystalline hydroxy waxes, insoluble crystalline surfactant structures, encapsulated particles and smectite clay. In this study, moisturizing effect of various occlusives such as petrolatum and triglycerides was researched in emulsion body cleansing systems. The experiment shows that petrolatum has less moisturizing capacity in emulsion body cleansing systems than triglycerides. In "leave-on" products such as lotion and cream formulations, the moisturizing capacity of petrolatum is more than that of triglycerides, but in "wash-off" emulsion body cleanser of this research, different results appeared. Emulsion body cleansing systems contained high levels of anionic and amphoteric surfactants, therefore petrolatum has more solubility and less deposited amount into the skin during washing process than triglycerides.

• The Korean Journal of Physiology and Pharmacology
• /
• v.3 no.6
• /
• pp.615-621
• /
• 1999

In spite many evidences has supported the cardioprotective effect of bradykinin, its direct effects at the cell level are still under question. We investigated the both effects of bradykinin (BK) on $Ca^{2+}-related$ ionic currents using whole cell voltage clamp technique in rabbit cardiomyocytes and on the intracellular $Ca^{2+}$ transient using calcium sensitive fluorescence dye, indo-1AM. Simultaneously with recording intracellular $Ca^{2+}$ transients, cell contractility was estimated from the changes in length of the electrical stimulated rat cardiac myocytes. L-type $Ca^{2+}$ current decreased by bradykinin at the entire voltage range. Inward tail current increased initially up to its maximum about 4 min after exposing myocytes to BK, and then gradually decreased again by further exposure to BK. This tail current decreased remarkably at washing BK off but slowly recovered ca. 20 min later. The change in cell contractility was similar to that in tail current showing initial increase followed by gradual decrease. Removal of BK brought remarkable decrease in contractility, which was recovered $15{\sim}20$ min after cessation of electrical stimulation. Bradykinin increased $Ca^{2+}$ transient initially but after some time $Ca^{2+}$ transient also decreased coincidentally with contractility. From these results, it is suggested that bradykinin exerts directly its cardioprotective effect on the single myocytes by decreasing the intracellular $Ca^{2+}$ level followed by an initial increase in $Ca^{2+}$ transient.

• Journal of Haehwa Medicine
• /
• v.13 no.2
• /
• pp.187-196
• /
• 2004

Now many sustitution and false articles is used in korea instead of shanyao. To use shanyao correctly, we will make a quilitative certificational plan of shanyao to investigate all of lieraturea, records and documents. And we could reach conclusions as folloews. 1) Source About a source of shanyao, though korea and china has a each other source, we think there is no problem in use of both. 2) Process In our country producing shanyao as medical use is a 'duanma', we can divide into peeling and non-peeling, drying at bulks and at briquets, steaming shanyao and fresh shanyao. Regardless of existence for peeling and steaming, a distributing shanyao is received a proper judgment. Like this result was expressed by insufficiency of standards about medical components or indicating components. We detected a reminding S02 more than 10 ppm. And this expresses that there ia a problum at a drying method. To suggest proper processing methods, a standard of quility will have to be made which the existence of peeling, difference of quility between 'changma' and 'duanma', drying method and exudation test with cutted thickness are adaptable. Besides, 'maoshanyao' and 'guangshanyao' of china is processed by various methods which decrease a medical effect such as too much soaking shanyao in water, steaming with a sulfur, too much peeling, So we must process shanyao like the next methods. (1) When harvesting, dig deeply not to cut off roots. (2) Not to peel, wash shanyao in a washing machine. (3) Dry to 50-60% degree at sunny place or drying machine. (4) To be easy for drying and exudation, cut off a thick piece with 5 mm (5) Dry perfectly at ding machine. 3) Quality3) Quality (1) Functional standards It is not Proper that 'guangshanyao' is used in china because it has a problem with quility on process of working, If they did not soak shanyao in water or heat with steam, it is the real situation that they cannot cutt off shanyao evenly. In conclusion, shanyao must be heavy, powdery with a perfectly non-peeling surface, section surface is yellow-white color, unequal and has no holes. (2) Physicochemical standards It is the real situation that we can not distinguish into quility of shanyao with established test because various workings which decrease medical effects is used. Therefore we suggest a testing standard of S02 which is used in bleaching. And testing standards relatived with decrease of medical effects must be established at once. It must that Dry on loss is less than 14.0%, content of ash is less than 6.0%. Content of acid-nonsoluble ash is less than 0.5%. Contens of heavy metal has to detect less than 30 ppm and there is no reminding agricultural medince.

• Journal of Bio-Environment Control
• /
• v.19 no.4
• /
• pp.343-350
• /
• 2010

This study was conducted to investigate the effect of harvest seasons on quality and microbial population at different steps of production chain of fresh-cut iceberg lettuce. Iceberg lettuces harvested in May, June, July, October, and December were processed following industrial practices, and stored at $5^{\circ}C$ for 9 days. For microbial measurement, samples were taken from each of the following steps: harvest, transport, pretreatment, cutting, 1st-washing, 2nd-washing, and day 3, 6, and 9 of storage. Iceberg lettuce cultivated in protect house and harvested in May and October showed higher $CO_2$ levels in the packages and electrolyte leakages than lettuce harvested in June, July and December. Microbial population of raw materials harvested in July was highest (6.76 log), and microbial growth rate during storage was highest in samples harvested in May. Lettuce harvested in June had better quality and microbial safety compared to other lettuces. Although lettuce harvested in October and December had less microbial population in either raw materials or processed products, those samples had inferior quality due to off-odor development and severe browning. Therefore, it is required to maintain quality and ensure microbial safety to distribute fresh-cut lettuce with high quality and safety throughout the year.

• Journal of Bio-Environment Control
• /
• v.21 no.4
• /
• pp.411-418
• /
• 2012

This study was conducted to investigate the effect of calcinated calcium (CC) alone or combination with heat treatment on storage quality and microbial growth in fresh-cut broccoli. Fresh broccoli samples were cut into small pieces and washed in normal tap water (TW), $50{\mu}L{\cdot}L^{-1}$ chlorinated water (pH 6.5), $1.5g{\cdot}L^{-1}$ CC, heat treatment in TW at $45^{\circ}C$, and CC dissolved in TW at $45^{\circ}C$ for 2 minutes separately. Samples were then packaged in $50{\mu}m$ polyethylene bags and stored at $5^{\circ}C$. Results revealed that like $50{\mu}L{\cdot}L^{-1}$ chlorine, washing in CC at normal water temperature was effective in reducing microbial population in fresh-cut broccoli samples. Washing with CC combined with heat treatment increased an electrical conductivity of fresh-cut broccoli. Combined heat treatments with TW and CC reduced aerobic plate count on fresh-cut broccoli, only in initial period of storage. But, later on heat treatment induced injury of fresh-cut broccoli resulting more microbial population compared to non heat treatment. However, samples treated with CC alone had good quality with low off-odor at the end of storage. Results suggest that CC, an environment-friendly sanitizer could be an alternative to chlorinated water for washing of fresh-cut broccoli without affecting sensorial quality.

• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.4 no.1
• /
• pp.125-129
• /
• 1968

For the study of method for promoting the germination of Korean sod seeds harvseted newly some physical and chemical treatments were tested in this experiment. The summarized results of these tests are as follows: 1. Storage of wet seed in low temperature of 0~$2^{\circ}C$ during 2~30 days was seemed the most effective treatment for promoting the germination of sod seed. 2. The treatment that Soaking and mixing up the seeds in cone sulphuric acid about one and half minutes and then washing off in the water promoted fairly the germination of sod seeds. 3. Better germination of sod seeds was found in the light than in the dark or soil. 4. Cutting the top of seed and crushing of seed coat with sand seemed to promote slightly the germination of sod seeds. 5. No promoting effect for germination of sod seeds was found with treatments of Gibberellin, $NH_4$ $NO_3$ and NAA.

• Korean Journal of Materials Research
• /
• v.22 no.9
• /
• pp.476-481
• /
• 2012

Among the various roll-to-roll printing technologies such as gravure, gravure-offset, and reverse offset printing, reverse offset printing has the advantage of fine patterning, with less than 5 ${\mu}m$ line width. However, it involves complex processes, consisting of 1) the coating process, 2) the off process, 3) the patterning process, and 4) the set process of the ink. Each process demands various ink properties, including viscosity, surface tension, stickiness, and adhesion with substrate or clich$\acute{e}$; these properties are critical factors for the printing quality of fine patterning. In this study, Ag nano ink was developed for reverse offset printing and the effect of polyvinylpyrrolidone(PVP), used as a capping agent of Ag nano particles, on the printing quality was investigated. Ag nano particles with a diameter of ~60 nm were synthesized using the conventional polyol synthesis process. Ethanol and ethylene glycol monopropyl ether(EGPE) were used together as the main solvent in order to control the drying and absorption of the solvents during the printing process. The rheological behavior, especially ink adhesion and stickiness, was controlled with washing processes that have an effect on the offset process and that played a critical role in the fine patterning. The electrical and thermal behaviors were analyzed according to the content of PVP in the Ag ink. Finally, an Ag mesh pattern with a line width of 10 ${\mu}m$ was printed using reverse offset printing; this printing showed an electrical resistivity of 36 ${\mu}{\Omega}{\cdot}cm$ after sintering at $200^{\circ}C$.

• Proceedings of the Korean Institute of Navigation and Port Research Conference
• /
• 2006.06b
• /
• pp.221-226
• /
• 2006

This study is about backwash condition and membrane fouling at continuous filtration process in ballast water treatment. Displayed result that handle particle contaminant and hydrospace organism included a number of ballast that is happened in ship using automatic back washing filter. Reason that removes first contaminant that is included in number of ballast is that heighten processing effect of after processing process of the filter. Another advantage is to drop off the solids with controlling revolution of drum screen in pretreatment filtration process. The capacity of pilot plant was $10m^3/h$. The result of the test, Backwash cycle time and duration time and a signification effect on the efficiency of system and backwash Backwash duration time was determined to be fixed in 6 seconds of the system with more than 95% removal rate, It needed 1hour backwash frequency. Filtration system removal aquatic organism over $70{\mu}m$ in ballast water. This study shows that the filtration treatment system has a potential for the treatment of ballast water.

• Proceedings of KOSOMES biannual meeting
• /
• 2006.05a
• /
• pp.79-83
• /
• 2006

Displayed result that handle particle contaminant and hydrospace organism included in number of ballast that is happened in ship using automatic bade washing filter. Reason that remove first contaminant that is included in number of ballast is that heighten processing effect of after processing process. of the filter. Another advantage is to drop off the solids with controlling revolution of drum screen in pretreatment filtration process. The fact that it is easy to attach and detach a several type of screen for getting the expected water quality is another advantage. Filter rotation speed at 1.0rpm is filter resistance 3.0bar and 3.0rpm is filter resistance 2.8bar. Filter out impurities from ballast water over 6.0rpm is filter resistance 26bar and 10rpm is filter resistance 2.5bar. Filtration system removal aquatic organism over $80{\mu}m$ in ballast water. This study shows that the filtration treatment system has a potential for the treatment of ballast water.

• Journal of the Society of Cosmetic Scientists of Korea
• /
• v.47 no.3
• /
• pp.237-245
• /
• 2021

Particulate matter and ultra-particle matters generally refer to very small floating dust, such as 1/6 to 1/7 and 1/20 to 1/30, respectively, compared to the thickness of human hair, and contain various types of heavy metal ions. In addition to breathing, particle matters (PM) that flows in through the gaps in the pores of the skin can induce health problems in the body's tissues and skin, so it must be removed by blocking the inflow or by washing. Through this study, we confirmed the possibility that heavy metal ions can be adsorbed and removed by using Oryza sativa (Rice) bran oil (OSBO). In addition, the cell viability is much higher than that of grain-derived components through cytotoxicity experiments, and the cytoprotective effect of an external stimulus source can be expected. It was confirmed that the expression amount of COL1A1 mRNA increased, and accordingly, it was believed that wrinkles that might be caused by moisture lost by heavy metal ions in fine dust could be alleviated. Based on the results of these experiments, we tried to present a cosmetics containing OSBO, which is a wash-off formulation, in order to finally remove heavy metals.