• 대한기계학회논문집B
• /
• 제33권12호
• /
• pp.1014-1021
• /
• 2009

A new eddy viscosity equation was formulated from assumption of turbulence length scale equation and specific dissipation ratio equation. Then, a set of turbulence model equations for the turbulent kinetic energy ${\kappa}$, the viscosity ${\nu}_t$, and the intermittency factor ${\gamma}$ is proposed by considering the entrainment effect. Closure coefficients are determined by experimental data and resorting to numerical optimization. Present model has been applied to compute four representative cases of free shear flows and successfully compared with experimental data. In particular, the spreading rate, the centreline mean velocity and the profiles of intermittency are calculated with improved accuracy. Also, the proposed ${\nu}_t-{\kappa}-{\gamma}$ model was applied to channel flow by considering the wall effect and the results show good agreements with the Direct Numerical Simulation data.

• Journal of Advanced Marine Engineering and Technology
• /
• 제24권3호
• /
• pp.29-35
• /
• 2000

The present numerical study investigates heat transfer enhancement mechanism for suspensions of polystyrene particles in water. Numerical simulations were done for turbulent hydrodynamic fully developed flows in a circular duct with constant wall heat flux. The experimental result of microparticle suspensions show 25∼45% heat transfer enhancement over those of water. The present numerical results show the main parameter for the heat transfer enhancement of microparticle suspension in a circular duct is the change of velocity profile by the non-Newtonian fluid behavior.

• 한국전산유체공학회지
• /
• 제18권3호
• /
• pp.14-19
• /
• 2013

Renal failure patients have to operate arteriovenous graft for hemodialysis. Blood flow characteristics influence the patency rate of arteriovenous graft. Numerical investigation is performed with the arteriovenous graft according to injection of blood. As a result, when the injection is not applied to venous graft, the low wall shear stress region appears at venous anastomosis. It may cause intimal hyperplasia at venous anastomosis.

• 한국농공학회논문집
• /
• 제46권2호
• /
• pp.93-103
• /
• 2004

In trench excavation, essential factor of earth-retaining temporary work structure should be easy taking to pieces and movement, and dead weight must be less. This paper studies about the light weight material and application as earth-retaining structure to prevent the slope failure of sand soil ground caused by the variation of groundwater level in trench excavation. That is, light weight earth-retaining structural is proposed and a simulation with FEM on application of proposed structural in sandy soil is presented. The results are summarized as follows; (1) The study proposed FRP H-shaped pannel for the light weight member, and also presented estimation method about stability. (2) Mechanical property (bending moment, shear force, axial force, displacement) were changed according to groundwater level, but these values had been within enough safety rate and allowable stress. Therefore, proposed light weight pannel with FRP is available for bracing structure in trench excavation.

• 대한의용생체공학회:의공학회지
• /
• 제20권5호
• /
• pp.593-599
• /
• 1999

수축절정기에 0.2mm, 0.4mm 두께의 소구경 인조혈관의 내경3.2mm의 동맥에 문합한 단단문합 주위의 유동과 구조해석을 동시에 수행하였다. 유동해석 결과 속도분포 및 벽단전률은 타 연구결과와 매우 유사하며 이론해와 매우 유사함을 보였다. 유동에 의해서 문합부 주위에 작용하는 응력은 문합부에 집중되며 이는 수십만 pa에 달했다. 또한 인조혈관과 동맥에 작용하는 원주방향의 응력을 이론해와 비교한 결과 서로 유사함을 보였으며 두께가 얇은 인조혈관을 사용하는 경우 문합부의 compliance mismatch 는 개선되나 반대로 응력은 더 많이 받음을 알 수 있었다. 본 연구를 통해서 유체에 의하여 혈관이 영향을 받는 심혈관계 현상을 연구하는데 있어서 이와 같은 유체-구조 상호작용을 고려하여 동시에 해결 하는 방법은 매우 유용할 것으로 생각된다.

• 한국수자원학회:학술대회논문집
• /
• 한국수자원학회 2016년도 학술발표회
• /
• pp.196-196
• /
• 2016

Landslide dam failure presents as a severe natural disaster due to its adverse impact to people and property. If the landslide dams failed, the discharge of a huge volume of both water and sediment could result in a catastrophic flood in the downstream area. In most of previous studies, breaching process used to be considered as a constructed dam, rather than as a landslide dam. Their erosion rate was assumed to relate to discharge by a sediment transport equation. However, during surface erosion of landslide dam, the sediment transportation regime is greatly dependent on the slope surface and the sediment concentration in the flow. This study aims to accurately simulate the outflow hydrograph caused by landslide dam by overtopping through a 2D surface flow erosion/deposition model. The lateral erosion velocity in this model was presented as a function of the shear stress on the side wall. The simulated results were then compared and it was coherent with the results obtained from the experiments.

• Geomechanics and Engineering
• /
• 제22권3호
• /
• pp.197-206
• /
• 2020

Reutilization of solid waste such as Tire Derived Aggregate (TDA) and mixing it with soft soil for backfill material not only reduces the required volume of backfill soil (i.e., sand-mining procedures; reinforcement), but also preserves the environment from pollution by recycling. TDA is a widely-used material that has a good track record for improving sustainable construction. This paper attempted to investigate the performance of Kaolin-TDA mixtures as a backfill material underneath a strip footing and close to a retaining wall. For this purpose, different types of TDA i.e., powdery, shredded, small-size granular (1-4 mm) and large-size granular (5-8 mm), were mixed with Kaolin at 0, 20, 40, and 60% by weight. Static surcharge load with the rate of 10 kPa per min was applied on the strip footing until the failure of footing happened. The behaviour of samples K80-G (1-4 mm) 20 and K80-G (5-8 mm) 20 were identical to that of pure Kaolin, except that the maximum footing stress had grown by roughly three times (300-310 kPa). Therefore, it can be concluded that the total flexibility of the backfill and shear strength of the strip footing have been increased by adding the TDA. The results indicate that, a significant increase in the failure vertical stress of the footing is observed at the optimum mixture content. In addition, the TDA increases the elasticity behaviour of the backfill.

• 설비공학논문집
• /
• 제9권2호
• /
• pp.144-152
• /
• 1997

Film absorption involves simultaneous heat and mass transfer in the vapor-liquid system. In the present work, the absorption process of water vapor by an aqueous soluton of LiBr flowing inside of the vertical tube was investigated. The continuity, momentum, energy and diffusion equations for the solution film and vapor were formulated in integral forms and solved numerically. The model could predict the film thickness, the pressure gradient, and the heat and mass transfer rate. Particularly the effects of vapor flow conditions on the absorption process were investigated in terms of the vapor Reynolds number. As the vapor Reynolds number increased, the shear stress at the vapor-solution interface also increased. Consequently solution film became thinner at higher vapor flowrate under the co-currentflow condition. Thinner film was capable of higher heat transfer to the wall and leaded to higher absorption rate of the water vapor into the solution film.

• 대한의용생체공학회:의공학회지
• /
• 제24권1호
• /
• pp.37-44
• /
• 2003

본 실험연구에서는 정상유동상태에서 새롭게 설계된 자가팽창성 그래프트 스텐트의 수력학적 성능을 평가하고자 하였다. 코팅 재질이 다른 두 개의 그래프트 스텐트와 한 개의 타이티놀 금속스텐트가 실험에 사용되었으며, 유량이 가자 5, 10, 15 1/min에서 스텐트 전후에서의 압력변화 및 속도분포를 측정하였다. 스텐트 삽입에 의한 압력손실은 유량이 증가함에 지수적으로 증가하였다. 특히 15 1/min의 유량에서 다공성 PTFE 그래프트 스텐트와 TiNi 금속스텐트의 압력손실은 거의 동일하나 PU 그래프트 스텐트는 약 6배 이상의 현저한 증가를 보이고 있다. 스텐트 후류에서의 속도분포는 다공성 PTFE 그래프트 스텐트와 TiNi 금속스텐트는 유량에 관계없이 유사한 형태를 보여주고 있다. 그러나, PU 그래프트 스텐트에서는 특히 유량이 10 1/min 이상에서 속도분포가 비대칭적이고 관 중심에서의 상대적인 낮은 유속을 보여주고 있으며, 결과적으로 벽면전단응력 및 수직응력의 증가론 초래하고 있다. 이와같이 PU 그래프트 스텐트의 상대적으로 낮은 수력학적 성능은 스텐트가 보다 작은 관에 삽입되었을때 코팅재질의 낮은 유연성으로 인하여 스텐트의 표면에 주름이 발생하여 유동단면이 비대칭적으로 되고 벽면의 조도가 증가하며, 관벽과 스텐트와 틈새가 존재하여 제트류가 형성되기 때문으로 해석된다.

• 한국지반환경공학회 논문집
• /
• 제8권3호
• /
• pp.59-65
• /
• 2007

투수성이 낮은 흙에서 과잉간극수압은 빨리 소산되지 못하므로 유효응력을 감소시키게 되며, 이는 보강토 옹벽에서 보강재와 흙 사이의 인터페이스 전단강도를 감소시키는 결과를 가져온다. 이러한 조건에서는 간극수압의 소산속도가 매우 중요하며, 이는 벽체의 크기, 뒤채움 흙의 투수성 그리고 보강재의 길이 등에 의해 영향을 받는다. 본 논문에서는 이러한 영향요소의 효과를 조사하기 위하여 유한요소해석을 실시하였고, 그 결과 투수계수 $10^{-3}cm/sec$ 이하부터는 간극수압 소산시간이 점차 증가하기 시작함을 알 수 있었다. 간극수압 소산시간의 증가는 유효응력의 감소를 의미하여 보강재 인발력의 감소로 이어질 것이며, 이는 본 논문에서 수행된 수치해석으로 확인되었다. 또한, 보강재의 길이가 길수록 간극수압 소산시간이 더 많이 필요한 것으로 나타났는데 이는 배수거리의 증가에 기인한다.