• Archives of Plastic Surgery
• /
• v.32 no.1
• /
• pp.37-42
• /
• 2005

The human nose is located in the center of the face and it's cosmetic importance is high. The contour of the nasal dorsum and side walls play a major role in the shaping of the nose, and even a slight distortion may results in significant variance of the human facies. However, in the case of patients with wide nasal bone, augmention rhinoplasty can make nasal planes look wide, resulting in bulbous appearing noses or lateral borders of the nasal implant may be visible after the surgery making the final cosmetic results unsatisfactory. To solve such problems, from march, 1999 to march, 2004, the authors have performed augmention rhinoplasty in 36 patients. The cause of operations were as follows: flat nose 20, hump nose 5, deviated nose 4, secondary rhinoplasty 7. Paramedian osteotomy was performed at a distance that was the same as the width of the implant from the midline(5 mm + 5 mm). To prevent it from connecting to the roof at the lateral osteotomy line, intentional green stick fracture of the roof was performed. Agumentation rhinoplasty was done with either Silicone or Gortex and ear cartilage as a supplement. The follow up period was 2 weeks to 13 months with an average of 5.5 months. There were no infections and postoperative bleeding. As a result, the nose was augmented higher and narrower than before which we and the patient both found highly satisfactory.

• Journal of the Korean institute of surface engineering
• /
• v.53 no.2
• /
• pp.80-86
• /
• 2020

This paper is concerned with type of imperfections present within the anodic oxide films on AA2024 and surface hardness of the anodic film measured after ink-impregnation. The anodic oxide films were formed for 25 min at 40 mA/㎠ and 15±0.5℃ and 300 rpm of magnet stirring rate in 20% sulfuric acid solution. The ink-impregnation allows clear observations of not only the imperfections within the anodic oxide films but also an indentation mark on the oxide film surface made by a pyramidal-diamond penetrator for the hardness measurement. There were observed four different regions in the anodic oxide films on AA2024 and the surface hardness of the anodic oxide films appeared to be crucially dependent on the type of defects, showing 60~100 H_v on the oxide surface region I with large size black defect, 100~140 H_v on the oxide surface region II with large size grey defect, 140~170 H_v on the oxide surface region III with mall size black and/or grey defects and 170~190 H_v on the oxide surface region IV without defects. The pyramidal indentation marks were observed to be distorted in the regions with a large size black and grey defects, while no distortion of the indentation mark was observed in the regions with small size defects and without visible defects.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2013.08a
• /
• pp.204.1-204.1
• /
• 2013

Fluorine, the radius of which is close to that of oxygen, could be an appropriate anion doping candidate. A lower lattice distortion could be expected for F doping, compared with Al, Ga, and In doping. F-doped ZnO (FZO) and undoped ZnO nanorods were grown onto glass substrate by the hydrothemal method. The doping level in the solution, designated by F/Zn atomic ratio of was varied from 0.0 to 10.0 in 2.0 steps. To investigate the effects of the structure and optical properties of FZO nanorods were investigated using X-ray diffraction, UV-visible spectroscopy and photoluminescence (PL). For the PL spectra, the maximum peak position of NBE moves to higher energy, from 0 to 4 at.%. As the doping concentration increases, the maximum peak position of NBE gradually moves to lover energy, from 4 to 10 at.%.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.33 no.4
• /
• pp.132-138
• /
• 2023

Doped and undoped-BiVO₄ samples with different elements (Li, Mg) and amounts were synthesized with a hydrothermal method. The synthesized samples were characterized using various techniques including X-ray diffraction (XRD), X-ray photoelectron spectroscopy (XPS), UV-Vis diffusion reflectance spectroscopy (UV-Vis DRS), and photoluminescence (PL) spectroscopy. Photocatalytic activity of the samples was evaluated by measuring the degradation of methyl blue (MB) under visible light irradiation. The results indicated that the incorporation of Mg and Li into BiVO₄ caused lattice distortion, the presence of surface hydroxyl groups, a narrower band gap, and a reduced recombination ratio of photo-induced electron-hole pairs. Notably, the photocatalytic activity of Mg5%-Li5% co-doped BiVO₄ sample exhibited a significant improvement compared to that of undoped BiVO₄ sample.

• Korean Journal of Remote Sensing
• /
• v.37 no.5_1
• /
• pp.1013-1027
• /
• 2021

Images taken with KOMPSAT-3 have additional NIR and PAN bands, as well as RGB regions of the visible ray band, compared to imagestaken with a standard camera. Furthermore, electrical and optical properties must be considered because a wide radius area of approximately 17 km or more is photographed at an altitude of 685 km above the ground. In other words, the camera sensor of KOMPSAT-3 is distorted by each CCD pixel, characteristics of each band,sensitivity and time-dependent change, CCD geometry. In order to solve the distortion, correction of the sensors is essential. In this paper, we propose a method for detecting uniform regions in side-slider-based KOMPSAT-3 images using segment-based noise analysis. After detecting a uniform area with the corresponding algorithm, a correction table was created for each sensor to apply the non-uniformity correction algorithm, and satellite image correction was performed using the created correction table. As a result, the proposed method reduced the distortion of the satellite image,such as vertical noise, compared to the conventional method. The relative radiation accuracy index, which is an index based on mean square error (RA) and an index based on absolute error (RE), wasfound to have a comparative advantage of 0.3 percent and 0.15 percent, respectively, over the conventional method.

• Bulletin of the Korean Chemical Society
• /
• v.29 no.6
• /
• pp.1141-1148
• /
• 2008

Geometry optimizations and electronic structure calculations are reported for meso-tetraphenyl porphyrin (TPP) and a series of meso-substituted catecholic porphyrins (KP99150, KP99151, KP99152, KP99153, and KP99090) using density functional theory (DFT). The calculated B3LYP//RHF bond lengths are slightly longer than those of LSDA//RHF. The calculated electronic structures clearly show that TPP and meso-catecholic group contribute to π-electron conjugation along porphyrin ring for HOMO and LUMO, significantly reduced the HOMO-LUMO gap. The wavelength due to B3LYP energy gaps is favored with experimental value in Soret (B), and LSDA energy gaps are favored with experimental value in visible bands (Q). The electronic effect of the catecholic groups is to reduced energies of both the HOMOs and LUMOs. However, the distortion of porphyrin predominantly raises the energies of the HOMOs, so the net result is a large drop in HOMO and smaller drop in LUMO energies upon meso-substituted catecholic group of the porphyrin macrocycle as shown in KP99151 and KP99152 of Figure 5(a). These results are in reasonable agreement with normal-coordinate structural decomposition (NSD) results. The HOMO-LUMO gap is an important factor to consider in the development of photodynamic therapy (PDT).

• Proceedings of the Korean Vacuum Society Conference
• /
• 2013.02a
• /
• pp.337-337
• /
• 2013

ZnO seed layers were deposited on a quartz substrate using the sol-gel method, and B-doped ZnO (BZO) nanorods with different B concentrations ranging from 0 to 2.5 at.% were grown on the ZnO seed layers by the hydrothermal method. The structural, optical, electrical propertiesof the ZnO and BZO nanorods were investigated using field-emission scanning electron microscopy, X-ray diffraction (XRD), photoluminescence (PL), ultraviolet-visible spectroscopy, and hall effect. The ZnO and BZO nanorods grew well aligned on the surface of the quartz substrates. From the XRD data, it can be seen that the B doping is responsible for the distortion of the ZnO lattice. The PL spectra show near-band-edge emission and deep-level emission, and they also show that B doping significantly affects the PL properties of ZnO nanorods. The optical band gaps are changed by B doping, and thus the Urbach energy value changed with the optical band gap of the ZnO nanorods. From the hall measurements, it can be observed that the values of electrical resistivity, carrier concentration, and mobility are changed by B doping.

• Korean Journal of Cognitive Science
• /
• v.28 no.3
• /
• pp.133-147
• /
• 2017

Human perception is an outcome of the influence of various factors rather than objective reflection of external environment. Among the factors, action-specific perception is a phenomenon where perception changes in terms of one's ability to act on the environment. Previous research reported contradictory results regarding whether action-specific perception occurs during performance or after performance due to memory distortion or knowledge about performance results. In this research, we conducted three experiments to determine when action-specific perception occurs. Participants threw darts at different distances and reported perceived size of targets in each trial. The results showed that, in Experiments 1 and 2, participants perceived targets larger when they hit than missed the targets, and the effect was greater when the targets were not visible after each throw. However, because participants had knowledge about the results of their throws, there could have been bias in participants' responses. In Experiment 3, where this possibility was excluded, we also obtained action-specific perception, and therefore concluded that action-specific perception occurs during but not after task performance.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.26 no.7
• /
• pp.157-165
• /
• 1989

To recover three dimensional information in Shape from Texture, the distorting effects of projection must be distinguished from properties of the texture on which the distortion acts. In this paper, we show an approximated maximum likelihood estimation method in which we find surface orientation of the visible surface (hemisphere) in gaussian sphere using local analysis of the texture. In addition, assuming that an orthogonal projection and a circle is an image formation system and a texel (texture element) respectively, we drive the surface orientation from the distribution of variation by means of orthogonal projection of a tangent direction which exists regularly in the arc length of a circle. We present the orientation parameters of textured surface with slant and tilt in gradient space, and also the surface normal of the resulted surface orientationas as needle map. This algorithm is applied to geographic contour (artificially generated chejudo) and synthetic texture.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2001.10a
• /
• pp.487-490
• /
• 2001

With the establishment of the optimized copyright, digital image watermarking technique is demended to identify the owner of a certain image and to avoid the unauthorized distribution of digital image copies. Also, a robust watermarking approach should survive several possible attacks, such as image processing and lossy image compession. The proposed scheme distributes the 256 gray-level signature information in discrete wavelet transform domain of the host image where is very little visible distortion. While much of the privious work used signature data that is a small fraction of th e host images the proposed approach can easily handle gray-scale Images. As the result, stable reconstruction can be obtained even when the images are transformed, JPEG lossy compression or otherwise modified by low-pass filtering operations.