• 한국태양에너지학회 논문집
• /
• 제32권3호
• /
• pp.50-58
• /
• 2012

The objective of this study is to evaluate the lighting dimming rates with various parameters of the building skin in a small office. We compared to simulated workplane illuminance and measured workplane illuminance for the base model. After that, the five veriables(the presence of vertical wall in double skin facade, the presence of windowsill, window to wall ratio(WWR), window visible transmittance, the width of double skin facade) were applied to base model, and we analyzed the simulated lighting energy saving rates. The results are listed as below. The simulated workplane illuminance results are similar to the measurement. Simulated illuminance was smaller than measured illuminance by 16.5%(60 lx). In accordance with applicable building skin parameters, lighting energy saving rate results are summarized as follows. Lighting energy saving rate of case1(windowsill height 0.7m) is higher than that of base case(windowsill and vertical wall) by 7.3% and the lighting energy saving rate of case2(no vertical wall) is higher than that of base case by 7.6% and the lighting energy saving rate of case3(no windowsill and vertical wall) is higher than that of base case by 12.4%. The lighting energy saving rate is increased by 2.3%, when window visible transmittance is increased from 70% to 86%. The lighting energy saving rate is increased by 4.6%, when we changed the WWR 70% to 90%. lighting energy savings rate is increased by 6.5%, when the width of double skin facade is reduced from 1m to 0.3m.

• 한국지반공학회:학술대회논문집
• /
• 한국지반공학회 2001년도 봄 학술발표회 논문집
• /
• pp.355-362
• /
• 2001

Since micropiles were conceived in Italy in the early 1950s, which have been widely used for In-situ reinforcement, bearing pile or the concept of combination in the world-wide. The meaning of micropiles usually differs from that of a general deep foundation. Because the load capacity of it was mainly affected by skin friction. Also, it could be obtained the improvement effects of load capacity or ground's rigidity by the unitary behavior of ground and micropiles. In this study, The model tests were peformed on the dense sand where micropiles are set to the vertical direction. Strip footing was used in it. Steel bars of dia. 2 and 4㎜ were used in model tests of which the sand was attached on the surface, and the length of it was changed as 2B to 6B(where, B is width of strip footing) Through this process, the load capacity were analyzed from the test results in the relationship between load and displacement.

• Fibers and Polymers
• /
• 제4권4호
• /
• pp.215-221
• /
• 2003

A vertical skin model with two detachable environmental chambers was developed to simulate a Human-Clothing-Environment system and to evaluate heat and moisture transport properties of textile materials under severe conditions and during transient states. The construction of the system was described and data reproducibility and accuracy of the instrument were verified by using PEG treated nonwovens. Also advantages over a traditional static type experiment were demonstrated based on a series of experiments.

• International Journal of Naval Architecture and Ocean Engineering
• /
• 제6권1호
• /
• pp.151-161
• /
• 2014

In this study, an experimental investigation has been made of the applicability of outer-layer vertical blades to real ship model. After first devised by Hutchins and Choi (2003), the outer-layer vertical blades demonstrated its effectiveness in reducing total drag of flat plate (Park et al., 2011) with maximum drag reduction of 9.6%. With a view to assessing the effect in the flow around a ship, the arrays of outer-layer vertical blades have been installed onto the side bottom and flat bottom of a 300k KVLCC model. A series of towing tank test has been carried out to investigate resistance (CTM) reduction efficiency and improvement of stern wake distribution with varying geometric parameters of the blades array. The installation of vertical blades led to the CTM reduction of 2.15~2.76% near the service speed. The nominal wake fraction was affected marginally by the blades array and the axial velocity distribution tended to be more uniform by the blades array.

• 한국지반환경공학회 논문집
• /
• 제24권1호
• /
• pp.5-14
• /
• 2023

본 연구에서는 설계 대상인 현장타설말뚝기초에 대하여 상사율을 고려한 하중전이 대형토조 모형시험과 3차원 수치해석을 수행함으로써 현장타설말뚝 선단부와 주면부의 하중전이 특성을 분석하고 하중분담율을 산정하였다. 대형토조 모형시험 및 3차원 수치해석 결과에서 나타난 현장타설말뚝의 선형적 거동으로부터, 본 연구의 설계 조건에 대한 주면하중전이곡선은 Baquelin 등의 제안식, 선단하중전이곡선은 Baquelin 등의 제안식, 수평하중전이곡선은 Reese 등의 제안식이 적정한 것으로 확인되었다. 암반근입부에서 축하중은 시험값이 수치해석값보다 약간 크게 측정되었지만 암반 근입부에서 하중분담율은 연직하중이 증가함에 따라 평균적으로 약 27.8%의 분담율을 나타내었다. 연직재하 시에 말뚝두부의 침하량은 해석값이 시험값보다 약간 작게 평가되었으며, 모형시험 및 해석 최대 연직하중에서 말뚝두부의 최대 침하량은 시험치 10.6mm, 해석치 10.0mm 이고, 말뚝선단에서 최대 침하량은 시험치 2.0mm, 해석치 1.9mm로 나타났다. 수평재하 시에 기둥 두부(지표)와 말뚝 두부에서 수평변위는 시험값과 해석값이 비교적 잘 일치하는 것으로 나타났고, 모형토조시험 결과 최대 수평변위 38.0mm에서 측정된 수평하중은 24,713kN, 수치해석에서의 수평하중은 26,073kN으로 평가되었다.

• Journal of the Korean Society for Industrial and Applied Mathematics
• /
• 제22권4호
• /
• pp.241-251
• /
• 2018

The present study is carried out to examine the combined effect of heat absorption on flow model. The model consists of unsteady flow of a viscous, incompressible and electrically conducting fluid. The flow is along an impulsively started oscillating vertical plate with variable mass diffusion. The magnetic field is applied perpendicular to the plate. The fluid model under consideration has been solved by Laplace transform technique. The numerical data obtained is discussed with the help of graphs and table. The numerical values obtained for skin-friction have been tabulated. To shorten the lengthy equations in the solution some symbols have been assumed, which are mentioned in appendix. The appendix is included in the article as the last section of the manuscript.

• 한국지반공학회논문집
• /
• 제20권8호
• /
• pp.59-66
• /
• 2004

본 연구에서는 연직말뚝과 경사말뚝에 대하여 모형실험과 수치해석을 실시하여 경사말뚝의 거동 특성을 분석하였다. 상대밀도 79%인 모래지반에 경사각도 0$^{\circ}$, $10^{\circ}$, 20$^{\circ}$, 30$^{\circ}$의 강관말뚝을 항타 관입하여 하중재하실험을 실시하였고, 상용 유한요소 프로그램인 PENTAGON 3D를 이용하여 수치해석을 수행하였다. 모형실험에 의한 경사말뚝의 축방향 지지 력은 경사각도가 $10^{\circ}$, 20$^{\circ}$, 30$^{\circ}$에서 연직말뚝에 비하여 111, 95, 81%로 나타났고, 수치해석의 결과도 다소 차이는 있지만 비슷하게 나타났다. 그러나 Petrasovits & Award의 결과는 경사각 $10^{\circ}$에서 모형실험 결과와 유사하지만, 경사각 20$^{\circ}$와 30$^{\circ}$에서는 모형실험결과를 과대평가하였다. 경사각도에 따른 주면마찰력과 선단하중은 모형실험과 수치해석 모두 $10^{\circ}$경사에서 최대값을 나타낸 후, 경사각도가 증가함에 따라 감소하였고, 전체하중에서 주면마찰력과 선단하중의 구성비율은 경사각도에 관계없이 거의 비슷하게 나타났다.

• 대한기계학회:학술대회논문집
• /
• 대한기계학회 2001년도 춘계학술대회논문집D
• /
• pp.648-653
• /
• 2001

This study represents the numerical analysis of natural convection of a microenvironments with a air permeability in the clothing air-layer. The clothing air layer of shoulder and arm was used for numerical analysis model. As a numerical analysis method, we adopted a finite volume method for two-dimensional laminar flow, and analyzed the flow and thermal characteristics of velocity, temperature and concentration in the air layer between body and clothing. As a temperature boundary conditions, we considered that a body skin has a high temperature with $34^{\circ}C$ the environmental temperatures are $5,\;15\;and\;25^{\circ}C$ for various permeability coefficients. The distributions of concentration, temperature and velocity were showed that two large cells were. formed at horizontal and vertical air layer, respectively. As the temperature difference between body skin and environment decrease, the heat transfer was decreased rapidly.

• 설비공학논문집
• /
• 제13권12호
• /
• pp.1282-1287
• /
• 2001

This study presents the numerical analysis of natural convection of a micro- environments with air permeability in the clothing air-layer. As a numerical model the clothing air layer of shoulder and arm were adopted. Finite volume method for two-dimensional laminar flow was used for the analysis of flow and thermal characteristics of velocity, temperature and concentration in the air layer between body and clothing. As temperature boundary conditions, a body skin has a high temperature with $34^{\circ}C$ and the environmental temperatures are 5, 15 and $25^{\circ}C$ for various permeability coefficients. The distributions of concentration, temperature and velocity are shown that two large cells form at horizontal and vertical air layer, respectively. As the temperature difference between body skin and environment decreases, the heat transfer is decreased rapidly.

• 한국한의학연구원논문집
• /
• 제14권3호
• /
• pp.103-111
• /
• 2008

Recently, skin diagnosis has been suggested as a promising tool for discrimination of Sasang Constitution, reported by examining the skin characteristics such as thickness, stiffness, slip, and skin textures like wrinkles and furrows. However, the works had a limitation in that clinical decision on the skin characteristics was made by relying upon oriental medicine doctors' subjective sense of touch. In order to objectify the skin diagnosis and claim its efficacy on the discrimination of the Sasang Constitutions, it is necessary to demonstrate its discrimination capability by providing numerical values in terms of physical quantities obtained from measurements using today's sensors and equipment technologies, which motivated this work as a priliminary step towards objectification of skin diagnosis. The skin characteristics focused in this work is the slip property of the back-hand skin that has been exploited using the dynamic friction measurement system. First, curved geometric effects of the back-hand skin on the measured lateral/vertical force signals were estimated using the artificially designed silicon coated structures, which led to a suggestion on a quality controlled experimental design based upon a empirical analysis model. Second, the experimental design thus suggested has been applied to the measurement of dynamic friction coefficients for two healthy male subjects of Taeumin (TE) and Soyangin (SY), respectively. The result shows that the dynamic friction coefficient is less for the SY subject than for the TE subject around the area of the skin used for diagnosis by the oriental medicine doctor, implying the TE subject's skin is more slippery than the SE subject's that is consistent with the oriental medicine doctor's diagnosis. Hopefully, this work can provide guidelines for obtaining quality data in friction measurement to be collected for discussion on the efficacy of the skin diagnosis and its objectification through statistical analysis.