• Journal of Korean Society of Occupational and Environmental Hygiene
• /
• v.29 no.1
• /
• pp.1-12
• /
• 2019

Objective: Significant concerns have been raised over chemical exposure and potential health risks such as increased cancer mortality among laboratory workers. The aim of this study was to investigate the overall exposure and unit task exposure levels of researchers in organic synthesis laboratories at universities. Methods: Seventy-seven personal Time-weighted average(TWA) samples and 139 task-based samples from four organic synthesis laboratories at two universities were collected over three days. The concentrations of acetone, chloroform, dichloromethane(DCM), diethyl ether, ethyl acetate, n-hexane, tetrahydrofuran(THF), benzene, toluene, and xylene were determined using the GC-FID. Results: The most frequently used chemicals in the laboratories were acetone, DCM, n-hexane, methanol, and THF. Carcinogens such as benzene, chloroform, and DCM were used in one or more laboratories. The TWA full-shift exposures of researchers to acetone was the highest(ND-59.3 ppm). Benzene was observed above the occupational exposure limit in 18-40% of the samples. The levels of exposure to organic solvents were statistically different by task(p<0.05), while washing task was the highest. Washing was not perceived as a part of the real lab tasks. Rather it was considered as simple dish-washing or experimental preparation and performed in an open sink where exposure to organic solvents was unavoidable. TWAs and task-based concentrations were compared by substance, which suggests that TWA-based assessment could not reflect short-term and high concentration exposures. Conclusions: Laboratory workers may be exposed to various organic solvents at levels of concern. TWA-based measurement alone cannot guarantee holistic exposure assessment among lab workers as their exposures are very dependent on their tasks. Further investigation and characterization for specific tasks and overall chronic exposures will help protect lab workers from unnecessary exposure to chemicals while they perform research.

• Analytical Science and Technology
• /
• v.36 no.3
• /
• pp.128-134
• /
• 2023

Centella asiatica (C. asiatica) extracts, including asiaticoside and madecassoside, are used in ointments to treat the wound and atopic dermatitis due to their antibacterial and skin-regenerating effects in Asia. Therefore, research on the cultivation and extraction efficiency of C. asiatica is being actively conducted to increase commercialization efficiency. In this study, various deep eutectic solvents (DESs) were prepared and used as the extraction solvents according to the mole ratio between the hydrogen bond acceptor (HBA) and hydrogen bond donor (HBD). And then, the extraction yields in distilled water (DW) and methanol (MeOH), commonly used extraction solvents for C. asiatica, were compared and analyzed by HPLC in the optimized operating condition. As a result, a mixture of DW and DES at a ratio of 3:7 showed about 1.4 times higher extraction efficiency than MeOH only. Conversely, the extraction efficiency in a mixture of MeOH and DES at a ratio of 3:7 was about 6 % lower than that in MeOH only.

• 한국문화재보존과학회:학술대회논문집
• /
• 2007.10a
• /
• pp.43-45
• /
• 2007

• Bulletin of the Korean Chemical Society
• /
• v.10 no.2
• /
• pp.129-132
• /
• 1989

Reactions of thebaine with phenylsulfonylpropadiene in various solvents were investigated. It was found that Diels-Alder reaction adduct was obtained in nonpolar solvent, while addition reaction adduct was obtained in polar solvent. Transformations of these two products were also carried out.

• Proceedings of the Korean Magnestics Society Conference
• /
• 2016.11a
• /
• pp.80-80
• /
• 2016

• Polymer(Korea)
• /
• v.31 no.2
• /
• pp.98-104
• /
• 2007

The expansion behavior of polystyrene (PS) chains with various molecular weights has been investigated above Flory $\Theta$temperature by viscometry after dissolving in the three different mixed solvents systems such as benzene/n-heptane, 1,4-dioxane/isopropanol, and 1,4-dioxane/n-heptane. Two different regimes are observed as increasing temperature: one regime is for the expansion of chain and the other is for the contraction. For the higher molecular weight sample of PS, the higher peak temperature showing its maximum expansion is obtained. Within a certain system of Ps/mixed solvents, the $\tau/\tau_c$ parameter shows universality for the variation of molecular weight. But while each system of Ps/mixed solvents has shown its own different slope, the universality breaks down in the overall system of mixed solvents. However after introducing a new empirical $b^{2/3}\tau/\tau_c$ parameter, all data points of three different systems have dropt on one master curve and the universality of chain expansion has recovered again. Here $\tau$ and $\tau_c$ are defined as $(T-\Theta)/\Theta$ and $(\Theta-T_c)/T_c$, respectively and $T_c$ is the critical solution temperature, and b of Schultz-Flory equation is corresponding to the effective slope in the plot of $1/T_c$ against $1/M_w^{1/2}$.

• Bulletin of the Korean Chemical Society
• /
• v.33 no.2
• /
• pp.597-600
• /
• 2012

Polyynes were formed by laser ablation of a graphite target in deionized water ($H_2O$ and $D_2O$) and various organic solvents such as acetonitrile, n-hexane, and c-hexane and were identified by analyzing ultraviolet (UV) absorption and Raman spectra. We assigned the major UV absorption peaks that coincided with the electronic transitions corresponding to linear polyyne chains. The UV absorption peak intensities of a polyyne solution decreased as the holding temperature of the solution increased. Also, the absorption spectra of polyynes obtained by laser ablation of a graphite target at different volume fractions of $H_2O$ and $D_2O$ were examined.

• Bulletin of the Korean Chemical Society
• /
• v.33 no.8
• /
• pp.2748-2752
• /
• 2012

Cr(III) and Co(III) complexes with acetylacetonate were anchored onto a mesoporous MCM-41 through Schiff condensation. The materials were characterized by XRD, FT-IR, BET, CHN and ICP techniques. Elemental analysis of samples revealed that one C=N bond was formed through Schiff condensation on MCM-41 surface. The catalysts were tested for the alcohol oxidations using t-butyl hydroperoxide (TBHP) and $H_2O_2$ as oxidant. The catalytic experiments were carried out at both room temperature and reflux condition. Various solvents such as dichloromethane, acetonitrile and water were examined in the oxidation of alcohols. Among the different solvents, catalytic activity is found more in acetonitrile. Further, the catalysts were recycled three times in the oxidation of alcohols and no major change in the conversion and selectivity is observed, which shows that the immobilized metal-acetylacetonate complexes are stable under the present reaction conditions.

• Journal of the Korean Society of Clothing and Textiles
• /
• v.37 no.4
• /
• pp.506-513
• /
• 2013

Rubia cordifolia L (Indian madder) contains red color purpurin (65-67%) and yellow color munjistin (10-12%) as well as nordamncanthal (9-10%). Purpurin is a traditional red dye. The purpose of this research is to increase the dyeability of silk and light fastness of dyed silk fabric. We dyed silk fabrics after pretreatment to remove the yellow component of madder using various solvents such as ethyl acetate, ethanol, methanol, chloroform, and acetone. The total K/S value was the highest in the case of chloroform and reflectance was the lowest at the red color region from 470nm to 530nm. Chloroform dissolved the yellow color of Rubia cordifolia; in addition, we found that the total K/S value increased and the ${\Delta}E$ value decreased by chloroform pretreatment for silk dyeing.

• YAKHAK HOEJI
• /
• v.28 no.6
• /
• pp.299-303
• /
• 1984

In order to eluciate the effect of humidity and organic solvent on the decomposition of carbamide peroxide, the kinetic study was carried out. The carbamide peroxide was prepared from urea and 30%-hydrogen peroxide. The accelerated stability analysis for carbamide peroxide crystal in various relative humidity, and for 10%-carbamide peroxide solution of organic solvents were investigated. Both humidity and temperature were important factors influencing the decomposition rate of carbamide peroxide crystal. The higher the humidity and temperature, the greater was the reaction rate. The breakdown rate of crystal was observed as an apparent zero-order, and was faster than the rate of decomposition in dilute propylene glycol, glycerine or sorbitol solutioos which were measured as an apparent first-order reaction. The more dilute to 10% the organic solvents of 10%-carbamide peroxide, the slower was breakdown rate. It is, therefore, useful in the aspects of stability and economics to substitute solvent of carbamide peroxide topical solution (USP XXI) with 10%-propylene glycol or glycerine instead of anhydrous glycerine.