• 한국자동차공학회논문집
• /
• 제7권9호
• /
• pp.75-81
• /
• 1999

In this paper, the details of electronically controlled CVT is described , which Kia Motor company recently developed in prototype form for hybrid passenger car. This transmission has two input shafts, one for engine and the other for traction motor. The shaft for traction motor is located at rear side which is extended from primary pulley shaft and connected to traction motor through adapter gear box. Adopting two input system, various driving mode is available such as motor alone driving in hybrid vehicle application. As far as electrohydraulic system concerned , this transmission uses two bleed type variable force solenoids for line pressure and ratio control, and one on-off solenoid for clutch control. Another feature for this transmission is that oil pump for transmission is separate from CVT for supplying oil pressure even at vehicle standstill.

• 인터넷정보학회논문지
• /
• 제8권5호
• /
• pp.161-170
• /
• 2007

본 논문은 데이터 메모리 평면과 스위칭 평면을 분리하여 패킷 데이터의 저장과 메모리 주소 포인터의 스위칭이 병렬적으로 처리 가능하며 IP 패킷의 가변 길이 스위칭이 가능한 새로운 스위치 구조를 제안한다. 제안한 구조는 기존 VOQ방식의 복잡한 중재 알고리즘이 필요 없으며 출력 큐 방식의 스위치에서만 적용되고 있는 QoS를 입력 큐에서 고려한다. 성능분석 결과 제안한 구조는 기존의 공유 메모리 기반의 구조들에 비해 상대적으로 낮은 평균 지연 시간을 가지며 스위치의 크기가 증가하더라도 일정한 지연 시간을 보장함을 확인하였다.

• 한국정밀공학회지
• /
• 제17권2호
• /
• pp.114-120
• /
• 2000

Fossil power plant availability is significantly affected by gradual degradations of equipment as operation of the plant continues. It is quite important to determine whether or not to replace some equipment and when to replace the equipment. Performance calculation and analysis can provide the information. Robustness in the performance calculation can be increased by using verification ＆ validation of measured input data. We suggest new algorithm in which estimation relation for validated measurement can be obtained using correlation between measurements. Input estimation model is obtained using design data and acceptance measurement data of domestic 16 fossil power plant. The model consists of finding mostly correlated state variable in plant state and mapping relation based on the model and current state of power plant.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2003년도 춘계학술대회 논문집 전기기기 및 에너지변환시스템부문
• /
• pp.318-320
• /
• 2003

This paper presents a novel single-stage high frequency resonant DC-DC converter using zero voltage switching with high input power factor. The proposed high frequency resonant converter integrates half-bridge boost rectifier as power factor corrector (PFC) and half-bridge resonant converter into a single stage. The input stage of the half-bridge boost rectifier is working in discontinuous conduction mode(DCM) with constant duty cycle and variable switching frequency. So that a high power factor is achieved naturally. Simulation results through the Pspice have demonstrated the feasibility of the Proposed DC-DC converter. This proposed converter will be able to be practically used as a power supply in various fields as induction heating applications, DC-DC converter etc.

• 전기학회논문지
• /
• 제59권9호
• /
• pp.1680-1685
• /
• 2010

In this note, a proof of Utkin's theorem is presented for a MI(Multi Input) uncertain linear case. The invariance theorem with respect to the two transformation methods so called the two diagonalization methods are proved clearly and comparatively for MI uncertain linear systems. With respect to the sliding surface transformation and the control input transformation, the equation of the sliding mode i.e., the sliding surface is invariant. Both control inputs have the same gains. By means of the two transformation methods the same results can be obtained. Through an illustrative example and simulation study, the usefulness of the main results is verified.

• Structural Engineering and Mechanics
• /
• 제34권4호
• /
• pp.417-447
• /
• 2010

The uncertainty often observed in experimental strengths of masonry constituents makes critical the selection of the appropriate inputs in finite element analysis of complex masonry buildings, as well as requires modelling the building ultimate load as a random variable. On the other hand, the utilization of expensive Monte Carlo simulations to estimate collapse load probability distributions may become computationally impractical when a single analysis of a complex building requires hours of computer calculations. To reduce the computational cost of Monte Carlo simulations, direct computer calculations can be replaced with inexpensive Response Surface (RS) models. This work investigates the use of RS models in Monte Carlo analysis of complex masonry buildings with random input parameters. The accuracy of the estimated RS models, as well as the good estimations of the collapse load cumulative distributions obtained via polynomial RS models, show how the proposed approach could be a useful tool in problems of technical interest.

• 한국농공학회논문집
• /
• 제54권4호
• /
• pp.73-81
• /
• 2012

In this study, the settlement data of 32 center cored rockfill dams (total 39 monitored data) were collected and analyzed to develop the method to predict the crest settlement of a CCRD after impounding by using the internal settlement data occurred during construction. An artificial neural network (ANN) modeling was used in developing the method, which was considered to be a more reliable approach since in the ANN model dam height, core width, and core type were all considered as input variables in deriving the crest settlement, whereas in conventional methods, such as Clements's method, only dam height is used as a variable. The ANN analysis results showed a good agreement with the measured data, compared to those by the conventional methods using regression analysis. In addition, a simple procedure to use the ANN model for engineers in practice was provided by proposing the equations used for given input values.

• 제어로봇시스템학회논문지
• /
• 제17권9호
• /
• pp.875-881
• /
• 2011

This paper describes a new method of estimating the gradient of a function with perturbation and correlation. We impose a known periodic perturbation to the input variable and observe the output of the function in order to obtain much richer and more reliable information. By taking the correlation between the input perturbation and the resultant function outputs, we can determine the gradient of the function. The computation of the correlation does not require derivatives; therefore the gradient can be estimated reliably. Robust estimation of the gradient using perturbation/correlation, which is very effective when an analytical solution is not available, is described. To verify the effectiveness of perturbation/correlation based estimation, the results of gradient estimation are compared with the analytical solutions of an example function. The effects of amplitude of the perturbation and number of samplings in a period are investigated. A minimization of a function with the gradient estimation method is performed.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1999년도 하계학술대회 논문집 F
• /
• pp.2467-2469
• /
• 1999

In this paper. the stability control system of constant output DC-DC converter is composed of considering a ripple source input and a transient variable sinusoidal power. Also, we design I-PD controller and add phase shift controller. Therefore, it is proposed controller that is stable about the input voltage and load alteration and tracking desired value.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1999년도 하계학술대회 논문집 B
• /
• pp.728-730
• /
• 1999

This paper suggests a new supervisory control input for improving response of nonlinear system with adaptive neural controller. The proposed control input is constructed using variable parameters which is adjusted by a separated control law. With the proposed algorithm, the information about the parameters are not required and error range is managed by designer in this scheme. The effectiveness of the proposed control scheme is demonstrated through the control of inverted pendulum.