• 전자공학회논문지D
• /
• 제35D권5호
• /
• pp.1-10
• /
• 1998

A GaAs MMIC composed of VCO (voltage controlled oscillator) and mixer for PCS receiver has been developed using 1.mu.m ion implanted GaAs MESFET process. The VCO consists of a colpitts-type oscillator with a dielectric resonator and the circuit configuration of the mixer is a dual-gate type with an asymmetric combination of LO and RF FETs for the improvement of intermodulation characteristics. The common-source self-biasing is used in all circuits including a buffer amplifier and mixer, achieving a single power supply (3V) operation. The total power dissipation is 78mW. The VCO chip shows a phase noise of-99 dBc/Hz at 100KHz offset. The combined VCO/mixer chip shows a flat conversion gain of 2dB, the frequency-tuning factor of 80MHz/volts in the varacter bias ranging from 0.5V to 0.5V , and output IP3 of dBm at varactor bias of 0V. The fabricated chip size is 2.5mm X 1.4mm.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2008년도 하계학술대회 논문집 Vol.9
• /
• pp.501-503
• /
• 2008

This paper presents the design of a 2.4 GHz low phase noise fully integrated LC Voltage-Controlled-Oscillator (VCO) in $0.18{\mu}m$ CMOS technology. The VCO is without any tail bias current sources for a low phase noise and, in which differential varactors are adopted for the symmetry of the circuit. At the same time, the use of differential varactors pairs reduces the tuning range, i.e., the frequency range versus VTUNE, so that the phase noise becomes lower. The simulation results show the achieved phase noise of -138.5 dBc/Hz at 3 MHz offset, while the VCO core draws 3.9mA of current from a 1.8V supply. The tuning range is from 2.28GHz to 2.55 GHz.

• 대한전자공학회논문지SD
• /
• 제45권5호
• /
• pp.40-49
• /
• 2008

Mobile-DTV 응용을 위한 분수형 주파수 합성기를 1.8V $0.18{\mu}m$ CMOS 공정으로 설계하였다. VCO는 PMOS를 사용하여 위상잡음을 감소시켰고, 인덕터와 캐패시터, 버렉터(varactor)를 선택적으로 스위칭하는 기법을 적용하여 측정 결과 800MHz-1.67GHz 대역에서 동작이 가능한 것을 확인하였다. VCO 이득 곡선의 선형 특성을 개선하기 위해서 버렉터 바이어스 기법을 사용하였고, 개수를 2개로 최소화 하였다. 추가적으로 버렉터 스위칭 기법을 사용해서 VCO 이득 저하 특성을 개선하였다. 또한, VCO 주파수 교정 블록을 사용해서 VCO 이득 저하를 개선하면서, VCO 이득의 간격을 일정하게 유지하도록 설계하였다. 분수형 주파수 분주비를 위한 시그마-델타 변조기의 설계 시 통합 모의실험 기법(co-simulation method)을 적용해서 설계의 정확성과 효율성을 향상시켰다. VCO와 PFD, CP, LF는 Cadence Spectre를 이용하여 검증하였고, 분주기는 Spectre와 Matlab Simulink, ModelSim, HSPICE를 이용하여 검증하였다. 주파수 합성기의 전체 소모 전력은 1.8V 전원 전압에서 18mW이고, VCO의 주파수 영역은 최대 주파수의 약 52.1%가 되는 것을 확인하였다. 또한 VCO의 위상 잡음은 1GHz, 1.5GHz, 2GHz 출력 주파수에서 1MHz 오프셋에서 -100dBc/Hz 이하의 잡음 특성을 확인하였다.

• ETRI Journal
• /
• 제27권5호
• /
• pp.473-483
• /
• 2005

In this paper, we propose two LC voltage-controlled oscillators (VCOs) that improve both phase noise and tuning range. With both 1/f induced low-frequency noise and low-frequency thermal noise around DC or around harmonics suppressed significantly by the employment of a current-current negative feedback (CCNF) loop, the phase noise in the CCNF LC VCO has been improved by about 10 dB at 6 MHz offset compared to the conventional LC VCO. The phase noise of the CCNF VCO was measured as -112 dBc/Hz at 6 MHz offset from 5.5 GHz carrier frequency. Also, we present a bandwidth-enhanced LC VCO whose tuning range has been increased about 250 % by connecting the varactor to the bases of the cross-coupled pair. The phase noise of the bandwidth-enhanced LC-tank VCO has been improved by about 6 dB at 6 MHz offset compared to the conventional LC VCO. The phase noise reduction has been achieved because the DC-decoupling capacitor Cc prevents the output common-mode level from modulating the varactor bias point, and the signal power increases in the LC-tank resonator. The bandwidth-enhanced LC VCO represents a 12 % bandwidth and phase noise of -108 dBc/Hz at 6 MHz offset.

• Journal of electromagnetic engineering and science
• /
• 제4권4호
• /
• pp.168-174
• /
• 2004

A bandwidth-enhanced and phase noise-improved differential LC-tank VCO is proposed in this paper. By connecting the varactors to the bases of the cross-coupled transistors of the proposed LC-tank VCO, its input negative resistance has been widened. Also, the feedback capacitor Cc in the cross-coupling path of the proposed LC-tank VCO attenuates the output common-mode level modulated by the low-frequency noise because the modulated common-mode level jitters the varactor bias point and degrades phase noise. Compared with the fabricated conventional LC-tank VCO, the proposed LC-tank VCO demonstrates $200\;\%$ enhancement in tuning range, and 6 - dB improvement in phase noise at 6 MHz offset frequency from 5.4-GHz carrier. We achieved the phase noise of - 106 dBc/Hz at 6 MHz offset, and $10\;\%$ tuning range from the proposed LC-tank VCO. The proposed LC-tank VCO consumes 12 mA at 2.5 V supply voltage.

• ETRI Journal
• /
• 제36권3호
• /
• pp.510-513
• /
• 2014

A Q-band pHEMT image-rejection low-noise amplifier (IR-LNA) is presented using inter-stage tunable resonators. The inter-stage L-C resonators can maximize an image rejection by functioning as inter-stage matching circuits at an operating frequency ($F_{OP}$) and short circuits at an image frequency ($F_{IM}$). In addition, it also brings more wideband image rejection than conventional notch filters. Moreover, tunable varactors in L-C resonators not only compensate for the mismatch of an image frequency induced by the process variation or model error but can also change the image frequency according to a required RF frequency. The implemented pHEMT IR-LNA shows 54.3 dB maximum image rejection ratio (IRR). By changing the varactor bias, the image frequency shifts from 27 GHz to 37 GHz with over 40 dB IRR, a 19.1 dB to 17.6 dB peak gain, and 3.2 dB to 4.3 dB noise figure. To the best of the authors' knowledge, it shows the highest IRR and $F_{IM}/F_{OP}$ of the reported millimeter/quasi-millimeter wave IR-LNAs.

• 센서학회지
• /
• 제23권3호
• /
• pp.185-191
• /
• 2014

The width of depletion region in a varactor diode can be modulated by varying a reverse bias voltage. Thus, the preferred characteristics of depletion capacitance can obtained by the change in the width of depletion region so that it can select only the desirable frequencies. In this paper, the TV tuner varactor diode fabricated by hyper-abrupt profile control technique is presented. This diode can be operated within 3.3 V of driving voltage with capability of UHF band tuning. To form the hyperabrupt profile, firstly, p+ high concentration shallow junction with $0.2{\mu}m$ of junction depth and $1E+20ions/cm^3$ of surface concentration was formed using $BF_2$ implantation source. Simulation results optimized important factors such as epitaxial thickness and dose quality, diffusion time of n+ layer. To form steep hyper-abrupt profile, Formed n+ profile implanted the $PH_3$ source at Si(100) n-type epitaxial layer that has resistivity of $1.4{\Omega}cm$ and thickness of $2.4{\mu}m$ using p+ high concentration Shallow junction. Aluminum containing to 1% of Si was used as a electrode metal. Area of electrode was $30,200{\mu}m^2$. The C-V and Q-V electric characteristics were investigated by using impedance Analyzer (HP4291B). By controlling of concentration profile by n+ dosage at p+ high concentration shallow junction, the device with maximum $L_F$ at -1.5 V and 21.5~3.47 pF at 0.3~3.3 V was fabricated. We got the appropriate device in driving voltage 3.3 V having hyper-abrupt junction that profile order (m factor) is about -3/2. The deviation of capacitance by hyper-abrupt junction with C0.3 V of initial capacitance is due to the deviation of thermal process, ion implantation and diffusion. The deviation of initial capacitance at 0.3 V can be reduced by control of thermal process tolerance using RTP on wafer.

• 전기학회논문지
• /
• 제59권8호
• /
• pp.1429-1435
• /
• 2010

In this paper, a double lorentz composite right left handed(DL-CRLH) transmission line is designed using defected ground structure (DGS) and varactor diodes. Previously, the diode has been adopted only selectively for one of parallel or series resonators, and the balanced frequency as well as triple band frequencies were fixed. However in the proposed DL-CRLH transmission line, the balanced frequency, where the resonant frequencies of the series-connected parallel resonator and shunt-connected series resonator are the same, is adjustable. In addition, the triple band frequencies are controlled, too. The measured balanced frequency varies between 3.42~4.8GHz according to the controlled bias voltage. Under the same bias condition for the balanced frequency, the adjusted frequencies are 2.22~2.77GHz, 3.7~5.2GHz, 7.32~8.23GHz, 3.42~4.8GHz, and 4.44~5.92GHz for the conditions that ${\beta}d=+0.5{\pi}$, $-0.5{\pi}$, 2nd $+0.5{\pi}$, ${\omega}_{\infty}$, and ${\omega}_o$, respectively.

• 전자공학회논문지A
• /
• 제33A권7호
• /
• pp.121-126
• /
• 1996

In this paper an MMIC VCO which can be used in a double conversion TV tuner is designed, fabricated and measured. The VCO is designed using the small signal method and fabricated using ETRI GaAs MMIC foundry. The 3x200$\mu$m gate width MESFET with 1$\mu$m gate length is used for an active device and MIM capacitors, spiral inductors, thin film resitors are used as passive elements. The VCO has output power of 10.95dBm at 1955 MHz with 5V bias voltage and 4V tuning voltage. The oscillation frequency change form 1947 MHz to 1964 MHz is obtaine dby an external varactor diode connected to the gate with a tuning voltage from 0 V to 6V.

• 한국정보통신설비학회:학술대회논문집
• /
• 한국정보통신설비학회 2006년도 하계학술대회
• /
• pp.208-211
• /
• 2006

In this paper, a tunable image rejection filter using two varactors is developed for mobile convergence. The filter is fabricated on a 0.25um substrate. ESD Pad is embedded to prevent damage caused by electrostatic discharge(ESD). Bias voltages are at WCDMA(2.1GHz). WiBro(2.3GHz), and WLAN(2.45) are 0.5V, 0.95V and 1.8V respectively. And the image rejection rations are more than 28dB at each band and insertion losses are less than 2dB at each band.