• Journal of Sensor Science and Technology
• /
• v.23 no.2
• /
• pp.94-98
• /
• 2014

Aluminum nitride (AlN) thin films with a TiN buffer layer have been fabricated on SUS430 substrate by RF reactive magnetron sputtering at room temperature under 25~75% $N_2$ /Ar. The characterization of film properties were performed using surface profiler, X-ray diffraction, X-ray photoelectron spectroscopy(XPS), and pressure-voltage measurement system. The deposition rates of AlN films were decreased with increasing the $N_2$ concentration owing to lower mass of nitrogen ions than Ar. The as-deposited AlN films showed crystalline phase, and with increasing the $N_2$ concentration, the peak of AlN(100) plane and the crystallinity became weak. Any change in the preferential orientation of the as-deposited AlN films was not observed within our $N_2$ concentration range. But in the case of 50% $N_2$ /Ar condition, the peak of (002) plane, which is determinant in pressure sensing properties, appeared. XPS depth profiling of AlN/TiN/SUS430 revealed Al/N ratio was close to stoichiometric value (45:47) when deposited under 50% $N_2/Ar$ atmosphere at room temperature. The output signal voltage of AlN sensor showed a linear behavior between 26~85 mV, and the pressure-sensing sensitivity was calculated as 7 mV/MPa.

• Journal of the Korean Home Economics Association
• /
• v.24 no.3
• /
• pp.31-42
• /
• 1986

It is generallybelieved that the values of female students are different depending on the cultural enviromment of society. The purpose of this paper is to discern the value orientation of female students in Korea and America, and how they are related to the clothing behavior. 300 female students were selected as sample from the Univ. of Minnesota and 158 students filled out the questionnair. 420 female students were selected from five unversities in Jinju, Taegy and Pusan. RESULTS : 1) Korean students had highly evaluated theaethetic, political, religious and social values, and American students had higher evaluation on the economic and American students had higher evaluation on the economic and theoretical values. 2) Korean students tended to regard modesty, conformity and management as important factors when they chose new clothes, and for American students, appearance and tool were important. 3) The impact of values on clothing vehavior was as follows. a) Korean students who emphasized theoretical values did not use clothes as an instrument of status symbol and modesty. b) American students who emphasized the economic values tended to have an interest in purchase and wearing of clothes on purpose. c) Korean students who had positive attitudes on the aethetic values tended to be conservative, but they wanted to use the clothes as a demonstration of self exaggeraton. d) Korean students who regarded social values important tended to have a higher interest in the management of clothes. e) Korean students who had highly evaluated the religious values tended to be conservative when the selected new clothes. American students did not want to conform to the group norm when they chose new clothes. On the whole, American students did not put on clothes to achieve a specific goal. In short, it can be concluded that Korean students and American students have different values and they have a great impact on their clothing behavior.

• Journal of Magnetics
• /
• v.19 no.2
• /
• pp.126-129
• /
• 2014

We report the crystallographic and magnetic properties of $Ni_{0.3}Fe_{0.7}Ga_2S_4$ by means of X-ray diffractometer (XRD), a superconducting quantum interference device (SQUID) magnetometer, and a M$\ddot{o}$ssbauer spectroscopy. In particular, $Ni_{0.3}Fe_{0.7}Ga_2S_4$ was studied by M$\ddot{o}$ssbauer analysis for evidence of spin reorientation. The chalcogenide material $Ni_{0.3}Fe_{0.7}Ga_2S_4$ was fabricated by a direct reaction method. XRD analysis confirmed that $Ni_{0.3}Fe_{0.7}Ga_2S_4$ has a 2-dimension (2-D) triangular lattice structure, with space group P-3m1. The M$\ddot{o}$ssbauer spectra of $Ni_{0.3}Fe_{0.7}Ga_2S_4$ at spectra at various temperatures from 4.2 to 300 K showed that the spectrum at 4.2 K has a severely distorted 8-line shape, as spin liquid. Electric quadrupole splitting, $E_Q$ has anomalous two-points of temperature dependence of $E_Q$ curve as freezing temperature, $T_f=11K$, and N$\acute{e}$el temperature, $T_N=26K$. This suggests that there appears to be a slowly-fluctuating "spin gel" state between $T_f$ and $T_N$, caused by non-paramagnetic spin state below $T_N$. This comes from charge re-distribution due to spin-orientation above $T_f$, and $T_N$, due to the changing $E_Q$ at various temperatures. Isomer shift value ($0.7mm/s{\leq}{\delta}{\leq}0.9mm/s$) shows that the charge states are ferrous ($Fe^{2+}$), for all temperature range. The Debye temperature for the octahedral site was found to be ${\Theta}_D=260K$.

• Management & Information Systems Review
• /
• v.34 no.3
• /
• pp.141-160
• /
• 2015

IoT(Internet of Things) has become a major issue as new type of convergence technology, expending existing of USNs(Ubiquitous Sensor Networks), NFC(Near Field Communication), and M2M(Machine to Machine). The IoT technology defines as a networking for things, which can establish intelligent links collaboratively for sensing networking and processing between each other without human intervention. The purpose of this study is to investigate to forecast the future distribution changes and orientation of contribution of distribution industry on IoT and to provide the implication of distribution changes. To become a global market leader, IoT requires much more development of core technology of IoT for distribution industry, new service creation and try to use a market-based demand side strategy to create markets. So, to become a global leader in distribution industry, this study results show that first of all establishment of standardization of IoT, privacy safeguards, security issues, stability and value were more important than others. The research findings suggest that the development goals of IoT should strive to boost the creation of a global leader in distribution industry and convenience to consider consumers' demands as the most important thing.

• Korean Journal of Materials Research
• /
• v.15 no.8
• /
• pp.491-495
• /
• 2005

(Zn,Mg)O (ZMO) thin films doped with Ga $(0\~0.03mol\%)$ in the target source were prepared by pulsed laser deposition on c-plane sapphire substrates at $500^{\circ}C$, and the effect of Ga contents on the properties of the electrical, optical and crystal properties of the deposited films was investigated. From X-ray diffraction patterns, ZMO film doped with $0.02 mol\%$ Ga showed crystal structure with c-axis preferred orientation, showing only the (0002) and (0004) diffraction peaks. In contrast, ZMO film doped with $Ga=0.03 mol\%$ showed a randomly oriented crystal structure. All the samples were highly transparent, showing the transmittance values of above $85\%$ in the visible region. For all the Ga doped ZMO films, the value of energy band gap was found to be about 3.5 eV, regardless of their Ga contents. From the Hall measurements, the resistivity and the carrier density for the ZMO film doped with $0.01 mol\%$ Ga were about $5\times10^{-4}\Omega-cm$ and $2\times10^{21}cm^{-3}$, respectively.

• Korean Journal of Materials Research
• /
• v.28 no.9
• /
• pp.534-538
• /
• 2018

The annealing characteristics of a cold rolled Al-6.5Mg-1.5Zn alloy newly designed as an automobile material is investigated in detail. The aluminum alloy in the ingot state is cut to a thickness of 4 mm, a total width of 30 mm and a length of 100 mm and then reduced to a thickness of 1 mm (reduction of 75 %) by multi-pass rolling at room temperature. Annealing after rolling is performed at temperatures ranging from 200 to $400^{\circ}C$ for 1 hour. The tensile strength of the annealed material tends to decrease with the annealing temperature and shows a maximum tensile strength of 482MPa in the material annealed at $200^{\circ}C$. The tensile elongation of the annealed material increases with the annealing temperature, while the tensile strength does not, and reaches a maximum value of 26 % at the $350^{\circ}C$ annealed material. For the microstructure, recovery and recrystallization actively occur as the annealing temperature increases. The recrystallization begins to occur at $300^{\circ}C$ and is completed at $350^{\circ}C$, which results in the formation of a fine grained structure. After the rolling, the rolling texture of {112}<111>(Cu-Orientation) develops, but after the annealing a specific texture does not develop.

• Journal of Magnetics
• /
• v.21 no.1
• /
• pp.12-19
• /
• 2016

The <100> oriented $Fe_{83}Ga_{17}$ alloys with various contents of NbC or B were prepared by directionally solidification method at the growth rate of $720mm{\cdot}h^{-1}$. With a small amount of precipitates, the columnar grains grew with cellular mode during directional solidification process, while like-dendrite mode of grains growth was observed in the alloys with higher contents of 0.5 at% due to the dragging effect of precipitates on the boundaries. The NbC precipitates disperse both inside grains and along the boundaries of $Fe_{83}Ga_{17}$ alloys with NbC addition, and the Fe2B secondary phase particles preferentially distribute along the grain boundaries in B-doped alloys. Precipitates could affect grain growth and improved the <100> orientation during directional solidification process. Small amount of precipitate element addition slightly increased the magnetostrictive strain, and a high value of 335 ppm under pre-stress of 15 MPa was achieved in the alloys with 0.1 at% NbC. Despite the fact that the effect on magnetic induction density of small amount of precipitates could be negligible, the coercivity markedly increased with addition of precipitate element for $Fe_{83}Ga_{17}$ alloy due to the retarded domain motion resulted by precipitates.

• Journal of Powder Materials
• /
• v.25 no.1
• /
• pp.54-59
• /
• 2018

Sb-doped $SnO_2$ (ATO) transparent conducting films are fabricated using horizontal ultrasonic spray pyrolysis deposition (HUSPD) to form uniform and compact film structures with homogeneously supplied precursor solution. To optimize the molar concentration and transparent conducting performance of the ATO films using HUSPD, we use precursor solutions of 0.15, 0.20, 0.25, and 0.30 M. As the molar concentration increases, the resultant ATO films exhibit more compact surface structures because of the larger crystallite sizes and higher ATO crystallinity because of the greater thickness from the accelerated growth of ATO. Thus, the ATO films prepared at 0.25 M have the best transparent conducting performance ($12.60{\pm}0.21{\Omega}/{\square}$ sheet resistance and 80.83% optical transmittance) and the highest figure-of-merit value ($9.44{\pm}0.17{\times}10^{-3}{\Omega}^{-1}$). The improvement in transparent conducting performance is attributed to the enhanced carrier concentration by the improved ATO crystallinity and Hall mobility with the compact surface structure and preferred (211) orientation, ascribed to the accelerated growth of ATO at the optimized molar concentration. Therefore, ATO films fabricated using HUSPD are transparent conducting film candidates for optoelectronic devices.

• Journal of the Economic Geographical Society of Korea
• /
• v.21 no.3
• /
• pp.254-269
• /
• 2018

The aim of this paper is to identify the components of the sustainable regional ecosystem of social economy enterprises (hereafter 'regional ecosystem'), and to explore the principles of reciprocity, regard and public policy, which have a fundamental impact on the development of such regional ecosystem. The regional ecosystem is an interactive system of the stakeholders who are related to the process of planning, producing, distributing and selling goods and services, and the agents who maintain and spread their social value orientation. This system operates through the interaction of 'local network (business relations and social relations)', 'intermediary organization' and 'public role.' On the basis of the conceptual framework on the regional ecosystem, the result of the in-depth analysis on the case of Gorang-erang Coop shows the interaction of reciprocity and public policy with respect to regard within the context of a characteristic of the regional ecosystem.

• Korean Journal of Social Welfare
• /
• v.56 no.4
• /
• pp.195-214
• /
• 2004

As one of the essential elements of social work practice, knowledge articulates what the social work profession is doing and ought to do. With an emphasis on building a body of knowledge for the profession, this study analyses the nature of social work knowledge. First, the study examines concepts of social work theories and models, which are built around separate clusters of concepts from a broad base of theoretical orientation. The study reviews epistemological and ideological debates over how to perceive and approach social issues and the role of the social work profession. In organizing a clear conceptual framework for social work practice, different frames of reference and selective and fragmentary knowledge from other disciplines are considered barriers. For the development of a clear identity as a unified profession and the prospects of a value-based profession, more attention needs to be given to specify practical knowledge that is contextual and appropriate to practice settings and more sensitive to social issues.