• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.27 no.9
• /
• pp.1589-1596
• /
• 2003

In this paper, we performed the improvement study for the dynamic characteristics enhancement of the motor stator coil vertical winding machine. The dynamic characteristics improvement was done by means of the optimized design and the weight reduction of the flyer configuration, modified design of the servo control system for the flyer and the former actuation, and the development of jump timing digital circuit for the reduction of former jumping error. As the results, the maximum winding speed pattern of the developed machine was attained up to 3000rpm and also reduced the jumping error. In conclusion, domestic design technology for manufacturing the motor coil vertical winding machine was established through this study.

• Korean Journal of Applied Biomechanics
• /
• v.13 no.3
• /
• pp.1-14
• /
• 2003

This study was conducted to investigate the principles and motions for increasing the jumping height of Fosbury Flop. The subjects were three male jumpers who were former Korean national team players. Their jumping motions were analyzed using the DLT method of three-dimensional cinematography. The conclusions were as follows. 1. The horizontal velocity of approach run and decreasing of this velocity during the take off phase were increased as the jumping height was increased. Therefore, in order to increase the jumping height, the horizontal velocity of approachrun should be increased and decreased properly during the take-off phase. The average height of the analyzed Dials was 2.15m. The average horizontal velocity of approachrun was 7.49m/s and decreased to 4.16m/s at the instance of take-off. 2. The vertical velocity of the center of gravity was increased as the ascending height of the center of gravity during the take-off phase was increased. Therefore, the center of gravity at the instant of touch down should be lowered. This could be possible by increasing the length of the last stride and the backward lean angle of the body. The average length of the last stride was 111.1% of the standing height, the average height of the center of gravity was 46.6% of the standing height and the average backward lean angle of the body was 40.3 degrees.

• Journal of the Korean Society for Precision Engineering
• /
• v.21 no.4
• /
• pp.120-131
• /
• 2004

In this paper, we propose the method of a motion planning generation in which the movement of the 3-link leg subsystem is constrained to a slider-link and a singular posture can be easily avoided. The proposed method is the jumping control moving in vertical direction which mimics a cat's behavior. That is, it is jumping toward wall and kicking it to get a higher-place. Considering the movement from the point of constraint mechanical system, the robotic system which realizes the motion changes its configuration according to the position and it has several phases such as; ⅰ) an one-leg phase, ⅱ) in an air-phase. In other words, the system is under nonholonomic constraint due to the reservation of its momentum. Especially, in an air-phase, we will use a control method using state transformation and linearization in order to control the landing posture. Also, an iterative learning control algorithm is applied in order to improve the robustness of the control. The simulation results for jumping control will illustrate the effectiveness of the proposed control method.

• Korean Journal of Applied Biomechanics
• /
• v.25 no.2
• /
• pp.175-182
• /
• 2015

Objective : The purpose of this study was to investigate difference in fascicle behavior of the medial gastrocnemius during the locomotion with varying intensities, such as gait and one-legged and two-legged vertical jumping. Methods : Six subjects (3 males and 3 females; age: $27.2{\pm}1.6yrs.$, body mass: $62.8{\pm}9.8kg$, height: $169.6{\pm}8.5cm$) performed normal gait (G) at preferred speed and maximum vertical jumping with one (OJ) and two (TJ) legs. While subjects were performing the given tasks, the hip, knee and ankle joint motion and ground reaction force was monitored using a 8-infrared camera motion analysis system with two forceplates. Simultaneously, electromyography of the triceps surae muscles, and the fascicle length of the medial gastrocnemius were recorded using a real-time ultrasound imaging machine. Results : Comparing to gait, the kinematic and kinetic parameters of TJ and OJ were found to be significantly different. Along with those parameters, change in the medial gastrocnemius (MG) muscle-tendon complex (MTC) length ($50.57{\pm}6.20mm$ for TJ and $44.14{\pm}5.39mm$ for OJ) and changes in the fascicle length of the MG ($18.97{\pm}3.58mm$ for TJ and $20.31{\pm}4.59mm$ for OJ) were observed. Although the total excursion of the MTC and the MG fascicle length during the two types of jump were not significantly different, however the pattern of length changes were found to be different. For TJ, the fascicle length maintained isometric longer during the propulsive phase than OJ. Conclusion : One-legged and two-legged vertical jumping use different muscle-tendon interaction strategies.

• Physical Therapy Rehabilitation Science
• /
• v.4 no.1
• /
• pp.22-27
• /
• 2015

Objective: Jump training helps increase the muscle power by improving the muscle strength and reaction time of the muscle in operation. The purpose of this study was to identify the effects of strengthening, stretching exercise and meditation on electromyographic (EMG) onset timing of rectus femoris and gastrocnemius muscle during vertical jump performance. Design: Cross-sectional study. Methods: Ten healthy adults (5 male and 5 female) who were familiar with the vertical jumping task and had no lower extremity injuries or any bone or joint disorders, were recruited for this study. Muscle onset timing was measured by surface EMG. After EMG onset timing were measured during performing three baseline vertical jump trials, strengthening and stretching exercises of the rectus femoris and gastrocnemius, and meditation were performed in random order. EMG onset timing was measured during vertical jump after intervention, respectively. EMG value was averaged for the three trials and analyzed using one-way repeated ANOVA. Results: During vertical jump, EMG onset timing of gastrocnemius was a significant difference after intervention (p<0.05), and then there was significantly faster in strengthening exercise than meditation (p<0.05). Conclusions: These results indicate the potential positive effect of performing strengthening exercise of the gastrocnemius before a jumping event. Future research is required to identify the effects of intervention over a long period.

• Korean Journal of Applied Biomechanics
• /
• v.19 no.1
• /
• pp.27-36
• /
• 2009

The purpose of this study was to identify effects of restricted trunk motion on the performances of the maximum vertical jump. Ten healthy males performed normal countermovement jump(NJ) and control type of countermovement jump(CJ), in which subjects were required to restrict trunk motion as much as possible. The results showed 10% decreases of jumping height in CJ compared with NJ, which is primarily due to vertical velocity at take off. NJ with trunk motion produced significantly higher GRF than RJ, especially at the early part of propulsive phase, which resulted from increased moments on hip joint. And these were considered the main factors of performance enhancement in NJ. There were no significant differences in the mechanical outputs on knee and ankle joint between NJ and RJ. With trunk motion restricted, knee joint alternatively played a main role for propulsion, which is contrary on the normal jump that hip joint was highest contributor. And restricted trunk motion resulted in the changes of coordination pattern, knee-hip extension timing compared with normal proximal-distal sequence. In conclusion these results suggest that trunk motion is effective strategy for increasing performance of vertical jumping.

• Korean Journal of Applied Biomechanics
• /
• v.28 no.1
• /
• pp.61-67
• /
• 2018

Objective: The human body is often modelled as a spring-mass system. Lower extremity stiffness has been considered to be one of key factor in the performance enhancement of running, jumping, and hopping involved sports activities. There are several different classification of lower extremity stiffness consisting of vertical stiffness, leg stiffness, joint stiffness, as well as muscle and tendon stiffness. The primary purpose of this paper was to review the literature and describe different stiffness models and discuss applications of stiffness models while engaging in sports activities. In addition, this paper provided a current update of the lower extremity literature as it investigates the relationships between lower extremity stiffness and both functional performance and injury. Summary: Because various methods for measuring lower extremity stiffness are existing, measurements should always be accompanied by a detailed description including type of stiffness, testing method and calculation method. Moreover, investigator should be cautious when comparing lower extremity stiffness from different methods. Some evidence highlights that optimal degree of lower extremity stiffness is required for successful athletic performance. However, the actual magnitude of stiffness required to optimize performance is relatively unexplored. Direct relationship between lower extremity stiffness and lower extremity injuries has not clearly been established yet. Overall, high stiffness is potentially associate risk factors of lower extremity injuries although some of the evidence is controversial. Prospective injures studies are necessary to confirm this relationship. Moreover, further biomechanical and physiological investigation is needed to identify the optimal regulation of the lower limb stiffness behavior and its impact on athletic performance and lower limb injuries.

• Journal of Electrical Engineering and Technology
• /
• v.1 no.2
• /
• pp.200-210
• /
• 2006

This paper proposes the motion generation method in which the movement of the 3-links leg subsystem in constrained to slider-link and a singular posture can be easily avoided. This method is the realization of jumping control moving in a vertical direction, which mimics a cat's behavior. To consider the movement from the point of the constraint mechanical system, a robotics system for realizing the motion will change its configuration according to the position. The effectiveness of the proposed scheme is illustrated by simulation and experimental results.

• Journal of KSNVE
• /
• v.6 no.4
• /
• pp.439-446
• /
• 1996

This paper introduces a newly designed pendulum system that enables the more accurate boservation of dynamic behaviour arising from both horizontal and vertical(i.e. two dimension) excitation. First, experiments were carried out to examine the frequency responses of the devised pendulum system. Interestingly, experimental results for the three excitation angles of 22, 32 and 48 degree show 'new' jump phenomena. For the further understanding of these phenomena, experimental investigationhas been made to identify the equation of motion of the pendulum system from experimental data. This attempt has revealed that the viscous, coulomb and aerodynamic damping factors are involved in the equation of motion. By applying the Ritz averaging method to the equation, it becomes apparent that the jumping phenomena of the pendulum system in this work is more theoretically understood.

• Journal of Digital Convergence
• /
• v.13 no.8
• /
• pp.495-502
• /
• 2015

The purpose of this study was to investigating the effect of taping knee by testing the difference on kinetic variables of lower extremity when speed skating athletes jump on one leg. The results were as follows. The height of jumping after taping was higher, but the vertical height was not different according to taping. On take-off(TO), the horizontal and anterior-posterior maximum impulse force were decreased while the vertical maximum impact force was increased after taping. On landing(LD), the anterior-posterior maximum impulse force was decreased but the horizontal and vertical maximum impulse force were increased. TO, the impulse showed low after taping and the impulse dropped largely LD. The knee's moment of extension, eversion were reduced after tapping TO. LD, the flection moment of knee was decreased, but the inversion moment was increased after tapping. This study implies that the knee tapping helps injury prevention and performance enhancement, sports medicine convergence are needed.