• The Korean Journal of Ecology
• /
• v.24 no.2
• /
• pp.117-119
• /
• 2001

Solar ultraviolet-B (UV-B) irradiances incident on a horizontal surface at Taegu, Korea during 1996-1998 were calculated with 5 minute averages of measurements taken every 30 seconds by a broadband UV-B sensor. The average, maximum and minimum of daily UV-B dose were 11.31, 22.04 and 3.20kJ m$^{-2}$ day$^{-1}$ , respectively, for the measuring period. Variations in stratospheric ozone concentration measured from space explain 85% of changes in the daily UV-B dose. It was expected that decrease of 50 Du in stratospheric ozone cause increase of 24.1% in daily UV-B dose in this study.

• Journal of the Korean Vacuum Society
• /
• v.13 no.1
• /
• pp.39-45
• /
• 2004

Ultraviolet-nanoimprint lithography (UV-NIL) is a promising method for cost-effectively defining nanoscale structures at room temperature and low pressure. A 5${\times}$5${\times}$0.09 in. quartz stamp is fabricated using the etch process in which a Cr film was employed as a hard mask for transferring nanostructures onto the quartz plate. FAS(Fluoroalkanesilane) is used as a material for anti-adhesion surface treatment on the stamp and a thin organic film to improve adhesion on a wafer is formed by spin-coating. The low viscosity resin droplets with a nanometer scale volume are dispensed on the whole area of the coated wafer. The UV-NIL experiments have been performed using the EVG620-NIL. 370 nm - 1 m features on the stamp have been transferred to the thin resin layer on the wafer using the multi-dispensing method and UV-NIL process. We have measured the imprinted patterns and residual layer using SEM and AFM to evaluate the potential of the process.

• The Korean Journal of Malacology
• /
• v.29 no.1
• /
• pp.23-32
• /
• 2013

The purpose of this study is to evaluate the effects of oil dispersant and ultraviolet (UV) radiation on the toxicity of crude oil. The toxicity of water-accommodated fraction (WAF) and chemically enhanced water-accommodated fraction (CEWAF) of Hebei Spirit crude oil was investigated in the embryo of the Manila clam, Ruditapes philippinarum with- and without ultraviolet radiation. The WAF and CEWAF with- and without UV radiation affected significantly the embryonic development of R. philippinarum. The EC50s of WAF without UV, WAF with UV, CEWAF without UV, and CEWAF with UV were 2.82, 0.79, 1.60, and 0.45 g/L, respectively. CEWAF was 1.6 times more toxic than WAF. UV radiation increased crude oil toxicity to 3.6 times for both WAF and CEWAF. The oil dispersant and UV radiation did not affect the acute toxicity to the embryo but retarded the period of embryonic development up to 26%. R. philippinarum proved to be a sensitive species to reflect the toxic effects of oil spill combined with oil dispersant and UV radiation. It is suggested that the chemical analyses on the WAF and CEWAF is important for the identification and quantitative explanation of the phototoxic compounds in crude oil.

• Journal of Korean Society of Water and Wastewater
• /
• v.33 no.6
• /
• pp.469-480
• /
• 2019

This study was conducted to evaluate the degradation and mineralization of PPCPs (Pharmaceuticals and Personal Care Products) using a CBD(Collimated Beam Device) of UV/H₂O₂ advanced oxidation process. The decomposition rate of each substance was regarded as the first reaction rate to the ultraviolet irradiation dose. The decomposition rate constants for PPCPs were determined by the concentration of hydrogen peroxide and ultraviolet irradiation intensity. If the decomposition rate constant is large, the PPCPs concentration decreases rapidly. According to the decomposition rate constant, chlortetracycline and sulfamethoxazole are expected to be sufficiently removed by UV irradiation only without the addition of hydrogen peroxide. In the case of carbamazepine, however, very high UV dose was required in the absence of hydrogen peroxide. Other PPCPs required an appropriate concentration of hydrogen peroxide and ultraviolet irradiation intensity. The UV dose required to remove 90% of each PPCPs using the degradation rate constant can be calculated according to the concentration of hydrogen peroxide in each sample. Using this reaction rate, the optimum UV dose and hydrogen peroxide concentration for achieving the target removal rate can be obtained by the target PPCPs and water properties. It can be a necessary data to establish design and operating conditions such as UV lamp type, quantity and hydrogen peroxide concentration depending on the residence time for the most economical operation.

• Journal of IKEEE
• /
• v.19 no.1
• /
• pp.80-86
• /
• 2015

There are many studies and products using a test paper impregnated with chemical solution can react with ozone. The color of a test paper can indicate the concentration of ozone. The purpose of this research is to design and manufacture a system using ultraviolet light source to measure the ozone density. This new technique is based on the characteristic of decomposition from ozone into oxygen under ultraviolet light. We used two sources of ultraviolet light including UV lamp and UVLED to determine the decomposition of ozone. This system is built with the electronic components, sensors and sealed pump tube to measure the ozone density in units of $g/cm^3$,ppm,ppb. In this paper,, we present some initial results of measuring the ozone density from ozone generator after completing inspection for safety.

• Journal of Conservation Science
• /
• v.27 no.2
• /
• pp.191-199
• /
• 2011

A study was done to compare the properties of artificially deteriorated silk with ultraviolets for reinforcing of loss area of paintings on silk. Deteriorated surface of raw silk irradiated by long-wavelength ultraviolet(UV-A) than short-wavelength ultraviolet(UV-C) was similar to naturally aged raw silk. UV-A irradiation raw silk was slowly decreased in tensile tenacity and elongation and lowered in yellowness index than that of UV-C. Water content of UV-A irradiation raw silk than that of UV-C was higher. UV-A irradiation raw silk had no problem in dyeing and inpainting for conservation because of low yellowness index. UV-C irradiation raw silk was brittle, but UV-A irradiation raw silk was seemed to tough and similar to naturally aged raw silk. Korean painting conservator estimated that UV-A irradiation raw silk was more proper for reinforcing of loss area of paintings on silk than that of UV-C.

• Journal of Sensor Science and Technology
• /
• v.28 no.3
• /
• pp.152-156
• /
• 2019

An ultraviolet (UV) image sensor is an extremely important optoelectronic device used in scientific and medical applications because it can detect images that cannot be obtained using visible or infrared image sensors. Because photodetectors and transistors are based on different materials, conventional UV imaging devices, which have a hybrid-type structure, require additional complex processes such as a backside etching of a GaN epi-wafer and a wafer-to-wafer bonding for the fabrication of the image sensors. In this study, we developed a monolithic GaN UV passive pixel sensor (PPS) by integrating a GaN-based Schottky-barrier type transistor and a GaN UV photodetector on a wafer. Both individual devices show good electrical and photoresponse characteristics, and the fabricated UV PPS was successfully operated under UV irradiation conditions with a high on/off extinction ratio of as high as $10^3$. This integration technique of a single pixel sensor will be a breakthrough for the development of GaN-based optoelectronic integrated circuits.

• International Journal of Industrial Entomology and Biomaterials
• /
• v.17 no.1
• /
• pp.121-124
• /
• 2008

The caspase family proteins play an important role in programmed cell death (apoptosis). To date, the expression profiles of the caspase family genes in Bombyx mori (Bm) are poorly known. In this study, we examined the expression profiles of two novel Bm caspase family genes (ice-2 and ice-5), the potential change of the mitochondrial membrane and the morphology in Bm cells after stimulation of ultraviolet (UV) irradiation. The results showed the potential change of the mitochondrial membrane occurred at 5 hours after UV irradiation treatment. Analysis of fluorescent quantitative RT-PCR demonstrated that both the ice-2 and ice-5 might be involved in UV induced apoptosis in Bm cells. Notably, after UV irradiating, expression pattern of ice-2 and ice-5 were remarkably different. The ice-2 gene was highly expressed at two time points, 0.5 and 5 hours after UV stimulating, while the expression level of ice-5 only peaked at 5 hours after UV stimulating. It indicated that apoptosis induced by UV irradiation was involved in the mitochondrial pathway and the two isoforms of Bm ice may act but play different role during the apoptosis of Bm cells.

• Current Optics and Photonics
• /
• v.2 no.4
• /
• pp.303-307
• /
• 2018

We propose a simple ultraviolet (UV) sensor consisting of a conventional single-mode optical fiber capped with an azobenzene-moiety-containing polymer. The UV light changes the dimensions of the azobenzene polymer, as well as the refractive index of the material. Incident light with a wavelength of 1550 nm was reflected at the fiber/polymer and polymer/air interfaces, and interference of the reflected beams resulted in spectral interference that shifted the wavelength by 0.78 nm at a UV input power of $2.5mW/cm^2$. The UV sensor's response to wavelength is nonlinear and stable. The response speed of the sensor is limited by detection noise, which can be improved by modifying the insertion loss of the UV sensor and the signal-to-noise ratio of the detection system. The proposed compact UV sensor is easy to fabricate, is not susceptible to electromagnetic interference, and only reacts to UV light.

• Elastomers and Composites
• /
• v.33 no.5
• /
• pp.363-369
• /
• 1998

Photografting reaction onto styrene-butadiene rubber (SBR) as a function of monomer concentration, irradiation time and carbon black content has been studied using ultraviolet (UV). Acrylamide and benzophenone are used as monomer and photoinitiator, respectively. FT-IR ATR and static contact angle analysis using distilled water are used to measure the graft ratio of acrylamide onto SBR surface. Graft ratio of acrylamide increases with acrylamide concentration and irradiation time and contact angle tends to decrease with increasing graft ratio. It is observed that graft ratio increases with carbon black content.