• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.45 no.3
• /
• pp.19-26
• /
• 2008

We propose a selective detection scheme based on pulse repetition considering the BER (Bit Error Rate) performance and complexity of coherent IR-UWB (Impulse Radio-Ultra Wide Band) systems. To take system complexity into account, the proposed scheme transmits the UWB signals by pulse repetition at the transmitter, like conventional PRC (Pulse Repetition Coding). However, to effectively improve BER performance of the system, the proposed scheme performs selective detection by estimating the SNR (Signal-to-Noise Ratio) of the received pulse-repeated signal at the UWB receiver. Hence, the proposed scheme effectively improves BER performance of the coherent IR-UWB systems without increasing system complexity, as compared to the conventional PRC algorithm.

• Journal of Advanced Navigation Technology
• /
• v.25 no.5
• /
• pp.357-362
• /
• 2021

UWB(ultra wide band) communication systems employ short pulses to transmit information which spreads the signal energy over a very wide frequency spectrum. Received signal-to-noise power ratio of UWB signals is an important factor in determining the accuracy of a positioning system. As the signal to noise power ratio gets higher, positioning errors decrease since noise becomes less effective. Calculation of signal to noise power ratio as a function of communication distance provides important guidelines for the system design. And the performance of a positioning system also depends heavily on the channel model. As a result of the analysis, it was found that the performance of the received signal to noise power ratio according to the communication distance was better in the LOS channel environment than in the Non LOS(line of sight) channel environment. And as the symbol interval of the preamble signal increases at a specific communication distance, the channel capacity of the UWB system increases.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.30 no.12C
• /
• pp.1208-1213
• /
• 2005

Recently, ultra wideband(UWB) is emerging as a solution for the IEEE 802.15.3a(TG3a) standard because of its potential to enable high-speed data transmission with low power consumption. One of the submitted systems as s PHY proposal is M-ary biorthogonal keying direct sequence ultra wideband(M-BOK DS-UWB). In this paper, adaptive multiple antenna transmission scheme for achieving high capacity and reliability in M-BOK DS-UWB is proposed. This proposed system can overcome the limitations of STBC and V-BLAST, such as bit error rate performance and throughput.

• Journal of Advanced Navigation Technology
• /
• v.10 no.3
• /
• pp.268-275
• /
• 2006

The rapid proliferation of in-home and office information applications and services is driving the need for new wireless technologies enabling wideband short range multimedia communications. Due to the growing demand for higher quality media and faster wireless connections, several IEEE standardization groups are considering very high data rate alternatives physical layer(s) for Wireless Personal Area Network (WPAN). The Ultra Wide Band (UWB) multiple access technology based on very narrow pulse transmission, is one viable candidate for these applications providing very high bit rates services, low power consumption and accurate positioning capability. In this paper we provide a methodology to evaluate the UWB system BER performance in UWB wireless fading networks with power controlled UWB devices are considered. Results can be used to analyze the performance of a given network topology and to provide useful design ideas for an UWB home sensor network.

• Proceedings of the IEEK Conference
• /
• 2004.06a
• /
• pp.305-308
• /
• 2004

In this paper, we analyze system level and link level performance for MB-OFDM UWB system. we propose physical layer model of MB-OFDM UWB system in MBOA. For this analysis, Base-band channel model from IEEE 802.15 3a was adopted. we considered the channel index parameter to select any one of 100 distinct realizations provided by the IEEE working group. Our experimental results indicate BER values according to Es/No.

• Journal of Korea Multimedia Society
• /
• v.22 no.9
• /
• pp.1011-1019
• /
• 2019

In this paper, we propose a system that can more precisely identify and monitor the position of the tool used in the assembling workplace such as automobile production. The proposed positioning monitoring system is a combination of UWB communication module and MEMS IMU sensor. Since UWB does not need modulation and demodulation function and has low power density, UWB is widely used in indoor positioning field. However, it may cause positioning error due to errors in RF transmission and reception process, which may cause positioning accuracy. Therefore, in this paper, we propose an algorithm that uses IMU as an auxiliary means to compensate for errors that may occur in positioning using only UWB. The tag and anchor of UWB module measure the transmission / reception time by transmitting signals to each other and then estimate the distance between tag and anchor. The MEMS IMU sensor serves to provide positioning calibration information. The tag, which is a mobile node and attached to a moving tool, measures the three-dimensional position of the tool and transfers the coordinate data to the anchor. Thus, it is possible to confirm whether or not the specific tool is properly used according to the prescribed regulations.

• Journal of Communications and Networks
• /
• v.5 no.4
• /
• pp.365-373
• /
• 2003

This paper investigates the performance of M-ary pulse position modulation (PPM) multiuser ultra-wideband (UWB) communication systems in terms of symbol error rate (SER) over fading and additive white Gaussian noise (AWGN) channel. Based on Gaussian approximation for the multiple access interference, an expression for the signal-to-noise ratio (SNR) is derived for the UWB system. This expression is used to derive exact SER expressions for coherent UWB receivers. The effect of pulse selection on the SER of multiuser UWB system is studied. In addition to rectangular pulse, the 2nd derivative Gaussian waveform and Rayleigh pulses were considered. We show that the system capacity and/or SER performance can be significantly increased by using the monocycle pulse in fading channels.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.4 no.3
• /
• pp.258-272
• /
• 2010

The low-rate (LR) UWB is a promising technology for the ubiquitous sensor network (USN) due to its extremely low power consumption and simple transceiver implementation. However the limited communication range is a bottleneck for its widespread use. This paper deals with a new frame structure of class 4 active RFID multi-hop relay system based on ISO/IEC 18000-7 standard integrating with IEEE 802.15.4a LR-UWB PHY layer specification, which sets up a connection to USN. As a result of the vital importance of the coverage and throughput in the application of USN, further we analyze the performance of the proposed system considered both impulse radio UWB (IR-UWB) and chirp spread spectrum (CSS). Our simulation results show that the coverage and throughput are remarkably increased.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.29 no.2C
• /
• pp.187-198
• /
• 2004

In this paper, we analyze the performance of BPM (Bi-Phase Modulation) UWB (Ultra Wide Band) multiple access system using PN (Pseudo Noise) code based time hopping sequence in indoor wireless channels. In particular, we compare BPM UWB multiple access system with PPM (Pulse Position Modulation) UWB multiple access system in terms of signalling and demodulation schemes. Moreover, we analytically evaluate the performance of these UWB systems by deriving the bit error rate expressions under the assumption that pulse energy and data transmission rate are identical for both systems. Simulation results in additive white Gaussian noise and realistic indoor multipath wireless channels show that the performance of BPM scheme is approximately 1 dB better than that of PPM scheme. However, the performance discrepancy becomes negligible as the number of users increases.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.29 no.11C
• /
• pp.1498-1509
• /
• 2004

In this paper, we evaluate the performance of a noncoherent OOK (On-Off Keying) UWB (Ultra Wide Band) system based on power detection with noise power calibration and noise power windowing for ubiquitous sensor network applications in typical indoor wireless channels. Utilizing noise power calibration and noise power windowing, the current noise information can be initially or adaptively provided to determine suitable detection threshold value for signal demodulation. Simulation results show that the noncoherent OOK UWB system using noise power calibration achieves good BER (Bit Error Rate) performance which is favorably comparable to that of the system using the ideal adaptive threshold, while maintaining simple receiver structure. However, despite the serious loss of the data transmission rate, the performance improvement by noise power windowing is not so remarkable. furthermore, these performance results are similarly maintained in BEE 802.15 Task Group 3a UWB indoor channel model, and it is also revealed that the BER performance can be significantly improved by increasing the pulse repetition rate.