• International Journal of Internet, Broadcasting and Communication
• /
• v.15 no.1
• /
• pp.145-149
• /
• 2023

In this study, the spectrum changes induced from the doping of phosphor micro particles in a twist nematic liquid crystal cell was observed. The experimental results show that the achromatic transmission can be observed with a proper driving condition, which may be applied to the design of an achromatic liquid crystal device. In this paper, we tried to figure out the spectrum changes induced from the doping of phosphor micro particles. The experimental result of the phosphor powder doped twist nematic liquid crystal cell shows that the achromatic transmission and the wavelength linearly dependent transmission both can be observed with some proper driving conditions, respectively. The result is useful on developing an achromatic liquid crystal device and it can be applied for Vihicle lamp.

• Proceedings of the Optical Society of Korea Conference
• /
• 2009.02a
• /
• pp.347-348
• /
• 2009

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.17 no.2
• /
• pp.207-211
• /
• 2004

We have performed computer simulation to obtain a globa1 optimization of power consumption and viewing angle characteristic of reflective twisted nematic (R-TN) mode liquid crystal display (LCD) with sin81e polarizer and λ/4 plate. Our studies shout that with increasing the twist angle, a steepness of reflectance-voltage curve increase, operation voltages decreases, the region where contrast ratio (CR) greater than 10 increases but the reflectance of the white state starts to decrease at above the twist angle of 75$^{\circ}$. Above the twist angle of 90$^{\circ}$, the R-TN mode LCD shows the most favorable combination of low consumption and good viewing angle characteristic.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2007.08a
• /
• pp.290-292
• /
• 2007

A twisted nematic type liquid crystal electro-optic modulator (TN-LC modulator) was developed. The modulator used single polarizer and the reflection on-off ratio was maximized by optimization of twist angle and retardation of liquid crystal cell. The TNLC modulator shows better sensitivity and response time than conventional liquid crystal modulator.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2008.10a
• /
• pp.292-294
• /
• 2008

We have developed new reflective LCD for Mixed twist nematic LC mode with high quality image. We have found out an optimal twist angle of LC and optical film's axis by simulation. Also we measured electro-optic characteristics for new design panel. As a result, high reflectance and wide viewing angle characteristics were achieved.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2004.05a
• /
• pp.206-209
• /
• 2004

We investigated response characteristics of liquid crystal display(LCD) with different operating mode of nematic liquid crystals (NLCs) such as $45^{\circ}$twist nematic (TN), $67.3^{\circ}$TN and ECB(electrical controlled birefringence) on a rubbed polyimide (PI) surface. The three kinds of LCD operating mode obtain stable EO performance. Low transmittances of the $45^{\circ}$TN and $67.3^{\circ}$TN cell on the rubbed PI surface were achieved by using low cell gap d. The fast response time of ECB cell among the three kinds of LCD operating mode was measured.

• Korean Journal of Optics and Photonics
• /
• v.19 no.3
• /
• pp.161-168
• /
• 2008

We propose a novel bistable nematic liquid crystal cell, which has a dual-frequency liquid crystal material and pixel-isolating polymer wall formed by an anisotropic phase separation of a mixture of liquid crystals and UV-curable pre-polymers. The proposed cell has two stable states of left- and right-handed ${\pi}$-twist. The switching between the two states is achieved by using a sequential waveform of low and high frequencies. A transmissive bistable liquid crystal display is designed, which achieves high contrast ratio by using the proposed cell and optical films.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2009.10a
• /
• pp.502-504
• /
• 2009

We demonstrate a pixel-isolated bistable twist-splay namatic (PI-BTSN) liquid crystal (LC) cell which has two stable states of splay and ${\pi}$-twist. Each state is stabilized by a multi-dimensional anchoring effect of pixel-isolating polymer walls without any chiral additives. Polymer walls are formed around the pixel region by anisotropic phase separation between LCs and reactive mesogens. Switching between the two states is archived by using vertical and horizontal electric fields. The memory mode of the fabricated LC cell has shown infinity memory time.

• Journal of Information Display
• /
• v.12 no.1
• /
• pp.11-15
• /
• 2011

An inverse-twisted-nematic (ITN) transflective (TRF) liquid crystal (LC) display, where two imprinted optical films (IOFs) with surface microstructures are embedded was developed. One of the IOFs serves as an in-cell patterned retarder with multioptic axes, and the other behaves as a viewing-angle enhancement film. In the presence of an applied voltage, the surface microstructures on the IOFs provide the spontaneous twist of the LC from a vertically aligned state to a $90^{\circ}$ twisted-nematic (TN) state in the transmissive part, and to a $45^{\circ}$ TN state in the reflective part. The developed ITN TRF LC display exhibits high transmission and reflectance, fast response, and wide-viewing characteristics, along with achromaticity.

• Current Optics and Photonics
• /
• v.2 no.2
• /
• pp.185-194
• /
• 2018

Ultra-small optical anisotropy of a rubbed polyimide (PI) alignment layer is quantitatively characterized using the improved reflection ellipsometer. Twisted nematic (TN) cells are fabricated using the rubbed PIs of known surface anisotropy as alignment layers. Distribution of liquid crystal (LC) molecules in the TN cell is characterized using transmission ellipsometry. The retardation of the rubbed PI surface increases as rubbing strength increases. The tilt angle of the optic axis of the rubbed PI surface decreases as rubbing strength especially as the angular speed of the rubbing roller increases. Pretilt angle of LC molecules in the TN cell shows strong correlation with tilt angle of the optic axis of the rubbed PI surface. Both the apparent order parameter and the effective twist angle of the LC molecules in the TN cell decrease as the pretilt angle of LC molecules increases.