• 한국정보통신학회:학술대회논문집
• /
• 한국해양정보통신학회 2000년도 추계종합학술대회
• /
• pp.568-572
• /
• 2000

This paper describes the experimental results of a transient impedance characteristics of grounding rods to a square pulse and standard lightning impulse current. The test were performed on single grounding rod($\phi$ 10mm, 1m) and triple-grounding rods( $\phi$ 10mm, 1m) of equilateral triangles with 5m spacing. For measurements of transient impedance, a pulse generator which can produce square wave of 30ns rise time and 20U Pulse duration was designed and fabricated. In the experiment, transient impedance of the grounding systems have been investigated from the recorded potential and current waveforms. The results showed that the value of the transient impedance is quite higher than the stationary resistance, and provide useful information for the value of a grounding system considered transient characteristics under a high frequency condition such as lightning stokes and ground-fault.

• 한국지반환경공학회 논문집
• /
• 제6권4호
• /
• pp.59-64
• /
• 2005

근래 건설현장에서의 연약처리문제는 자주 대두되는 문제이며, 이러한 연약지반을 개량하기 위한 고압분사공법은 없어서는 아니될 필수적인 공법이지만 적용에 있어서 보강효과미흡, 지하수 및 지반오염문제 등 해결해야할 선결문제가 있다. MJM(Mortar Jet Method)공법은 주입재료로서 기존의 시멘트 외에 모래를 혼합하여 획기적 강도증대가 가능하며 3중관으로서, 슬라임 배출을 용이하게 하는 노즐을 부착시켜 치환율을 높여 전단면이 균질한 주상형고결체를 형성시킬 수 있고 특히, 해성점토 지반에서 기초말뚝으로서의 활용이 기대된다. 본 연구에서는 MJM공법의 실내 시험 및 현장시험시공을 통해 현장 적용성을 검토하였다.

• Journal of electromagnetic engineering and science
• /
• 제14권1호
• /
• pp.9-14
• /
• 2014

This paper discusses the resonant characteristics, such as the resonant frequencies and Q factors, as well as tuning methods of the resonant frequency of the triple-mode dielectric resonators, for their possible application to compact bandpass filters for mobile communication systems. The resonators include spheres and cylindrical rods that can be applied to compact bandpass filters. These high Q ceramic resonators can replace the conventional coaxial type resonators, which are large sized and also have relatively low Q values. Both simulated and measured results show that the Q values of the sphere and rod reach 27,000 and 24,000, respectively. Decoupling of degenerate modes is also briefly discussed.

• 한국정보통신학회논문지
• /
• 제5권1호
• /
• pp.133-143
• /
• 2001

본 논문은 직각파 및 뇌충격진류에 대한 봉상접지각의 과도임피던스 특성을 정상접지지항과 비교.분석하였다. 접지계는 단일$(\Psi10[mm], 1[m])$과 5[m]의 간격을 두고 서로 연접한 3연접 봉상접지극으로 구성하였으며, 과도 임피던스 특성을 분석하기 위하여 상승시간 30[ns], 펄스폭 $20[\mus]$의 직각파전류 발생장치를 설계 제작하였다. 실제 낙뢰에 의한 접지임피던스의 변화를 관찰하기 위하여, 국제규격 ANSI/IEEE, IEC에 규정되어 있는 뇌충격전류를 인가하여 이에 따른 특성변화를 측정.분석하였다. 접지계로 유입된 과도전류는 접지계의 전위를 상승시키며, 이 때의 전위상승과 유입전류의 비로써 접지임피던스를 산출하며, 뇌격전류에 대한 경제적인 보호 수준을 평가.예측하기 위하여 임피던스 파라미터를 측정결과로부터 산출하였다. 또한 연접에 따른 접지임피던스의 감소와 접지리드선이 미치는 영향도 분석하였다.

• 유체기계공업학회:학술대회논문집
• /
• 유체기계공업학회 2006년 제4회 한국유체공학학술대회 논문집
• /
• pp.445-448
• /
• 2006

The effects of surface roughness on a spatially-developing turbulent boundary layer (TBL) were investigated by performing direct numerical simulations of TBLs over rough and smooth walls. The Reynolds number based on the momentum thickness was varied in the range $Re_{\theta}=300{\sim}1400$. The roughness elements used were periodically arranged two-dimensional spanwise rods, and the roughness height was $k=1.5{\theta}_{in}$, which corresponds to $k/{\delta}=0.045{\sim}0.125$. To avoid generating a rough wall inflow, which is prohibitively difficult, a step change from smooth to rough was placed $80{\theta}_{in}$ downstream from the inlet. The spatially-developing characteristics of the rough-wall TBL were examined. Along the streamwise direction, the friction velocity approached a constant value and a self-preserving form of the turbulent stress was obtained. Introduction of the roughness elements affected the turbulent stress not only in the roughness sublayer but also in the outer layer. Despite the roughness-induced increase of the turbulent stress in the outer layer, the roughness had only a relatively small effect on the anisotropic Reynolds stress tensor in the outer layer. Inspection of the triple products of the velocity fluctuations revealed that introducing the roughness elements onto the smooth wall had a marked effect on vertical turbulent transport across the whole TBL. By contrast, good surface similarity in the outer layer was obtained for the third-order moments of the velocity fluctuations.