• Journal of Advanced Navigation Technology
• /
• v.7 no.2
• /
• pp.191-198
• /
• 2003

In this paper, we analyze the performance of transmit diversity techniques which are the key technologies of the third generation mobile communication systems. Transmit diversity techniques adopted on the specification of 3GPP are classified into open-loop and closed-loop methods depending on the existence of feedback data. In WCDMA systems, the DPCH signal is space-time coded to provide a mobile station with diversity. Computer simulations shall be performed to analyze and compare their performance considering the effect of mobile speed, number of path, power control, and delay of feedback with the WCDMA slot format #13 for application to WCDMA systems.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.29 no.6A
• /
• pp.607-613
• /
• 2004

The future wireless communication systems will use spatial multiplexing with Multiple Input Multiple Output(MIMO) system to take advantage of high spectral efficiencies. In such systems it will be desirable to select a sub-set of available transmit or receive antennas to reduce cost and complexity. In this paper we propose a novel transmit antenna selection schemes for MIMO systems which is suitable for multipath environment. The proposed transmit antenna selection schemes offer better BER performance than that of MIMO systems without antenna selection and with traditionally proposed antenna selection schemes.

• The KIPS Transactions:PartC
• /
• v.12C no.7 s.103
• /
• pp.1025-1030
• /
• 2005

Cooperative communications among users in multiple access wireless environments is an efficient way to obtain the powerful benefits of multi-antenna systems without the demand for physical arrays. This paper proposes a solution to optimize the weights of partnering users' signals for the minimum error probability at the output of maximum likelihood (ML) detector under the transmit power constraints by taking advantage of channel state information (CSI) feedback from the receiver to the transmitter. Simulation programs are also established to evaluate the performance of the system under flat Rayleigh fading channel plus AWGN (Additive White Gaussian Noise).

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.46 no.5
• /
• pp.104-108
• /
• 2009

In this paper, we investigate the performance of ARQ-aided downlink Time Switched Transmit Diversity (TSTD) in the WCDMA LCR-TDD system. Proposed TSTD system applies the ARQ scheme in which the receiver sends the response signal (ACK or NACK signal) to the transmitter and predicts the channel condition based on response signal after receiver checks the error, then it re-sends data. Simulation results demonstrate that the proposed TSTD scheme yields about 5.5dB performance gain, compared with the conventional TSTD in term of the frame error rate(FER) for a mobile speed of 3km/h and an FER value of 1%. In addition, 7% of throughput gain is shown when Eb/N0=7dB.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.37 no.8A
• /
• pp.612-617
• /
• 2012

Two phase control (PC) schemes using limited feedback are proposed for multiple-input single-output (MISO) systems. One PC scheme cophases channel gains with respect to the first transmit antenna channel gain, and the other PC scheme cophases channel gains by positioning all the channel gains into a fixed sector. We analyze the combined channel gain for both PC schemes, and find that the PC scheme that cophases with respect to the first transmit antenna channel gain provides 1.2 dB power gain over an orthogonal space-time block code (OSTBC) when the number of transmit antennas is four and the number of feedback bits is three.

• Journal of Korea Society of Digital Industry and Information Management
• /
• v.8 no.4
• /
• pp.115-120
• /
• 2012

In multi-user multi-input multi-output (MU-MIMO) system, zero forcing beamforming (ZFB) is regarded as a realistic solution for transmitting scheme due to its low complexity and simple structure. However, ZFB shows a significant performance degradation when channel matrix has large condition number. In this case, the largest singular value of the channel inversion matrix has a dominant effect on transmit power. In this paper, we propose a perturbation method for reducing an effect of the dominant singular value. In the proposed algorithm, channel inverse matrix is first decomposed by SVD for the transmit signal to be expressed as a combination of singular vectors. Then, the transmit signal is perturbed to reduce the coefficient of the singular vector corresponding to the largest singular value. When a number of transmit antennas is 4, the simulation results of this paper shows that the proposed method shows 8dB performance enhancement at 10-3 uncoded bit error rate (BER) compared with conventional ZFB. Also, the simulation results show that the proposed method provides a comparable performance to Tomlinson-Harashima Precoding (THP) with much lower complexity.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.14 no.4
• /
• pp.330-335
• /
• 2003

PTS（partial transmit sequences) has been widely studied for reducing the PAPR of OFDM signal, since it is flexible and any spectral regrowth may not occurred. A drawback of this PTS method should transmit the side information of the optimized phase factor for correct OFDM symbol recovery. A new idea of this paper is to insert the feedback type side information in the conventional PTS method. The simulation results show that the proposed scheme has the same PAPR reduction performance as the conventional PTS without side information and OFDM data are correctly recovered to get the required BER. Also, this method is independent of the channel characteristics and can be easily realized.

• The Journal of the Acoustical Society of Korea
• /
• v.21 no.7
• /
• pp.606-613
• /
• 2002

In this paper we applied a transmit beamforming technique to the underwater acoustic communication system for high rate data transmission. A prototype transmit system was designed and implemented with the general purpose DSP processor and multiple digital-to-analog converters. The performances of the implemented system were evaluated by the experiment in water tank. In order to simplify the procedure the channel coding and equalizer were omitted. And the simplest OOK (On-Off Keying) technique in digital communication methods was applied. The experimental result shows that the transmission data rate is higher about 3 times in the case of 5 hydrophone transmitting may than 1 hydrophone transmitter at bit error rate 10/sup -2/. We verified that the maximum data rate was 400 bps for speech signal transmission in water tank.

• Journal of electromagnetic engineering and science
• /
• v.11 no.1
• /
• pp.34-41
• /
• 2011

This paper proposes a systematic design for a precoding codebook for a transmit-ing space-division multiple access (TN-SDMA) sharing spectrum with existing fixed wireless service (FWS). Based on an estimated direction angle of a victim FWS system, an interfering transmitter adaptively constructs a codebook, forming a transmit in the direction angle, while satisfying orthogonal beamforming constraints. Sum throughput results indicate that the throughput loss of TN-SDMA relative to a practical SDMA, called per user unitary and rate control ($PU^2RC$), is lower at larger number of transmission antennas, lower signal-to-noise ratio, or a smaller number of users. In particular, a small loss (12% throughput loss) is provided for practical system parameters. Spectrum sharing results confirm that TNSDMA efficiently shares spectrum with FWS systems by reducing protection distance to more than 66 %. Although a TN-SDMA system always has lower throughput compared to $PU^2RC$ in non-coexistence scenarios; it offers an intriguing opportunity to re-use a spectrum already allocated to an FWS.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2015.10a
• /
• pp.159-162
• /
• 2015

In this paper, implement a baby monitor using the arduino for deaf and Visually Impaired. The proposed baby monitors are divided into measuring part & transmit part and linked with the application. The measuring part consists of a sound volume sensor, a transmit part consists of a bluetooth module. The measuring part and transmit part are controlled by the Arduino board. Measure the value of the sound by the sound sensor and delivers value to the arduino board. The measured value is sent to the application by the bluetooth module of transmit part. The application determines the received value and control the smart phone, and outputs the light from the sound and vibration for the value. It showed that the proposed baby monitor and an application is correctly operating in accordance with the value.