• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.21 no.7
• /
• pp.734-743
• /
• 2010

In this paper, we analyzed the EMP coupling for the nonuniform transmission lines, such as twisted cables, using the chain matrix algorithm and the multi-conductor analysis. The BLT method is widely used for the EMP coupling analysis of the transmission line, however, it is difficult to apply to the nonuniform transmission lines. In order to analyze the EMP coupling of nonuniform transmission lines, the whole nonuniform transmission line is divided into incremental uniform line sections of the finite numbers, and the coupling in each small sections is now summed up to get the EMP coupling effect of the entire nonuniform transmission line. To verify the proposed EMP coupling analysis method, the result of the EMP coupling simulation is compared with the solution of BLT equations for a uniform transmission line case. The proposed method is applied to the twisted cable over ground in case of being illuminated by the HEMP in order to analyze the EMP coupling.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.21 no.8
• /
• pp.1589-1596
• /
• 2017

In synchronous secure communications, a synchronization signal is transmitted over the same channel where ciphertext is transmitted for cryptographic synchronization between an encryptor and a decryptor, so, it causes data rate lowering and transmission delay for plain communication. Especially, in poor environments such as wireless channels and so on, since secure communications require a periodic resynchronization protocol, synchronization signal transmission method can dominate its quality. In this paper, we proposed a new synchronization signal transmission method without additional bandwidth as well as resynchronization protocol based on it. We embeded a synchronization signal as a watermark in a transmission image and restored it from a detected watermark in the decryptor. Experimental results of image have demonstrated that the proposed synchronization signal transmission method using watermarking is efficient in transmission rate and can support reliable synchronization detection.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.16 no.4
• /
• pp.605-610
• /
• 2021

Wireless charging method using a laser is considered as the most efficient method at a long distance of the wireless charging method. Combining long-range laser wireless charging technology with wireless communication technology will make it possible to use it for a variety of applications. Accordingly, this paper shows the results of research and experiments on wireless charging and wireless communication simultaneously based on a laser. This technique uses a laser as a light source for E/O(: Electric-to-Optical) conversion at the transmitter for optical wireless power transmission. In the experimental results, the optical power transmission using a 100 mW laser transmitter and a solar cells receiver showed a DC-to-DC efficiency of 1.9 %, wireless optical communication showed a transmission speed of up to 90 kbps when the transmission distance is 15 m.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.24 no.5
• /
• pp.623-629
• /
• 2020

In this paper, a multiple transmission communication system employing ranging based transmission timing adjustment capability is proposed. In addition, a decision feedback equalizer with the use of combinations of soft decision and hard decision adequate to the proposed multiple transmission communication system is also proposed. The proposed ranging based transmission timing adjustment capability makes the received signals from the multiple transmission points centered on the different symbol timing boundaries. The decision making method for the inputs to the proposed decision feedback equalizer is adaptively selected between soft decision and hard decision as per channel conditions like SNR. The performance of the proposed method had been analyzed through the simulation under the fading channel environments and compared with the previous methods. The simulation results showed performance improvement of the proposed method over the existing ones without noticeable increments in complexities.

• Structural Engineering and Mechanics
• /
• v.48 no.4
• /
• pp.435-453
• /
• 2013

A new computational approach for the rain load on the transmission tower is presented to obtain the responses of system subjected to the wind and rain combined excitations. First of all, according to the similarity theory, the aeroelastic modeling of high-voltage transmission tower is introduced and two kinds of typical aeroelastic models of transmission towers are manufactured for the wind tunnel tests, which are the antelope horn tower and pole tower. And then, a formula for the pressure time history of rain loads on the tower structure is put forward. The dynamic response analyses and experiments for the two kinds of models are carried out under the wind-induced and wind-rain-induced actions with the uniform and turbulent flow. It has been shown that the results of wind-rain-induced responses are bigger than those of only wind-induced responses and the rain load influence on the transmission tower can't be neglected during the strong rainstorm. The results calculated by the proposed method have a good agreement with those by the wind tunnel test. In addition, the wind-rain-induced responses along and across the wind direction are in the same order of response magnitude of towers.

• The Journal of the Acoustical Society of Korea
• /
• v.39 no.6
• /
• pp.585-591
• /
• 2020

The adaptive transmission techniques are efficient method for underwater acoustic communication to improve the system efficiency by varying transmission parameters according to channel conditions. In this paper, we construct four transmission modes with different data rates using the convolutional codes, which is freely set to size of information bits. On the receiver side, one critical component of adaptive system is to find which mode has best performance. In this paper, we proposed threshold detection algorithm to decide appropriate mode and applied turbo equalization method based on BCJR decoder in order to improve performance. We analyzed the performance of four modes based on threshold detection algorithm through the lake experiment.

• IEIE Transactions on Smart Processing and Computing
• /
• v.6 no.1
• /
• pp.39-46
• /
• 2017

In this paper, we propose an integer frequency offset estimation and compensation method based on PLC preamble correlation in DOCSIS 3.1 Downstream system. The proposed method determines the PLC preamble subcarrier location recovered from PLC data and the one obtained from PLC preamble correlation. We showed the performance of PLC preamble detection in the received signal through the maximum value detection of PLC preamble correlation. Thus we can estimate and compensate for the integer frequency offset by computing the difference of PLC subcarrier locations.

• Proceedings of the KIEE Conference
• /
• summer
• /
• pp.497-499
• /
• 2004

Due to a typhoon named MAEMI on Sep12, 2004, 7 transmission towers collapsed and 3 were damaged in the Gyeongnam and Busan areas. These caused long-term black-outs in Goeje-do. When a transmission tower collapses or is damaged, Construction will take more than 2 months and this will be accompanied by long-term black-outs. Therefore a temporary iron pole is used in such emergencies. Current temporary rehabilitation angle steel iron Pole consistes of around 800 members, 2,800 bolts and it takes about 5 days to construct a temporary transmission line. Consiquently wide black-outs occur during the construction of the temporary transmission line. To reduce black-out time, the construction period must be reduced as much as possible. This paper presents new methods to reduce temporary transmission line construction time to within 48 hours by applying a self-reliance assembling method instead of the current man power assembling method and by modulizing each angle steel with duralumin.

• Carbon letters
• /
• v.14 no.4
• /
• pp.247-250
• /
• 2013

In this study, we present a facile method of fabricating graphene oxide (GO) films on the surface of polyimide (PI) via layer-by-layer (LBL) assembly of charged GO. The positively charged amino-phenyl functionalized GO (APGO) is alternatively complexed with the negatively charged GO through an electrostatic LBL assembly process. Furthermore, we investigated the water vapor transmission rate and oxygen transmission rate of the prepared (reduced GO $[rGO]/rAPGO)_{10}$ deposited PI film (rGO/rAPGO/PI) and pure PI film. The water vapor transmission rate of the GO and APGO-coated PI composite film was increased due to the intrinsically hydrophilic property of the charged composite films. However, the oxygen transmission rate was decreased from 220 to 78 $cm^3/m^2{\cdot}day{\cdot}atm$, due to the barrier effect of the graphene films on the PI surface. Since the proposed method allows for large-scale production of graphene films, it is considered to have potential for utilization in various applications.

• Journal of information and communication convergence engineering
• /
• v.4 no.2
• /
• pp.71-74
• /
• 2006

A basic access method about IEEE 802.11 MAC layer protocol using IEEE 802.11 wireless LANs is the DCF thatis based on the CSMA/CA. But, cause of IEEE 802.11 MAC layer uses original backoff algorithm (exponential backoff method), when collision occurred, the size of contention windows increases the double size Also, a time of packet transmission delay increases and efficienty is decreased by original backoff scheme. In this paper, we have analyzed TCP packet transmission time of IEEE 802.11 MAC DCF protocol for wireless LANs a proposed enhanced backoff algorithm. It is considered the transmission time of transmission control protocol (TCP) packet on the orthogonal frequency division multiplexing (OFDM) in additive white gaussian noise (A WGN) and Rician fading channel. From the results, a proposed enhanced backoff algorithm produces a better performance improvement than an original backoff in wireless LAN environment. Also, in OFDM/quadrature phase shift keying channel (QPSK), we can achieve that the transmission time in wireless channel decreases as the TCP packet size increases and based on the data collected, we can infer the correlation between packet size and the transmission time, allowing for an inference of the optimal packet size in the TCP layer.