• Bulletin of the Korean Chemical Society
• /
• 제23권3호
• /
• pp.413-416
• /
• 2002

The dielectric responses of 10 and 40 wt% siloxane-epoxy copolymers were investigated in temperature range near the glass transition of polydimethylsiloxane at which the dielectric transitions were also observed. On the other hand, the pure epoxy did not show any dielectric transition in measurement temperature range -90 to 150 $^{\circ}C.$ The experimental data showed that for the copolymer investigated, the temperature-frequency super-position principle could be applied to the dielectric response. From the Cole-Cole equation, the dielectric relaxation of the 10 wt% siloxane near the glass transition temperature resulted in a broad distribution with ${\beta}=$ 0.19 and the relaxation time at -70 $^{\circ}C$ was 5.3 ${\times}$ $10^{-2}$s. The glass transition temperature, 188 K, was estimated by using WLF relation, which was consistent with the data presented in experiment.

• 펄프종이기술
• /
• 제39권5호
• /
• pp.7-11
• /
• 2007

Kraft pulping of Trema orientalis (Nalita) was studied in order to find kinetic data for delignification. Pulping runs were carried out in the temperature range of $160-180\;^{\circ}C$ under constant and well-defined conditions. The delignification was found to be first order with respect to residual lignin and was chemically controlled. The rate of delignification reaction was increased 1.11-1.23 for $10\;^{\circ}C$ temperature increase in the range of $160-180\;^{\circ}C$ range. A mean value of 93% of lignin was removed at the transition between bulk and residual delignification. The influence of cooking temperature on the rate constant was expressed by an Arrhenius-type equation. The obtained activation energy of the delignification reaction was 6,164 cal/mol. The transition point between bulk and residual phase was shifted to lower lignin and carbohydrate yield with the increase of temperature.

• 한국주조공학회지
• /
• 제2권2호
• /
• pp.2-9
• /
• 1982

This paper is concerned with the improvement of impact and tensile Properties of spheroidal graphite cast iron of the following duplex matricess which were heat treated in the eutectic transformation temperature range (that is, $({\alpha}+{\gamma})$ coexisting range) ; ferrite-martensite, ferrite-bainite and ferrite-pearlite. The absorbed energy and maximum load was measured by recording the load-deflection curve with instrumented Charpy impact testing machine in the temperature range from $+100^{\circ}C$ to $-196^{\circ}C$. It was found the ferrite-bainite duplex matrix showed the highest toughness among the above matrices in the room temperature and the low temperature range. Comparison of this matrix to ferrite-pearlite matrix(that is, as cast) showed a lowering of $27^{\circ}C$ in the nil-ductility transition temperature (NDT) and a lowering of $40^{\circ}C$ in the ductile-brittle transition temperature (TrE), Which seems to result from the finner dimple pattern observed using miorofractography.

• Current Optics and Photonics
• /
• 제6권6호
• /
• pp.583-589
• /
• 2022

Vanadium dioxide (VO₂) is a well-known material that undergoes insulator-to-metal phase transition near room temperature. Since the conductivity of VO₂ changes several orders of magnitude in the terahertz (THz) spectral range during the phase transition, VO₂-based active metamaterials have been extensively studied. Experimentally, it is reported that the metal nanostructures on the VO₂ thin film lowers the critical temperature significantly compared to the bare film. Here, we theoretically studied such early transition phenomena by developing an analytical model. Unlike experimental work that only measures transmission, we calculate the reflection and absorption and demonstrate that the role of absorption is quite different for bare and patterned samples; the absorption gradually increases for bare film during the phase transition, while an absorption peak is observed at the critical temperature for the metamaterials. In addition, we also discuss the gap width and VO₂ thickness effects on the transition temperatures.

• Journal of Welding and Joining
• /
• 제14권1호
• /
• pp.38-46
• /
• 1996

High temperature low cycle fatigue crack growth behavior is investigated over a range of two temperatures and various frequencies in SUS 304 stainless steel. It is found that low frequency and temperature can enhance time-dependent crack growth. With high temperature, low frequency and long crack length, ${\Delta}J_c/{\Delta}J_ f$, the ratio of creep J integral range to fatigue J integral range is increased and time-dependent crack growth is accelerated. Interaction between ${\Delta}J_f$ and ${\Delta}J_c$ is occured at high frequency and low temparature and ${\Delta}J_c$, creep J integral range is fracture mechanical parameter on transition from cycle-dependent to time dependent crack growth in creep temperature region.

• 한국진공학회지
• /
• 제7권s1호
• /
• pp.1-6
• /
• 1998

The influence of the order-disorder structural transition on the magnetic and mageto-optical, and transport properties of Fe-Al and Co-Al alloy films has been investigated. The disordered states in the alloy films were prepared by vapor quenching deposition on glass substrates cooled by liquid nitrogen. The experimental study of the magento-optical properties of the ordered and disordered Fe-Al and Co-Al alloy films has been carried out in 1.05-5.0 eV energy range at room temperature. The transport properties have been measured in 2-300K temperature range with and without magnetic field of 0.5T. The influence of the order-disorder structural transition on the magnetic and magneto-optical properties was discussed by using the effective medium approximation and the structural defect approach. That on the temperature dependence of the resistivity was analyzed in a framework of the partial localization of the electronic states and the variable range hopping conductivity.

• 한국세라믹학회지
• /
• 제29권11호
• /
• pp.855-862
• /
• 1992

Thermoelectric power, electrical conductivity and Hall effect were measured, as functions of temperature in the range of 100 to 600 K, on polycrystalline Bi4/3Sb2/3Te3 which had been prepared via uniaxial hot-pressing at different temperatures in the range of 373 K to 773 K, aiming at searching a profitable processing route to a polycrystalline thermoelectric material, a promising, viable alternative to a single crystalline one. It was found that, with increasing temperature of pressing under a fixed pressure, the material, normally a p-type prior to being hot-pressed, underwent a transition to n-type. This transition was confirmed to be due to plastic deformation during hot-pressing and interpreted as being attributed to the change of the major ionic defect BiTe' into TeBi˙at temperature high enough for structure elements mobility. Thermoelectric figure-of-merit of the hot-pressed material was discussed in connection with the p-n transition in addition to microstructure.

• Journal of Magnetics
• /
• 제16권1호
• /
• pp.23-26
• /
• 2011

The effects of titanium ions on the crystallographic and spin-rotation transitions in iron sulfide have been examined by M$\"{o}$ssbauer spectroscopy in the temperature range of 78 to 600 K. It is noted that the titanium impurity of $Ti_{0.02}Fe_{0.98}S$ affects both the crystallographic and spin-rotation transitions of the iron sulfide. 2% impurity of $Ti^{2+}$ in FeS causes the increase in the difference between the spin rotation and ${\alpha}$ transition temperature by as much as 10 K compared with that for FeS. Both 1c and 2c structures coexist in the range between the ${\alpha}$ transition temperature and approximately 26 K, with a smaller hyperfine field corresponding to the 1c structure. The spin-rotation temperature for $Ti_{0.02}Fe_{0.98}S$ was measured to be 365 K, which is 10 K lower than the ${\alpha}$ transition temperature. By the 2% impurity of $Ti^{2+}$ in FeS the N$\'{e}$el temperature appreciably is not affected.

• Current Applied Physics
• /
• 제18권12호
• /
• pp.1605-1608
• /
• 2018

$Gd_{1-x}Ho_xNi$ melt-spun ribbons were fabricated by a single-roller melt spinning method. All the compounds crystallize in an orthorhombic CrB-type structure. The Curie temperature ($T_C$) was tuned between 46 and 99 K by varying the concentration of Gd and Ho. A spin reorientation (SRO) transition is observed around 13 K. Different from $T_C$, the SRO transition temperature is almost invariable for all compounds. Two peaks of magnetic entropy change (${\Delta}S_M$) were found. One at the higher temperature range was originated from the paramagnet-ferromagnet phase transition and the other at the lower temperature range was caused by the SRO transition. The maximum of ${\Delta}S_M$ around $T_C$ is almost same. The other maximum of ${\Delta}S_M$ around SRO transition, however, had significantly positive relationship with x. It reached a maximum about $8.2J\;kg^{-1}\;K^{-1}$ for x = 0.8. Thus double large ${\Delta}S_M$ peaks were obtained in $Gd_{1-x}Ho_xNi$ melt-spun ribbons with the high Ho concentration. And the refrigerant capacity power reached a maximum of $622J\;kg^{-1}$ for x = 0.6. $Gd_{1-x}Ho_xNi$ ribbons could be good candidate for magnetic refrigerant working in the low temperature especially near the liquid nitrogen temperature range.

• Journal of Korean Vacuum Science & Technology
• /
• 제7권1호
• /
• pp.13-17
• /
• 2003

The influence of structural transition on the resistance and impedance behavior of Ni$_2$MnGa alloy was investigated. The temperature-dependent resistance and impedance were measured in a temperature range of 4 - 350 K and 185 - 300 K, respectively. The dependence of temperature coefficient of resistivity on temperature shows a kink at 220 K, which is related to the structural transition. The change in dominant scattering mechanism results in the observed kink. Significant increases were also observed around the transition temperature for both real and imaginary parts of impedance. It is thought that this phenomenon originates from disappearance of the martensite twin boundaries during the structural transformation.